Calibration of JASON-1 Altimeter over Lake Erie

This article describes absolute calibration results for both JASON-1 and TOPEX Side B (TSB) altimeters obtained at the Lake Erie calibration site, Marblehead, Ohio, USA. Using 15 overflights, the estimated JASON altimeter bias at Marblehead is 58 ± 38 mm, with an uncertainty of 19 mm based on detailed error analysis. Assuming that the TSB bias is negligible, relative bias estimates using both data from the TSB-JASON formation flight period and data from 48 water level gauges around the entire Great Lakes confirmed the Marblehead results. Global analyses using both the formation flight data and dual-satellite (TSB and JASON) crossovers yield a similar relative bias estimate of 146 ± 59 mm, which agrees well with open ocean absolute calibration results obtained at Harvest, Corsica, and Bass Strait (e.g., Watson et al. 2003). We find that there is a strong dependence of bias estimates on the choice of sea state bias (SSB) models. Results indicate that the invariant JASON instrument bias estimated oceanwide is 71 mm, with additional biases of 76 mm or 28 mm contributed by the choice of Collecte Localisation Satellites (CLS) SSB or Center for Space Research (CSR) SSB model, respectively. Similar analysis in the Great Lakes yields the invariant JASON instrument bias at 19 mm, with the SSB contributed biases at 58 mm or 13 mm, respectively. The reason for the discrepancy is currently unknown and warrants further investigation. Finally, comparison of the TOPEX/POSEIDON mission (1992-2002) data with the Great Lakes water level gauge measurements yields a negligible TOPEX altimeter drift of 0.1 mm/yr.     

Further evidence for non-reemergence of winter SST anomalies in the North Pacific eastern subtropical mode water area

Following our previous study (Sugimoto and Hanawa, 2005b), we further investigate the reason why reemergence of winter sea surface temperature anomalies does not occur in the North Pacific eastern subtropical mode water (NPESTMW) area, despite its occurrence in the North Pacific subtropical mode water and North Pacific central mode water areas. We use vertical temperature and salinity profiles of the World Ocean Circulation Experiment Hydrographic Program and Argo floats with high vertical and temporal resolution, together with heat flux data through the sea surface. We point out first that one of the causes for non-occurrence of reemergence is that the thickness of NPESTMW is very thin. In addition to this basic cause, two major reasons are found: a vigorous mixing in the lower portion of NPESTMW and less heat input from the atmosphere in the warming season. Since, in the lower portion of NPESTMW and deeper, the stratification is favorable for salt-finger type convection to occur compared with the other mode water areas, vigorous mixing takes place. This is confirmed by both a large Turner Angle there and the existence of staircase structures in vertical temperature and salinity profiles. From the viewpoint of heat input, the NPESTMW area gradually gains heat in the warming season compared with other mode water areas. As a result, NPESTMW cannot be capped so quickly by the shallow summer mixed layer, and water properties of NPESTMW are to be gradually modified, even in the upper portion.     

Long-term Sensor Drift Found in Recovered Argo Profiling Floats

We recovered three Argo profiling floats after 2 to 2.5 years of operation, and recalibrated their temperature, conductivity, and pressure sensors. The results demonstrate that these floats exhibited a significant drift in salinity of −0.0074 to −0.0125, primarily due to the conductivity sensor drift. Combined with the recalibration result for another previously recovered float, the indication is that the negative salinity drift increases nearly in proportion to the operating period of floats. The increasing rate is −0.0041 (±0.0015) year⁻¹, which yields a salinity drift of −0.016 (±0.006) for the expected float lifetime of four years. The present result suggests that reducing the float surfacing time would improve the accuracy of the salinity measurements.     

Analysis of Offshore Oil Pipeline Floating Laying

-Based on the calculation model for the floating laying of the offshore oil pipeline, this paper analyses in detail the internal force, and deformation of the pipeline under a definite structural form (pipeline and buoy) and the way of pulling. The obtained results can be used for the buoy deployment, structure design, and the determination of pulling parameters (the pulling force of the cable and its length, etc.), providing an effective analysis method for floating pipeline-laying. A calculation example is given to show the related calculation process and the main results are analyzed and discussed.     

深海资料浮标体及系泊系统的阻力试验研究

本文结合国家“七五”重点科技攻关项目“深海资料浮标”研制而进行浮标体和系泊系统的各种阻力试验研究，试验成果已直接应用于深海资料浮标系泊系统设计。实践表明本文介绍的各种阻力试验结果是可靠的。     

赤道暖池区漂流浮标运动轨迹分析

TOGA—COARE强化观测期间,对赤道暖池区海流作了多种方法、多层次的观测;根据美国释放的漂流浮标不同时刻位置的资料,分别对赤道及其南、北海域的表层漂流状况作了计算分析,指出:从1°N向北存在单一的北向流;从1°N～1°S这个近赤道区域内为东向流;1°N～2°S区域为过渡区,以东向流为主,个别浮标出现涡旋状运动。2°S以南为一反时针运动的大涡旋。     

Experimental survey of the hydrodynamic performance of a small spar buoy

The objective in this experimental work is to evaluate the capability of several cylindrical buoys to follow and measure waves. Eleven configurations have been studied, eight among which were furnished with disks of different diameters at the waterline. The experiments took place in the test basin at ISITV. On the one hand, we have obtained a set of transfer coefficients for each frequency and each configuration in regular waves. On the other hand, we have determined the corresponding transfer functions, then we have used the latter to measure irregular waves. The time signals as measured by the buoys with and without corrections have been compared with wave gage measurements and subjected to a wave-by-wave analysis. The results allow the conclusion that the buoy with a medium size disk constitutes the best compromise. In fact, it permits the buoy to follow the free surface while minimizing parasitic motions.     

Stability of Temperature and Conductivity Sensors of Argo Profiling Floats

After recalibration of the temperature and conductivity sensors of three Argo profiling floats recovered after operations for four to nine months, the results indicate that the floats basically showed no significant drift, either in temperature or salinity, and adequately fulfilled the accuracy requirement of the Argo project (0.005°C for temperature and 0.01 psu for salinity). Only the third float showed a significant offset in salinity of about −0.02 psu, as expected from comparison between the float data and the shipboard conductivity-temperature-depth data. This offset was caused by the operational error of the PROVOR-type float, in which the surface water was pumped immediately after the launch, fouling the conductivity sensor cell. This revised version was published online in July 2006 with corrections to the Cover Date.     

Validity of sea surface temperature observed with the TRITON buoy under diurnal heating conditions

In order to investigate the validity of buoy-observed sea surface temperature (SST), we installed special instruments to measure near-surface ocean temperature on the TRITON buoy moored at 2.07°N, 138.06°E from 2 to 13 March 2004, in addition to a standard buoy sensor for the regular SST measurement at 1.5-m depth. Large diurnal SST variations were observed during this period, and the variations of the temperatures at about 0.3-m depth could be approximately simulated by a one-dimensional numerical model. However, there was a notable discrepancy between the buoy-observed 1.5-m-depth SST (SST_1.5m) and the corresponding model-simulated temperature only during the daytime when the diurnal rise was large. The evaluation of the heat balance in the sea surface layer showed that the diurnal rise of the SST_1.5m in these cases could not be accounted for by solar heating alone. We examined the depth of the SST_1.5m sensor and the near-surface temperature observed from a ship near the buoy, and came to the conclusion that the solar heating of the buoy hull and/or a disturbance in the temperature field around the buoy hull would contribute to the excessive diurnal rise of the SST_1.5m observed with the TRITON buoy. However, the temperature around the hull was not sufficiently homogenized, as suggested in a previous paper. For the diurnal rise of the SST_1.5m exceeding 0.5 K, the daytime buoy data became doubtful, through dynamics that remain to be clarified. A simple formula is proposed to correct the unexpected diurnal amplitude of the buoy SST_1.5m.     

Fifteen Years of Ocean Observations with China Argo

For 15 years since the beginning of China Argo project, China has deployed over 350 profiling floats in Pacific and Indian ocean, and constructed China Argo ocean observing network. Moreover, we have setup the Argo data receiving, processing and distributing system, and developed various Argo data products using Argo observations, which has promoted the progress of ocean data sharing in China. The abundant Argo data have become a main data source in oceanic and atmospheric basic researches and operational applications. A batch of important achievements in basic research and operational application have been brought, e.g. in aspects of tropical cyclone (typhoon), ocean circulation, meso-scale eddy, turbulence, heat/salt storage and transport and water mass, as well as in ocean, atmosphere/climate operational forecasting and predicting. With the extension of the international Argo program from “Core Argo” to “Global Argo”, we are faced with great challenges in the long-term maintaining and sustained developing of our Argo ocean observing network. It is suggested that we should take the opportunity to construct China regional Argo ocean observing network as soon as possible in adjacent northwestern Pacific and Indian ocean using Chinese BeiDou profiling floats, which will make us to take responsibility and obligation of a big country for addressing global climate changes and preventing natural disasters.