Møre Margin: Crustal structure from analysis of Expanded Spread Profiles

Analysis in both the x—t and —p domains of high-quality Expanded Spread Profiles across the Møre Margin show that many arrivals may be enhanced be selective ray tracing and velocity filtering combined with conventional data reduction techniques. In terms of crustal structure the margin can be divided into four main areas: 1) a thicker than normal oceanic crust in the eastern Norway Basin; 2) expanded crust with a Moho depth of 22 km beneath the huge extrusive complex constructed during early Tertiary breakup; 3) the Møre Basin where up to 13–14 km of sediments overlie a strongly extended outer part with a Moho depth at 20 km west of the Ona High; and 4) a region with a 25–27 km Moho depth between the high and the Norwegian coast. The velocity data restricts the continent-ocean boundary to a 15–30 km wide zone beneath the seaward dipping reflector wedges. The crust west of the landward edge of the inner flow is classified as transitional. This region as well as the adjacent oceanic crust is soled by a 7.2–7.4 km s^–1 lower crustal body which may extend beneath the entire region that experienced early Tertiary crustal extension. At the landward end of the transect a 8.5 km s^–1 layer near the base of the crust is recognized. A possible relationship with large positive gravity anomalies and early Tertiary alkaline intrusions is noted.     

GPS signal acquisition using the repeatability of successive code phase measurements

This paper introduces a new method for GPS signal acquisition, which is based on the repeatability of successive code phase measurements and the M-of-N search algorithm. The performance of the proposed method in terms of probability of signal detection is similar to that of traditional methods, except that the calculation of the probability of detection does not rely on the noise distribution or the Carrier-to-Noise ratio (C/N₀). The code phase repeatability-based method is presented along with equations for probability of detection and probability of false detection. If the distribution of the noise is known, it also provides an estimate of the C/N₀. The proposed method is illustrated for coherent and non-coherent acquisition and C/N₀ estimation.     

Dynamic data integration for structural modeling: model screening approach using a distance-based model parameterization

This paper proposes a novel history-matching method where reservoir structure is inverted from dynamic fluid flow response. The proposed workflow consists of searching for models that match production history from a large set of prior structural model realizations. This prior set represents the reservoir structural uncertainty because of interpretation uncertainty on seismic sections. To make such a search effective, we introduce a parameter space defined with a “similarity distance” for accommodating this large set of realizations. The inverse solutions are found using a stochastic search method. Realistic reservoir examples are presented to prove the applicability of the proposed method.     

Developing a SPASE Query Language

The advent of the Virtual Observatory has begun an evolution in the space physics data environment. A number of nascent and discipline specific Virtual Observatories have started to emerge with an emphasis on data search and retrieval. As this new data environment takes shape an emphasis will be placed on interdisciplinary communication in attempts to address large scale and global problems. To this end we formulate the development of a query language to facilitate Virtual Observatory to Virtual Observatory communication. Furthermore, we outline the goals of such a language, how it would work and how existing community efforts can be leveraged to speed the development of this query language.

Reservoir description using dynamic parameterisation selection with a combined stochastic and gradient search

There is a correspondence between flow in a reservoir and large scale permeability trends. This correspondence can be derived by constraining reservoir models using observed production data. One of the challenges in deriving the permeability distribution of a field using production data involves determination of the scale of resolution of the permeability. The Adaptive Multiscale Estimation (AME) seeks to overcome the problems related to choosing the resolution of the permeability field by a dynamic parameterisation selection. The standard AME uses a gradient algorithm in solving several optimisation problems with increasing permeability resolution. This paper presents a hybrid algorithm which combines a gradient search and a stochastic algorithm to improve the robustness of the dynamic parameterisation selection. At low dimension, we use the stochastic algorithm to generate several optimised models. We use information from all these produced models to find new optimal refinements, and start out new optimisations with several unequally suggested parameterisations. At higher dimensions we change to a gradient-type optimiser, where the initial solution is chosen from the ensemble of models suggested by the stochastic algorithm. The selection is based on a predefined criterion. We demonstrate the robustness of the hybrid algorithm on sample synthetic cases, which most of them were considered insolvable using the standard AME algorithm.     

Water temperature behaviour in the River Loire since 1976 and 1881

Analysis of monthly mean river temperatures, recorded on an hourly basis in the middle reaches of the Loire since 1976, allows reconstruction by multiple linear regression of the annual, spring and summer water temperatures from equivalent information on air temperatures and river discharge. Since 1881, the average annual and summer temperatures of the Loire have risen by approximately 0.8?°C, this increase accelerating since the late 1980s due to the rise in air temperature and also to lower discharge rates. In addition, the thermal regime in the Orleans to Blois reach is considerably affected by the inflow of groundwater from the Calcaires de Beauce aquifer, as shown by the summer energy balance. To cite this article: F. Moatar, J. Gailhard, C. R. Geoscience 338 (2006).     

Une approche innovante pour modéliser la biodégradation des composés organochlorés volatils en aquifères poreux

The goal of this study was to develop an innovative chloroethene biodegradation module based on biological, thermodynamical and mechanistic concepts. The biodegradation scheme was based on the postulate that in each part of an aquifer only one degradation mechanism is dominant: the one involving the most energetic electron acceptor. Thus, the selection of the active degradation mechanism was a function of the concentration of different electron acceptors. Modified Monod-type kinetics was used in order to take into account the possible influence of some compounds on the biodegradation of a given organic compound. The numerical model developed was applied to a simple test case, whose results are presented here. To cite this article: F. Nex et al., C. R. Geoscience 338 (2006).     

洪水演进三维模拟仿真系统可视化研究

洪水演进仿真系统的研制，是实施“数字流域”工程的重要组成部分；结合洪水演进可视化目标的分析，基于Visual C 系统开发平台，融GIS技术和Opengl开发技术，采用三角形逼近、光滑处理和加入法向量以控制光照的方式，实现了流域地形及河床的三维可视化仿真；应用广度优先搜索算法确定了运动水体与流域河床形态的自适应与自相依的关系，使流域洪水演进模拟具有真实自然的可视化效果。所研制的系统雏形，可有效的模拟流域洪水的三维演进过程；     

Alpujarride attribution of the supposed ‘Almagride Complex’ (Betic Internal Zone,Almerı́a Province,Spain)Appartenance Alpujarride du prétendu « Complexe almagride » (Zones internes bétiques,province d'Almeria,Espagne)

The differentiation of units in the Sierra de Almagro has been a source of controversy. There were defined the Almagride and Ballabona–Cucharón complexes, the former considered by several authors as part of a Subbetic metamorphosed and outcropping in a tectonic window. In this study, the units of Ballabona, Almagro and Cucharón are integrated into a single one, that of Tres Pacos, because they correspond to different parts of the same stratigraphic series. This unit is tectonically over the Nevado–Filabride Complex. The existence of the Almagride and Ballabona–Cucharón complexes is discarded and their units form part of the Alpujarride Complex. To cite this article: C. Sanz de Galdeano, F.J. Garc??a Tortosa, C. R. Geoscience 334 (2002) 355–362.     

Soulèvement et plissement tectoniques révélés par analyse mathématique empirique de profils longitudinaux de rivières : un cas à TaiwanEmpirical mathematical analysis of longitudinal river profiles reveals tectonic uplift and folding: a case in Taiwan

We analyse longitudinal river profiles in southwestern Taiwan. As all necessary data are not available, a physical modelling of river erosion would be subject to large uncertainties. We thus shortcut this modelling and adopt simple empirical exponential equations giving riverbed elevation as a function of downstream distance. We identify a positive altimetric anomaly, which reveals active uplift of an anticline at the front of the fold-and-thrust belt. To cite this article: J. Angelier, R.-F. Chen, C. R. Geoscience 334 (2002) 1103–1111.