Vermiculite bio-barriers for Cu and Zn remediation: an eco-friendly approach for freshwater and sediments protection

The increase in heavy metal contamination in freshwater systems causes serious environmental problems in most industrialized countries, and the effort to find eco-friendly techniques for reducing water and sediment contamination is fundamental for environmental protection. Permeable barriers made of natural clays can be used as low-cost and eco-friendly materials for adsorbing heavy metals from water solution and thus reducing the sediment contamination. This study discusses the application of permeable barriers made of vermiculite clay for heavy metals remediation at the interface between water and sediments and investigates the possibility to increase their efficiency by loading the vermiculite surface with a microbial biofilm of Pseudomonas putida, which is well known to be a heavy metal accumulator. Some batch assays were performed to verify the uptake capacity of two systems and their adsorption kinetics, and the results indicated that the vermiculite bio-barrier system had a higher removal capacity than the vermiculite barrier (+34.4 and 22.8 % for Cu and Zn, respectively). Moreover, the presence of P. putida biofilm strongly contributed to fasten the kinetics of metals adsorption onto vermiculite sheets. In open-system conditions, the presence of a vermiculite barrier at the interface between water and sediment could reduce the sediment contamination up to 20 and 23 % for Cu and Zn, respectively, highlighting the efficiency of these eco-friendly materials for environmental applications. Nevertheless, the contribution of microbial biofilm in open-system setup should be optimized, and some important considerations about biofilm attachment in a continuous-flow system have been discussed.     

Occurrence and Resistance of Pathogenic Bacteria Along the Tietê River Downstream of São Paulo in Brazil

The load of pathogenic bacteria, their fate and their dangerousness in the Tietê River were assessed along 100 km starting from the city of São Paulo, Brazil. The data were compared with those from two German rivers. High loads of pathogens were found in the Tietê River near the city of São Paulo (Escherichia coli O157:H7, Shigella flexneri, and Shigella boydii), which were absent 30 km downstream of São Paulo. The antibiotic resistances observed in the Tietê river were rather low and decreased after the major input in São Paulo to significantly lower levels about 30 km downstream. While the Brazilian isolates were more susceptible for ampicillin than the German ones, the reverse was observed for gentamycin. For optimal control of infections in humans critical areas where these bacteria survived longer and their elimination mechanisms should be identified as well as the extent and the origin of antibiotic resistance should be determined.     

First record of petrified Permian pecopterids from the Paraná Basin,Brazil (Corumbataí Formation,Passa Dois Group,northeastern State of São Paulo): Morphology,anatomy and paleoecological implications

Petrified pecopterids are described for the first time in the Paraná Basin. They were collected at an outcrop of the Corumbataí Formation (Passa Dois Group, Middle Permian) in the Municipality of Piracicaba (State of São Paulo, Brazil). The assemblage is composed of Pecopteris taguaiensis Rohn and Rösler, 1986, Pecopteris sp. 1, Pecopteris sp. 2 and Pecopteris sp. 3. An emendation to the diagnosis of P. taguaiensis is proposed on the basis of the characteristics shown by the preserved three-dimensional external leaf morphology and partially by the epidermis (not available in the previously described impressions). The small size of the pinnules, the thick, downward-rolled leaf lamina, the thick veins, the straight walls of the epidermal cells, and the trichomes of the four pecopterid taxa may be interpreted as xeromorphic features developed in response to relatively dry climatic conditions and/or direct incidence of the sunlight. The leaves were impregnated with silica before the final burial, considering that they are fragmented, not deformed and associated with angular breccia clasts.     

Taxonomic sufficiency for soft-bottom sublittoral mollusks assemblages in a tropical estuary, Guanabara Bay, Southeast Brazil

Guanabara Bay (GB) is considered to be one of the most polluted environments of the southern Brazilian coastline. This typical estuarine system is impacted by the heavy discharge of both industrial and domestic waste from the Rio de Janeiro metropolitan area. The mollusc community structure and distribution was investigated between 2000 and 2001, using a three month sampling design of 38 stations, according to austral seasons. Species abundance was aggregated into progressively higher taxa matrices (genus, family, order) and were analysed using multivariate techniques. Mollusc distribution in GB varied significantly in space and time and was probably ruled by the organic enrichment effects of hypoxia and altered redox conditions coupled with prevailing patterns of circulation. Within the sectors of GB an increasing gradient in mollusc diversity and occurrence was observed, ranging from the azoic and impoverished stations in the inner sector to a well-structured community in terms of species composition and abundance inhabiting the outer sector. The non-metric multidimensional scaling (nMDS) and cluster analysis showed similar results when species were aggregated into genera and families, while greater difference occurred at coarser taxonomic identification (order). The literature about taxonomic sufficiency has demonstrated that faunal patterns at different taxonomic levels tend to become similar with increased pollution. In Guanabara Bay, an analysis carried out solely at family level is perfectly adequate to describe the ecophysiological stress. Further aggregation to order level changed the perceived patterns of differences. However, a different taxonomic resolution can be chosen depending on the type of ecological patterns investigated.     

Downscaling of South America present climate driven by 4-member HadCM3 runs

The objective of this work is to evaluate climate simulations over South America using the regional Eta Model driven by four members of an ensemble of the UK Met Office Hadley Centre HadCM3 global model. The Eta Model has been modified with the purpose of performing long-term decadal integrations and has shown to reproduce “present climate”—the period 1961–1990—reasonably well when forced by HadCM3. The global model lateral conditions with a resolution of 2.5° latitude?×?3.75° longitude were provided at a frequency of 6?h. Each member of the global model ensemble has a different climate sensitivity, and the four members were selected to span the range of uncertainty encompassed by the ensemble. The Eta Model nested in the HadCM3 global model was configured with 40-km horizontal resolution and 38 layers in the vertical. No large-scale internal nudging was applied. Results are shown for austral summer and winter at present climate defined as 1961–90. The upper and low-level circulation patterns produced by the Eta-CPTEC/HadCM3 experiment set-up show good agreement with reanalysis data and the mean precipitation and temperature with CRU observation data. The spread in the downscaled mean precipitation and temperature is small when compared against model errors. On the other hand, the benefits in using an ensemble is clear in the improved representation of the seasonal cycle by the ensemble mean over any one realization. El Ni?o and La Ni?a years were identified in the HadCM3 member runs based on the NOAA Climate Prediction Center criterion of sea surface temperature anomalies in the Ni?o 3.4 area. The frequency of the El Ni?o and La Ni?a events in the studied period is underestimated by HadCM3. The precipitation and temperature anomalies typical of these events are reproduced by most of the Eta-CPTEC/HadCM3 ensemble, although small displacements of the positions of the anomalies occur. This experiment configuration is the first step on the implementation of Eta-CPTEC/HadCM3 upcoming experiments on climate change studies that are discussed in a companion paper.     

Sediments Quality Assessment of Jacarepaguá Lagoon: The Venue of the 2011 Rock in Rio

In order to aid in the efforts of the 2016 Olympic Games, the organizers of 2011 Rock in Rio decided to build a permanent venue next to the Olympic Park. The area is problematic from the geotechnical point of view since it presents soils with low shear strength, low permeability, and high plasticity, so major soil improvement works were carried out. Bored soil–cement columns were placed to increase soil shear strength and reduce compressibility. A meter thick fill composed of gneiss residual soil was placed and trenches were digged to drain rainwater. However, earlier studies conducted on Jacarepaguá Lagoon have detected the presence of heavy metals in these sediments. In this study, an environmental survey on the Jacarepaguá Lagoon sediments took place in order to choose a place where its sediments could be dredged to be later used in the drainage facilities. The results indicated areas where the threshold level 1 (low probability of adverse effects) issued by the general procedures for sediments quality assessments for dredging purposes, Resolution no 344 of the Brazilian Federal Government, was surpassed. Levels above the limits established for cadmium (Cd), lead (Pb), copper (Cu), nickel (Ni), and zinc (Zn) were detected. Based on this consideration the State Environmental Agency issued a permit allowing the organizers of 2011 Rock in Rio to dredge an area close to City of Rock in order to obtain coarse sediments for the drainage facilities. In addition, it was found that those sediments were ideal for this application since their hydraulic conductivity is on the order of 10^?2 cm/s.     

Land use and land cover dynamics in Leiria City: relation between peri-urbanization processes and hydro-geomorphologic disasters

Natural Hazards - The objective of the present study is to evaluate the relation between the spatial and temporal dynamics of Land Use and Land Cover (LULC) and the hydro-geomorphological processes...     

Downscaling projections of climate change in Sao Tome and Principe Islands,Africa

Sao Tome and Principe is a small insular African country extremely vulnerable to rising sea levels and impacts such as inundation, shore line change, and salt water intrusion into underground aquifers. Projections of climate change have considered coarse model resolutions. The objective of this work is to dynamically downscale the global model projections to 4-km resolution and to assess the climate change in the Sao Tome and Principe islands. The global climate projections are provided by the Canadian Earth System Model under two Representative Concentration Pathways greenhouse gas scenarios, RCP4.5 and RCP8.5. The downscaling is produced by the Eta regional climate model. The baseline period is taken between 1971 and 2000, and the future climate period is taken between 2041 and 2070. The 2-m temperature simulations show good agreement with station data. The model simulates temperature more accurately than precipitation. The precipitation simulations systematically show underestimation and delay of the rainy and the dry seasons by about 1 month, a feature inherited from the global climate model. In the middle of the 21st century, projections show the strongest warming in the elevated parts of the Sao Tome Island, especially in February under RCP8.5. Warmer nights and warmer days become more frequent in the islands when compared with those in the present. While under RCP4.5, precipitation increases in the islands; under RCP8.5, it decreases everywhere in both islands. Heavy precipitation rates should increase, especially in the south-southwestern parts of the Sao Tome islands. Detailed spatial variability of the temperature and precipitation changes in the islands can only be revealed at very high spatial model resolution. Implications for the potential energy production from two major river basins are assessed in this work.     

Effect of phosphorus on the attenuation of lead and chromium transport in soils

This study analyses the adsorption of Pb(II) and Cr(III) in soils. These metals are commonly found together in nature in urban wastes or industrial spillages, and the theoretical approach of the work was to evaluate the response of the soil to continuous Cr and Pb spillages to soil in terms of several physicochemical parameters. The influence of an anthropogenic input of phosphorus was evaluated. Continuous flow experiments were run in duplicates in acrylic columns (25 cm × 3.2 cm). The influent Cr(III) and Pb(II) solutions of 10 mg l^?1 and 25 mg l^?1 at pH 5 were pumped upward through the bottom of the columns to ensure saturation flow conditions. Also, successive experiments were run with the above concentrations of Cr(III) and Pb(II) and NaH₂PO₄, keeping metal to phosphorus ratio of 1:0, 1:0.1 and 1:1. Modelling parameters included Freundlich and Langmuir equations, together with the Two-site adsorption model using CXTFIT code. Results obtained allowed concluding that Pb(II) adsorption presents a certain degree of irreversibility and the continued spillages over soil increment the fraction which is not easily desorbed. Cr(III) desorption was almost complete, evidencing its high mobility in nature. The presence of an anthropogenic input of phosphorus leads to a marked increase of both Pb(II) and Cr(III) adsorption in soils. Z-potential measurements allow to discard the electrostatic attraction of Cr(III) and Pb(II) with the surface charged soil as the dominant process of metal sorption. Instead, CheaqsPro simulation allows to identify PbH₂PO₄ ⁺, PbHPO₄ (aq) and CrHPO₄ ⁺ as the dominant species which regulate Cr(III) and Pb(II) transport in soils.