Experimental investigations in a recirculating wind tunnel of the mechanisms of formation of accretionary lapilli have demonstrated that growth is controlled by collision of liquid-coated particles, due to differences in fall velocities, and binding as a result of surface tension forces and secondary mineral growth. The liquids present on particle surfaces in eruption plumes are acid solutions stable at 100% relative humidity, from which secondary minerals, e.g. calcium sulphate and sodium chloride, precipitate prior to impact of accretionary lapilli with the ground. Concentric grain-size zones within accretionary lapilli build up due to differences in the supply of particular particle sizes during aggregate growth. Accretionary lapilli do not evolve by scavenging of particles by liquid drops followed by evaporation — a process which, in wind tunnel experiments, generates horizontally layered hemispherical aggregates. Size analysis of particles in the wind tunnel air stream and particles adhering to growing aggregates demonstrate that the aggregation coefficient is highly grain-size dependent. Theoretical simulation of accretionary lapilli growth in eruption plumes predicts maximum sizes in the range 0.7–20 mm for ash cloud thicknesses of 0.5–10 km respectively. 相似文献
Hydrothermal conversion of fly ash into zeolites was conducted and the effects of the addition of sodium halide and waste solutions produced after zeolitization of fly ash, as well as the adjustment of the Si/Al ratio prior to synthesis process on the formation and cation exchange capacity (CEC) of zeolite product were evaluated. Both the addition of NaCl and NaF ameliorated the crystallinity and CEC of synthesized zeolite, but NaF had a better improvement effect. Na+ was considered to enhance the crystallization of zeolite, while F− favored the dissolution of fly ash. The type of zeolite formed depended on the Si/Al ratio of the starting material prior to the nucleation and crystallization of zeolite. The adjustment of the Si/Al ratio of fly ash by addition of Na2SiO4 and Al(OH)3 changed the type and CEC of zeolite. Waste solutions contained large amount of Si and little Al due to the formation of a zeolite named NaP1 in zeolite terminology with the Joint Committee of Powder Diffraction Standard (JCPDS) code of 39-0219. The alkalinity decreased largely. As a result, the CEC value of zeolite products synthesized with waste solution as alkali source decreased. The supplementation of new alkali to adjust the alkalinity of waste solution could enhance the CEC of synthesized product. It was concluded that: (1) addition of sodium halide and adjustment of the Si/Al ratio prior to synthesis can improve the quality of zeolite; (2) waste solutions produced following the zeolitization of fly ash can be reused as an alkali source in the activation of fly ash; zero-emission of waste solution in the synthesis of zeolite from fly ash is possible. 相似文献
Particles, less than PM10 in size, emitted from the stack of pulverized coal-fired power plants are of environmental concern since they can easily enter the human respiratory track. These fine particles are examined by Scanning Electron Microscope/Electron Dispersive Spectrometry (SEM/EDX). Plerospheres are found in fly ash and are particles containing smaller particles formed during combustion of coal. The large plerospheres 〉50 μm mostly are present in ESP fly ash, indicating that they are effectively capturing fine particles and reducing their stack emission. 相似文献
Abstract. Oxidation and reduction processes can influence extent of leaching of elements from solid waste. Three samples of municipal solid waste combustion fly ash were subjected to oxidizing and reducing conditions in order to evaluate leaching of elements in the Milli-Q water and fly ash (liquid to solid ratio, 100) mixtures. Although the oxidizing and reducing conditions were applied for 6 hours only, elements like Cs, Li, Mg, Sb, Tl and V leached more under oxidizing condition than under reducing condition in the case of all three ash samples. Cadmium, Pb and Zn leached more from all samples under reducing condition than under oxidizing condition. Leaching of other elements like Al, Ba, Cr, Cu, Ni and Rb was inconsistent with oxidizing or reducing conditions and varied from sample to sample, suggesting that factors other than redox may be more important in controlling leaching of these elements. Strong acid neutralization capacity of the fly ash samples let the pH vary within a narrow range, and thus severely limited the extent of leaching during the course of the experiment. Lead and Zn were the most sensitive while K and Na were the least sensitive to changes in redox conditions. 相似文献
A link between the inhalation of respirable silicas (SiO2) and respiratory diseases such as silicosis is widely recognized. Ash from dome collapse eruptions on Montserrat has been found to contain high levels (〉20%) of silicas in the form of cristobalite, tridymite, quartz and/or amorphous silica. The toxicity of these silica polymorphs varies widely. Cristobalite and quartz (tridymite less well established) are viewed as carcinogenic to humans whereas amorphous silica generally shows a reduced biological response. In assessing the potential health effects of volcanic ash particulates it is vital to determine the types and concentration of silicas as well as their size (respirable fraction), shape and surface properties. The aim of this study is to develop methods to assess potentially toxic respirable airborne silicas in the dome collapse ash (applicable to a range of ash types) and to develop a model to predict the levels and types of respirable silicas from future eruptions. The model is being developed by comparing dome rock with related ash from a series of previous eruption events. Mineralogical assessment using conventional scanning X-ray diffraction (XRD) was hampered by difficulties in differentiating characteristic peaks for cristobalite and tridymite in complex multi-component ash samples (containing high levels of plagioclase). These difficulties have been largely overcome using an Enraf-Nonius PDS120 diffractometer with curved (120 degrees 20) position sensitive detector (PSD). The determination of size, shape and elemental characteristics of ash particulate and dome rock samples has been carried out using automated analytical scanning electron microscopy. The quantification of mineral proportions using PSD-XRD was highly successful with an accuracy of 1 to 2 wt%. However, the determination of phase proportions using automated analytical SEM was problematic due to scattering effects and the multiphase nature of many of the particles. 相似文献
Fly ash is the solid waste of thermal power plants where coal is used as fuel, and its management and utilization have been of environmental concern for decades. Since the technique of synthesizing zeolite from coal fly ash was introduced by Holler[1] (19… 相似文献
Sewage sludge ash (SSA), the waste generated in sewage sludge incineration, was obtained from Wuhan Sewage Treatment Plant and used as a low-cost sorbent for removing Cu(Ⅱ) from wastewaters. The sorbent was first modified with 5 % sulfuric acid to increase its sorption capacity. The specific surface area, porosity, cation-exchange capacity (CEC) and pHZPC of the sorbent were measured. Batch experiments were made to study the effect of contact time, solution pH value and temperature on sorption. Both Langmuir and Freundlich models well described the Cu(Ⅱ) sorption process, with correlation coefficient (R2) values of 0.993 4 and 0.989 9 respectively. And the sorption process follows the Lagergren first order kinetic model. The equilibrium sorption capacity of acidified SSA to Cu(Ⅱ) is estimated to be 7.78 mg/g under optimal conditions. 相似文献
This paper presents data on the properties of coal and fly ash from two coal mines and two power plants that burn single-source coal from two mines in Indiana. One mine is in the low-sulfur (<1%) Danville Coal Member of the Dugger Formation (Pennsylvanian) and the other mines the high-sulfur (>5%) Springfield Coal Member of the Petersburg Formation (Pennsylvanian). Both seams have comparable ash contents (11%). Coals sampled at the mines (both raw and washed fractions) were analyzed for proximate/ultimate/sulfur forms/heating value, major oxides, trace elements and petrographic composition. The properties of fly ash from these coals reflect the properties of the feed coal, as well as local combustion and post-combustion conditions. Sulfur and spinel content, and As, Pb and Zn concentrations of the fly ash are the parameters that most closely reflect the properties of the source coal. 相似文献
Waste disposal constitutes an acute problem in numerous African cities. One solution could lie in the recycling of the nutrient-rich waste into agriculture taking place in and around cities. Farmers involved in vegetable production around Jos, Nigeria, have developed a sophisticated soil fertility management strategy combining inorganic fertilizers, manure and urban waste ash. This paper: (1) investigates the socio-economic constraints linked to obtaining scarce organic inputs, particularly urban waste ash and the health hazards (particularly heavy metal contamination of soil and crops) caused by using this ash and (2) suggests ways to improve use of this important resource. 相似文献
The delivery of volcanogenic sulphur into the upper atmosphere by explosive eruptions is known to cause significant temporary climate cooling. Therefore, phreatomagmatic and phreatoplinian eruptions occurring during the final rifting stages of active flood basalt provinces provide a potent mechanism for triggering climate change.
During the early Eocene, the northeast Atlantic margin was subjected to repeated ashfall for 0.5 m.y. This was the result of extensive phreatomagmatic activity along 3000 km of the opening northeast Atlantic rift. These widespread, predominantly basaltic ashes are now preserved in marine sediments of the Balder Formation and its equivalents, and occur over an area extending from the Faroe Islands to Denmark and southern England. These ash-bearing sediments also contain pollen and spore floras derived from low diversity forests that grew in cooler, drier climates than were experienced either before or after these highly explosive eruptions. In addition, coeval plant macrofossil evidence from the Bighorn Basin, Wyoming, USA, also shows a comparable pattern of vegetation change. The coincidence of the ashes and cooler climate pollen and spore floras in northwest Europe identifies volcanism as the primary cause of climate cooling. Estimates show that whilst relatively few phreatomagmatic eruptive centres along the 3000 km opening rift system could readily generate 0.5–1 °C cooling, on an annual basis, only persistent or repeated volcanic phases would have been able to achieve the long-term cooling effect observed in the floral record. We propose that the cumulative effect of repeated Balder Formation eruptions initiated a biodiversity crisis in the northeast Atlantic margin forests. Only the decline of this persistent volcanic activity, and the subsequent climatic warming at the start of the Eocene Thermal Maximum allowed the growth of subtropical forests to develop across the region. 相似文献