Spinor: Visible and Infrared Spectro-Polarimetry at the National Solar Observatory

The Spectro-Polarimeter for Infrared and Optical Regions (SPINOR) is a new spectro-polarimeter that will serve as a facility instrument for the Dunn Solar Telescope at the National Solar Observatory. This instrument is capable of achromatic polarimetry over a very broad range of wavelengths, from 430 to 1600 nm, allowing for the simultaneous observation of several visible and infrared spectral regions with full Stokes polarimetry. Another key feature of the design is its flexibility to observe virtually any combination of spectral lines, limited only by practical considerations (e.g., the number of detectors available, space on the optical bench, etc.). Visiting Astronomers, National Solar Observatory, operated by the Association of Universities for Research in Astronomy, Inc. (AURA), under cooperative agreement with the National Science Foundation.     

Seasonal variations of alkenones and U37 in the Chesapeake Bay water column

Alkenone unsaturation indices (U^K₃₇ and U^K′₃₇) have long been used as proxies for surface water temperature in the open ocean. Recent studies have suggested that in other marine environments, variables other than temperature may affect both the production of alkenones and the values of the indices. Here, we present the results of a reconnaissance field study in which alkenones were extracted from particulate matter filtered from the water column in Chesapeake Bay during 2000 and 2001. A multivariate analysis shows a strong positive correlation between U^K₃₇ (and U^K′₃₇) values and temperature, and a significant negative correlation between U^K₃₇ (and U^K′₃₇) values and nitrate concentrations. However, temperature and nitrate concentrations also co-vary significantly. The temperature vs. U^K₃₇ relationships (U^K₃₇=0.018 (T)−0.162, R²=0.84, U^K′₃₇=0.013 (T)−0.04, R²=0.80) have lower slopes than the open-ocean equations of Prahl et al. [1988. Further evaluation of long-chain alkenones as indicators of paleoceanographic conditions. Geochimica et Cosmochimica Acta 52, 2303–2310] and Müller et al. [1998. Calibration of the alkenone paleotemperature index U^K′₃₇ based on core-tops from the eastern South Atlantic and the global ocean (60°N–60°S). Geochimica et Cosmochimica Acta 62, 1757–1772], but are similar to the relationships found in controlled studies with elevated nutrient levels and higher nitrate:phosphate (N:P) ratios. This implies that high nutrient levels in Chesapeake Bay have either lowered the U^K₃₇ vs. temperature slope, or nutrient levels are the main controller of the U^K₃₇ index. In addition, particularly high abundances (>5% of total C₃₇ alkenones) of the tetra-unsaturated ketone, C_37:4, were found when water temperatures reached 25 °C or higher, thus posing further questions about the controls on alkenone production as well as the biochemical roles of alkenones.     

The sea-surface microlayer of puget sound: Part I. Toxic effects on fish eggs and larvae

The sea surface is an important habitat for the developmental stages (eggs and larvae) of many fish and invertebrates; it is also a concentration point for anthropogenic contaminants entering the sea. Studies were conducted to determine the extent to which the sea surface of Puget Sound was toxic to the early life history stages of fish. Three urban bays with suspected contamination, a rural reference bay, and a Central Sound site were compared. Surface-dwelling eggs and organisms (zooneuston) were collected with a surface-skimming neuston net and their densities enumerated. Sand sole (Psettichthys melanostictus) embryos were exposed in the field and laboratory to the sea-surface microlayer. To develop a useful year-round approach to monitoring sea-surface toxicity, larval development of anchovies, kelp bass, and sea urchins was also evaluated as an indication of sea-surface microlayer toxicity.During the spawning season (February and March), urban boys in Puget Sound had lower concentrations of sand sole eggs and neustonic organisms on the sea surface than did the rural bayor Central Sound reference sites. Compared to the reference sites, laboratory exposure to surface microlayer samples collected from urban bay sites generally resulted in more chromsomal aberrations in developing sole embryos, reduced hatching success of sole larvae, and reduced growth in trout cell cultures. In situ hatching success of sole eggs was reduced by half or more in urban bays compared to reference sites.Toxicity was associated with visible surface slicks and, in urban bays, increased with increasing surface pressure (dynes cm⁻¹). Results to be reported separately (Part II) indicate that toxicity is strongly correlated with the presence of high concentrations of polycyclic aromatic hydrocarbons and metals in the sea-surface microlayer. The toxicity of SMIC samples was similar when evaluated by sole, anchovy, kelp bass, or sea urchin tests. A sea-surface monitoring program could use sea urchin embryos to evaluate site-specific sea-surface toxicity throughout the year.     

Laboratory wave reflection analysis using co-located gages

Most coastal and ocean engineering laboratories employ techniques that use two or three spatially separated wave gages to estimate reflection of irregular waves in two-dimensional wave flumes. This paper presents a frequency domain method for separating incident and reflected wave spectra from co-located gages (gages located on the same vertical line). The technique is based on linear wave theory, and it can be applied to time series of sea surface elevation and horizontal water velocity collected in a vertical array, or it can be used with horizontal and vertical water velocity time series collected at the same point in the water column. Application of the method is limited to those frequencies showing good coherence between time series signals. Outside the range of good coherence, gross inaccuracies occur.The utility of the co-located gage method is illustrated using water velocity data collected in a wave flume with a laser Doppler velocimeter, and the method is validated for the case of complete reflection by a vertical wall. Side-by-side comparison to the spatially-separated wave gage method of Goda and Suzuki (1976) exhibited close agreement for a variety of irregular wave trains being weakly reflected by a mild sloping beach. The co-located gage method is useful in situations where there are spatial variations in the wavelength, such as on a mildly sloping bottom, or in the region close to highly reflective structures where errors arising from spatial variations in characteristic wave parameters would corrupt estimates made using the spatially-separated wave gage method.     

High-resolution seafloor mapping using the DSL-120 sonar system: Quantitative assessment of sidescan and phase-bathymetry data from the Lucky Strike segment of the Mid-Atlantic Ridge

High-resolution, side-looking sonar data collected near the seafloor (100 m altitude) provide important structural and topographic information for defining the geological history and current tectonic framework of seafloor terrains. DSL-120 kHz sonar data collected in the rift valley of the Lucky Strike segment of the Mid-Atlantic Ridge near 37° N provide the ability to quantitatively assess the effective resolution limits of both the sidescan imagery and the computed phase-bathymetry of this sonar system. While the theoretical, vertical and horizontal pixel resolutions of the DSL-120 system are <1 m, statistical analysis of DSL-120 sonar data collected from the Lucky Strike segment indicates that the effective spatial resolution of features is 1–2 m for sidescan imagery and 4 m for phase-bathymetry in the seafloor terrain of the Mid-Atlantic Ridge rift valley. Comparison of multibeam bathymetry data collected at the sea-surface with deep-tow DSL-120 bathymetry indicates that depth differences are on the order of the resolution of the multibeam system (10–30 m). Much of this residual can be accounted for by navigational mismatches and the higher resolving ability of the DSL-120 data, which has a bathymetric footprint on the seafloor that is 20 times smaller than that of hull-mounted multibeam at these seafloor depths (2000 m). Comparison of DSL-120 bathymetry with itself on crossing lines indicates that residual depth values are ±20 m, with much of that variation being accounted for by navigational errors. A DSL-120 survey conducted in 1998 on the Juan de Fuca Ridge with better navigation and less complex seafloor terrain had residual depth values half those of the Lucky Strike survey. The quality of the bathymetry data varies as a function of position within the swath, with poorer data directly beneath the tow vehicle and also towards the swath edges.Variations in sidescan amplitude observed across the rift valley and on Lucky Strike Seamount correlate well with changes in seafloor roughness caused by transitions from sedimented seafloor to bare rock outcrops. Distinct changes in sonar backscatter amplitude were also observed between areas covered with hydrothermal pavement that grade into lava flows and the collapsed surface of the lava lake in the summit depression of Lucky Strike Seamount. Small features on the seafloor, including volcanic constructional features (e.g., small cones, haystacks, fissures and collapse features) and hydrothermal vent chimneys or mounds taller than 2 m and greater than 9 m² in surface area, can easily be resolved and mapped using this system. These features at Lucky Strike have been confirmed visually using the submersible Alvin, the remotely operated vehicle Jason, and the towed optical/acoustic mapping system Argo II.