Green Lake Landslide and other giant and very large postglacial landslides in Fiordland,New Zealand

Green Lake Landslide is an ancient giant rock slide in gneiss and granodiorite located in the deeply glaciated Fiordland region of New Zealand. The landslide covers an area of 45 km² and has a volume of about 27 km³. It is believed to be New Zealand's largest landslide, and possibly the largest landslide of its type on Earth. It is one of 39 known very large (10⁶–10⁷ m³) and giant (≥10⁸ m³) postglacial landslides in Fiordland discussed in the paper. Green Lake Landslide resulted in the collapse of a 9 km segment of the southern Hunter Mountains. Slide debris moved up to 2.5 km laterally and 700 m vertically, and formed a landslide dam about 800 m high, impounding a lake about 11 km long that was eventually infilled with sediments. Geomorphic evidence supported by radiocarbon dating indicates that Green Lake Landslide probably occurred 12 000–13 000 years ago, near the end of the last (Otira) glaciation. The landslide is described, and its geomorphic significance, age, failure mechanism, cause, and relevance in the region are discussed, in relation to other large landslides and recent earthquake-induced landslides in Fiordland. The slope failure occurred on a low-angle fault zone undercut by glacial erosion, and was probably triggered by strong shaking (MM IX–X) associated with a large (≥ M 7.5–8) earthquake, on the Alpine Fault c. 80 km to the northwest. Geology was a major factor that controlled the style and size of Green Lake landslide, and in that respect it is significantly different from most other gigantic landslides. Future large earthquakes on the Alpine Fault in Fiordland are likely to trigger more very large and giant landslides across the region, causing ground damage and devastation on a scale that has not occurred during the last 160 years, with potentially disastrous effects on towns, tourist centres, roads, and infrastructure. The probability of such an event occurring within the next 50 years may be as high as 45%.     

Mineral compositions in Antarctic and Greenland micrometeorites

Abstract— The mineral compositions of 250 micrometeorites have been studied and olivines and low-calcium pyroxenes with crystals larger than 5 μm have been analyzed. While magnesium-rich grains dominate, the Fa content of olivine may reach 50% and the Fs content of pyroxene may reach 26%. The Ca and Mn of the olivine show no consistent trends with increasing Fe, but Cr shows a negative correlation. For low-Ca pyroxene, Al and Cr contents are generally higher than in pyroxenes of equilibrated chondrites but similar to those of highly unequilibrated chondrites. Calcium-bearing pyroxene, feldspar and chromite are rare in the micrometeorites which were selected because of their high Mg, Si, Fe and their low Ca and Al content. All these minerals are found as coarse-grained particles often with adhering iron-rich scoria or as clasts in fine-grained or scoriaceous micrometeorites. Apart from a few particles which could be the debris of ordinary chondrites, most micrometeorites probably come from a common source similar, but not identical to carbonaceous chondrites, as shown by their lower Ni and S content and their different oxygen isotopic composition assuming two measurements performed on olivine grains prove to be typical.     

A 20 cm2 CCD mosaic camera for a dark matter search part I : Mechanics,optics and cryogeny

A 20cm ² CCD mosaic camera has been especially built to search for dark galactic halo objects by the gravitational microlensing effect. The sensitive area is made of 16 edge-buttable CCDs developped by Thomson-CTS, with 23×23 µm ² pixels. The 35 kg camera housing and mechanical equipment is presented. The associated electronics and data acquisition system are described in a separate paper. The camera resides at the focal plane of a 40 cm, f/10, Ferson reflector. The instrument has been in operation since December 1991 at the La Silla Observatory (ESO).     

Inner part observation of theβ pictoris disk

The inner regions of the circumstellar disk around Pictoris might be dust-free due to a possible planet which may have cleared up dust particles. We present a new observational technique based on the use of an anti-blooming CCD in order to directly image this zone. The structure of the disk is revealed down to 2 arcsec from the star (30 AU). We show that the Pic disk brightness is neutral inV, R, andI _C , but drops down when going inward inB, possibly related to a change in the dust composition. Also, a slight disk asymmetry is present but inverted from the outer to the inner zones.Paper presented at the Conference onPlanetary Systems: Formation, Evolution, and Detection held 7–10 December, 1992 at CalTech, Pasadena, California, U.S.A.     

A methodology for regionalizing 3‐D effective porosity at watershed scale in crystalline aquifers

An innovative approach for regionalizing the 3‐D effective porosity field is presented and applied to two large, overexploited, and deeply weathered crystalline aquifers located in southern India. The method derives from earlier work on regionalizing a 2‐D effective porosity field in that part of an aquifer where the water table fluctuates, which is now extended over the entire aquifer using a 3‐D approach. A method based on geological and geophysical surveys has also been developed for mapping the weathering profile layers (saprolite and fractured layers). The method for regionalizing 3‐D effective porosity combines water table fluctuation and groundwater budget techniques at various cell sizes with the use of satellite‐based data (for groundwater abstraction), the structure of the weathering profile, and geostatistical techniques. The approach is presented in detail for the Kudaliar watershed (983 km²) and tested on the 730 km² Anantapur watershed. At watershed scale, the effective porosity of the aquifer ranges from 0.5% to 2% in Kudaliar and between 0.3% and 1% in Anantapur, which agrees with earlier works. Results show that (a) depending on the geology and on the structure of the weathering profile, the vertical distribution of effective porosity can be very different and that the fractured layers in crystalline aquifers are not necessarily characterized by a rapid decrease in effective porosity and (b) that the lateral variations in effective porosity can be larger than the vertical ones. These variations suggest that within a same weathering profile, the density of open fractures and/or degree of weathering in the fractured zone may significantly vary from a place to another. The proposed method provides information on the spatial distribution of effective porosity that is of prime interest in terms of flux and contaminant transport in crystalline aquifers. Implications for mapping groundwater storage and scarcity are also discussed, which should help in improving groundwater resource management strategies.     

Numerical analysis of frost effects in porous media. Benefits and limits of the finite element poroelasticity formulation

The aim of this paper is to analyse the performance of a finite element formulation usable for predicting the mechanical consequences of frost effects on porous media. It considers the characteristics of porous media and how the frost action can be assessed. The problem is then separated into two parts: thermal and poromechanical calculations. The constitutive equations developed in the framework of poromechanics are presented and the implementation in a usual finite element poroelasticity formulation based on Zuber's method is adopted. An analysis of the time‐step influence on the convergence rate is given and leads us to propose a simple method in order to obtain objectivity of the finite element response and avoid over‐long calculations. Frost effect simulations are carried out on real porous media (two fired clays) as a case study. Although the experimental behaviour of the porous media subjected to frost action is in accordance with some observations, the calculated strains appear to be overestimated compared with measurements. The problem could be largely attributable to the difficulty of assessing permeability evolution during frost development. Copyright © 2011 John Wiley & Sons, Ltd.     

Mapping and geochemical characterization of the Toarcian organic matter in the Mediterranean Tethys and Middle East

Organic matter from Toarcian outcrops and boreholes in several basins around the Mediterranean Sea and Middle East has been studied. Rock-Eval pyrolysis, elemental analyses of kerogens and gas chromatography of chloroform extracts within these different basins have been used to determine the amount, petroleum potential and type of the organic matter. The results have been used to compile a mapping of the organic matter for the Toarcian stage, which shows heterogeneities in the distribution and type of organic matter:

1. (1) Marine organic matter (type II) occurs in different environments of deposition. Whereas high contents (>5% total organic carbon) correspond to thick deposits within the West European realm (Great Britain, North Sea, Paris Basin and Germany), the organic matter is less abundant in the Mediterranean area where lower concentrations (1–2% TOC), preserved in Lower Toarcian thin levels, are limited only to restricted basins (northern Italy, Greece).

2. (2) The predominance of continental organic matter (type III) along the northern margin of the Tethys corresponds to a deltaic environment.

3. (3) There is a predominance of altered organic matter within the carbonated platforms around the Mediterranean Tethys.

These results, supplemented with the data issuing from the literature, add a geochemical dimension to the paleogeography of the Tethys.     

A new calcium-aluminate from a refractory inclusion in the Leoville carbonaceous chondrite

The first meteoritic occurrence of CaAl₄O₇ is described from a Ca-Al-rich inclusion (CAI) in the Leoville carbonaceous chondrite. This CAI consists mainly of gehlenitic melilite, spinel, perovskite, and hibonite. CaAl₄O₇ is a minor component and occurs within melilite preferentially in portions rich in perovskite.The CAI is enveloped by a succession of three rims (from inside out): (a) hibonite+melilite+spinel+perovskite, (b) diopside, and (c) olivine.On the basis of mineral associations found and from the presence of moderately volatile elements (Fe and Cr) we conclude that the CaAl₄O₇-bearing CAI from Leoville is of residual nature. CaAl₄O₇ is apparently stable in the very Mg- and Si-poor environment of this CAI and is probably of igneous origin.The rims are interpreted as products of partial evaporation (rim (a)) and associated re-condensation (rims (b) and (c)).