隧道工程地质评价的内容和方法

结合工程隧道实际,首先阐述了隧道工程的基本地质环境和工程地质条件,然后针对隧道工程可能出现的不良地质现象和可采取的工程措施,从大气降水、围岩稳定、围岩压力、洞口稳定、隧道比选等角度探讨隧道工程地质评价的主要方法和一般内容,进行隧道工程地质评价,为隧道施工、支护提供了依据.     

Modelling of deformation response and chemo‐mechanical coupling in chalk

A constitutive relation is derived for describing the mechanical response of chalk. The approach is based on a phenomenological framework which employs chemo‐plasticity. The properties of the material are assumed to be affected by the physico‐chemical processes that occur through the interaction between the skeleton and the pore fluid. The underlying mechanism is discussed by invoking a micromechanical analysis. The performance of the framework is illustrated by examining the evolution of mechanical characteristics in the presence of different pore fluids. Copyright © 2006 John Wiley & Sons, Ltd.     

地下洞库勘察中的深斜孔钻探和压水试验技术

青岛市黄岛区拟建设海底地下油气储藏库,前期地质勘察工作要求施工倾角45°、深220m的取心钻孔4个,并在孔内分段进行压水试验.本文介绍了如何利用XY-4型金刚石小口径钻机施工基岩深斜孔及压水试验技术.     

Formation Pressure Evaluation Method for Single Well

The paper deals with the methods of formation pressure evaluation for a single well by using the very common ac-cepted parameters, such as drilling exponent , and flowline temperature , etc. which is part of compiling the end well report.     

Possible chemical structures and biological precursors of different vitrinites in coal measure in Northwest China

Chemical structure of Jurassic vitrinites isolated from the coals in basins in NW China have been checked using solid state ¹³C NMR and flash pyrolysis-GC/MS. Study shows some Jurassic collodetrinites are rich in aliphatic products in pyrolysates, consisting with the high amount of methylene carbon in ¹³C NMR spectra. In contrast, pyrolysates of Jurassic collotelinites are rich in phenols and alkylbenzenes. Also one Pennsylvanian and one Permian vitrinite selected from the Ordos basin, NW China have been checked for comparison. The proportion of aliphatics is low in pyrolysates, and aliphatic carbon peak in ¹³C NMR spectrum of Permian vitrinite is mostly composed of gas-prone carbons compared with collodetrinites in those Jurassic basins. But both pyrolysis and ¹³C NMR data shows the Pennsylvanian vitrinite is not only gas-prone but also oil-prone. Relatively high proportion of long chain aliphatic structure of some Jurassic vitrinite in Junggar, Turpan-Hami basins may be due to the contribution of liptodetrinites, which may be included during the formation of vitrinites. And it seems that suberinite is the most possible precursor of long chain aliphatics in the structure of Jurassic collodetrinite.     

Ultrahigh pressure macro diamonds from Copeton (New South Wales, Australia), based on Raman spectroscopy of inclusions

Mining of Cenozoic alluvial deposits at Copeton and Bingara (Eastern Australia) has produced two million macrodiamonds (0.25 ct median size). Raman spectroscopy is used to identify included minerals within uncut Copeton diamonds, with sealed chamber remnant pressures of 31.7 to 35.6 kbar for coesite, 13.6 and 22.7 kbar for clinopyroxene, and 7.6 kbar for grossular garnet. Assuming elastic behaviour, these values generate inclusion entrapment PT loci which intersect, restricting diamond formation conditions: from 250 °C, 43 kbar to 800 °C, 52 kbar. Larger than error (± 100 °C and ± 4 kbar), this range shows a systematic variation in inclusion composition with diamond zoning and N properties. Published research shows 1) Copeton and Bingara diamonds are unique, and 2) modern alluvium in the Bingara district carries mantle-formed garnet, captured by post-tectonic alkali basalt from an extensive diamondiferous ultrahigh pressure (UHP) terrane that stalled at depth because it is dominated by mafic eclogite. The combined Raman and geological results indicate two sets of subduction UHP diamond formation conditions/protolith are required, firstly cooler oceanic slab and secondly including higher temperature continental crust. The Copeton and Bingara stones are UHP macrodiamonds, and Carboniferous ⁴⁰Ar/³⁹Ar age dates on clinopyroxene inclusions should be interpreted as ages of crystallisation, representing the termination of subduction. The characteristic features of ruptured inclusions and etched percussion marks on Copeton and Bingara diamond indicate volcanic delivery to the earth's surface. Alluvial deposits elsewhere in Eastern Australia may carry similar diamond along with diamond of different origin.     

Impact evaluation on groundwater of the infiltration of an urban wastewater geopurification system placed over a detrital aquifer in a semiarid region (Spain)

Over a period of 4 years and 4 months, the geopurification installations at Dehesas de Guadix (Granada, Spain) were monitored to determine the impact on soil and groundwater of the controlled discharge of urban wastewater, and also to identify the best indicators of the entry of the recharged water into the aquifer. The installations are located in an area where the climate is Mediterranean sub-arid, with an average precipitation of less than 287 mm/year, and a rate of evapotranspiration that is almost three times greater. The system was controlled by determining the balance of majority nutrients and boron in the soil and in the groundwater, both at the points affected directly by the wastewater discharge and at others. The quantity of mass discharged was relatively large (COD 14,656 g/m², NO₃ 85 g/m², NO₂ 4 g/m², NH₄ 2,425 g/m², PO₄ 1,143 g/m², K 1,531 g/m², B 63 g/m²). It was observed that the elimination of nutrients within the soil (COD 97.5%, PO₄ 94.4%, K 59.17%, N _total 18.8%, B 12.69%) was very efficient except for the nitrogen, which nevertheless did not reach the groundwater, as it was eliminated at deep levels of the unsaturated zone. Only 12.69% of the boron was removed, and appreciable, increasing amounts of this element did reach the groundwater. Unexpectedly, none of the majority nutrients behaved as a reliable indicator of the impact on groundwater; despite this, the boron and the bicarbonate did clearly reflect the arrival of the recharged water, and are proposed as the best indicators.     

Problems of soil and groundwater pollution in the disposal of “marble” slurries in NW Sicily

This work deals with disposal of slurries generated during the cutting and polishing processes of slabs of decorative sedimentary carbonate rocks in the north western Sicily. At present, they are used as fillers of dismantled quarries near the sawmills and, as a final step of reclamation, are covered with earth layers. In spite of such inexpensive solution, there is lack of knowledge about the composition of the waste. In order to assess if there is any threat for the environment and to suggest indications for alternative solutions, such as recycling or inactivation processes, the slurries were analysed by XR diffraction, simultaneous thermal analysis, ICP/MS, ionic chromatography, FTIR, UV-Vis, COD and TOC measurements, grain size analysis. Results indicate that the slurries can threaten the groundwater, because of the high chemical oxygen demand; furthermore they can modify the mechanism of groundwater recharge, because of their grain size distribution. Some laboratory tests show that, even in very aggressive conditions, the solid pollutants persist in the waste and slowly release into water the products of their degradation. The slurry therefore should be subjected to inactivation treatment before disposal or, alternatively, recycled as secondary raw material for a suitable process.     

Mapping susceptibility of rainfall-triggered shallow landslides using a probabilistic approach

To prepare a landslide susceptibility map is essential to identify hazardous regions, construct appropriate mitigation facilities, and plan emergency measures for a region prone to landslides triggered by rainfall. The conventional mapping methods require much information about past landslides records and contributing terrace and rainfall. They also rely heavily on the quantity and quality of accessible information and subjectively of the map builder. This paper contributes to a systematic and quantitative assessment of mapping landslide hazards over a region. Geographical Information System is implemented to retrieve relevant parameters from data layers, including the spatial distribution of transient fluid pressures, which is estimated using the TRIGRS program. The factor of safety of each pixel in the study region is calculated analytically. Monte Carlo simulation of random variables is conducted to process the estimation of fluid pressure and factor of safety for multiple times. The failure probability of each pixel is thus estimated. These procedures of mapping landslide potential are demonstrated in a case history. The analysis results reveal a positive correlation between landslide probability and accumulated rainfall. This approach gives simulation results compared to field records. The location and size of actual landslide are well predicted. An explanation for some of the inconsistencies is also provided to emphasize the importance of site information on the accuracy of mapping results.