小波分析理论在GPS技术中的应用

在GPS数据处理中 ,存在着误差影响、影响波的干扰、周跳和数据量大等问题。误差影响和影响波的干扰实质是在接收卫星信号时受到其它因素的影响 ;周跳是由于卫星信号的失锁而造成信号的不连续 ;数据量大是因为GPS观测需要采样间隔小又连续观测所致。由于小波理论具有时频分析、波形分解、特征提取和快速小波变换等特性 ,应用小波变换和波形分解可以解决误差影响和影响波的干扰的问题 ;应用特征提取可以解决周跳检测问题 ;应用快速小波变换可进行数据压缩     

大气层对GPS信号传播影响的规律之探讨──关于广州地区大气层对GPS系统定位定时影响问题研究之二

大气层对ＧＰＳ信号的传播有时间延迟作用，时廷将影响ＧＰＳ系统的定位和定时精度，且随气象因素的变化而变化．本文根据３年有关的气象资料，采用大气指数模型分析了广州地区大气层随昼夜变化、季节变化和太阳活动变化对ＧＰＳ信号传播时延影响的变化规律．分析得知，在信号垂直传播时，大气层对ＧＰＳ信号传播的影响，用距离表示．最大时为２．６９１ｍ，最小时也会产生１．９９３ｍ的误差；如果信号斜传播，误差因仰角因素将更大．     

Microboudin structures of piemontite along the Sambagawa metamorphic belt, Japan: implications for lateral variation of differential stress during regional metamorphism

Evidence is presented of a lateral variation in differential stress during metamorphism along a regional metamorphic belt on the basis of the proportion of microboudinaged piemontite grains (p) in a quartz matrix in metacherts. It is proposed that p is a practical indicator of relative differential stress. Analysis of 123 metacherts from the 800 km long Sambagawa metamorphic belt, Japan, reveals that p‐values range from < 0.01 to 0.7 in this region. Most samples from Wakayama in the mid‐belt area have p‐values of 0.4–0.6, whereas those from western Shikoku have p‐values of < 0.1. This difference cannot be explained by variations in metamorphic temperature, and is instead attributed to a regional, lateral variation in differential stress during metamorphism.     

青藏块体东北缘地壳水平运动状态

应用青藏块体东北缘1999～2003年多期GPS观测资料，计算了不同时段GPS点水平运动速率。通过分析发现：甘青块体可分为东部块体和西部块体，东、西部块体的运动状态存在明显的差异；受2001年11月14日昆仑Ms8．1地震的影响，震后地壳运动状态发生了明显的改变。     

Crustal motion and deformation in Greece from a decade of GPS measurements, 1993–2003

The Hellenic plate boundary region, located in the collision zone between the Nubian/Arabian and Eurasian lithospheric plates, is one of the seismo-tectonically most active areas of Europe. During the last 15 years, GPS measurements have been used to determine the crustal motion in the area of Greece with the aim to better understand the geodynamical processes of this region. An extended reoccupation network covering whole Greece has been measured periodically in numerous GPS campaigns since the late eighties, and a continuous GPS network has been operated in the region of the Ionian Sea since 1995. In this paper, we present a new detailed high-quality solution of continuous and campaign-type measurements acquired between 1993 and 2003. During the GPS processing, a special effort was made to obtain consistent results with highest possible accuracies and reliabilities. Data of 54 mainly European IGS and EUREF sites were included in the GPS processing in order to obtain results which are internally consistent with the European kinematic field and order to allow for a regional interpretation. After an overview of the results of the IGS/EUREF sites, the results from more than 80 stations in Greece are presented in terms of velocities, time series, trajectories and strain rates. Previous geodetic, geological and seismological findings are generally confirmed and substantially refined. New important results include the observation of deformation zones to the north and to the south of the North Aegean Trough and in the West Hellenic arc region, arc-parallel extension of about 19 mm/yr along the Hellenic arc, and compression between the Ionian islands and the Greek mainland. Due to continuous long-term observations of 4–8 years, it was possible to extract height changes from the GPS time series. In Greece, we observe a differential subsidence of the order of 2 mm/yr between the northern and central Ionian islands across the Kefalonia fault zone. The differential subsidence of the central Ionian islands with respect to the northwestern Greek mainland amounts to 4 mm/yr.     

预防油页岩地层钻进中压差卡钻的措施

分析了油页岩地层钻进中压差卡钻发生的原因,提出了预防压差卡钻的途径及处理方法,并通过工程实例来强调预防为主的重要性。     

增氧机自动控制电路

介绍作者自行设计、研制的控制增氧机运行时间的自动控制电路及其原理．该电路采用ＣＭＯＳ集成芯片，结构简单、工作可靠，价格低，业经试验证实：各项性能指标均符合要求．     

Fluid flow equations governing primary oil migration as a separate phase

A mathematical model of primary oil migration as a separate phase out of compacting shales is presented. During burial and oil generation, source rock porosity decreases and oil saturation increases until residual oil saturation is reached. At this stage oil is expelled out by capillary and excess fluid pressure gradients. The model is a system of differential equations which relate changes in oil and water saturation in time to water and oil flow out of the source rock during burial. An additional set of equations for periods of erosion of overburden are also provided. The equations can be numerically solved by finite difference method. If oil and water flow is to be simulated during oil generation, then at each time step, changes by oil generation in oil and water saturations and porosity must be calculated. The solution procedure is briefly outlined.     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

GPS测高技术在无验潮水深测量中的应用

应用双频GPS动态后处理高精度定位技术，建立了一套完整的GPS无验潮海洋深度测量作业模式，通过海上试验与传统作业模式作了数值分析比较，结果表明，该作业模式不仅无需验潮，而且能够有效消除传统作业模式中船只动态吃水和涌浪等因素对测量成果的影响，显著提高水深测量成果的精度。