影响鸢乌贼手钓上钩率的因子探讨

根据印度洋西北部鸢乌贼（Sym plectoteuthis oualaniensis）作业渔场的现场调查数据．分析了作业水深、作业时段、摄食等级和月相等因子对手钓上钩率的影响。统计表明．晚上、午夜和凌晨3个不同时段和不同作业水深对手钓上钩率均有显著性影响。3个时段中，其摄食等级呈先低后高再低的现象。午夜和凌展，上钩率的变化趋势与摄食等级的变化趋势呈显著的负相关。在月相的影响下．离朔日三四天之前，手钓产量呈上升趋势；离望日五六天之前。手钓产量呈明显的下降趋势。     

浅论经济增长与物价水平的关系

从交易方程出发，初步分析了经济增长与物价水平的关系，得到了一些有益的结果。     

蜕壳素对凡纳滨对虾生长及表观消化率的影响

研究了外源性蜕皮激素对凡纳滨对虾生长和表观消化率的影响 ,实验时在基础饲料中分别添加 0 .1%、0 .2 %、0 .4 %的两种市售蜕壳素产品 ,制成 6种外源性脱壳素配合饲料 ,不添加的基础饲料作为对照组 ,试验在 2 6 0L玻璃钢循环水养殖系统中 ,每个剂量组设 3个重复 ,8周生长试验结果表明 :市售蜕壳素产品能有效地促进对虾生长 ,试验结束时 ,试验组虾体增重分别较对照组增加 16 .8%、7.5 2 %、5 .9%、11.4 %、2 9.0 7%、16 .5 3% ,但是凡纳滨对虾对饲料粗蛋白的表观消化率没有明显地提高 ,凡纳滨对虾对脂肪的表观消化率较低。推算凡纳滨对虾饲料中最佳蜕皮酮添加量为 6 0mg/kg。     

企鹅珍珠贝人工苗生长的初步观察

为了解企鹅珍珠贝生长规律，观察了壳高2.5～5.0mm的出池幼苗，按月测量其生长参数和成活率，以及环境因子。结果表明，企鹅珍珠贝生长最快的月份为7～11月和次年4～6月，壳长，壳高和壳宽月均增加量分别为3.8～13.0mm、4.7～11.2mm、2.3～3.8mm，月成活率97.8%～98.6%。企鹅珍珠贝生长最慢月份是11月至次年3月。     

Survival,growth and shell deformities of copper- and cadmium-exposed mussels (Mytilus edulis L.) in brackish water

Mussels, Mytilus edulis L., were exposed to elevated concentrations of copper or cadmium in the laboratory, then placed in cages in the sea (salinity 7‰). One year later maximum lengths of the mussels were measured and shells screened for deformities. Growth was 0·6 cm year^?1 in the control cages and retarded in cages of exposed mussels. A total of 63% of cadmium-exposed and 46% of copper-exposed mussels had shell deformities. In the control cages 26% were deformed while in a natural population only 3% were deformed. The proportion of deformities to growth was inversely related. Low concentrations showed their injuriousness in this long-term test, probably due to the closing of the valves during exposure to high concentrations.     

运输系统的区域效应研究

运输系统改进—运距缩短—产业布局调整这一空间过程对不同的区域可能具有完全不同的意义。本文通过对一个两区域—两部门经济模型的研究得出结论:当较落后的资源产区与经济中心之间的距离由于运输系统的改进而缩短时,资源产区的经济结构向单一化转变,初级产品的生产和输出在经济建设中逐渐占主导地位,加工工业逐渐萎缩,地方经济发展受到阻碍,而且这种变化是在距离的某一特定值处突然出现的,带有跃变的性质。这一研究结果表明,对区域运输系统的任何改进措施都应该慎而行之,以免造成与本来目标相悖的区域效应。     

Characterization of the Si:As Blocked Impurity Band (BIB) Detector in Keck's Long Wavelength Spectrometer (LWS)

Keck's Long Wavelength Spectrometer (LWS), is the facility instrument used for imaging and spectroscopy in the wavelength range of 3–28 μm at the Keck Observatory. LWS uses an 128 × 128 Si:As blocked impurity band (BIB) array manufactured by the Boeing Corporation. This paper discusses the method used for optimizing the detector's operating parameters at a temperature of 8.5 K and bias voltage of 1.2 V. A process for characterizing detective quantum efficiency of BIB detectors is also presented. This revised version was published online in July 2006 with corrections to the Cover Date.     

REVIEWS OF GEOGRAPHIC SOFTWARE

Reviews of geographic software in this article: DEMO-GRAPHICS: WORLD POPULATIONS AND PROJECTIONS. ESP GAUSS. CEMODEL S. Damus LIMDEP. William H. Greene MICROSTAT 4.1 OTIS PCIPS. (Personal Computer Image Processing System) . H.J. Meyers and R. Bernstein. REGRESSION ANALYSIS OF TIME SERIES (RATS) SPSS/PC+ URBAN DATA MANAGEMENT SOFTWARE (UDMS)     

Time scale of an early to mid-Paleozoic orogenic cycle of the long-lived Central Asian Orogenic Belt, Inner Mongolia of China: Implications for continental growth

We present a detailed, new time scale for an orogenic cycle (oceanic accretion–subduction–collision) that provides significant insights into Paleozoic continental growth processes in the southeastern segment of the long-lived Central Asian Orogenic Belt (CAOB). The most prominent tectonic feature in Inner Mongolia is the association of paired orogens. A southern orogen forms a typical arc-trench complex, in which a supra-subduction zone ophiolite records successive phases during its life cycle: birth (ca. 497–477 Ma), when the ocean floor of the ophiolite was formed; (2) youth (ca. 473–470 Ma), characterized by mantle wedge magmatism; (3) shortly after maturity (ca. 461–450 Ma), high-Mg adakite and adakite were produced by slab melting and subsequent interaction of the melt with the mantle wedge; (4) death, caused by subduction of a ridge crest (ca. 451–434 Ma) and by ridge collision with the ophiolite (ca. 428–423 Ma). The evolution of the magmatic arc exhibits three major coherent phases: arc volcanism (ca. 488–444 Ma); adakite plutonism (ca. 448–438 Ma) and collision (ca. 419–415 Ma) of the arc with a passive continental margin. The northern orogen, a product of ridge-trench interaction, evolved progressively from coeval generation of near-trench plutons (ca. 498–461 Ma) and juvenile arc crust (ca. 484–469 Ma), to ridge subduction (ca. 440–434 Ma), microcontinent accretion (ca. 430–420 Ma), and finally to forearc formation. The paired orogens followed a consistent progression from ocean floor subduction/arc formation (ca. 500–438 Ma), ridge subduction (ca. 451–434 Ma) to microcontinent accretion/collision (ca. 430–415 Ma); ridge subduction records the turning point that transformed oceanic lithosphere into continental crust. The recognition of this orogenic cycle followed by Permian–early Triassic terminal collision of the CAOB provides compelling evidence for episodic continental growth.     

An Atomic Force Microscopy study of the growth of calcite in the presence of sodium sulfate

In situ atomic force microscopy (AFM) has been used to compare the growth of pure calcite and the growth of calcite in the presence of sulfate ions from aqueous solutions at a constant value of supersaturation (S.I. = 0.89) with respect to calcite. The effect of sulfate ions on calcite growth rates is determined and a potential incorporation of sulfate ions is identified in the calcite during growth. Solutions supersaturated with respect to calcite with solution concentration ratio of one and a constant pH of 10.2, were prepared and sulfate was added as Na₂SO₄ aqueous solution. The solution composition was readjusted in order to keep the supersaturation and pH constant. PHREEQC was used to determine relevant solution concentrations. In situ AFM experiments of calcite growth were performed using a fluid cell and flowing solutions passed over a freshly cleaved calcite surface. Growth rates were determined from the closure of the rhombohedral etch pits induced by initial dissolution with pure water. The spreading rate of 2-dimensional nuclei was also measured. At low concentrations of sulfate (≤ 0.5 mM), no effect on the growth rate of the calcite was observed. At higher concentrations (2 to 3 mM) of sulfate, the growth rate increased, possibly because a higher concentration of calcium and carbonate was necessary to maintain the supersaturation constant. At much higher concentrations of additional sulfate (up to 60 mM) the growth rate of the calcite was substantially decreased, despite the fact that a further increase of calcium and carbonate was required. The morphology of 2-dimensional growth nuclei became increasingly elongated with increasing sulfate content. Measurements of step height showed that newly grown steps were approximately 1 Å higher when grown in high sulfate concentrations, compared to steps grown in sulfate-free solutions. At sulfate concentrations above 5 mM the growth mechanism changes from layer growth to surface roughening. These observations suggest that the new growth has incorporated sulfate into the calcite surface.