Timing of Fracture Formation and Duration of Mineralization at the Hishikari Deposit, Southern Kyushu, Japan

Abstract. The Hishikari epithermal gold deposit consists of the Honko-Sanjin zone and Yamada zone. On the basis of observed crosscutting relationships of veins, vein system in the Hishikari deposit was classified into the early and late veins. They differ from orientation, width, control by unconformity, the amount of displacement and structural features, but have similarity in gold grade and Au/Ag ratios. K-Ar ages are presented for the classified veins to clarify timing of fracturing and duration of mineralization.
Age determination revealed that the early veins in the Honko-Sanjin zone range from 0.86 to 1.11 Ma and that the late veins range from 0.73 to 0. 84 Ma. The economically most important mineralization in the Hishikari deposit occurred around 0.90 Ma in a very short period (about 0.05 million years).
The distribution of mineralization age in the whole Hishikari deposit, occurrences of slickensides and ground water temperatures imply that mineralization lasted longer in the southern part of the deposit. As compared the early veins with late veins, structural changes including width, strike, dip and vein characteristics occurred at around 0.85 Ma.     

Transpressional tectonics of the Mineoka Ophiolite Belt in a trench–trench–trench-type triple junction, Boso Peninsula, Japan

Abstract   Structures developed in metamorphic and plutonic blocks that occur as knockers in the Mineoka Ophiolite Belt in the Boso Peninsula, central Japan, were analyzed. The aim was to understand the incorporation processes of blocks of metamorphic and plutonic rocks with an arc signature into the serpentinite mélange of the Mineoka Ophiolite Belt in relation to changes in metamorphic conditions during emplacement. Several stages of deformation during retrogressive metamorphism were identified: the first faulting stage had two substage shearing events (mylonitization) under ductile conditions inside the crystalline blocks in relatively deeper levels; and the second stage had brittle faulting and brecciation along the boundaries between the host serpentinite bodies in relatively shallower levels (zeolite facies). The first deformation occurred during uplift before emplacement. The blocks were intensively sheared by the first deformation event, and developed numerous shear planes with spacing of a few centimeters. The displacement and width of each shear plane were a few centimeters and a few millimeters, respectively, at most. In contrast, the fault zone of the second shearing stage reached a few meters in width and developed during emplacement of the Mineoka Ophiolite. Both stages occurred under a right-lateral transpressional regime, in which thrust-faulting was associated with strike-slip faulting. Such displacement on an outcrop scale is consistent with the present tectonics of the Mineoka Belt. This implies that the same tectonic stress has been operating in the Boso trench–trench–trench-type triple junction area in the northwest corner of the Pacific since the emplacement of the Mineoka Ophiolite. The Mineoka Ophiolite Belt must have worked as a forearc sliver fault during the formation of a Neogene accretionary prism further south.     

Viscosity of peridotite liquid up to 13 GPa: Implications for magma ocean viscosities

The viscosity of synthetic peridotite liquid has been investigated at high pressures using in-situ falling sphere viscometry by combining a multi-anvil technique with synchrotron radiation. We used a newly designed capsule containing a small recessed reservoir outside of the hot spot of the heater, in which a viscosity marker sphere is embedded in a forsterite + enstatite mixture having a higher solidus temperature than the peridotite. This experimental setup prevents spheres from falling before a stable temperature above the liquidus is established and thus avoids difficulties in evaluating viscosities from velocities of spheres falling through a partially molten sample.

Experiments have been performed between 2.8 and 13 GPa at temperatures ranging from 2043 to 2523 K. Measured viscosities range from 0.019 (± 0.004) to 0.13 (± 0.02) Pa s. At constant temperature, viscosity increases with increasing pressure up to  8.5 GPa but then decreases between  8.5 and 13 GPa. The change in the pressure dependence of viscosity is likely associated with structural changes of the liquid that occur upon compression. By combining our results with recently published 0.1 MPa peridotite liquid viscosities [D.B. Dingwell, C. Courtial, D. Giordano, A. Nichols, Viscosity of peridotite liquid, Earth Planet. Sci. Lett. 226 (2004) 127–138.], the experimental data can be described by a non-Arrhenian, empirical Vogel-Fulcher-Tamman equation, which has been modified by adding a term to account for the observed pressure dependence of viscosity. This equation reproduces measured viscosities to within 0.08 log₁₀-units on average. We use this model to calculate viscosities of a peridotitic magma ocean along a liquid adiabat to a depth of  400 km and discuss possible effects on viscosity at greater pressures and temperatures than experimentally investigated.     

A New Retracking Technique for Brown Peaky Altimetric Waveforms

A new Brown-Peaky (BP) retracker has been developed for peaky waveforms that usually appear within ～10 km to the coastline. The main feature of the BP is that it fits peaky waveforms using the Brown model without introducing a peak function. The retracking strategy first detects the peak location and width of a waveform using an adaptive peak detection method, and then estimates retracking parameters using a weighted least squares (WLS) estimator. The WLS assigns a downsized weight to corrupted waveform gates, but an equal weight to other normal waveform gates. The BP retracker has been applied to 4-year Jason-1 waveform (2002–2006) in two Australian coastal zones. The results retracked by BP, MLE4 and ALES retrackers have been validated against tide-gauge observations located at Burnie, Lorne and Broome. The comparison results show that three retrackers have similar performance over open oceans with the correlation coefficient (～0.7) and RMSE (～13 cm) between altimetric and tide-gauge sea levels for distance >7 km offshore. The main improvement of BP retracker occurs for distance ≤7 km to the coastline, where validation results indicate that data retracked by BP are more accurate (15–21 cm) than those by ALES (16–24 cm) and MLE4 (19–37 cm).     

卫星测高不同波形重构方法的偏差特性分析

利用我国近海4条轨迹、40个周期EnviSat-1的卫星测高波形数据,采用OCOG、Threshold、5-β参数算法以及Ocean法进行波形重构计算。根据不同轨迹和周期的波形数据,由上述四种方法重构海面高并计算相互之间的偏差及其中误差。结果表明,OCOG、Threshold、5-β参数算法与Ocean方法之间的偏差分别为88.46cm、35.90cm和25.83cm,相应的中误差分别为2.11cm、1.96cm和0.41cm,而且该偏差量对于不同的轨迹和周期是不变的。因此,只要对系统偏差进行改正,就能融合不同波形重构方法求得海面高,充分发挥不同波形重构方法在不同海区的优势,为近岸海域海平面变化,大地水准面的研究提供高精度的资料。     

A new preparation process of coal-based magnetically activated carbon

Fe/C-based magnetically activated carbon （MAC） was obtained by carbonizing and activating its precursor, that was prepared by co-precipitation of anthracite coal impregnated in ferric chloride solution. The effect of the concentrations of FeC13 and pH of solution on BET surface area, pore volume and magnetic properties of the MAC was studied by BET N2 adsorption and VSM method. The results indicated that the magnetization of MAC gradually increases with increasing concentration of FeC13 and pH value of solution, and BET surface area was inclined to fluctuation. The largest BET surface area and magnetization of MAC were 1327.5 m2/g and 35.56 emu/g, respec- tively. The form of magnetic matter in the magnetically activated carbon was mainly Fe3C by X-ray powder diffrac- tion （XRD） and magnetic attraction test.     

New interpretation of the Franciscan mélange at San Simeon coast,California: tectonic intrusion into an accretionary prism

Many concepts and interpretations on the formation of the Franciscan mélange have been proposed on the basis of exposures at San Simeon, California. In this paper, we show the distribution of chaotic rocks, their internal structures and textures, and the interrelationship between the chaotic rocks and the surrounding sandstones (turbidites). Mélange components, particularly blueschists, oceanic rocks, including greenstone, pillow lava, bedded chert, limestone, sandstone, and conglomerate, have all been brecciated by retrograde deformation. The Cambria Slab, long interpreted as a trench slope basin, is also strongly deformed by fluidization, brecciation, isoclinal folding, and thrusting, leading us to a new interpretation that turbiditic rocks (including the Cambria Slab) represent trench deposits rather than slope basin sediments. These rocks form an accretionary prism above mélanges that were diapirically emplaced into these rocks first along sinistral-thrust faults, and then along dextral-normal faults. Riedel shear systems are observed in several orders of scale in both stages. Although the exhumation of the blueschist blocks is still controversial, the common extensional fractures and brecciation in most of the blocks in the mélanges and further mixture of various lithologies into one block with mélange muddy matrix indicate that once deeply buried blocks were exhumed from considerable depths to the accretionary prism body, before being diapirically intruded with their host mélange along thrust and normal faults, during which retrograde deformation occurred together with retrograde metamorphism. Recent similar examples of high-pressure rock exhumation have been documented along the Sofugan Tectonic Line in the Izu forearc areas, in the Mineoka belt in the Boso Peninsula, and as part of accretionary prism development in the Nankai and Sagami troughs of Japan. These modern analogues provide actively forming examples of the lithological and deformational features that characterize the Franciscan mélange processes.     

Street-scale storm surge load impact assessment using fine-resolution numerical modelling: a case study from Nemuro,Japan

Natural Hazards - Due to gradual sea level rise and changes in the climate system, coastal vulnerability to storm surge hazards is expected to increase in some areas. Studies regarding the effect...     

The Kellwasser events in the Upper Devonian Frasnian to Famennian transition in the Toc Tat Formation,northern Vietnam

Upper Devonian carbonates of the Toc Tat Formation in the Si Phai Pass area of Dong Van District, northern Vietnam were deposited in carbonate platform, slope, and basin environments. These carbonates yield abundant conodonts indicative of the Palmatolepis nasuta, Pa. linguiformis and Pa. triangularis zones, the Frasnian–Famennian stage boundary being identified by the first occurrence of Pa. triangularis. Two positive carbon isotope excursions are recognized, the lower excursion peaking in the interval of the lower to middle Pa. nasuta Zone, whilst the upper excursion peaks just above the local Frasnian–Famennian boundary. Based on the biostratigraphy, these excursions equate to the Lower and Upper Kellwasser events. Locally, tentaculitoid taxa (Nowakia, Styliolina, Homoctenus, and Metastyliolina?) are abundant in the interval of the Pa. nasuta Zone, but show a drastic decline in abundance before the Lower Kellwasser Event, and only two taxa survived into the Famennian.