Study of the flood control scheduling scheme for the Three Gorges Reservoir in a catastrophic flood

The Three Gorges Project is the world's largest water conservancy project. According to the design standards for the 1,000‐year flood, flood diversion areas in the Jingjiang reach of the Yangtze River must be utilized to ensure the safety of the Jingjiang area and the city of Wuhan. However, once these areas are used, the economic and life loss in these areas may be very great. Therefore, it is vital to reduce this loss by developing a scheme that reduces the use of the flood diversion areas through flood regulation by the Three Gorges Reservoir (TGR), under the premise of ensuring the safety of the Three Gorges Dam. For a 1,000‐year flood on the basis of a highly destructive flood in 1954, this paper evaluates scheduling schemes in which flood diversion areas are or are not used. The schemes are simulated based on 2.5‐m resolution reservoir topography and an optimized model of dynamic capacity flood regulation. The simulation results show the following. (a) In accord with the normal flood‐control regulation discharge, the maximum water level above the dam should be not more than 175 m, which ensures the safety of the dam and reservoir area. However, it is necessary to utilize the flood diversion areas within the Jingjiang area, and flood discharge can reach 2.81 billion m³. (b) In the case of relying on the TGR to impound floodwaters independently rather than using the flood diversion areas, the maximum water level above the dam reaches 177.35 m, which is less than the flood check level of 180.4 m to ensure the safety of the Three Gorges Dam. The average increase of the TGR water level in the Chongqing area is not more than 0.11 m, which indicates no significant effect on the upstream reservoir area. Comparing the various scheduling schemes, when the flood diversion areas are not used, it is believed that the TGR can execute safe flood control for a 1,000‐year flood, thereby greatly reducing flood damage.     

天气雷达数据处理系统人控应用软件

天气雷达用于抗灾和减灾很重要,本文提出一种人工降雨和驱冰雹软件,给出了程序流图,对编程的关键进行了分析,最后结果表明它能提高人控作业效率。     

蜕壳素对凡纳滨对虾生长及表观消化率的影响

研究了外源性蜕皮激素对凡纳滨对虾生长和表观消化率的影响 ,实验时在基础饲料中分别添加 0 .1%、0 .2 %、0 .4 %的两种市售蜕壳素产品 ,制成 6种外源性脱壳素配合饲料 ,不添加的基础饲料作为对照组 ,试验在 2 6 0L玻璃钢循环水养殖系统中 ,每个剂量组设 3个重复 ,8周生长试验结果表明 :市售蜕壳素产品能有效地促进对虾生长 ,试验结束时 ,试验组虾体增重分别较对照组增加 16 .8%、7.5 2 %、5 .9%、11.4 %、2 9.0 7%、16 .5 3% ,但是凡纳滨对虾对饲料粗蛋白的表观消化率没有明显地提高 ,凡纳滨对虾对脂肪的表观消化率较低。推算凡纳滨对虾饲料中最佳蜕皮酮添加量为 6 0mg/kg。     

基于ARP协议的网络主机地址的识别技术研究

从移动IPv6工作原理入手，IP地址管理器是针对越来越严重的IP地址盗用现象而设计的一套有效的监控和管理IP地址的方案。分析与研究IP地址管理器中的信息收集模块后，以Winpcap为开发工具，利用ARP，附等协议完成对网络中活动主机的扫描以及信息（主机名、MAC、操作系统）的收集和识别。模块实现了对网络的自动实时监控，有效地提高了管理效率。     

CPLD技术及其在现代时统中的应用

对CPLD(复杂可编程逻辑器件)技术的基本特征和发展趋势作了简要介绍,揭示了该技术在现代数字系统中的重要地位及作用.利用CPLD对时统设备IRIG-B码产生器进行集成,其实验结果表明,集成了的B码产生器不但简单、可靠,而且便于调试,克服了以往硬件电路复杂的缺点.     

CCD联合平差方法及其初步实例检验

在常规照相天体测量工作中 ,对暗天体的定位是采用逐级定标星过渡的方法实现的。由于星表系统差和局部差的存在 ,最终定位结果可能包含难以把握的误差积累。在CCD小视场观测情况下时常难以找到足够数量的定标星。鉴于此 ,推导了CCD观测联合平差方法的严格矢量表达式 ,以期通过共同星的过渡 ,实现大天区统一平差。原理上此方法可实现相对于河外天体的定位 ,以削弱星表系统差和局部差对定位结果的影响。讨论了CCD联合平差方法实现中的问题 ,包括底片常数模型选择、切点位置改正、共同星的较差改正和法方程解算方法等 ,并分析了具体的处理措施。用实例初步检验了CCD联合平差方法的效果 ,表明通过对多张CCD观测的联合平差 ,可以削弱单张CCD观测参考星数目过少、单张CCD观测参考星分布不均、个别参考星存在位置偏差和局部区域参考星存在系统性位置偏差等不利因素对归算结果的影响 ,进而达到扩大视场和提高归算精度的目的     

2种亚洲龙鱼的D-Loop序列结构分析

采用PCR技术对2种亚洲龙鱼的mtDNAD_Loop全序列进行扩增和测序,序列结构分析和序列同源性比对结果表明,2种亚洲龙鱼的mtDNAD_Loop在靠近5’端有3个终止相关序列TAS(Ⅰ、Ⅱ、Ⅲ),靠近D_Loop的3’端有4个保守区域CSB1、CSB2、CSB3、CSB-D。在终止相关序列和保守区域之间是连续重复区域。经DNASP4.0软件分析,全序列中检测出多态位点数(S)为26,其中有17个转换,核苷酸多样性(Pi)为0.013,平均核苷酸差异数(K)为17.333。     

企鹅珍珠贝人工苗生长的初步观察

为了解企鹅珍珠贝生长规律，观察了壳高2.5～5.0mm的出池幼苗，按月测量其生长参数和成活率，以及环境因子。结果表明，企鹅珍珠贝生长最快的月份为7～11月和次年4～6月，壳长，壳高和壳宽月均增加量分别为3.8～13.0mm、4.7～11.2mm、2.3～3.8mm，月成活率97.8%～98.6%。企鹅珍珠贝生长最慢月份是11月至次年3月。     

激变食变星PG0027+260的CCD光变曲线

我们于1989年11月30日晚对PG0027+260进行了时间分辨率为108秒的高速CCD测光,得到了一条完整的光变曲线,从而确认其为激变食变星系统,轨道周期0.146~d     

Numerical prediction of blast‐induced stress wave from large‐scale underground explosion

This paper presents a numerical model for predicting the dynamic response of rock mass subjected to large‐scale underground explosion. The model is calibrated against data obtained from large‐scale field tests. The Hugoniot equation of state for rock mass is adopted to calculate the pressure as a function of mass density. A piecewise linear Drucker–Prager strength criterion including the strain rate effect is employed to model the rock mass behaviour subjected to blast loading. A double scalar damage model accounting for both the compression and tension damage is introduced to simulate the damage zone around the charge chamber caused by blast loading. The model is incorporated into Autodyn3D through its user subroutines. The numerical model is then used to predict the dynamic response of rock mass, in terms of the peak particle velocity (PPV) and peak particle acceleration (PPA) attenuation laws, the damage zone, the particle velocity time histories and their frequency contents for large‐scale underground explosion tests. The computed results are found in good agreement with the field measured data; hence, the proposed model is proven to be adequate for simulating the dynamic response of rock mass subjected to large‐scale underground explosion. Extended numerical analyses indicate that, apart from the charge loading density, the stress wave intensity is also affected, but to a lesser extent, by the charge weight and the charge chamber geometry for large‐scale underground explosions. Copyright © 2004 John Wiley & Sons, Ltd.