Surface evolution of dissolving minerals investigated with a kinetic Ising model

In natural weathering systems, both the chemistry and the topography of mineral surfaces change as rocks and minerals equilibrate to surface conditions. Most geochemical research has focused on changes in solution chemistry over time; however, temporal changes in surface topography may also yield information about rates and mechanisms of dissolution. We use stochastic dissolution simulations of a regular 2-D lattice with reaction mechanisms defined in terms of nearest neighbor interactions to elucidate how the surface area and reactivity of a crystal evolve during dissolution. Despite the simplicity of the model, it reproduces key features observed or inferred for mineral dissolution. Our model results indicate that: (i) dissolving surfaces reach a steady-state conformation after sufficient dissolution time, (ii) linear defects cause surface area and dissolution rate to vary in concert with one another, (iii) sigmoidal and non-sigmoidal rate vs. free-energy of reaction (ΔG_rxn) behavior can be rationalized in terms of the multiple steps occurring during dissolution, and (iv) surface roughness as a function of ΔG_rxn is highly sensitive to the reaction mechanism. When simulated times to reach steady-state are compared to published time series rate data using suitable scaling, good agreement is found for silicate minerals while the model significantly over-predicts the duration of the transient for Fe and Al oxides. The implication of our simple model is that many aspects of mineral dissolution behavior, including approach to steady-state, sigmoidal vs. non-sigmoidal rate vs. ΔG_rxn behavior, and development of rougher surfaces in conditions further from equilibrium can be explained by nearest neighbor interactions and simple Kossel-type models where reactivity of a surface is defined in terms of perfect surface, step, and kink sites.     

Patterns of heritability of decreased EROD activity and resistance to PCB 126-induced teratogenesis in laboratory-reared offspring of killifish (Fundulus heteroclitus) from a creosote-contaminated site in the Elizabeth River,VA, USA

Killifish (Fundulus heteroclitus) from a highly contaminated site on the Elizabeth River are resistant to the acute toxicity and the cytochrome P4501A (CYP1A)-inducing activity of both the sediments from the site and chemically pure polycyclic aromatic hydrocarbons (PAHs). These effects are highly heritable for one generation, but heritable to a lesser degree by subsequent generations, in clean conditions in the laboratory. We show that offspring of this population of Elizabeth River killifish are also resistant to the teratogenicity and P4501A-inducing activity of PCB congener 126, a prototypical coplanar halogenated aromatic hydrocarbon (HAH). Furthermore, the pattern of greater resistance to acute toxicity and P4501A-inducing activity in the first generation and less in subsequent generations is also observed upon exposure to PCB-126.     

Otolith shape as a stock discrimination tool for ling (Genypterus blacodes) in the fjords of Chilean Patagonia

ABSTRACT

Genypterus blacodes, in terms of its fishing history and local economic importance, is an emblematic species harvested in Chilean Patagonia (41°00’–57°00’S). Most of the current fisheries and biological knowledge of this species come from the open ocean, whereas information about the species in fjords and inner channels is fragmentary. In 2018, two research surveys targeting G. blacodes were conducted in the fjords and inner channels of Chilean Patagonia. A total of 253 pairs of sagittal otoliths were sampled at three different localities, and their contours were modelled using wavelet analysis as a tool for stock discrimination. Contours were compared using canonical analysis, and classification was performed using linear discriminant and Random Forest analyses. The results indicated that the wavelet method is efficient in modelling otolith contours, and the discriminant analyses showed differences among fishing grounds across the latitudinal gradient, thus confirming the hypothesis that G. blacodes conform to at least two separate stock units in Chilean Patagonia. Fishing grounds that were closer in space showed higher levels of misclassification. The discussion focuses on how environmental variables and the geography of fjords shape stock differences and how this information can be used for the sustainable management of G. blacodes.     

The Equatorial Atlantic Mid-Ocean Channel: An Ultra High-Resolution Image of Its Burial History Based on TOPAS Profiles

Multibeam bathymetric and ultra high-resolution seismic data reveal that the distal course of the Equatorial Atlantic Mid-Ocean Channel (EAMOC) extends further east and south than was previously known, and is controlled by the presence of morphologic highs related to the Fernando de Noronha Fracture Zone. Distal course of the EAMOC is buried by sediments, and does not have bathymetric expression on the seafloor. The channel fill consists of three seismic sequences, suggesting that the recent geological evolution of the channel is composed of successive phases of decreasing sedimentary activity that finally resulted in its complete burial. Tectonic and volcanic activity related to the Fernando de Noronha Fracture Zone and Ridge, together with the effect of strong pulses of the Antarctic bottom water current during the upper Pliocene are suggested to have contributed to the progressive burial and the final abandonment of the EAMOC.     

Nonparametric Estimates of the Sea State Bias for the Jason-1 Radar Altimeter

The Jason-1 sea state bias (SSB) is analyzed in depth from the first year of GDR products. Compared to previous missions, this work benefits from two aspects of the empirical determination of the SSB from the altimetric data themselves. First, from a methodological point of view, a nonparametric technique (NP) has been developed and largely tested on TOPEX/Poseidon 1, GFO and Envisat data. The NP estimator has proven to be a useful tool in the SSB estimation, and it is now mature enough to be used for a refined analysis. On the other hand, the SSB can be extracted from three different data sets (crossovers, collinear data, and residuals) with different characteristics. It is then possible to cross calibrate various estimations of the SSB models and to determine the most accurate one. A systematic comparison is made between these different estimates for the Jason-1 altimeter. The collinear and crossover data sets yield very similar estimates despite their difference of spatial and temporal distributions. These SSB models assure consistency with the TOPEX mission when comparing Jason-1 and TOPEX residuals during the tandem phase. Thanks to the present work, the impact of the short wavelengths filtering on the SSB estimation is evidenced. More generally, our understanding of potential errors affecting the sea surface height and their impact onto the SSB estimation is also improved.     

Design and projected performance of a flapping foil AUV

The design and construction of a biomimetic flapping foil autonomous underwater vehicle is detailed. The vehicle was designed as a proof of concept for the use of oscillating foils as the sole source of motive power for a cruising and hovering underwater vehicle. Primary vehicle design requirements included scalability and flexibility in terms of the number and placement of foils, so as to maximize experimental functionality. This goal was met by designing an independent self-contained module to house each foil, requiring only direct current power and a connection to the vehicle's Ethernet local area network for operation. The results of tests on the foil modules in the Massachusetts Institute of Technology (MIT) Marine Hydrodynamics Water Tunnel and the MIT Ship Model Testing Tank are both used to demonstrate fundamental properties of flapping foils and to predict the performance of the specific vehicle design based on the limits of the actuators. The maximum speed of the vehicle is estimated based on the limitations of the specific actuator and is shown to be a strong function of the vehicle drag coefficient. When using four foils, the maximum speed increases from 1 m/s with a vehicle C/sub D/ of 1.4 to 2 m/s when C/sub D/=0.1, where C/sub D/ is based on vehicle frontal area. Finally, issues of vehicle control are considered, including the decoupling of speed and pitch control using pitch-biased maneuvering and the tradeoff between actuator bandwidth and authority during both the cruising and hovering operation.     

SeagrassNet monitoring across the Americas: case studies of seagrass decline

Seagrasses are an important coastal habitat worldwide and are indicative of environmental health at the critical land–sea interface. In many parts of the world, seagrasses are not well known, although they provide crucial functions and values to the world's oceans and to human populations dwelling along the coast. Established in 2001, SeagrassNet, a monitoring program for seagrasses worldwide, uses a standardized protocol for detecting change in seagrass habitat to capture both seagrass parameters and environmental variables. SeagrassNet is designed to statistically detect change over a relatively short time frame (1–2 years) through quarterly monitoring of permanent plots. Currently, SeagrassNet operates in 18 countries at 48 sites; at each site, a permanent transect is established and a team of people from the area collects data which is sent to the SeagrassNet database for analysis. We present five case studies based on SeagrassNet data from across the Americas (two sites in the USA, one in Belize, and two in Brazil) which have a common theme of seagrass decline; the study represents a first latitudinal comparison across a hemisphere using a common methodology. In two cases, rapid loss of seagrass was related to eutrophication, in two cases losses related to climate change, and in one case, the loss is attributed to a complex trophic interaction resulting from the presence of a marine protected area. SeagrassNet results provide documentation of seagrass change over time and allow us to make scientifically supported statements about the status of seagrass habitat and the extent of need for management action.     

Application of environmental groundwater tracers at the Sulphur Bank Mercury Mine, California, USA

Boron, chloride, sulfate, δD, δ¹⁸O, and ³H concentrations in surface water and groundwater samples from the Sulphur Bank Mercury Mine (SBMM), California, USA were used to examine geochemical processes and provide constraints on evaporation and groundwater flow. SBMM is an abandoned sulfur and mercury mine with an underlying hydrothermal system, adjacent to Clear Lake, California. Results for non-³H tracers (i.e., boron, chloride, sulfate, δD, and δ¹⁸O) identify contributions from six water types at SBMM. Processes including evaporation, mixing, hydrothermal water input and possible isotopic exchange with hydrothermal gases are also discerned. Tritium data indicate that hydrothermal waters and other deep groundwaters are likely pre-bomb (before ~1952) in age while most other waters were recharged after ~1990. A boron-based steady-state reservoir model of the Herman Impoundment pit lake indicates that 71–79% of its input is from meteoric water with the remainder from hydrothermal contributions. Results for groundwater samples from six shallow wells over a 6–month period for δD and δ¹⁸O suggests that water from Herman Impoundment is diluted another 3% to more than 40% by infiltrating meteoric water, as it leaves the site. Results for this investigation show that environmental tracers are an effective tool to understand the SBMM hydrogeologic regime.

---

Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.

---

Résumé Les concentrations en bore, chlorure, sulfate, δD, δ¹⁸O, et ³H d’échantillons d’eaux de surface et souterraine prélevés dans le banc de soufre de la mine de mercure (SBMM en anglais) en Californie, USA, ont été utilisées pour étudier les processus géochimiques et pour fournir des contraintes à l’évaporation et à l’écoulement des eaux souterraines. La SBMM est une mine de soufre et de mercure abandonnée, adjacente au lac Clear en Californie et sous laquelle se trouve un système hydrothermal.Les résultats des traceurs autres que le tritium (bore, chlorure, sulfate, δD, et δ¹⁸O) ont permis d’identifier des contributions de six types d’eaux à SBMM. Des processus tels que l’évaporation, le mélange, l’entrée d’eau hydrothermale et de possibles échanges isotopiques avec des gaz hydrothermaux ont également été identifiés. Les données de tritium montrent que les eaux hydrothermales et d’autres eaux profondes sont probablement d’age antérieure à la bombe (avant ~1952), alors que la plupart des autres eaux sont issues de la recharge après ~1990. Un modèle de réservoir représentant le lac situé dans la partie Herman Impoundment de l’ancienne mine, en régime permanent et basé sur le bore, montre que 71–79% de l’eau provient des précipitations, le reste provenant de contributions hydrothermales. Les résultats de δD et δ¹⁸O pour des échantillons d’eau souterraine de six puits peu profonds sur une période de 6 mois suggèrent que l’eau de Hermann Impoundment est encore diluée entre 3% jusqu’à plus de 40% lorsqu’elle quitte le site du fait de l’infiltration d’eau météorique. Les résultats de cette étude montrent que les traceurs environnementaux constituent un outil efficace pour comprendre le régime hydrogéologique de la SBMM.

---

Resumen Se han utilizado datos de concentraciones de boro, cloruros, sulfatos, δD, δ¹⁸O, y ³H en muestras de aguas superficiales y subterráneas procedentes de la Mina de Mercurio Sulphur Bank (SBMM), California, USA, para estudiar los procesos geoquímicos y caracterizar la evaporación y el flujo del agua subterránea. SBMM es una mina abandonada de azufre y mercurio con un sistema hidrotermal subyacente, cercano al Lago Clear, California.Los resultados de los trazadores que no son ³H (por ejemplo, boro, cloruros, sulfatos δD, y δ¹⁸O) identifican las contribuciones de seis tipos de agua en la SBMM. Se han identificado diversos procesos, como evaporación, mezcla, entrada de agua hidrotermal y la posibilidad de intercambios isotópicos con gases hidrotermales. Los datos de tritio indican que las aguas hidrotermales y otras aguas subterráneas profundas son probablemente pre-bombas (previas a ~1952) en edad mientras que la mayoría de las otras aguas se han recargado después de ~1990. Un modelo estacionario basado en el boro de la fosa del lago Herman Impoundment indica que el 71–79% de su entrada procede de agua meteórica con restos de contribución hidrotermal. Los resultados para las muestras de aguas subterráneas procedentes de seis pozos superficiales en un periodo de 6 meses para δD y δ¹⁸O sugieren que el agua procedente de Herman Impoundment se diluye en otro 3% hasta más del 40% debido a la infiltración de agua meteórica., que sale del sitio. Los resultados de esta investigación muestran que los trazadores ambientales son una herramienta efectiva para entender el régimen hidrogeológico de la SBMM.