Spatial Variation in the Structure of Kelp Forest Communities Along a Wave Exposure Gradient

Abstract. Four sites were sampled in kelp (Macrocysiis pyrifera) forests occupying rocky bottom habitats along a wave exposure gradient in central California. Consistent betwecn-site differences were found in the three major structural elements - the surface canopy, the undcrstory assemblage, and the ground cover/turf assemblage - of kelp forest communities. Macrocysiis pyrifera was found at all four sites. Nereucyslis tuelkeana only at the most exposed site. The understory kelps Laminaria setchellii and Pterygopltora californica were also characteristic of exposed sites. Articulated coralline algae were more abundant at exposed sites than protected, while fleshy red algae showed the opposite pattern. All four study sites were located along 8.5 km of coastline, and thus were assumed to have available to them the same species pool for colonization. The substrate composition was the same and the amount of unconsolidated substrate was similar at all four sites. We suggest that exposure to wave-generated water motion, through its influence on the surface canopy and therefore on the amount of light reaching the bottom, is responsible for these between-site differences.     

Seismic response predictions of multi‐span steel bridges through pushover analysis

In the new trend of seismic design methodology, the static pushover analysis is recommended for simple or regular structures whilst the time‐history analysis is recommended for complex structures. To this end, the applicable range of the pushover analysis has to be clarified. This study aims at investigating the applicability of pushover analysis to multi‐span continuous bridge systems with thin‐walled steel piers. The focus is concentrated on the response demand predictions in longitudinal or transverse directions. The pushover analysis procedure for such structures is firstly summarized and then parametric studies are carried out on bridges with different types of superstructure‐pier bearing connections. The considered parameters, such as piers' stiffness distribution and pier–0.5ptdeck stiffness ratio, are varied to cover both regular and irregular structures. Finally, the relation of the applicability of pushover analysis to different structural formats is demonstrated and a criterion based on the higher modal contribution is proposed to quantitatively specify the applicable range. Copyright © 2003 John Wiley & Sons, Ltd.     

Heat influx and exhumation of the Shimanto accretionary complex: Miocene fission track ages from the Kii Peninsula, southwest Japan

Abstract   To determine how local geological events contributed to the evolution of accretionary complexes and eventual exposure of rocks with different structural levels, geochronological mapping was carried out using fission track (FT) analysis at the Kii Peninsula, southwest Japan. At this site, the original zonal structure of Cretaceous accretionary complexes parallel to the subduction zone is disturbed by the northward projection of the Shimanto accretionary complex. Twenty-six zircon FT ages were obtained from an area of ∼12 km in an east–west direction and ∼15 km in a north–south direction, and classified into three groups: (i) ages ∼15 Ma (range ∼10–20 Ma), which are distributed along the northwest–southeast valley; (ii) ages of ∼50 Ma in the northwest of the study area; and (iii) ages older than those in Groups 1 and 2. Based on results from eight zircon FT length distributions, the Miocene ages appear to be the result of spatial variations in heat influx and cooling after the regional exhumation of the area, as recorded by FT ages of ∼50 Ma.     

K-Ar Ages of Granitic Magmatism and Related Pegmatite Formation at the Umanotani-Shiroyama Mine, Shimane Prefecture, SW Japan and Their Bearings on Cooling History

Abstract. The Umanotani-Shiroyama pegmatite deposits, the largest producer of K-feldspar and quartz in Japan, are of typical granitic pegmatite. Ilmenite-series biotite granite and granite porphyry, hosting the ore deposits, and biotites separated from these rocks yielded K-Ar ages ranging from 89.0 to 81.4 Ma and 95.2 to 93.7 Ma, respectively. Muscovite and K-feldspar separated from the ore zone yielded K-Ar ages with the range of 96.2 to 93.1 Ma and 87.3 to 80.7 Ma, respectively. Muscovites from quartz-muscovite veins in the ore zone and in the granite porphyry yielded K-Ar ages of 90.4 and 76.3 Ma, respectively. K-feldspar is much younger in age than coexisting muscovite. It is noted that the K-Ar ages of biotite separates and the whole-rock ages are identical to those of muscovite and K-feldspar in the ore zone, respectively. These time relations, as well as field occurrence, indicate that the formation of the pegmatite deposits at the Umanotani-Shiroyama mine is closely related in space and time to a series of granitic magmatism of ilmenite-series nature. Using closure temperatures of the K-Ar system for biotite and K-feldspar (microcline), cooling rate of the pegmatite deposits is estimated to be about 82C/m.y. at the beginning, but slowed down to about 15C/m.y. in the later period.     

Methane in the East China Sea water

Methane in the East China Sea water was determined four times at a fixed vertical section along PN line consisting of 11–14 stations, in February 1993, October 1993, June 1994 and August 1994. The mean concentration of methane in the surface water was not significantly higher than that in the open ocean. The methane concentration below the pycnocline increased during the stratified period in summer to autumn and reached to 15 nmoles/l at most in October. The concentration of methane was fairly well correlated with AOU in the layer below the pycnocline in the stratified season. This means that methane in the bottom water has only a single source, which is expected to be anoxic sediments near the coast, and that the oxidation rate of methane in the water is extremely slow in the oxic water. The high methane observed in October completely disappeared in February, indicating that the methane was escaped to the atmosphere or transported to the pelagic ocean by the Kuroshio current. The East China Sea, therefore, is not a large direct and stationary source for the atmospheric methane, but may have some role as a source by supplying it sporadically to the atmosphere in early winter or indirectly from the surface of the pelagic ocean.     

“Extreme boiling” model for variable salinity of the Hokko low-sulfidation epithermal Au prospect, southwestern Hokkaido, Japan

The Hokko prospect is located in the Minamikayabe area southwestern Hokkaido, Japan, where gold-bearing quartz veins of Pliocene age are exposed at the surface. The alteration mineral assemblage is typical of low-sulfidation epithermal systems, with the quartz veins associated with adularia alteration overprinted on Late Miocene propylitic alteration. Fluid inclusion studies of the vein quartz reveal mean homogenization temperatures of approximately 220 °C, and the co-existence of low-salinity (<2 wt.% NaCl equivalent) and moderate salinity (2 to 12 wt.% NaCl equivalent) fluid inclusions within the same veins. The moderate salinity fluid inclusions (2–12 wt.% NaCl equivalent) typically have relatively low homogenization temperatures between 150° to 200 °C. The results obtained from stable isotope analysis of  δ¹⁸O in quartz vein material showed a gradual decrease in  δ¹⁸O signatures with increasing depth. The majority of the samples have calculated fluid source signatures (δ¹⁸O_H2O) between −8.0 and −10.0‰, but there is a significant change in the composition above 185 m drill depth. The shallower samples in particular show a wide range of oxygen isotope signatures that are associated with the moderate salinity fluid inclusions. We interpret that low-salinity inclusions within the Hokko system represent the composition of the liquid phase of the fluid, before boiling, and that the moderate-salinity inclusions are representative of the residual liquid phase, after extensive non-adiabatic boiling and vapor loss in an open system. This mechanism resulted in the entrapment of fluids with variable salinities at the same time, and in close proximity to each other. This is also reflected in the  δ¹⁸O_H2O values which become more variable and heavier where the moderate-salinity inclusions occur. Deposition of ore minerals within the Hokko vein system also occurred at this time as a result of boiling and gas loss. Received: 30 May 1997 / Accepted: 6 January 1998     

Preserved paleo-oceanic plateaus in accretionary complexes: Implications for the contributions of the Pacific superplume to global environmental change

We have reinvestigated the mid-Cretaceous plume pulse in relation to paleo-oceanic plateaus from accretionary prisms in the circum-Pacific region, and we have correlated the Pacific superplume activity with catastrophic environmental changes since the Neoproterozoic. The Paleo-oceanic plateaus are dated at 75–150 Ma; they were generated in the Pacific superplume region and are preserved in accretionary prisms. The volcanic edifice composed of both modern and paleo-oceanic plateaus is up to 10.7 × 10⁶ km² in area and 19.1 × 10⁷ km³ in volume. The degassing rate of CO₂ (0.82 − 1.1 × 10¹⁸ mol/m.y.) suggests a significant impact on Cretaceous global warming. The synchronous occurrence of paleo-oceanic plateaus in accretionary complexes indicates that Pacific superplume pulse activities roughly coincided at the Permo-Triassic boundary and the Vendian–Cambrian boundary interval. The CO₂ expelled by the Pacific superplume probably contributed to environmental catastrophes. The initiation of the Pacific superplume contributed to the snowball Earth event near the Vendian–Cambrian boundary; this was one of the most dramatic events in Earth's history. The scale of the Pacific superplume activity roughly corresponds to the scale of drastic environmental change.     

Gold Mineralization and Occurrence of Sinter in the Hoshino Area, Fukuoka Prefecture, Japan

Abstract. Several epithermal gold deposits occur in the Hoshino area, which is located in the western end of the late Cenozoic Hohi volcanic zone, north‐central Kyushu, Japan. The area is characterized by intermediate to felsic extrusive rocks of Pliocene age. In the Hoshino area, the shallow manifestation of the hydrothermal activity is exposed on the surface. Several outcrops of sinter are still preserved on the top of hydro thermally altered volcanic rocks, and high‐grade gold‐bearing quartz veins occur on the surface at lower levels. The hydrothermal alteration resulted into well‐developed alteration zones. The zonal alteration pattern, primarily of near‐neutral pH type, is characterized by the outer smectite zone of a lower temperature, and the inner mixed layer minerals zone of a higher temperature. Quartz vein‐related or fracture‐controlled alteration, is represented by the occurrence of interstratified illite/smectite and K‐feldspar, suggesting a potassium‐enriched alteration. The mineralization in the Hoshino area is recognized on the surface by the occurrence of gold‐bearing quartz veins distributed mainly in the mixed layer minerals zone. The fracture system related to the gold mineralization is mainly characterized by NW‐SE trend. The alteration pattern and the mineralogical composition of the veins suggest that the mineralizing fluids had near‐neutral pH and the mineralization is of low‐sulfidation‐type. Fluid inclusion data and textures observed in quartz veins indicate that gold precipitated during boiling. The chemical composition of quartz veins shows that high‐grade gold‐bearing quartz veins are characterized by higher content of Al₂O₃, K₂O and Rb. Several outcrops of silica‐sinters are distributed on the top of the mixed layer minerals zone. Although their structures are not very well preserved, because of later silicification, the Hoshino sinters still show characteristic textures identical to those observed in modern sinters, such as the presence of plant fossil incorporated into the sinters, the strongly developed depositional laminations and the columnar structures perpendicular to the depositional surfaces. Quartz is the only silica mineral constituting the Hoshino sinters presently. The conversion of amorphous silica into quartz was probably governed by higher temperatures resulting from later hydrothermal activity. This later hydrothermal activity is reflected by the intense silicification affecting mainly the lower parts of the sinters and also by the presence of quartz veins cutting the sinters. The distribution of sinters in the Hoshino area is very significant. The presence beneath the sinters of concealed high‐grade gold‐bearing quartz veins should be highly considered and exploration work is strongly suggested.