Study of the flood control scheduling scheme for the Three Gorges Reservoir in a catastrophic flood

The Three Gorges Project is the world's largest water conservancy project. According to the design standards for the 1,000‐year flood, flood diversion areas in the Jingjiang reach of the Yangtze River must be utilized to ensure the safety of the Jingjiang area and the city of Wuhan. However, once these areas are used, the economic and life loss in these areas may be very great. Therefore, it is vital to reduce this loss by developing a scheme that reduces the use of the flood diversion areas through flood regulation by the Three Gorges Reservoir (TGR), under the premise of ensuring the safety of the Three Gorges Dam. For a 1,000‐year flood on the basis of a highly destructive flood in 1954, this paper evaluates scheduling schemes in which flood diversion areas are or are not used. The schemes are simulated based on 2.5‐m resolution reservoir topography and an optimized model of dynamic capacity flood regulation. The simulation results show the following. (a) In accord with the normal flood‐control regulation discharge, the maximum water level above the dam should be not more than 175 m, which ensures the safety of the dam and reservoir area. However, it is necessary to utilize the flood diversion areas within the Jingjiang area, and flood discharge can reach 2.81 billion m³. (b) In the case of relying on the TGR to impound floodwaters independently rather than using the flood diversion areas, the maximum water level above the dam reaches 177.35 m, which is less than the flood check level of 180.4 m to ensure the safety of the Three Gorges Dam. The average increase of the TGR water level in the Chongqing area is not more than 0.11 m, which indicates no significant effect on the upstream reservoir area. Comparing the various scheduling schemes, when the flood diversion areas are not used, it is believed that the TGR can execute safe flood control for a 1,000‐year flood, thereby greatly reducing flood damage.     

天气雷达数据处理系统人控应用软件

天气雷达用于抗灾和减灾很重要,本文提出一种人工降雨和驱冰雹软件,给出了程序流图,对编程的关键进行了分析,最后结果表明它能提高人控作业效率。     

Microwave Type III Burst Group in the 1993 October 2 Flare

Microwave Type III bursts with positive frequency drifting rate were found by Stahli and Benz (1987) for first time. Type III events are especially interesting because they are well-known to be signatures of electron beams in coronal plasma, and they are effective means for diagnosting of source plasma. A microwave burst consisting of some microwave type III burst groups was registered at Beijing Astronomical Observatory with the 2545–2645–2840 MHz synchronous observing system. The distributions of frequency drifting rate, half power duration, and intensity for each impulse in the groups have been statistically analysed. From this analysis, some important parameters for the dynamic process in the flare are deduced and discussed.     

基于ARP协议的网络主机地址的识别技术研究

从移动IPv6工作原理入手，IP地址管理器是针对越来越严重的IP地址盗用现象而设计的一套有效的监控和管理IP地址的方案。分析与研究IP地址管理器中的信息收集模块后，以Winpcap为开发工具，利用ARP，附等协议完成对网络中活动主机的扫描以及信息（主机名、MAC、操作系统）的收集和识别。模块实现了对网络的自动实时监控，有效地提高了管理效率。     

CPLD技术及其在现代时统中的应用

对CPLD(复杂可编程逻辑器件)技术的基本特征和发展趋势作了简要介绍,揭示了该技术在现代数字系统中的重要地位及作用.利用CPLD对时统设备IRIG-B码产生器进行集成,其实验结果表明,集成了的B码产生器不但简单、可靠,而且便于调试,克服了以往硬件电路复杂的缺点.     

CCD联合平差方法及其初步实例检验

在常规照相天体测量工作中 ,对暗天体的定位是采用逐级定标星过渡的方法实现的。由于星表系统差和局部差的存在 ,最终定位结果可能包含难以把握的误差积累。在CCD小视场观测情况下时常难以找到足够数量的定标星。鉴于此 ,推导了CCD观测联合平差方法的严格矢量表达式 ,以期通过共同星的过渡 ,实现大天区统一平差。原理上此方法可实现相对于河外天体的定位 ,以削弱星表系统差和局部差对定位结果的影响。讨论了CCD联合平差方法实现中的问题 ,包括底片常数模型选择、切点位置改正、共同星的较差改正和法方程解算方法等 ,并分析了具体的处理措施。用实例初步检验了CCD联合平差方法的效果 ,表明通过对多张CCD观测的联合平差 ,可以削弱单张CCD观测参考星数目过少、单张CCD观测参考星分布不均、个别参考星存在位置偏差和局部区域参考星存在系统性位置偏差等不利因素对归算结果的影响 ,进而达到扩大视场和提高归算精度的目的     

A New Solar Radio Spectrometer at 1.10-2.06 GHz and First Observational Results

An improved Solar Radio Spectrometer working at 1.10-2.06 GHz with much improved spectral and temporal resolution, has been accomplished by the National Astronomical Observatories and Hebei Semiconductor Research Institute, based on an old spectrometer at 1-2 GHz. The new spectrometer has a spectral resolution of 4 MHz and a temporal resolution of 5ms, with an instantaneous detectable range from 0.02 to 10 times of the quiet Sun flux. It can measure both left and right circular polarization with an accuracy of 10% in degree of polarization. Some results of preliminary observations that could not be recorded by the old spectrometer at 1-2 GHz are presented.     

Generalized strain probing of constitutive models

Advanced material constitutive models are used to describe complex soil behaviour. These models are often used in the solution of boundary value problems under general loading conditions. Users and developers of constitutive models need to methodically investigate the represented soil response under a wide range of loading conditions. This paper presents a systematic procedure for probing constitutive models. A general incremental strain probe, 6D hyperspherical strain probe (HSP), is introduced to examine rate‐independent model response under all possible strain loading conditions. Two special cases of HSP, the true triaxial strain probe (TTSP) and the plane‐strain strain probe (PSSP), are used to generate 3‐D objects that represent model stress response to probing. The TTSP, PSSP and general HSP procedures are demonstrated using elasto‐plastic models. The objects resulting from the probing procedure readily highlight important model characteristics including anisotropy, yielding, hardening, softening and failure. The PSSP procedure is applied to a Neural Network (NN) based constitutive model. It shows that this probing is especially useful in understanding NN constitutive models, which do not contain explicit functions for yield surface, hardening, or anisotropy. Copyright © 2004 John Wiley & Sons, Ltd.     

企鹅珍珠贝人工苗生长的初步观察

为了解企鹅珍珠贝生长规律，观察了壳高2.5～5.0mm的出池幼苗，按月测量其生长参数和成活率，以及环境因子。结果表明，企鹅珍珠贝生长最快的月份为7～11月和次年4～6月，壳长，壳高和壳宽月均增加量分别为3.8～13.0mm、4.7～11.2mm、2.3～3.8mm，月成活率97.8%～98.6%。企鹅珍珠贝生长最慢月份是11月至次年3月。     

On the microwave millisecond spike emission and its associated phenomena during the impulsive phase of large solar flare

We propose a model of two acceleration regions, which can explain, on the basis of microwave maser caused by a “hollow-beam” distribution of electrons, the presence of millisecond spikes in the event of 1981 May 16 and their absence in the event of 1981 October 12, and the enhanced continuous emission in the latter. We have also uncovered relations among the features, e.g. the Type III_G, Type IV_DCIM and hard x-ray bursts, that accompany the microwave millisecond spikes during the impulsive phase of a large flare.