Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.     

Fast genetic mapping in barley: case studies of cuticle mutants using RNA-sequencing

Barley(Hordeum vulgare L.) is one of the earliest domesticated crop species and ranked as the fourth largest cereal production worldwide. Forward genetic studies in barley have greatly advanced plant genetics during the last century; however, most genes are identified by the conventional mapping method. Array genotyping and exome-capture sequencing have also been successfully used to target the causal mutation in barley populations, but these techniques are not widely adopted because of associated costs and partly due to the huge genome size of barley. This review summarizes three mapping cases of barley cuticle mutants in our laboratory with the help of RNA-sequencing. The causal mutations have been successfully identified for two of them and the target genes are located in the pericentromeric regions. Detailed information on the mapping-by-sequencing, mapping-and-sequencing, and RNA-sequencing assisted linkage mapping are presented and some limitations and challenges on the mapping assisted by RNA sequencing are also discussed. The alternative and elegant methods presented in this review may greatly accelerate forward genetics of barley mapping, especially for laboratories without large funding.     

SDSS J143030.22-001115.1： A Misclassified Narrow-line Seyfert 1 Galaxy with Flat X-ray Spectrum

We used multi-component profiles to model the Hβ and [OⅢ]λλ4959,5007 lines of SDSS J143030.22-001115.1, a narrow-line Seyfert 1 galaxy (NLS1) in a sample of 150 NLS1 candidates selected from the Sloan Digital Sky Survey (SDSS), Early Data Release (EDR). After subtracting the Hβ contribution from narrow line regions (NLRs), we found that its full width half maximum (FWHM) of broad Hβ line is nearly 2900km s~(-1) , significantly larger than the customarily adopted criterion of 2000 km s~(-1) . With its weak Fe Ⅱ multiples, we believe that SDSS J143030.22-001115.1 should not be classified as a genuine NLS1. When we calculate the virial black hole masses of NLS1s, we should use the Hβ linewidth after subtracting the NLR component.     

Multistep matched-field inversion for broad-band data from ASIAEX2001

This paper discusses the results of geoacoustic inversion carried out using explosive charge data from the Asian Seas International Acoustic Experiment (ASIAEX) East China Sea (ECS) Experiment. A multifrequency incoherent matched-field inversion processor and a genetic algorithm (GA) are used for the inversion. A multistep matched field inversion approach is presented, which makes use of the varying sensitivities of wave fields at various frequencies to reduce the inversion problem into a sequence of smaller inversions with fewer unknowns to estimate at each stage. Different parameters are estimated using data at different frequencies according to their sensitivities. Inversion results for different areas in the ECS region are summarized and compared with core data.     

Theory of stability, and regulation and control of ecological system in oasis

Starting with analysis on the evolving course of oasis and the characteristics and evolution of transitional zone between oasis and desert, in consideration of ecological elements including plant stomata resistance, area covered by vegetation, and physical elements including albedo of vegetation and bare soil, atmosphere temperature, and humidity, under the condition of the balance among net radiation flux, latent heat flux, and sensible heat flux, the following are calculated: temperatures of vegetation and bare soil in different conditions, as well as the evapotranspiration rate of ecosystem. Analysis on evapotranspiration rate indicates that it depends on both the climate of environment and the physiological and ecological conditions of plants. On certain conditions, the evapotranspiration rate of transitional zone between oasis and desert (i.e. area covered by vegetation less than 20%), in some parameter domains, appears in bifurcation or multiequilibrium state. Meanwhile, in such area, ecosystem is extremely unstable. Any minor change to the balance will cause either increase or reduction of area covered by vegetation in ecosystem, on the basis of discussion on the emergency of these phenomena. This paper is attempting to propose an effective way of destruction and rebuilt ecosystem in transitional zone. The way is to control the evaporation of plant through selecting anti-drought country plant with big stomata resistance, and modify the roughness of the underlying surface in ecosystem by establishing rational interspace structure of plant community, so as to put the degenerative ecosystem into the natural succession track. This primary theory is being verified through observation and analysis on historical data.     

Zircon U–Pb and Hf isotopic study of gneissic rocks from the Chinese Altai: Progressive accretionary history in the early to middle Palaeozoic

Gneissic rocks in the Chinese Altai Mountains have been interpreted as either Paleozoic metasedimentary rocks or Precambrian basement. This study reports geochemical and geochronological data for banded paragneisses and associated gneissic granitoids collected along a NE–SW traverse in the northwestern Chinese Altai. Petrological and geochemical data suggest that the protoliths of the banded gneisses were possibly immature sediments with significant volcanic input and that the gneissic granitoids were derived from I-type granites formed in a subduction environment. Three types of morphological features can be recognized in zircons from the banded gneisses and are interpreted to correlate with different sources. Zircons from five samples of banded paragneiss cluster predominantly between 466 and 528 Ma, some give Neoproterozoic ages, and a few yield discordant Paleoproterozoic to Archean ages. Zircon Hf isotopic compositions indicate that both juvenile/mantle and crust materials were involved in the generation of the source rocks from which these zircons were derived. In contrast, zircons occur ubiquitously as elongated euhedral prismatic crystals in the four samples of the gneissic granitoids, and define single populations for each sample with mean ages between 380 and 453 Ma. The general absence of Precambrian inheritance and positive zircon ?Hf values for these granitoids suggest insignificant crustal contribution to the generation of the precursor magmas. Our data can be interpreted in terms of a progressive accretionary history in early to middle Palaeozoic times, and the Chinese Altai may possibly represent a magmatic arc built on a continental margin dominated by Neoproterozoic rocks.     

泸州古隆起对贵州赤水地区早、中三叠世沉积环境和相带展布的控制

地质历史中,区域大地构造和区域古地貌单元的不同特征是控制沉积相带展布及发育的主要因素之一。东吴运动形成的泸州古隆起是影响本区沉积相带展布的重要因素。早、中三叠世时,泸州古隆起的高部位向南延伸到太和场以南,宝元以北一带。宝元、龙爪等构造处于泸州古隆起东南部斜坡上,而宝元构造处于古隆起东南部斜坡上部,龙爪构造处于古隆起东南部斜坡中部。此古地貌格局,与区域海平面升降一起,控制了早三叠世沉积相带展布和地层厚度。在古地貌高的隆起区域,由于水体开阔、水动力条件相对较强,沉积了有利于形成储集体的滩相沉积物（生屑滩、砂屑滩、鲕粒滩等）。从泸州古隆起的高部位向古隆起的斜坡区,地层厚度逐渐增大,沉积物向粒度变细、颜色加深的特征相变。     

案例推理技术及其在决策科学中的应用研究

CBR技术反映了人类认知科学研究的新成果,强调了人类时过去经验和前人智慧的重现.并依靠它们指导解决实际工作中遇到的新问题.基于案例推理特别适用于领域定理难以表示成规则形式,而易表示成案例形式并且已积累了丰富案例的领域.文章探讨了决策问题与决策模式,研究了基于案例技术的科学决策过程,提出了应用案例智能技术来解决决策科学中的柔性决策难题.     

桩静载荷试验快速法与慢速法对比研究

通过对54根管桩静载荷试验快速法与慢速法对比试验研究,找出了在各级荷载作用下,快速法与慢速法沉降差异规律及快速法与慢速法分别得出的极限承载力差异规律;得出了将快速法静载试验下的沉降及单桩极限承载力修正成慢速法静载试验的沉降及单桩极限承载力的公式;提出了适应天津地区管桩的快速法静载试验方法。     

深井旋转轴套流场的CFD模拟

旋转轴套在超深井工作时,其井下流动是三维湍流流动,旋转轴套的旋转和表面曲率效应以及随之而来的哥氏力和离心力,使流场在超深井的流动中极其复杂,同时,由于流体介质泥浆属于液固两相流,更致使内部流场测试困难,而且超深井中的工况在使用常规方法已很难得到较准确的数据。为此,将计算流体力学软件Fluent应用于超深井下流场的模拟,基于Navier-Stokes方程和Reynolds应力方程模型,建立多种仿真模型,在相同条件下,使用CFD仿真软件Fluent模拟仿真的不同结果,优化与旋转轴套叶片设计相关的几何参数,提高