Near-Infrared Imaging Spectrophotometry Of Comet C/1995 O1 (Hale-Bopp) Near Perihelion

We present 1- to 5-μm broadband and CVF images of comet Hale-Bopp taken 1997 February 10.5 UT, 50 days before perihelion. All the images exhibit a nonspherical coma with a bright “ridge” in the direction of the dust tail approximately 10″ from the coma. Synthetic aperture spectrophotometry implies that the optically important grains are of a radius ≤0.4 μm; smallest radius for any comet seen to date. The variation of the integrated surface brightness with radial distance from the coma (ρ) in all the images closely follows the “steady state” ρ⁻¹ model for comet dust ablation (Gehrz and Ney, 1992). The near-infrared colors taken along the dust tail are not constant implying the dust grain properties vary with coma distance. This revised version was published online in July 2006 with corrections to the Cover Date.     

Digital underwater acoustic voice communications

This paper describes the design of an underwater acoustic diver communication system controlled by a digital signal processor. The speech signal transmission rate is compressed by using linear predictive coding (LPC) and the extracted parameters are transmitted through the water to a synchronized receiver by employing digital pulse position modulation (DPPM). The pulse position in each time frame is estimated by an energy detection and decision algorithm which enables the received LPC parameters to be recovered and used to synthesize the speech signal     

Comparison of the pseudo-static and dynamic behaviour of gravity retaining walls

Summary Pseudo-static and dynamic non-linear finite element analyses have been performed to assess the dynamic behaviour of gravity retaining walls subjected to horizontal earthquake loading. In the pseudo-static analysis, the peak ground acceleration is converted into a pseudo-static inertia force and applied as a horizontal incremental gravity load. In the dynamic analysis, an actual measured earthquake acceleration time history has been scaled to provide peak ground acceleration values of 0.1 g and 0.3 g. Good agreement is obtained between the pseudo-static analysis and analytical methods for the calculation of the active coefficient of earth pressure. However, the results from the dynamic analysis require careful interpretation. In the pseudo-static analysis, the increase in the point of application of the resultant active force with the horizontal earthquake coefficient k _h from the one-third point to the mid-height of the wall is clearly observed. In the dynamic analysis, the variation in the point of application is shown to be a function of the type of wall deformation. Both finite element analyses indicate the importance of determining the magnitude of the predicted displacements when assessing the behaviour of the wall to seismic loading.     

Using a Thermal Proxy to Examine Sediment–Water Exchange in Mid-Continental Shelf Sandy Sediments

Fluid exchange across the sediment–water interface in a sandy open continental shelf setting was studied using heat as a tracer. Summertime tidal oscillation of cross-shelf thermal fronts on the South Atlantic Bight provided a sufficient signal at the sediment–water interface to trace the advective and conductive transport of heat into and out of the seabed, indicating rapid flushing of ocean water through the upper 10–40 cm of the sandy seafloor. A newly developed transport model was applied to the in situ temperature data set to estimate the extent to which heat was transported by advection rather than conduction. Heat transported by shallow 3-D porewater flow processes was accounted for in the model by using a dispersion term, the depth and intensity of which reflected the depth and intensity of shallow flushing. Similar to the results of past studies in shallower and more energetic nearshore settings, transport of heat was greater when higher near-bed velocities and shear stresses occurred over a rippled bed. However, boundary layer processes by themselves were insufficient to promote non-conductive heat transport. Advective heat transport only occurred when both larger boundary layer stresses and thermal instabilities within the porespace were present. The latter process is dependent on shelf-scale heating and cooling of bottom water associated with upwelling events that are not coupled to local-scale boundary layer processes.     

Molecular distribution, 13C‐isotope,and enantiomeric compositions of carbonaceous chondrite monocarboxylic acids

The water‐soluble organic compounds in carbonaceous chondrite meteorites constitute a record of the synthetic reactions occurring at the birth of the solar system and those taking place during parent body alteration and may have been important for the later origins and development of life on Earth. In this present work, we have developed a novel methodology for the simultaneous analysis of the molecular distribution, compound‐specific δ¹³C, and enantiomeric compositions of aliphatic monocarboxylic acids (MCA) extracted from the hot‐water extracts of 16 carbonaceous chondrites from CM, CR, CO, CV, and CK groups. We observed high concentrations of meteoritic MCAs, with total carbon weight percentages which in some cases approached those of carbonates and insoluble organic matter. Moreover, we found that the concentration of MCAs in CR chondrites is higher than in the other meteorite groups, with acetic acid exhibiting the highest concentration in all samples. The abundance of MCAs decreased with increasing molecular weight and with increasing aqueous and/or thermal alteration experienced by the meteorite sample. The δ¹³C isotopic values of MCAs ranged from ?52 to +27‰, and aside from an inverse relationship between δ¹³C value and carbon straight‐chain length for C₃–C₆ MCAs in Murchison, the ¹³C‐isotopic values did not correlate with the number of carbon atoms per molecule. We also observed racemic compositions of 2‐methylbutanoic acid in CM and CR chondrites. We used this novel analytical protocol and collective data to shed new light on the prebiotic origins of chondritic MCAs.     

Geophysical surveys of the sediments of Loch Ness,Scotland: implications for the deglaciation of the Moray Firth Ice Stream,British–Irish Ice Sheet

We present results from three geophysical campaigns using high‐resolution sub‐bottom profiling to image sediments deposited in Loch Ness, Scotland. Sonar profiles show distinct packages of sediment, providing insight into the loch's deglacial history. A recessional moraine complex in the north of the loch indicates initial punctuated retreat. Subsequent retreat was rapid before stabilisation at Foyers Rise formed a large stillstand moraine. Here, the calving margin produced significant volumes of laminated sediments in a proglacial fjord‐like environment. Subsequent to this, ice retreated rapidly to the southern end of the loch, where it again deposited a sequence of proglacial laminated sediments. Sediment sequences were then disturbed by the deposition of a thick gravel layer and a large turbidite deposit as a result of a jökulhlaup from the Spean/Roy ice‐dammed lake. These sediments are overlain by a Holocene sheet drape. Data indicate: (i) a former tributary of the Moray Firth Ice Stream migrated back into Loch Ness as a major outlet glacier with a calving margin in a fjord‐like setting; (ii) there was significant sediment supply to the terminus of this outlet glacier in Loch Ness; and (iii) that jökulhlaups are important for sediment supply into proglacial fjord/lake environments and may compose >20% of proglacial sedimentary sequences. Copyright © 2011 John Wiley & Sons, Ltd.     

Geological controls on Pleistocene glaciation and cirque form in Greece

Limestone and ophiolite rocks are common across the eastern Mediterranean and many of the highest mountains are formed in these rock types. In northwest Greece, Pleistocene glacial erosion was much more effective on limestone terrain where pronounced glacial incision and subglacial glacio-karst processes produced locally-complex topography. This enabled Pleistocene glaciers to form on a range of slope orientations in contrast to ophiolite terrains, where glaciers were strongly controlled by aspect. On limestone terrains, the largest ice masses formed on south-facing slopes, whereas in neighbouring higher mountains formed in ophiolite, glaciers were much more restricted and predominantly formed on north- and east-facing slopes.     

Tempos of Elderly Age and Geographical Concentration*

This paper presents a method to measure two types of tempos: 1) the tempo of elderly age concentration, the rate of change in the elderly proportion in a region; and 2) the tempo of elderly geographical concentration, the rate of change in a region's share of the national elderly population. The two measurements are applied to historical data for the United States. The results reveal that both tempos vary spatially and temporally. Relative tempos are also introduced to compare the indices between different age groups and regions.     

Composite suspended sediment particles in river systems: their incidence,dynamics and physical characteristics

Most of the existing data on the effective particle size characteristics of fluvial suspended sediment derive from instantaneous sampling methods that may not be representative of the overall suspended sediment loads. This presents difficulties when there is a need to incorporate effective particle size data into numerical models of floodplain sedimentation and sediment‐associated contaminant transfer. We have used a field‐based water elutriation apparatus (WEA) to assemble a large (36 flood) database on the time‐integrated nature of the effective and absolute particle size characteristics of suspended sediment in four subcatchments of the River Exe basin of southwest England. These catchments encompass a wide range of terrains and fluvial environments that are broadly representative of much of the UK and temperate, low relief northwest Europe. The WEA provides important data on the physical characteristics of composite particles that are not attainable using other methods. This dataset has allowed, for the first time, detailed interbasin comparisons of the time‐integrated particle size characteristics of suspended sediment and reliable estimates of the contribution of five effective size classes to the mean annual suspended sediment load of the study catchments. The suspended sediment load of each river is dominated by composite rather than primary particles, with, for example, almost 60% (by mass) of the sediment load of the River Exe at Thorverton transported as composite particles > 16 µm in size. All the effective size classes contain significant clay components. A key outcome of this study is the recognition that each catchment has a distinctive time‐integrated effective particle size signature. In addition, the time‐integrated effective particle size characteristics of the suspended loads in each of the catchments display much greater spatial variability than the equivalent absolute particle size distributions. This indicates that the processes producing composite particles vary significantly between these catchments, and this has important implications for our understanding of the dynamics of suspended sediment properties. Copyright © 2007 John Wiley & Sons, Ltd.     

Gemini-N mid-IR observations of the dust properties of the ejecta excavated from Comet 9P/Tempel 1 during Deep Impact

We present mid-infrared spectra and images from the Gemini-N (+MICHELLE) observational campaign of Comet 9P/Tempel 1 before, during, and after its encounter with Deep Impact. We use our thermal grain model to probe the 10 μm properties of the dust grains in the coma of the comet. Before impact (3 July 2005 UT), and more than 24 h after impact (5, 16, and 28 July 2005 UT), the comet dust grains were composed mostly of amorphous olivine, and were relatively large (peak of the grain size distribution ). For the night of impact, we extract spectra by centering on the nucleus, and offset 1″ from the nucleus in the direction of the impact ejecta plume. We find small dust grains (∼0.2 μm) of a diverse mineralogy (amorphous olivine, amorphous pyroxene, amorphous carbon, and crystalline olivine) populating the ejecta. The submicron sized dust grains move faster than the other, larger grains (?0.7 μm), with amorphous olivine and amorphous carbon traveling together, and amorphous pyroxene and crystalline olivine dispersing at a similar rate. Deriving a velocity law from a time-of-flight analysis, we find that the material traveled with a velocity law scaled by and with a power of p=0.5. This velocity power-law requires a sustained release of grains for the duration of 45-60 min after impact. Since the mineral species are traveling at different speeds, and there was a sustained release of grains due to a possible “gas-plume,” we conclude that the different minerals did not originate from grain aggregates destroyed by the impact, but instead arise from an inhomogeneous nucleus.