Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.     

肋柱式锚杆支挡结构的徐变次内力分析

采用老化徐变理论和等效弹性模量法,对肋柱式锚杆支挡结构的徐变影响提出了具体计算方法,并通过实例计算了支挡结构的徐变次内力。计算结果表明,在逆作法条件下,随着开挖深度的加大,岩土侧向压力也增大,使后期施工的混凝土构件产生的徐变次内力也随之增大;考虑徐变后使结构设计更加安全可靠,尤其坡脚处后期浇筑的混凝土构件,更要关注徐变的影响。     

珠穆朗玛峰高程与板块构造运动问题

喜马拉雅山是由印度板块和欧亚板块相碰撞而形成,这已被当代多数有关科学家所认识。一些测量数据也表明喜马拉雅山现在仍在快速隆升。而喜马拉雅山主峰——珠穆朗玛峰的高程的测定,也成为当代地学界的热点。本文结合最新资料对精确测定珠峰高程的一些问题,诸如水准基面、峰顶标志和积雪等进行了讨论。     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

Ductile deformation of garnet in mylonitic gneisses from the Münchberg Massif (Germany)

Mylonitic gneisses from the Münchberg Massif contain single grains (type I) and polycrystalline aggregates (type II) of garnet displaying a distinct elongation parallel to a macroscopic lineation which is interpreted as the result of ductile deformation. Lattice-preferred orientations of quartz (textures) symmetrical to the macroscopic foliation and lineation and the lack of rotational microfabrics indicate that the bulk deformation was pure shear at least during the latest strain increments. Garnet textures measured by EBSD together with microprobe analyses demonstrate that these two structural types of garnet can be related to two different processes of ductile deformation: (1) For the single grains stretching can be attributed to diffusion creep along grain boundary zones (Coble creep). The related mass transfer is indicated by the fact that primary growth zones are cut off at the long faces of the grains while the related strain shadow domains do not show comparable chemical zoning. Pressure solution and precipitation suitable to produce similar structures can be largely ruled out because retrogressive reactions pointing to the presence of free hydrous fluids are missing. (2) For the polycrystalline garnet aggregates consisting of cores grading into fine-grained mantles, dislocation creep and associated rotation recrystallization can be assumed. Continuous lattice rotation from the core to the outer polycrystalline rim allow a determination of the related dominant slip systems which are {100}<010> and equivalent systems according to the cubic lattice symmetry. The same holds for garnets which appear to be completely recrystallized. For this type of fine-grained aggregates an alternative nucleation model is discussed. Due to penetrative dislocation glide in connection with short range diffusion and the resulting lattice rotation, primary growth zones are strongly disturbed.Since for the considered rock unit of the Münchberg Massif peak metamorphic temperatures between 630 and 670 °C can be assumed, this study clearly demonstrates that the inferred processes of ductile garnet deformation can occur not only in HT regimes as often suggested in the literature even if embedded within a matrix of “low-strength” minerals like quartz, feldspars and micas.     

Experimental and numerical studies of rock salt strain hardening

The work presented in this paper comes as part of a research program dealing with the thermomechanical behaviour of rock salt. It aims to study laboratory and in-situ long-term behaviour by means of creep tests with deviator and temperature changes. The laboratory results, using a triaxial multi-stages creep tests, highlighted the strain hardening character of rock salt. Furthermore, the in-situ results, using a borehole dilatometer multi-step creep test, have shown that the drilling is carried out in a weakly stressed pillar. The interpretation of the laboratory results, using the J.LEMAITRE law, did not indicate full agreement with all the test results. As a result a ‘double’ J.LEMAITRE model, which takes into account a double strain hardening variable, has been put forward. The validation of this model on the laboratory creep tests is very satisfactory. Furthermore, the activation energy seems satisfactory to represent the influence of the temperature. The in-situ behaviour modelling is clearly more complex than the modelization based on laboratory tests. In fact, it seems that if the rock salt behaviour is maintained by J.LEMAITRE law, it is necessary to vary with the stress, at least, one of the parameters assumed constant in the basic law.     

单一滑面边坡的非稳定蠕变模型分析

对单一滑面边坡的非稳定蠕变分析是边坡稳定性研究的基础。文中对岩质边坡单一滑面的流变变形机制进行了分析，提出了一种能较好反映这一变形机制的非稳定蠕变模型。特别是描述单一滑面边坡的非稳定蠕变破坏阶段，并对其稳定性进行了讨论。结合一些工程实例进行了对比验证，为滑坡灾害的预测和防治提供依据。     

青藏高原东部牧区雪灾的环流型及水汽场分析

冬、春季雪灾是青藏高原东部牧区重要的灾害性天气。本文利用历史天气图和国家气象中心T106L19全球模式的分析值格点资料，分析了青藏高原东部牧区近20年来冬，冬季降雨的天气形势和水汽场。结果表明，北脊南槽型、乌山脊型、阶梯槽型和国境槽型是造成高原东部牧区降雪的四类主要环流型；在高原东部牧区强降雪天气过程时气柱可降水量有明显增加，记要降雪区与水汽通量辐合区吻合，主要水汽来自孟加拉湾地区。