青藏高原及邻近区域的S波三维速度结构

本文收集了WWSSN台网和我国台网中13个地震台站的长周期地震记录,用140条10-90s瑞利波频散曲线和作者提出的Tarantola-Backus面波频散层析成象方法,作了青藏高原及邻区的速度反演,得出该地区岩石层速度结构的三维图象.结果表明,1.在10-110km深度范围内,速度结构出现与大地构造特征相关的分区性,显示出四个构造单元:青藏块体、柴达木-巴颜喀拉-三江块体、塔里木块体和印度块体.2.高原内部,深度为10-70km内速度较低,莫霍界面呈不对称盆形分布,藏北那曲附近地壳厚度超过70km,高原边缘壳厚为45-50km,90-110km为高速异常,表明高原内部存在上地幔盖层.3.高原北部的班公湖断裂和东部的三江断裂系是该区重要的分界线,是岩石层结构存在明显差异的重要接触部位,可能是冈瓦纳古陆与欧亚古陆的缝合带.4.柴达木-巴颜喀拉-三江块体内部速度分布不均匀,地壳厚度由北向南从45km加深到60km;在深度90-110km存在一低速层.5.塔里木地块内速度随深度均匀增加,从地壳到上地幔110km内没有发现低速层.地壳厚度约50km.     

Crustal and upper mantle structures of the brazilian coast

The Rayleigh wave phase and group velocities in the period range of 24–39 sec, obtained from two earthquakes which occurred in northeastern brazil and which were recorded by the Brazilian seismological station RDJ (Rio de Janeiro), have been used to study crustal and upper mantle structures of the Brazilian coastal region. Three crustal and upper mantle models have been tried out to explain crustal and upper mantle structures of the region. The upper crust has not been resolved, due basically to the narrow period range of the phase and group velocities data. The phase velocity inversions have exhibited good resolutions for both lower crust and upper mantle, with shear wave velocities characteristic of these regions. The group velocity data inversions for these models have showed good results only for the lower crust. The shear wave velocities of the lower crust (3.86 and 3.89 km/sec), obtained with phase velocity inversions, are similar to that (=3.89 km/sec) found byHwang (1985) to the eastern South American region, while group velocity inversions have presented shear velocity (=3.75 km/sec) similar to that (=3.78 km/sec) found byLazcano (1972) to the Brazilian shield. It was not possible to define sharply the crust-mantle transition, but an analysis of the phase and group velocity inversions results has indicated that the total thickness of the crust should be between 30 and 39 km. The crustal and upper mantle model, obtained with phase velocity inversion, can be used as a preliminary model for the Brazilian coast.     

多道瑞利波在矿井独头巷道超前探中的应用

瑞利波超前探测作为一种新的矿井地球物理探测方法,具有简便、快速、经济、分辨率高、适用场地小、应用范围广等优点。介绍了瑞利波探测技术原理,并将其用于煤矿井下独头巷道大距离超前探测中。实例表明,探测距离达80 m以上,条件允许时可达100 m以上。     

夹层厚度对瑞利面波频散曲线的影响

文章以弹性波横波速度为参数,利用瑞利面波频散曲线的快速标量传递算法进行正演模拟计算,系统研究软弱层厚度对瑞利面波基阶模频散曲线的影响,分析和总结了频率与相速度（f-c）、频率与波数（f-k）、深度与相速度（h-c）等瑞利面波基阶模曲线随软弱层厚度变化的规律。     

Transmission and reflection of Rayleigh waves at a thin low velocity vertical layer: A laboratory and theoretical study

A three-dimensional ultrasonic modelling was used to study the Rayleigh waves reflected from a thin low velocity vertical layer and those transmitted through the same zone. The reflection and transmission coefficients of the Rayleigh waves have been calculated by an approximate method based on the Green function technique. Nonrigid contact boundary conditions were used for the low velocity layer modelling. A rather good correspondence between the theoretical and experimental absolute values of the reflection and the transmission coefficients was obtained. Some discrepancies between experimental and theoretical results, in particular with regard to phase shifts, may be explained by a certain inadequacy of the theoretical model to the low velocity layer investigated by the ultrasonic modelling.     

Computation of Large Anisotropic Seismic Heterogeneities (CLASH)

A general tomographic technique is designed in order (i) to operate in anisotropic media; (ii) to account for the uneven seismic sampling and (iii) to handle massive data sets in a reasonable computing time. One modus operandi to compute a 3-D body wave velocity model relies on surface wave phase velocity measurements. An intermediate step, shared by other approaches, consists in translating, for each period of a given mode branch, the phase velocities integrated along ray paths into local velocity perturbations. To this end, we develop a method, which accounts for the azimuthal anisotropy in its comprehensive form. The weakly non-linear forward problem allows to use a conjugate gradient optimization. The Earth's surface is regularly discretized and the partial derivatives are assigned to the individual grid points. Possible lack of lateral resolution, due to the inescapable uneven ray path coverage, is taken into account through the a priori covariances on parameters with laterally variable correlation lengths. This method allows to efficiently separate the 2ψ and the 4ψ anisotropic effects from the isotropic perturbations. Fundamental mode and overtone phase velocity maps, derived with real Rayleigh wave data sets, are presented and compared with previous maps. The isotropic models concur well with the results of Trampert & Woodhouse. Large 4ψ heterogeneities are located in the tectonically active regions and over the continental lithospheres such as North America, Antarctica or Australia. At various periods, a significant 4ψ signature is correlated with the Hawaii hotspot track. Finally, concurring with the conclusions of Trampert & Woodhouse, our phase velocity maps show that Rayleigh wave data sets do need both 2ψ and 4ψ anisotropic terms.     

Determining Q of near-surface materials from Rayleigh waves

High-frequency (≥2 Hz) Rayleigh wave phase velocities can be inverted to shear (S)-wave velocities for a layered earth model up to 30 m below the ground surface in many settings. Given S-wave velocity (V_S), compressional (P)-wave velocity (V_P), and Rayleigh wave phase velocities, it is feasible to solve for P-wave quality factor Q_P and S-wave quality factor Q_S in a layered earth model by inverting Rayleigh wave attenuation coefficients. Model results demonstrate the plausibility of inverting Q_S from Rayleigh wave attenuation coefficients. Contributions to the Rayleigh wave attenuation coefficients from Q_P cannot be ignored when Vs/V_P reaches 0.45, which is not uncommon in near-surface settings. It is possible to invert Q_P from Rayleigh wave attenuation coefficients in some geological setting, a concept that differs from the common perception that Rayleigh wave attenuation coefficients are always far less sensitive to Q_P than to Q_S. Sixty-channel surface wave data were acquired in an Arizona desert. For a 10-layer model with a thickness of over 20 m, the data were first inverted to obtain S-wave velocities by the multichannel analysis of surface waves (MASW) method and then quality factors were determined by inverting attenuation coefficients.     

中国大陆及邻近海域的Rayleigh波群速度分布

利用Rayleigh波群速度资料反演得到中国大陆及其临近海域的(70°E-145°E,10°N-55°N)15-120s周期的群速度分布图像. 塔里木盆地在15s处清楚地显示为低速,在16-33s左右没有显示,但在36-5s显示为高速,说明塔里木盆地有较深的根. 青藏高原块体是44s至120s图像中最为突出的低速块体,南面与印度板块的分界线以及与北面的塔里木盆地、柴达木盆地的分界清晰,其块体中西部的速度低于东部. 泰国清迈附近存在一尺度为1000km左右的低速带,可能是青藏高原块体的物质向东南方向迁移造成上地幔物质上涌的结果. 南北地震带表现为强烈的速度梯度带,西面为低速,东面为高速. 中国南海的中央、日本海中央、菲律宾海表现为海洋性地壳. 菲律宾海的图像与地形及地震带完全吻合. 环绕菲律宾海及日本海存在400km左右宽的低速带,可能是岩浆活动带.     

克孜尔水库大坝的面波检测

1999年 3月 15日克孜尔地震之后对克孜尔水库坝体出现的裂缝进行了面波勘探。首先介绍了面波勘探法的基本原理 ,然后通过典型剖面检测与资料处理找出异常区、带并进行解释。试验表明面波勘探法适用于克孜尔水库大坝监测