Analytical study of ground motion caused by seismic wave propagation across faulted rock masses

Studying seismic wave propagation across rock masses and the induced ground motion is an important topic, which receives considerable attention in design and construction of underground cavern/tunnel constructions and mining activities. The current study investigates wave propagation across a rock mass with one fault and the induced ground motion using a recursive approach. The rocks beside the fault are assumed as viscoelastic media with seismic quality factors, Q_p and Q_s. Two kinds of interactions between stress waves and a discontinuity and between stress waves and a free surface are analyzed, respectively. As the result of the wave superposition, the mathematical expressions for induced ground vibration are deduced. The proposed approach is then compared with the existing analysis for special cases. Finally, parametric studies are carried out, which includes the influences of fault stiffness, incident angle, and frequency of incident waves on the peak particle velocities of the ground motions.     

基于噪声谱比法的内蒙古西部地区台站场地响应研究

利用内蒙古西部12个台站的地脉动噪声数据，采用噪声谱比法研究台站的场地响应情况。分析表明，台站场地响应按曲线形态可分为3类，且可能受地形地貌、局部构造和台基状况等条件影响。对比分析噪声谱比法与Moya方法的场地响应结果发现，场地响应曲线形态基本一致，只有极少数台站存在明显差异。结果表明，内蒙古西部区域大部分台站的台基状况总体较好，场地响应曲线较为平坦，无明显频率放大点。     

Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Petroleum exploration potential of Tamtsag Basin

The Tamtsag Basin is located in the extreme eastern portion of the Mongolia. The Basin and its counterpart in China (the Hailar Basin) are united a whole basin on the structural setting. In recent years, the Tamtsag Basin attracts more and more attention with the important exploration discovered in the 19th block by SOCO and in Hailar Basin of China. This paper discusses the exploration potential of Tamtsag Basin from the viewpoint of petroleum geology.     

The response of an elastic half‐space under a momentary shear line impulse

The response of an ideal elastic half‐space to a line‐concentrated impulsive vector shear force applied momentarily is obtained by an analytical–numerical computational method based on the theory of characteristics in conjunction with kinematical relations derived across surfaces of strong discontinuities. The shear force is concentrated along an infinite line, drawn on the surface of the half‐space, while being normal to that line as well as to the axis of symmetry of the half‐space. An exact loading model is introduced and built into the computational method for this shear force. With this model, a compatibility exists among the prescribed applied force, the geometric decay of the shear stress component at the precursor shear wave, and the boundary conditions of the half‐space; in this sense, the source configuration is exact. For the transient boundary‐value problem described above, a wave characteristics formulation is presented, where its differential equations are extended to allow for strong discontinuities which occur in the material motion of the half‐space. A numerical integration of these extended differential equations is then carried out in a three‐dimensional spatiotemporal wavegrid formed by the Cartesian bicharacteristic curves of the wave characteristics formulation. This work is devoted to the construction of the computational method and to the concepts involved therein, whereas the interpretation of the resultant transient deformation of the half‐space is presented in a subsequent paper. Copyright © 2003 John Wiley & Sons, Ltd.     

Virtual Huanghe River System： Framework and Technology

1 Introduction Huanghe (Yellow) River basin is located in 32°–42°N, 96°–119°E. The area of the catchment is more than 752,000km2. The river is 5464km long with a drop in elevation of 4830m. Among the whole area, the moun- tainous and stone area accounts for 29%, loess and hills area 46%, sandy area 11% and plain area 14%, respec- tively. Different natural landscapes exist in this area. The Huanghe River flows through the Loess Plateau, where the soil is eroded seriously (Wang, 2002;…     

Geological environment conflicts of Kunming Basin and its urban sustainable development

Kunming Basin locates middle of Yunnan altiplano and has a particularity in geography,topographic and geological environment.With the urban dilation quickly,add the reason of the unreasonable city layout,conflicts between environment and urban resources consumption become shrill increasingly.It is human being activities that lead to vulnerability and depravation of geological environment in local.Take a few examples on geological environment to expatiate relationship between urban construction and geological environment carrying capacity,and find a way how to make a better plan for urban sustainable development to achieve new balance between man and nature in local.     

Synthetic SH seismograms in a laterally varying medium by the discrete wavenumber method

Summary. We present a new method to calculate the SH wavefield produced by a seismic source in a half-space with an irregular buried interface. The diffracting interface is represented by a distribution of body forces. The Green's functions needed to solve the boundary conditions are evaluated using the discrete wavenumber method. Our approach relies on the introduction of a periodicity in the source-medium configuration and on the discretization of the interface at regular spacing. The technique developed is applicable to boundaries of arbitrary shapes and is valid at all frequencies. Some examples of calculation in simple configurations are presented showing the capabilities of the method.     

Damage identification method using harmonic excitation force considering both modelling and measurement errors

A method of structural damage identification using harmonic excitation force is presented. It considers the effects of both measurement and modelling errors in the baseline finite element model. Damage that accompanies changes in structural parameters can be estimated for a damaged structure from the change between measured vibration responses and ones calculated from the analytical model of the intact structure. In practice, modelling errors exist in the analytical model due to material and geometric uncertainties and a reduction in the degrees of freedom as well as measurement errors, making identification difficult. To surmount these problems, bootstrap hypothesis testing, which enables statistical judgment without information about these errors, was introduced. The method was validated by numerical simulation using a three‐dimensional frame structure and real vibration data for a three‐storey steel frame structure. Copyright © 2005 John Wiley & Sons, Ltd.     

中国大陆科学钻探先导孔零偏VSP资料解释

用六级三分量检波器在中国大陆科学钻探先导孔中实施了零偏VSP测量.数据处理结果表明,中国大陆科学钻探孔区超高压变质岩石的地震波速度主要介于4500～7000m/s之间,显著高于一般的沉积岩地区,而且随深度变化不明显.声波测井速度系统地稍低于VSP层速度,可能是由于井壁处岩石的完整性受到破坏而造成的.地震波速度与岩石密度和岩性存在明确的对应关系,榴辉岩的密度和地震波速度均显著高于片麻岩类岩石;由榴辉岩退变生成的斜长角闪岩类岩石,其密度和地震波速度均呈现出较大的变化,主要与其退变质程度有关;超基性岩中的裂隙系统导致其密度和地震波速度大幅度下降.由于榴辉岩与其他岩石类型之间存在较大的波阻抗差异,因此用零偏VSP资料标定该区地震波的地质层位是有效的.关于地震波反射的原因,通过综合研究地震波(包括反射纵波、上行转换横波、井筒波)的特征、岩石速度和密度分布以及井径变化,认为主要是岩性分界面、韧性剪切带和断裂(带),但还有一些因素尚待进一步研究.