Muon density measurements with the KASCADE central detector

Frequency distributions of local muon densities in high-energy extensive air showers (EAS) are presented as signature of the primary cosmic ray energy spectrum in the knee region. Together with the gross shower variables like shower core position, angle of incidence, and the shower sizes, the KASCADE experiment is able to measure local muon densities for two different muon energy thresholds. The spectra have been reconstructed for various core distances, as well as for particular subsamples, classified on the basis of the shower size ratio N_μ/N_e. The measured density spectra of the total sample exhibit clear kinks reflecting the knee of the primary energy spectrum. While relatively sharp changes of the slopes are observed in the spectrum of EAS with small values of the shower size ratio, no such feature is detected at EAS of large N_μ/N_e ratio in the energy range of 1–10 PeV. Comparing the spectra for various thresholds and core distances with detailed Monte Carlo simulations the validity of EAS simulations is discussed.     

Variability of Soft X—ray Spectral Shape in Blazars Observed by ROSAT

1 INTRODUCTION Blazars, including BL Lac objects, highly polarized and optically violently variable quasars,and flat-spectrum radio quasars (FSRQs), are characterized by highly variable non-thermalemission which dominates their characteristics from radio to y-ray bands. The mechanismbelieved to be responsible for their broadband emission is synchrotron radiation followed by in-verse Compton (IC) scattering at higher energies (e.g. Blandford & Konigl 1979). Relativisticbeaming of a jet…     

The effects of topographically-controlled thermal tides in the martian upper atmosphere as seen by the MGS accelerometer

Mars Global Surveyor accelerometer observations of the martian upper atmosphere revealed large variations in density with longitude during northern hemisphere spring at altitudes of 130-160 km, all latitudes, and mid-afternoon local solar times (LSTs). This zonal structure is due to tides from the surface. The zonal structure is stable on timescales of weeks, decays with increasing altitude above 130 km, and is dominated by wave-3 (average amplitude 22% of mean density) and wave-2 (18%) harmonics. The phases of these harmonics are constant with both altitude and latitude, though their amplitudes change significantly with latitude. Near the South Pole, the phase of the wave-2 harmonic changes by 90° with a change of half a martian solar day while the wave-3 phase stays constant, suggesting diurnal and semidiurnal behaviour, respectively. We use a simple application of classical tidal theory to identify the dominant tidal modes and obtain results consistent with those of General Circulation Models. Our method is less rigorous, but simpler, than the General Circulation Models and hence complements them. Topography has a strong influence on the zonal structure.     

抽油机悬点投影测量仪

油田抽油机的抽油杆幌动幅度过大，是引起抽油杆断裂的一个重要因素，检测这种幌动幅度是防止抽油杆断裂的一种有效手段。设计了一种基于面阵CCD和普通半导体激光器（LD）测量这种幌动的悬点投影测量方法，通过数字卷积滤波，达到了范围为0－40mm，误差＜0.2mm的技术检测指标。     

莱州湾南岸潍河下游地区咸水入侵灾害成因及特征

通过对莱州湾南岸咸水入侵较严重地潍河下游地区晚更新世以来沉积特征及现代自然环境条件变化的分析，探讨了沉积相对咸水入侵产生及空间范围特征的环境机理。晚更新世以来的三次海平面升降变化造成了潍河下游地区海陆沉积环境交替，形成了巨厚的海陆交互相沉积层。海进时期，大面积的滨海平原被淹没，在近海平原洼地滞留的海水经过蒸发、浓缩变为卤水，成为咸水入侵的物源；海退后陆源碎屑在滨海地区沉积形成了巨厚的古河道砂层。20世纪70年代末期以来，随着对地下淡水的过度开采，淡咸水水头压力差减小．卤水通过古河道砂层快速南侵。通过对潍河下游地区100余个地质钻孔水化学连续监测资料分析，阐明了咸水入侵的特征，有针对性地提出了咸水入侵的防治措施。     

P‐wave transmission across fractures with nonlinear deformational behaviour

Stress wave attenuation across fractured rock masses is a great concern of underground structure safety. When the wave amplitude is large, fractures experience nonlinear deformation during the wave propagation. This paper presents a study on normal transmission of P‐wave across parallel fractures with nonlinear deformational behaviour (static Barton–Bandis model). The results show that the magnitude of transmission coefficient is a function of incident wave amplitude, nondimensional fracture spacing and number of fractures. Two important indices of nondimensional fracture spacing are identified, and they divide the area of nondimensional fracture spacing into three parts (individual fracture area, transition area and small spacing area). In the different areas, the magnitude of transmission coefficient has different trends with nondimensional fracture spacing and number of fractures. In addition, the study reveals that under some circumstances, the magnitude of transmission coefficient increases with increasing number of fractures, and is larger than 1. Copyright © 2006 John Wiley & Sons, Ltd.     

Thick and thin models of the evolution of carbon dioxide on Mars

We present results from a new simulation code that accounts for the evolution of the reservoirs of carbon dioxide on Mars, from its early years to the present. We establish a baseline model parameter set that produces results compatible with the present (i.e., Patm?6.5 mbar with permanent CO₂ ice cap) for a wide range of initial inventories. We find that the initial inventory of CO₂ broadly determines the evolutionary course of the reservoirs of CO₂. The reservoirs include the atmosphere, ice cap, adsorbed CO₂ in the regolith, and carbonate rocks. We track the evolution of the free inventory: the atmosphere, ice cap and regolith. Simulations begin at 4.53 Gyr before present with a rapid loss of free inventory to space in the early Noachian. Models that assume a relatively small initial inventory (?5 bar) have pronounced minima in the free inventory of CO₂ toward the end of the Noachian. Under baseline parameters, initial inventories below ∼4.5 bar result in a catastrophic loss of the free inventory to space. The current free inventory would be then determined by the balance between outgassing, sputtering losses and chemical weathering following the end of the late bombardment. We call these “thin” models. They generically predict small current free inventories in line with expectations of a small present CO₂ ice cap. For “thick” models, with initial inventories ?5 bar, a surplus of 300-700 mbar of free CO₂ remains during the late-Noachian. The histories of free inventory in time for thick models tend to converge within the last 3.5 Gyr toward a present with an ice cap plus atmospheric inventory of about 100 mbar. For thick models, the convergence is largely due to the effects of chemical weathering, which draws down higher free inventories more rapidly than the low. Thus, thick models have ?450 mbar carbonate reservoirs, while thin models have ?200 mbar. Though both thick and thin scenarios can reproduce the current atmospheric pressure, the thick models imply a relatively large current CO₂ ice cap and thin models, little or none. While the sublimation of a massive cap at a high obliquity would create a climate swing of greenhouse warming for thick models, under the thin model, mean temperatures and pressures would be essentially unaffected by increases in obliquity.     

广西老厂铅锌矿床地质特征及其成因探讨

本文是在专题研究基础上,探讨广西老厂铅锌矿床地质特征和矿床成因。该矿床位于海洋山复式背斜南段的老厂穹窿构造核部,铅锌矿化受构造、地层和岩性控制。矿体呈脉状,产于NE向组张扭性断裂构造中;围岩为寒武系白云岩,板岩、砂岩;矿石类型以锌为主,矿物成分简单,以闪锌矿、方铅矿与石英、白云石为主,具充填、交代矿石结构、构造,矿石平均品位含Zn9.94%、Pb1.50%;围岩蚀变主要为硅化、绢云母化和碳酸盐化。据地层岩石元素丰度值、稀土元素配分和稳定同位素数据、资料,探讨了成矿物质来源于围岩,热液主要来自大气降水。因此,认为本矿床实属产于寒武系轻变质岩中的层控矿型大气降水热液铅锌矿床。     

The response of an elastic half‐space under a momentary shear line impulse

The response of an ideal elastic half‐space to a line‐concentrated impulsive vector shear force applied momentarily is obtained by an analytical–numerical computational method based on the theory of characteristics in conjunction with kinematical relations derived across surfaces of strong discontinuities. The shear force is concentrated along an infinite line, drawn on the surface of the half‐space, while being normal to that line as well as to the axis of symmetry of the half‐space. An exact loading model is introduced and built into the computational method for this shear force. With this model, a compatibility exists among the prescribed applied force, the geometric decay of the shear stress component at the precursor shear wave, and the boundary conditions of the half‐space; in this sense, the source configuration is exact. For the transient boundary‐value problem described above, a wave characteristics formulation is presented, where its differential equations are extended to allow for strong discontinuities which occur in the material motion of the half‐space. A numerical integration of these extended differential equations is then carried out in a three‐dimensional spatiotemporal wavegrid formed by the Cartesian bicharacteristic curves of the wave characteristics formulation. This work is devoted to the construction of the computational method and to the concepts involved therein, whereas the interpretation of the resultant transient deformation of the half‐space is presented in a subsequent paper. Copyright © 2003 John Wiley & Sons, Ltd.     

The grain-size characteristics of Quaternary deposits at Xingshan near Siping in Jilin province, China

This research paper analyses the grain-size characteristics of the Quaternary deposits at Xingshan near Siping, Jilin province in China by employing graphic measures to study the grain size distribution and its mode of transport and deposition. The Quaternary deposits at Xingshan lie unconformable on Cretaceous rocks made of siltstone, mudstone and sandstone. The average grain size is between 8.06 to 8.55Φ (0.002 6 ～0.003 7 mm). The Quaternary deposits at Xingshan mainly compose of very fine silt to clay. The compositions of the grade are clay 63% and silt 37%. The clay size components are weathered debris transported and deposited by flowing water from the SE highlands or hills to the low lying NW Xingshan plains whereas the silty components accumulated by aoelian process. The Quaternary deposits at Xingshan accumulated in the middle and late Pleistocene interglacial periods from (459.12～39.03) ka to (88.92～7.56) ka. The standard deviation ranged from 0.96 to 1.36Φ, indicating that the sediments are moderately to poorly sorted, Coefficient of skewness ranged from 0.16～0.31 with an average skewness of 0.218, (Positively skewed towards fine). Kurtosis values (0.84～1.05) from the grain size distribution and visual inspection of the frequency curves indicate platykurtic to mesokurtic curves and unimodal to bimodal grain-size distribution. The type of deposit formation is sand dune and the source is at a distal from its provenance.