Searching for Planetary Eclipses in Open Clusters: NGC 7086

In an attempt to discover planetary eclipses, we observed the open cluster NGC 7086. On one night we observed the cluster and standard stars through the B and V filters, enabling us to make a colour-magnitude diagram. Plots of the differential magnitudes were inspected for variability, but no planetary eclipses were found. New variable stars were discovered and their light curves show some of them to be eclipsing binary stars. The location on the colour-magnitude diagram of some of the variable stars is consistent with cluster membership.     

The use of principle component analyses in characterising trace and major elemental distribution in a 55 kyr peat deposit in tropical Australia: Implications to paleoclimate

The Lynch’s Crater peat deposit in NE-Australia is a sensitive environmental archive located in the tropical Southern Hemisphere. This unique deposit illustrates that local and regional changes had a profound effect on the local Australian ecosystem over the past 55 kyr. To obtain a proxy of past climate changes, trace and major element geochemistry analyses were applied to a 13 m peat core from the crater. Principle component analysis (PCA) was used to identify the main factors that control elemental distribution in the peat and to add interpretative strength to the geochemical behavior of selected major and trace elements. For example, Sc, Al, Cu, and Pb were found to be related to increased erosion of the basin soils, and from this, several periods of significant flux from atmospheric input and/or terrigenous run-off were identified. Geochemically mobile elements during rock weathering and pedogenesis, such as Mg, Ca, and Sr helped to identify the peat ombrotrophic-minerotrophic boundary at ∼1.5 m depth and offered important information about fluxes of these nutrients to the mire and their dynamics within the deposit. Arsenic and V comparisons between the peat record (high concentrations in some peat sections) and in local basin rocks (very low concentrations), suggested the presence of a long range, atmospheric dust source early in the formation of the mire. The Lynch’s Crater peat record presents a continuous record of environmental change in tropical Australia and contributes new understanding to geochemical processes in peatlands.     

Site Investigation for the Effects of Vegetation on Ground Stability

The procedure for geotechnical site investigation is well established but little attention is currently given to investigating the potential of vegetation to assist with ground stability. This paper describes how routine investigation procedures may be adapted to consider the effects of the vegetation. It is recommended that the major part of the vegetation investigation is carried out, at relatively low cost, during the preliminary (desk) study phase of the investigation when there is maximum flexibility to take account of findings in the proposed design and construction. The techniques available for investigation of the effects of vegetation are reviewed and references provided for further consideration. As for general geotechnical investigation work, it is important that a balance of effort is maintained in the vegetation investigation between (a) site characterisation (defining and identifying the existing and proposed vegetation to suit the site and ground conditions), (b) testing (in-situ and laboratory testing of the vegetation and root systems to provide design parameters) and (c) modelling (to analyse the vegetation effects).     

Quality Assessment Of Digital Surface Models Generated From IKONOS Imagery

The growing applications of digital surface models (DSMs) for object detection, segmentation and representation of terrestrial landscapes have provided impetus for further automation of 3D spatial information extraction processes. While new technologies such as lidar are available for almost instant DSM generation, the use of stereoscopic high-resolution satellite imagery (HRSI), coupled with image matching, affords cost-effective measurement of surface topography over large coverage areas. This investigation explores the potential of IKONOS Geo stereo imagery for producing DSMs using an alternative sensor orientation model, namely bias-corrected rational polynomial coefficients (RPCs), and a hybrid image-matching algorithm. To serve both as a reference surface and a basis for comparison, a lidar DSM was employed in the Hobart testfield, a region of differing terrain types and slope. In order to take topographic variation within the modelled surface into account, the lidar strip was divided into separate sub-areas representing differing land cover types. It is shown that over topographically diverse areas, heighting accuracy to better than 3 pixels can be readily achieved. Results improve markedly in feature-rich open and relatively flat terrain, with sub-pixel accuracy being achieved at check points surveyed using the global positioning system (GPS). This assessment demonstrates that the outlook for DSM generation from HRSI is very promising.     

A millennial-scale record of Holocene tsunamis on the Kronotskiy Bay coast, Kamchatka, Russia

Deposits from as many as 50 large tsunamis during the last 7000 years are preserved on the Pacific coast of the Kamchatka Peninsula near the mouth of the Zhupanova River, southern Kronotskiy Bay. These deposits are dated and correlated using Holocene marker tephra layers. The combined, preserved record of tsunami deposits and of numerous marker tephras on Kamchatka offers an unprecedented opportunity to study tsunami frequency. For example, from the stratigraphy along southern Kronotskiy Bay, we estimate frequency of large tsunamis (>5 m runup). In the last 3000 years, the minimum frequency is about one large tsunami per 100 years, and the maximum about one large tsunami per 30 years; the latter frequency occurred from about 0 to 1000 A.D. This time interval corresponds to a period of increased seismicity and volcanic activity that appears to be recorded in many places on the Kamchatka Peninsula.     

Numerical simulation of the response of a reinforced wall to a high speed train passage

The dynamic response of a mechanically stabilized earth wall to the passing of a high‐speed train is modelled using the finite element method. A three‐dimensional analysis is carried out, using a specific framework that allows performing the analysis with a moderate computational effort. In the first place, a so‐called multiphase approach is used to take into account the reinforcing strips. The moving load is taken into account by performing the calculation in a mobile referential using the properties of symmetry of the train cars and a simplifying assumption of periodicity for the whole train. We also assume a steady state. A partial validation of the approach is obtained by means of a comparison with an analytical solution. The quick increase in displacements induced by the train passing when the speed comes close to the celerity of Rayleigh waves clearly appears in the results. The vertical displacements, vertical stresses in the backfill, tensile forces in the strips and the influence of the stiffness of the soil are discussed. Copyright © 2017 John Wiley & Sons, Ltd.     

Upright crinoids of the Thornton Reef,Wenlock (Silurian) of Illinois,USA

The rare preservation of columns perpendicular to bedding may provide convincing evidence that ancient crinoids adopted an upright attitude during life. However, taphonomic and sedimentological analyses are important in determining whether such occurrences are truly in situ or represent unusual allochthonous accumulations. The Crinoid Biosome of the Thornton Reef Complex, Silurian of Illinois, USA, includes pluricolumnals preserved perpendicular to bedding, in association with more common specimens parallel or angled to bedding. Upright pluricolumnals are relatively shorter (<150 mm) than the longest non-upright specimens; they sometimes occur as imbricate accumulations and lack attachment structures (although these are preserved separately). Brachiopod valves and colonial corals may also be preserved perpendicular to bedding. These features suggest that the Thornton beds were formed as viscous mass flow deposits and that the upright crinoid columns are allochthonous or, at best, parautochthonous. © 1996 John Wiley & Sons, Ltd.     

Finite element analysis of the effect of corrosion on the behavior of reinforced earth walls

A simple model for the corrosion‐induced loss of stiffness and strength of the steel strips of earth‐reinforced walls was introduced in a finite element simulation of the long‐term behavior of the wall, in which the backfill‐strips interactions are taken into account by means of a generalized homogenization procedure (called a multiphase model). The results show an initial phase of slow displacements induced by the loss of stiffness, followed after a few decades by a steep acceleration of the displacements, leading to wall failure. The influences of the parameter controlling corrosion, the backfill cohesion and the heterogeneity of the corrosion process are discussed. Results are used to discuss a strategy for reinforced earth wall surveillance. Copyright © 2011 John Wiley & Sons, Ltd.     

Historic Landscape Reconstruction and Visualisation, West Oxfordshire, England

As part of the Wychwood Project in West Oxfordshire, England, aerial photography and historic maps are being used to reconstruct landscape change in the former medieval Royal Hunting Forest of Wychwood. An important objective of the project is to stimulate local interest in Wychwood and promote understanding of its evolution, thereby encouraging the support of stakeholders in the design of future landscapes. The parish of Leafield was selected to develop and test a method for reconstructing and visualising past and present landscapes to present to the public for evaluation and comparison. Leafield contains fine examples of both early and late enclosure landscapes and underwent large-scale disafforestation following the Enclosure Act of 1856. Ordnance Survey (O.S.) 1:10000 Landform Panorama contour data were used to create a digital elevation model (DEM) of the parish using ArcView 3D Analyst, enabling the user to create perspective views of the landscape from any height and viewing angle. Contemporary aerial photography was scanned and geo-rectified to create an overlay for 'draping' onto the DEM. Historical maps provided the reference for modifying the aerial photography using the PaintShop Pro graphics package. This paper presents and reviews the results and compares the method with other techniques, including VRML.     

Geologic Setting, Field Survey and Modeling of the Chimbote, Northern Peru, Tsunami of 21 February 1996

—Whereas the coast of Peru south of 10°S is historically accustomed to tsunamigenic earthquakes, the subduction zone north of 10°S has been relatively quiet. On 21 February 1996 at 21:51 GMT (07:51 local time) a large, tsunamigenic earthquake (Harvard estimate M _w = 7.5) struck at 9.6°S, 79.6°W, approximately 130 km off the northern coast of Peru, north of the intersection of the Mendaña fracture zone with the Peru–Chile trench. The likely mechanism inferred from seismic data is a low-angle thrust consistent with subduction of the Nazca Plate beneath the South American plate, with relatively slow rupture characteristics. Approximately one hour after the main shock, a damaging tsunami reached the Peruvian coast, resulting in twelve deaths. We report survey measurements, from 7.7°S to 11°S, on maximum runup (2–5m, between 8 and 10°S), maximum inundation distances, which exceeded 500 m, and tsunami sediment deposition patterns. Observations and numerical simulations show that the hydrodynamic characteristics of this event resemble those of the 1992 Nicaragua tsunami. Differences in climate, vegetation and population make these two tsunamis seem more different than they were. This 1996 Chimbote event was the first large (M _w >7) subduction-zone (interplate) earthquake between about 8 and 10°S, in Peru, since the 17th century, and bears resemblance to the 1960 (M _w 7.6) event at 6.8°S. Together these two events are apparently the only large subduction-zone earthquakes in northern Peru since 1619 (est. latitude 8°S, est. M _w 7.8); these two tsunamis also each produced more fatalities than any other tsunami in Peru since the 18th century. We concur with Pelayo and Wiens (1990, 1992) that this subduction zone, in northern Peru, resembles others where the subduction zone is only weakly coupled, and convergence is largely aseismic. Subduction-zone earthquakes, when they occur, are slow, commonly shallow, and originate far from shore (near the tip of the wedge). Thus they are weakly felt, and the ensuing tsunamis are unanticipated by local populations. Although perhaps a borderline case, the Chimbote tsunami clearly is another wake-up example of a "tsunami earthquake."