Correction to: Flood hazard assessment and mapping of River Swat using HEC-RAS 2D model and high-resolution 12-m TanDEM-X DEM (WorldDEM)

Natural Hazards - The original article was updated and corrected due to numbering errors in Figure 8’s subfigures and the placement of some of the article’s other figures. Additional...     

Sheet flow and suspension of sand in oscillatory boundary layers

after revisionTime-dependent measurements of flow velocities and sediment concentrations were conducted in a large oscillating water tunnel. The measurements were aimed at the flow and sediment dynamics in and above an oscillatory boundary layer in plane bed and sheet-flow conditions. Two asymmetric waves and one sinusoidal wave were imposed using quartz sand with D₅₀ = 0.21 mm. A new electro-resistance probe with a large resolving power was developed for the measurement of the large sediment concentrations in the sheet-flow layer. The measurements revealed a three layer transport system consisting of a pick-up/deposition layer, an upper sheet flow layer and a suspension layer.In the asymmetric wave cases the total net transport was directed “onshore” and was mainly concentrated in the thin sheet flow layer (< 0.5 cm) at the bed. A small net sediment flux was directed “offhore” in the upper suspension layer. The measured flow velocities, sediment concentrations and sedimenl fluxes showed a good qualitative agreement with the results of a (numerical) 1DV boundary-layer flow and transport model. Although the model did not describe all the observed processes in the sheet-flow and suspension layer, the computational results showed a reasonable agreement with measured net transport rates in a wide range of asymmetric wave conditions.     

Performance of hemi-cylindrical and rectangular submerged breakwaters

A parametric experimental study is conducted to compare the reflection and transmission characteristics of submerged hemi-cylindrical and rectangular rigid and water-filled flexible breakwater models. The results show that, for the rigid breakwaters, rectangular models are more effective than hemi-cylindrical ones in terms of reduction of transmitted waves. As for the flexible breakwaters, the hemi-cylindrical models may give better wave reflection than rectangular ones. However, the energy loss induced by the rectangular breakwaters is much larger and more significant to result in an overall better efficiency in terms of reduction in wave transmission. The effects of internal pressure show that the lowest pressurized flexible models considered in this work are the most effective in the reduction of the transmitted wave height. Higher wave reflection, lower wave transmission and higher energy loss are obtained consistently at the lower submergence depth ratio.     

Hydrogeologic assessment of escalating groundwater exploitation in the Indus Basin, Pakistan

Groundwater development has contributed significantly to food security and reduction in poverty in Pakistan. Due to rapid population growth there has been a dramatic increase in the intensity of groundwater exploitation leading to declining water tables and deteriorating groundwater quality. In such prevailing conditions, the hydrogeological appraisal of escalating groundwater exploitation has become of paramount importance. Keeping this in view, a surface water–groundwater quantity and quality model was developed to assess future groundwater trends in the Rechna Doab (RD), a sub-catchment of the Indus River Basin. Scenario analysis shows that if dry conditions persist, there will be an overall decline in groundwater levels of around 10 m for the whole of RD during the next 25 years. The lower parts of RD with limited surface water supplies will undergo the highest decline in groundwater levels (10 to 20 m), which will make groundwater pumping very expensive for farmers. There is a high risk of groundwater salinization due to vertical upconing and lateral movement of highly saline groundwater into the fresh shallow aquifers in the upper parts of RD. If groundwater pumping is allowed to increase at the current rate, there will be an overall decline in groundwater salinity for the lower and middle parts of RD because of enhanced river leakage.     

Evaluation of three waterborne polymers as stabilizers for sandy soil

This study reports on waterborne polymer emulsion systems that were used for structural modification of sandy soils. The first emulsion used was a styrene-acrylic, copolymer emulsion; the second and third were vinyl-acrylic, copolymer-based emulsions. Specimens were prepared by adding different polymer emulsions to the sand and water in prescribed amounts. The performance of the different emulsion systems as sand stabilizers was estimated through measurement of the hydraulic conductivity and compressive strength. Measurements of hydraulic conductivity were conducted in a flexible membrane test apparatus. The hydraulic conductivity for the three emulsions decreased at different rates, with an increase in polymer content up to 3 wt. (i.e., % by weight). Additional increase of polymer content did not introduce significant decrease in hydraulic conductivity, and, at 5 wt.%, the three emulsions had essentially the same effect. Measurements made on dry cylindrical specimens disclosed remarkable enhancement in the mechanical behavior of the system. The compressive strength and modulus of elasticity of the examined emulsions increased with a higher concentration of polymer. Scanning electron microscope (SEM) revealed that the reduction in the permeability and the improved mechanical properties can be attributed to three dominant structural changes: the development of interconnecting ties between the sand particles, the development of adhesion between neighboring sand particles in contact, and the covering of the sand particles with a thin polymer film.     

Evidence of early generation of liquid hydrocarbon from suberinite as visible under the microscope

The early generation of liquid hydrocarbons from suberinite can be clearly observed under the microscope. The generation of this oil-like material, mainly in the form of exsudatinite, from the maceral suberinite occurs at a maturity level of about 0.4% vitrinite reflectance. Hydrocarbons appear to be naturally expelled from coal initially through sweating and agglomeration of suberinite which subsequently forms exsudatinite. It is suggested that extensive expulsion of exsudatinite causes cracks to develop in vitrinite whereas limited expulsion of exsudatinite will only impregnate the vitrinite matrix. If cracks are formed, it is possible they could progressively develop to form an exsudatinite-crack network. The formation of such a network is believed to represent an effective way of hydrocarbon expulsion from coal source rocks.     

A new magnitude category disaggregation approach for temporal high‐resolution rainfall intensities

Simulation of quick runoff components such as surface runoff and associated soil erosion requires temporal high‐resolution rainfall intensities. However, these data are often not available because such measurements are costly and time consuming. Current rainfall disaggregation methods have shortcomings, especially in generating the distribution of storm events. The objectives of this study were to improve point rainfall disaggregation using a new magnitude category rainfall disaggregation approach. The procedure is introduced using a coupled disaggregation approach (Hyetos and cascade) for multisite rainfall disaggregation. The new procedure was tested with ten long‐term precipitation data sets of central Germany using summer and winter precipitation to determine seasonal variability. Results showed that dividing the rainfall amount into four daily rainfall magnitude categories (1–10, 11–25, 26–50, >50 mm) improves the simulation of high rainfall intensity (convective rainfall). The Hyetos model category approach (Hyetos_Cat) with seasonal variation performs representative to observed hourly rainfall compared with without categories on each month. The mean absolute percentage accuracy of standard deviation for hourly rainfall is 89.7% in winter and 95.6% in summer. The proposed magnitude category method applied with the coupled Hyetos_Cat–cascade approach reproduces successfully the statistical behaviour of local 10‐min rainfall intensities in terms of intermittency as well as variability. The root mean square error performance statistics for disaggregated 10‐min rainfall depth ranges from 0.20 to 2.38 mm for summer and from 0.12 to 2.82 mm for the winter season in all categories. The coupled stochastic approach preserves the statistical self‐similarity and intermittency at each magnitude category with a relatively low computational burden. Copyright © 2014 John Wiley & Sons, Ltd.     

Middle Paleolithic occupation on a Marine Isotope Stage 5 lakeshore in the Nefud Desert,Saudi Arabia

Major hydrological variations associated with glacial and interglacial climates in North Africa and the Levant have been related to Middle Paleolithic occupations and dispersals, but suitable archaeological sites to explore such relationships are rare on the Arabian Peninsula. Here we report the discovery of Middle Paleolithic assemblages in the Nefud Desert of northern Arabia associated with stratified deposits dated to 75,000 years ago. The site is located in close proximity to a substantial relict lake and indicates that Middle Paleolithic hominins penetrated deeply into the Arabian Peninsula to inhabit landscapes vegetated by grasses and some trees. Our discovery supports the hypothesis of range expansion by Middle Paleolithic populations into Arabia during the final humid phase of Marine Isotope Stage 5, when environmental conditions were still favorable.