Design of stable drainage networks in upland forestry plantations

Erosion of man-made, forestry drainage channels occurs when the plough cuts through the surface peat layer into the underlying erodible mineral soil. A procedure is developed, based on hydraulic considerations, which will allow the drainage engineer to design stable drainage networks in upland forestry plantations. An example design chart is given for an erodible sandy loam type soil.     

密度和压缩系数的散射层析成像法

本文在速度成像的基础上研究了同时对密度和压缩系数成像的散射波层析成像法.对不同散射角度的计算可以得到一系列反演图像,拟合这些图像,从而可以有效地达到对密度和压缩系数（或速度）成像的目的.与单纯的速度成像相比,增加了反演的难度.首先是对资料的方位性要求增加;其次是对资料的利用率下降.即便如此,从对较少量的炮点和检波点资料的数值计算来看,仍取得了满意的成像结果.我们对组成字母“A”的散射体结构进行了成像计算,结果能够同时再现密度和压缩系数,成像清晰,表明了方法的可行性,并能应用于复杂结构的成像问题.     

The relationship between hydrodynamic properties and weathering of soils derived from volcanic rocks,Galapagos Islands (Ecuador)

The aim of this interdisciplinary study is to examine a component of the hydrological cycle in Galapagos by characterizing soil properties. Nine soil profiles were sampled on two islands. Their physical and hydrodynamic properties were analyzed, along with their mineralogical composition. Two groups of soils were identified, with major differences between them. The first group consists of soils located in the highlands (>350 m a.s.l.), characterized by low hydraulic conductivity (<10⁻⁵ m s⁻¹) and low porosity (<25%). These soils are thick (several meters) and homogeneous without coarse components. Their clay fraction is considerable and dominated by gibbsite. The second group includes soils located in the low parts of the islands (<300 m a.s.l.). These soils are characterized by high hydraulic conductivity (>10⁻³ m s⁻¹) and high porosity (>35%). The structure of these soils is heterogeneous and includes coarse materials. The physical properties of the soils are in good agreement with the variations of the rainfall according to the elevation, which appears as the main factor controlling the soil development. The clayey alteration products constrain soils physical and hydrodynamic properties by reducing the porosity and consequently the permeability and also by increasing water retention.     

Controls on porphyroblast size along a regional metamorphic field gradient

Garnet-bearing schists from the Waterville Formation of south-central Maine provide an opportunity to examine the factors governing porphyroblast size over a range of metamorphic grade. Three-dimensional sizes and locations for all garnet porphyroblasts were determined for three samples along the metamorphic field gradient spanning lowest garnet through sillimanite grade, using high-resolution X-ray computed tomography. Comparison of crystal size distributions to previous data sets obtained by stereological methods for the same samples reveals significant differences in mode, mean, and shape of the distributions. Quantitative textural analysis shows that the garnets in each rock crystallized in a diffusion-controlled nucleation and growth regime. In contrast to the typical observation of a correlation between porphyroblast size and position along a metamorphic field gradient, porphyroblast size of the lowest-grade specimen is intermediate between the high- and middle-grade specimens’ sizes. Mean porphyroblast size does not correlate with peak temperatures from garnet-biotite Fe-Mg exchange thermometry, nor is post-crystallization annealing (Ostwald Ripening) required to produce the observed textures, as was previously proposed for these rocks. Robust pseudosection calculations fail to reproduce the observed garnet core compositions for two specimens, suggesting that these calc-pelites experienced metasomatism. For each of these two specimens, Monte Carlo calculations suggest potential pre-metasomatism bulk compositions that replicate garnet core compositions. Pseudosection analyses allow the estimation of the critical temperatures for garnet growth: ∼481, ∼477, and ∼485°C for the lowest-garnet-zone, middle-garnet-zone, and sillimanite-zone specimens, respectively. Porphyroblast size appears to be determined in this case by a combination of the heating rate during garnet crystallization, the critical temperature for the garnet-forming reaction and the kinetics of nucleation. Numerical simulations of thermally accelerated, diffusion-controlled nucleation, and growth for the three samples closely match measured crystal size distributions. These observations and simulations suggest that previous hypotheses linking the garnet size primarily to the temperature at the onset of porphyroblast nucleation can only partially explain the observed textures. Also important in determining porphyroblast size are the heating rate and the distribution of favorable nucleation sites.     

Flood hazard delineation combining geomorphological and hydrological methods: an example in the Northern Iberian Peninsula

Flood mapping requires the combination and integration of geomorphological and hydrological-hydraulic methods; however, despite this, there is very little scientific literature that compares and validates both methods. Two types of analysis are addressed in the present article. On the one hand, maps of flood plains have been elaborated using geomorphological evidence and historical flood data in the mountainous area of northwestern Spain, covering an area of more then 232 km² of floodplains. On the other hand, a hydrometeorological model has been developed (Clark semidistributed unit hydrograph) in the Sarria River basin (155 km², NW Spain). This basin is not gauged, hence the model was subjected to a goodness-of-fit test of its parameter (curve number) by means of Monte Carlo simulation. The peak flows obtained by means of the hydrological model were used for hydraulic modeling (one-phase, one-dimensional and steady flow) in a 4 km² urban stretch of the river bed. The delineation of surface areas affected by floods since 1918, as well as those analyzed subsequent to the geomorphological study, reveals a high degree of reliability in the delineation of the flooded areas with frequent recurrence intervals (<50 years). If we compare these flooded surface areas with the estimate obtained by the hydrological-hydraulic method we can see that the latter method overestimates the extent of the surface water by 144% for very frequent recurrence intervals (>10 years) and underestimates it as the recurrence interval increases, by up to 80% less floodplain for exceptional events (>500 years). Finally, a management map is put forth combining the most reliable results available by integrating both methods. Originally presented at the Sixth International Conference on Geomorphology.     

海洋声层析的基本原理和应用

从射线声学和简正波声学的角度，概述了海洋声层析的基本理论，包括射线走时反演、简正波走时反演、简正波相位反演和简正波水平折射层析。海洋声层析以反演海水温度和流速为基础。还总结了声层析在海洋学研究中的应用。     

Monitoring the Kuroshio Extension with Dynamically Constrained Synthesis of the Acoustic Tomography, Satellite Altimeter and in situ Data

A finite-difference quasigeostrophic (QG) model of an open ocean region has been employed to produce a dynamically constrained synthesis of acoustic tomography and satellite altimetry data with in situ observations. The assimilation algorithm is based upon the 4D variational data interpolation scheme controlled by the model's initial and boundary conditions. The data sets analyzed include direct and differential travel times measured at the array of five acoustic transceivers deployed by JAMSTEC in the region of the Kuroshio Extension in 1997, Topex/Poseidon altimetry, CTD soundings, and ADCP velocity profiles. The region monitored is located within the area 27.5°–36.5°N, 143°–155°. The results of assimilation show that mesoscale variability can be effectively reconstructed by five transceivers measuring direct and reciprocal travel times supported by relatively sparse in situ measurements. The misfits between model and data lie within the observational error bars for all the data types used in assimilation. We have compared the results of assimilation with the statistical inversion of travel time data and analyzed energy balances of the optimized model solution. Energy exchange between the depth-averaged and shear components of the observed currents reveals a weak decay of the barotropic mode at the rate of 0.2 ± 0.7⋅10⁻⁵ cm²/s³ due to topographic interaction. Mean currents in the region are unstable with an estimate of the available potential energy flux from the mean current to the eddies of 4.7 ± 2.3⋅10⁻⁵ cm²/s³. Kinetic energy transition has the same sign and is estimated as 2.8 ± 2.5⋅10⁻⁵ cm²/s³. Potential enstrophy is transferred to the mesoscale at a rate of 5.5 ± 2.7⋅10⁻¹⁸ s⁻³. These figures provide observational evidence of the properties of free geostrophic turbulence which were predicted by theory and observed in numerical experiments. This revised version was published online in July 2006 with corrections to the Cover Date.     

An experimental study on non-linear progressive wave-induced dynamic stresses in seabed

In this study, the dynamic stresses within the seabed induced by non-linear progressive waves were explored through a series of hydraulic model tests on a movable bed within a wave flume. By comparing Stokes’ 2nd-order wave theory with the theory of wave-induced dynamic stresses within the seabed as proposed by Yamamoto et al. [1978. On the response of a poro-elastic bed to water waves. Journal of Fluid Mechanics 87 (1), 193–206.] and Hsu and Jeng [1994. Wane-induced soil response in an unsaturated anisotropic seabed of finite thickness. International Journal for Numerical and Analytical Methods in Geomechanics 18, 785–807], the experimental results show that the pressure on the seabed surface, the pore water pressure within the seabed as well as the vertical and the horizontal stresses are all smaller than their theoretical values. If we were to obtain the characteristics of seabed soil, the analytical solution of Hsu and Jeng [1994. Wane-induced soil response in an unsaturated anisotropic seabed of finite thickness. International Journal for Numerical and Analytical Methods in Geomechanics 18, 785–807] might agree to the simulation of the wave-induced effective stresses and shear stress in the sandy seabed. A different phase shift exists among all the three soil stresses. Their influences on the three dynamic stresses within seabed soil are important for seabed stability, and can be used in the verification of numerical models. In the whole, the non-linear progressive waves and the naturally deposited seabed are found to have a strong interaction, and the behavior of the induced dynamic stresses within the seabed is very complicated, and should be investigated integrally.