基于噪声谱比法的内蒙古西部地区台站场地响应研究

利用内蒙古西部12个台站的地脉动噪声数据，采用噪声谱比法研究台站的场地响应情况。分析表明，台站场地响应按曲线形态可分为3类，且可能受地形地貌、局部构造和台基状况等条件影响。对比分析噪声谱比法与Moya方法的场地响应结果发现，场地响应曲线形态基本一致，只有极少数台站存在明显差异。结果表明，内蒙古西部区域大部分台站的台基状况总体较好，场地响应曲线较为平坦，无明显频率放大点。     

亚毫米波射电天文用超导SIS接收机的研制(英文)

为了研制亚毫米波射电天文用超导SIS(超导 -绝缘体 -超导 )接收机 ,我们重点开展了如下研究 ,1 )Nb超导SIS结在其能隙频率附近的量子混频特性 ,及其结合高能隙超导薄膜 (NbTiN)和高电导率金属薄膜 (Al)分布结阵在 780 - 950GHz频率区间的量子混频特性 ;2 )亚毫米波超导混频器嵌入阻抗的数值和实验表征 ;3)高电流密度小面积Nb超导SIS结的制备和特性表征 ;4)一个 60 0 - 72 0GHz超导SIS混频器的研制和特性表征。本文详细介绍了相关的数值分析和实验测量结果。     

Optimal Filtering Algorithm for Stochastic 2-D FMM Ⅱ with Multiplicative Noise

1　Introduction　Inrecentyearstherehasbeengrowingresearchin terestinthetwo dimensional (2 D )systemtheory .The 2 Dsystemsmayfindapplicationsinareassuchasmarineseismicdataprocessingandimageprocessing .Althoughmoreandmorevaluableresultshavebeengained ,mos…     

Readout Techniques for Drift and Low Frequency Noise Rejection in Infrared Arrays

Three different methods are presented to subtract thermal drifts and low-frequency noise from the signal of infrared array. The first is dead pixels with open Indium bumps, the second is reference output as implemented on the Hawaii2 multiplexer, and the third is dark pixels to emulate reference cells having a capacity connected to the gate of the unit cell field-effect transistor (FET). The third method is the most effective and yields a reduction in readout noise from15.4–9.4 erms. A novel method will be described to extend this readout technique to the Aladdin 1 K × 1 K InSb array. This revised version was published online in July 2006 with corrections to the Cover Date.     

小杂鱼脱脂技术的研究

以小杂鱼或低值鱼为原料 ,采用常温溶剂萃取法进行脱脂 ,研究了不同溶剂、溶剂混合比、流速和萃取时间对鱼类脱脂的影响。结果表明 ,在常温下用等体积的异丙醇和乙酸乙酯混合溶剂 ,以流速 4～ 8mL/min连续萃取 4～ 6h ,脱脂鱼肉的脂肪平均含量w为 0 .19%,脱脂率高达96 .2 6 %。该方法的溶剂损耗量为加热溶剂萃取法的 1/3倍。     

密度和压缩系数的散射层析成像法

本文在速度成像的基础上研究了同时对密度和压缩系数成像的散射波层析成像法.对不同散射角度的计算可以得到一系列反演图像,拟合这些图像,从而可以有效地达到对密度和压缩系数（或速度）成像的目的.与单纯的速度成像相比,增加了反演的难度.首先是对资料的方位性要求增加;其次是对资料的利用率下降.即便如此,从对较少量的炮点和检波点资料的数值计算来看,仍取得了满意的成像结果.我们对组成字母“A”的散射体结构进行了成像计算,结果能够同时再现密度和压缩系数,成像清晰,表明了方法的可行性,并能应用于复杂结构的成像问题.     

Predicting ground-motion variations at the Turkey-flat test site,California

Results of a single group participating in an international experiment are analyzed. The experiment served to verify computational predictions of the ground-motion variations due to near-surface geological effects at a site established for that purpose by the California Department of Conservation. Based on an acceleration record at a rock location, and geotechnical model of medium, records at the other locations of a nearby sedimentary deposit were predicted. A 2-D finite-difference sensitivity analysis suggested that the lateral wave-propagation effects are negligibly small, and locally 1-D computations are sufficient for the present site. Those computations are compared with observations not available to the authors during the blind prediction. Peak accelerations, peak velocities and RMS accelerations were predicted with errors less than 159%, 114% and 62%, respectively. Maxima of the response spectra were fitted within a factor of 2. The predicted and observed Husid's plots (i.e., the normalized cumulative plots of the acceleration squared) have the correlation coefficients 0.98. The detected misfits do not show any simple relation to the instrument location, component, frequency, or time.     

宁夏香山-天景山弧形断裂带新活动特征及1709年中卫南71/2级地震形变带

本文根据野外地质填图和水系位移测量结果,论述了香山-天景山弧形断裂带新生代有两个不同活动性质的阶段,即早期阶段的强烈挤压和晚期阶段的左旋走滑兼挤压。分析、讨论了不同活动阶段的时间界限和转变原因。指出了1709年中卫南71/_2级地震形变带的表现形式、延伸范围     

Crustal structure at the easternmost termination of the Variscan belt based on CELEBRATION 2000 and ALP 2002 data

The eastern margin of the Variscan belt in Europe comprises plate boundaries between continental blocks and terranes formed during different tectonic events. The crustal structure of that complicated area was studied using the data of the international refraction experiments CELEBRATION 2000 and ALP 2002. The seismic data were acquired along SW–NE oriented refraction and wide-angle reflection profiles CEL10 and ALP04 starting in the Eastern Alps, passing through the Moravo-Silesian zone of the Bohemian Massif and the Fore-Sudetic Monocline, and terminating in the TESZ in Poland. The data were interpreted by seismic tomographic inversion and by 2-D trial-and-error forward modelling of the P waves. Velocity models determine different types of the crust–mantle transition, reflecting variable crustal thickness and delimiting contacts of tectonic units in depth. In the Alpine area, few km thick LVZ with the Vp of 5.1 km s^− 1 dipping to the SW and outcropping at the surface represents the Molasse and Helvetic Flysch sediments overthrust by the Northern Calcareous Alps with higher velocities. In the Bohemian Massif, lower velocities in the range of 5.0–5.6 km s^− 1 down to a depth of 5 km might represent the SE termination of the Elbe Fault Zone. The Fore-Sudetic Monocline and the TESZ are covered by sediments with the velocities in the range of 3.6–5.5 km s^− 1 to the maximum depth of 15 km beneath the Mid-Polish Trough. The Moho in the Eastern Alps is dipping to the SW reaching the depth of 43–45 km. The lower crust at the eastern margin of the Bohemian Massif is characterized by elevated velocities and high Vp gradient, which seems to be a characteristic feature of the Moravo-Silesian. Slightly different properties in the Moravian and Silesian units might be attributed to varying distances of the profile from the Moldanubian Thrust front as well as a different type of contact of the Brunia with the Moldanubian and its northern root sector. The Moho beneath the Fore-Sudetic Monocline is the most pronounced and is interpreted as the first-order discontinuity at a depth of 30 km.     

A seismic source zone model for the seismic hazard assessment of the Italian territory

We designed a new seismic source model for Italy to be used as an input for country-wide probabilistic seismic hazard assessment (PSHA) in the frame of the compilation of a new national reference map.

We started off by reviewing existing models available for Italy and for other European countries, then discussed the main open issues in the current practice of seismogenic zoning.

The new model, termed ZS9, is largely based on data collected in the past 10 years, including historical earthquakes and instrumental seismicity, active faults and their seismogenic potential, and seismotectonic evidence from recent earthquakes. This information allowed us to propose new interpretations for poorly understood areas where the new data are in conflict with assumptions made in designing the previous and widely used model ZS4.

ZS9 is made out of 36 zones where earthquakes with M_w > = 5 are expected. It also assumes that earthquakes with M_w up to 5 may occur anywhere outside the seismogenic zones, although the associated probability is rather low. Special care was taken to ensure that each zone sampled a large enough number of earthquakes so that we could compute reliable earthquake production rates.

Although it was drawn following criteria that are standard practice in PSHA, ZS9 is also innovative in that every zone is characterised also by its mean seismogenic depth (the depth of the crustal volume that will presumably release future earthquakes) and predominant focal mechanism (their most likely rupture mechanism). These properties were determined using instrumental data, and only in a limited number of cases we resorted to geologic constraints and expert judgment to cope with lack of data or conflicting indications. These attributes allow ZS9 to be used with more accurate regionalized depth-dependent attenuation relations, and are ultimately expected to increase significantly the reliability of seismic hazard estimates.