Study of the flood control scheduling scheme for the Three Gorges Reservoir in a catastrophic flood

The Three Gorges Project is the world's largest water conservancy project. According to the design standards for the 1,000‐year flood, flood diversion areas in the Jingjiang reach of the Yangtze River must be utilized to ensure the safety of the Jingjiang area and the city of Wuhan. However, once these areas are used, the economic and life loss in these areas may be very great. Therefore, it is vital to reduce this loss by developing a scheme that reduces the use of the flood diversion areas through flood regulation by the Three Gorges Reservoir (TGR), under the premise of ensuring the safety of the Three Gorges Dam. For a 1,000‐year flood on the basis of a highly destructive flood in 1954, this paper evaluates scheduling schemes in which flood diversion areas are or are not used. The schemes are simulated based on 2.5‐m resolution reservoir topography and an optimized model of dynamic capacity flood regulation. The simulation results show the following. (a) In accord with the normal flood‐control regulation discharge, the maximum water level above the dam should be not more than 175 m, which ensures the safety of the dam and reservoir area. However, it is necessary to utilize the flood diversion areas within the Jingjiang area, and flood discharge can reach 2.81 billion m³. (b) In the case of relying on the TGR to impound floodwaters independently rather than using the flood diversion areas, the maximum water level above the dam reaches 177.35 m, which is less than the flood check level of 180.4 m to ensure the safety of the Three Gorges Dam. The average increase of the TGR water level in the Chongqing area is not more than 0.11 m, which indicates no significant effect on the upstream reservoir area. Comparing the various scheduling schemes, when the flood diversion areas are not used, it is believed that the TGR can execute safe flood control for a 1,000‐year flood, thereby greatly reducing flood damage.     

Zircon U–Pb age, trace element and Hf isotope composition of Kongling terrane in the Yangtze Craton: refining the timing of Palaeoproterozoic high-grade metamorphism

U–Pb age, trace element and Hf isotope compositions of zircon were analysed for a metasedimentary rock and two amphibolites from the Kongling terrane in the northern part of the Yangtze Craton. The zircon shows distinct morphological and chemical characteristics. Most zircon in an amphibolite shows oscillatory zoning, high Th/U and ¹⁷⁶Lu/¹⁷⁷Hf ratios, high formation temperature, high trace element contents, clear negative Eu anomaly, as well as HREE-enriched patterns, suggesting that it is igneous. The zircon yields a weighted mean ²⁰⁷Pb/²⁰⁶Pb age of 2857 ± 8 Ma, representing the age of the magmatic protolith. The zircon in the other two samples is metamorphic. It has low Th/U ratios, low trace element concentrations, variable HREE contents (33.8 ≥ Lu_N≥2213; 14.7 ≤ Lu_N/Sm_N ≤ 354) and ¹⁷⁶Lu/¹⁷⁷Hf ratios (0.000030–0.001168). The data indicate that the zircon formed in the presence of garnet and under upper amphibolite facies conditions. The metamorphic zircon yields a weighted mean ²⁰⁷Pb/²⁰⁶Pb age of 2010 ± 13 Ma. These results combined with previously obtained Palaeoproterozoic metamorphic ages suggest a c. 2.0 Ga Palaeoproterozoic collisional event in the Yangtze Craton, which may result from the assembly of the supercontinent Columbia. The zircon in two samples yields weighted mean two-stage Hf model ( T _DM2) ages of 3217 ± 110 and 2943 ± 50 Ma, respectively, indicating that their protoliths were mainly derived from Archean crust.     

影响鸢乌贼手钓上钩率的因子探讨

根据印度洋西北部鸢乌贼（Sym plectoteuthis oualaniensis）作业渔场的现场调查数据．分析了作业水深、作业时段、摄食等级和月相等因子对手钓上钩率的影响。统计表明．晚上、午夜和凌晨3个不同时段和不同作业水深对手钓上钩率均有显著性影响。3个时段中，其摄食等级呈先低后高再低的现象。午夜和凌展，上钩率的变化趋势与摄食等级的变化趋势呈显著的负相关。在月相的影响下．离朔日三四天之前，手钓产量呈上升趋势；离望日五六天之前。手钓产量呈明显的下降趋势。     

CPLD技术及其在现代时统中的应用

对CPLD(复杂可编程逻辑器件)技术的基本特征和发展趋势作了简要介绍,揭示了该技术在现代数字系统中的重要地位及作用.利用CPLD对时统设备IRIG-B码产生器进行集成,其实验结果表明,集成了的B码产生器不但简单、可靠,而且便于调试,克服了以往硬件电路复杂的缺点.     

CCD联合平差方法及其初步实例检验

在常规照相天体测量工作中 ,对暗天体的定位是采用逐级定标星过渡的方法实现的。由于星表系统差和局部差的存在 ,最终定位结果可能包含难以把握的误差积累。在CCD小视场观测情况下时常难以找到足够数量的定标星。鉴于此 ,推导了CCD观测联合平差方法的严格矢量表达式 ,以期通过共同星的过渡 ,实现大天区统一平差。原理上此方法可实现相对于河外天体的定位 ,以削弱星表系统差和局部差对定位结果的影响。讨论了CCD联合平差方法实现中的问题 ,包括底片常数模型选择、切点位置改正、共同星的较差改正和法方程解算方法等 ,并分析了具体的处理措施。用实例初步检验了CCD联合平差方法的效果 ,表明通过对多张CCD观测的联合平差 ,可以削弱单张CCD观测参考星数目过少、单张CCD观测参考星分布不均、个别参考星存在位置偏差和局部区域参考星存在系统性位置偏差等不利因素对归算结果的影响 ,进而达到扩大视场和提高归算精度的目的     

大气层对GPS信号传播影响的规律之探讨──关于广州地区大气层对GPS系统定位定时影响问题研究之二

大气层对ＧＰＳ信号的传播有时间延迟作用，时廷将影响ＧＰＳ系统的定位和定时精度，且随气象因素的变化而变化．本文根据３年有关的气象资料，采用大气指数模型分析了广州地区大气层随昼夜变化、季节变化和太阳活动变化对ＧＰＳ信号传播时延影响的变化规律．分析得知，在信号垂直传播时，大气层对ＧＰＳ信号传播的影响，用距离表示．最大时为２．６９１ｍ，最小时也会产生１．９９３ｍ的误差；如果信号斜传播，误差因仰角因素将更大．     

EFFECT OF NITRATE AND PHOSPHATE ON ACCUMULATION OF β-CAROTENE ISOMERS IN DUNALIELLA SALINA

DunaIiella salina, a halotolerent unicellular green alga, can accurmulate a Iarge amount of β-caroteneunder environmental conditions. The isorners of β-carotene extIacted from D. salina culturedin medium with different nitrate and phosphate concentrations were analysed by HPLC with Alox-Talumins column. At least six isomers were found in different proportions depending on the culture me-dia's nitrate and/or phosphate concentrations. Nitrate and/or phosphae defidency was conducive tothe accumulation of totaI cis isomers but not of al1 trans isomer. lt is sUggeSted that 1 mmol/L KNO_3and 0.1 mmol/L KH_2, PO_4 are favourable for accumulation of total cis β-carotene.     

Numerical prediction of blast‐induced stress wave from large‐scale underground explosion

This paper presents a numerical model for predicting the dynamic response of rock mass subjected to large‐scale underground explosion. The model is calibrated against data obtained from large‐scale field tests. The Hugoniot equation of state for rock mass is adopted to calculate the pressure as a function of mass density. A piecewise linear Drucker–Prager strength criterion including the strain rate effect is employed to model the rock mass behaviour subjected to blast loading. A double scalar damage model accounting for both the compression and tension damage is introduced to simulate the damage zone around the charge chamber caused by blast loading. The model is incorporated into Autodyn3D through its user subroutines. The numerical model is then used to predict the dynamic response of rock mass, in terms of the peak particle velocity (PPV) and peak particle acceleration (PPA) attenuation laws, the damage zone, the particle velocity time histories and their frequency contents for large‐scale underground explosion tests. The computed results are found in good agreement with the field measured data; hence, the proposed model is proven to be adequate for simulating the dynamic response of rock mass subjected to large‐scale underground explosion. Extended numerical analyses indicate that, apart from the charge loading density, the stress wave intensity is also affected, but to a lesser extent, by the charge weight and the charge chamber geometry for large‐scale underground explosions. Copyright © 2004 John Wiley & Sons, Ltd.     

Preliminary results for a semi-automated quantification of site effects using geomorphometry and ASTER satellite data for Mozambique,Pakistan and Turkey

Estimation of the degree of local seismic wave amplification (site effects) requires precise information about the local site conditions. In many regions of the world, local geologic information is either sparse or is not readily available. Because of this, seismic hazard maps for countries such as Mozambique, Pakistan and Turkey are developed without consideration of site factors and, therefore, do not provide a complete assessment of future hazards. Where local geologic information is available, details on the traditional maps often lack the precision (better than 1:10,000 scale) or the level of information required for modern seismic microzonation requirements. We use high-resolution (1:50,000) satellite imagery and newly developed image analysis methods to begin addressing this problem. Our imagery, consisting of optical data and digital elevation models (DEMs), is recorded from the ASTER (Advanced Spaceborne Thermal Emission and Reflection Radiometer) sensor system. We apply a semi-automated, object-oriented, multi-resolution feature segmentation method to identify and extract local terrain features. Then we classify the terrain types into mountain, piedmont and basin units using geomorphometry (topographic slope) as our parameter. Next, on the basis of the site classification schemes from the Wills and Silva (1998) study and the Wills et al (2000) and Wills and Clahan (2006) maps of California, we assign the local terrain units with V _s 30 (the average seismic shear-wave velocity through the upper 30m of the subsurface) ranges for selected regions in Mozambique, Pakistan and Turkey. We find that the applicability of our site class assignments in each region is a good first-approximation for quantifying local site conditions and that additional work, such as the verification of the terrain’s compositional rigidity, is needed.