Case a evolution of massive close binary systems

The evolution of three close binary systems of total mass 20.4M in and after the phase of mode Br mass-transfer in caseA of mass exchange is investigated. In every case a secondary component evolves to interfere with the progress of primary's evolution and the system overflows the outer critical surface before the primary completes its nuclear-burning evolution. This strongly indicates the importance of simultaneous calculation of both components. A summary of evolution of the systems considered in this series of papers up to the stage ofL ₂-overflow is given. The observational aspects of the numerical models are also discussed.     

Satellite detection of red tide in Ariake Sound, 1998–2001

High resolution SeaWiFS data was used to detect red tide events that occurred in the Ariake Sound, Japan, a small embayment known as one of the most productive areas in Japan. SeaWiFS chlorophyll data clearly showed that a large red tide event, which damaged seaweed (Nori) cultures, started early in December 2000 in Isahaya Bay, expanded to the whole sound and persisted to the end of February 2001. The monthly average of SeaWiFS data from May 1998 to December 2001 indicated that the chlorophyll peaks appeared twice a year, in early summer and in fall, after the peaks of rain and river discharge. The SeaWiFS data showed that the red tide event during 2000–2001 winter was part of the fall bloom; however, it started later and continued significantly longer than other years. Satellite ocean color data is useful to detect the red tide; however the algorithms require improvement to accurately estimate chlorophyll in highly turbid water and in red tide areas.     

Case a evolution of massive close binary systems

We present in this paper the evolutionary characteristics of the systems belonging to two evolution types, designated as 1C2COf and 1Nc2COf, among seven evolution types which were studied in the preceding paper of this series. These two types are most complicated and interesting in the evolutionary behaviour, which consists of repeated detached, semi-detached, and contact phases. We discuss observational aspects of the results. Evolutionary behaviour of the systems are also discussed, compared with the thermal relaxation oscillation model.     

Growth rate is temperature‐dependent,but the proportion of resource allocation between the growth and gonads is not,in early adult stage of the lancelet branchiostoma japonicum

The pattern of resource allocation into multiple life‐history traits can vary with the environment; for example, high temperatures generally facilitate growth. Changes in investment in growth due to temperature may alter the allocation to other traits that are in trade‐off with that. Here, we investigated the trade‐off between growth and reproduction and whether the proportion of allocation to these varies with increasing seawater temperature in the lancelet Branchiostoma japonicum. We reared the lancelets of early adult stage under three different temperature treatments (control, + 1°C and + 2°C treatments) for 427 days in the laboratory. Although the total body length at initiation did not differ between treatments, the length was influenced by the interaction between elapsed days and temperature treatments, suggesting that growth rate was temperature‐dependent; the lancelets under higher temperature conditions showed a more rapid growth rate than did those under the control conditions. The frequency of individuals with gonads did not differ between treatments throughout their reproductive season. The monthly growth increments were also not significantly affected by the interaction between the presence/absence of gonads and temperature treatments, although the presence of gonads caused the growth increments to decrease. In addition, the effect of temperature treatments was significant. These results suggest that changes in temperature did not alter the pattern of allocation between growth and reproduction that were in a trade‐off, whereas high temperature would solely result in an increase in resource intake, at least in the early adult stage of this species.     

Calibration and validation of the ocean color version-3 product from ADEOS OCTS

We present calibration and validation results of the OCTS’s ocean color version-3 product, which mainly consists of the chlorophyll-a concentration (Chl-a) and the normalized water-leaving radiance (_nL_w). First, OCTS was calibrated for the inter-detector sensitivity difference, offset, and absolute sensitivity using external calibration source. It was also vicariously calibrated using in-situ measurements for water (Chl-a and_nL_w) and atmosphere (optical thickness), which were acquired synchronously with OCTS under cloud-free conditions. Second, the product was validated using selected 17 in-situ Chl-a and 11 in-situ_nL_w measurements. We confirmed that Chl-a was estimated with an accuracy of 68% for Chl-a less than 2 mg/m³, and_nL_w from 94% (band 2) to 128% (band 4). Geometric accuracy was improved to 1.3 km. Stripes were significantly reduced by modifying the detector normalization factor as a function of input radiance.     

Lunar gravity field determination using SELENE same-beam differential VLBI tracking data

A lunar gravity field model up to degree and order 100 in spherical harmonics, named SGM100i, has been determined from SELENE and historical tracking data, with an emphasis on using same-beam S-band differential VLBI data obtained in the SELENE mission between January 2008 and February 2009. Orbit consistency throughout the entire mission period of SELENE as determined from orbit overlaps for the two sub-satellites of SELENE involved in the VLBI tracking improved consistently from several hundreds of metres to several tens of metres by including differential VLBI data. Through orbits that are better determined, the gravity field model is also improved by including these data. Orbit determination performance for the new model shows improvements over earlier 100th degree and order models, especially for edge-on orbits over the deep far side. Lunar Prospector orbit determination shows an improvement of orbit consistency from 1-day predictions for 2-day arcs of 6 m in a total sense, with most improvement in the along and cross-track directions. Data fit for the types and satellites involved is also improved. Formal errors for the lower degrees are smaller, and the new model also shows increased correlations with topography over the far side. The estimated value for the lunar GM for this model equals 4902.80080±0.0009 km³/s² (10 sigma). The lunar degree 2 potential Love number k ₂ was also estimated, and has a value of 0.0255 ± 0.0016 (10 sigma as well).     

Apatite Composition of Representative Magnetite‐series and Ilmenite‐series Granitoids in Japan

Apatites of representative magnetite‐series and ilmenite‐series granitoids were studied in the Japanese Islands. Concentrations of the volatile components F, Cl and SO₃ are differently distributed in apatites of these granitoid series. Apatites are always fluoroapatite. They have weakly higher F content in the ilmenite series than in the magnetite series. In contrast, Cl and SO₃, are significantly concentrated in apatites of the magnetite series compared to the ilmenite series. These characteristics reflect the original concentrations of these components in the host granitic magmas. A high fO₂ seems most important for the S‐concentration as sulfate in apatite of the magnetite series. REE and Y are only erratically high in the studied apatites.     

Genesis of the Jinchuan PGE deposit, China: evidence from fluid inclusions, mineralogy and geochemistry of precious elements

Summary The Jinchuan deposit is a platinum group element (PGE)-rich sulfide deposit in China. Drilling and surface sampling show that three categories of platinum group element (PGE) mineralization occur; type I formed at magmatic temperatures, type II occurs in hydrothermally altered zones of the intrusion, and type III in sheared dunite and lherzolite. All ore types were analyzed for Os, Ir, Ru, Rh, Pd, Pt and Au, as well as for Cu, Ni, Co and S. Type I ore has (Pt + Pd)/(Os + Ir + Ru + Rh) ratios of <7 and relatively flat chondrite-normalized noble metal patterns; the platinum group minerals (PGM) are dominated by sperrylite and moncheite associated with chalcopyrite, pyrrhotite and pentlandite. Type II has (Pt + Pd)/(Os + Ir + Ru + Rh) ratios from 40 to 330 and noble metal distribution patterns with a positive slope; the most common PGM are sperrylite and Pd bismuthotelluride phases concentrated mostly at the margins of base metal sulfides. Type III ores have the highest (Pt + Pd)/(Os + Ir + Ru + Rh) ratios from 240 to 710; the most abundant PGM are sperrylite and phases of the Pt–Pd–Te–Bi–As–Cl system. It is concluded that the Jinchuan deposit formed as a result of primary magmatic crystallization followed by hydrothermal remobilization, transport, and deposition of the PGE.     

K-Ar Ages of Granitic Magmatism and Related Pegmatite Formation at the Umanotani-Shiroyama Mine, Shimane Prefecture, SW Japan and Their Bearings on Cooling History

Abstract. The Umanotani-Shiroyama pegmatite deposits, the largest producer of K-feldspar and quartz in Japan, are of typical granitic pegmatite. Ilmenite-series biotite granite and granite porphyry, hosting the ore deposits, and biotites separated from these rocks yielded K-Ar ages ranging from 89.0 to 81.4 Ma and 95.2 to 93.7 Ma, respectively. Muscovite and K-feldspar separated from the ore zone yielded K-Ar ages with the range of 96.2 to 93.1 Ma and 87.3 to 80.7 Ma, respectively. Muscovites from quartz-muscovite veins in the ore zone and in the granite porphyry yielded K-Ar ages of 90.4 and 76.3 Ma, respectively. K-feldspar is much younger in age than coexisting muscovite. It is noted that the K-Ar ages of biotite separates and the whole-rock ages are identical to those of muscovite and K-feldspar in the ore zone, respectively. These time relations, as well as field occurrence, indicate that the formation of the pegmatite deposits at the Umanotani-Shiroyama mine is closely related in space and time to a series of granitic magmatism of ilmenite-series nature. Using closure temperatures of the K-Ar system for biotite and K-feldspar (microcline), cooling rate of the pegmatite deposits is estimated to be about 82C/m.y. at the beginning, but slowed down to about 15C/m.y. in the later period.     

REE Abundance and REE Minerals in Granitic Rocks in the Nanling Range,Jiangxi Province,Southern China,and Generation of the REE‐rich Weathered Crust Deposits

Studies of Mesozoic granites associated with rare earth element (REE)‐rich weathered crust deposits in southernmost Jiangxi Province indicate that they have high‐K to shoshonite compositions and belong to ilmenite‐series I‐type granites. Of the studied rocks at 59–292 ppm of bulk REE content, the highest are seen in the biotite granites of Dingnan (358, 429 ppm) and mafic biotite granite of the Wuliting Granite (344 ppm) near the Dajishan tungsten mine, both areas where weathered‐crust REE deposits occur. REE‐bearing accessory minerals in these granites are mainly zircon, apatite and allanite, and REE‐fluorocarbonates are common. REE enrichment occurs in the rims of apatite crystals, and in fluorocarbonates that occur along grain boundaries of and cracks in major silicate minerals, and in fluorocarbonates that replaced altered biotite. It is therefore thought that a major part of the REE content of these granites was concentrated during deuteric activity, rather than during magmatic crystallization. The crack‐filling REE‐fluorocarbonates could subsequently have been easily leached out and deposited in weathered crust developed during a long period of exposure.