Numerical simulation of comet nuclei I. Water-ice comets

A one-dimensional simulation of pure water-ice cometary nuclei is presented, and the effect of the nucleus as a heat reservoir is considered. The phase transition from amorphous to crystalline ice is studied for two cases: (1) where the released latent heat goes entirely into heating adjacent layers and (2) where the released latent heat goes entirely into sublimation. For a Halley-like orbit it was found that for case 1 the phase boundary penetrates about 15 m on the first orbit and does not advance until sublimation brings the surface to some 10 m from the phase boundary. For case 2 the phase boundary penetrates about 1 m below the surface and remains at this depth as the surface sublimates. For an orbit like that of Schwassmann-Wachmann 1 the phase boundary penetrates about 50 m initially for case 1 and about 1 m for case 2. There is no further transformation until the entire comet is heated slowly to near the transition temperature, after which the entire nucleus is converted to crystalline ice. For an Encke-type orbit case 1 gives a nearly continuous transition of the entire nucleus to crystalline ice, while for case 2 the initial penetration is about 8 m and remains at this depth relative to the surface as sublimation decreases the cometary radius. Thus the entire comet is converted to crystalline ice just before it is completely dissipated.     

Elastic solutions for stresses in a transversely isotropic half‐space subjected to three‐dimensional buried parabolic rectangular loads

In many areas of engineering practice, applied loads are not uniformly distributed but often concentrated towards the centre of a foundation. Thus, loads are more realistically depicted as distributed as linearly varying or as parabola of revolution. Solutions for stresses in a transversely isotropic half‐space caused by concave and convex parabolic loads that act on a rectangle have not been derived. This work proposes analytical solutions for stresses in a transversely isotropic half‐space, induced by three‐dimensional, buried, linearly varying/uniform/parabolic rectangular loads. Load types include an upwardly and a downwardly linearly varying load, a uniform load, a concave and a convex parabolic load, all distributed over a rectangular area. These solutions are obtained by integrating the point load solutions in a Cartesian co‐ordinate system for a transversely isotropic half‐space. The buried depth, the dimensions of the loaded area, the type and degree of material anisotropy and the loading type for transversely isotropic half‐spaces influence the proposed solutions. An illustrative example is presented to elucidate the effect of the dimensions of the loaded area, the type and degree of rock anisotropy, and the type of loading on the vertical stress in the isotropic/transversely isotropic rocks subjected to a linearly varying/uniform/parabolic rectangular load. Copyright © 2002 John Wiley & Sons, Ltd.     

Modeling X-Ray Photoionized Plasmas Produced at the Sandia Z-Facility

In experiments at the high-power Z-facility at Sandia National Laboratory in Albuquerque, New Mexico, we have been able to produce a low density photoionized laboratory plasma of Fe mixed with NaF. The conditions in the experiment allow a meaningful comparison with X-ray emission from astrophysical sources. The charge state distributions of Fe, Na and F are determined in this plasma using high resolution X-ray spectroscopy. Independent measurements of the density and radiation flux indicate unprecedented values for the ionization parameter ξ = 20–25 erg cm s⁻¹ under nearly steady-state conditions. First comparisons of the measured charge state distributions with X-ray photoionization models show reasonable agreement, although many questions remain.     

North European last glacial–interglacial transition (LGIT; 15–9 ka) tephrochronology: extended limits and new events

High‐precision correlation of palaeoclimatic and palaeoenvironmental records is crucial for testing hypotheses of synchronous change. Although radiocarbon is the traditional method for dating late Quaternary sedimentary sequences, particularly during the last glacial–interglacial transition (LGIT; 15–9 ka), there are inherent problems with the method, particularly during periods of climate change which are often accompanied by major perturbations in atmospheric radiocarbon content. An alternative method is the use of tephras that act as time‐parallel marker horizons. Within Europe, numerous volcanic centres are known to have erupted during the LGIT, providing considerable potential for high‐precision correlation independent of past radiocarbon fluctuations. Here we report the first identification of the Vedde Ash and Askja Tephra in Ireland, significantly extending the known provenance of these events. We have also identified two new horizons (the Roddans Port Tephras A and B) and tentatively recognise an additional horizon from Vallensgård Mose (Denmark) that provide crucial additional chronological control for the LGIT. Two phases of the Laacher See Tephra (LST) are reported, the lower Laacher See Tephra (LLST) and probably the C2 phase of the Middle Laacher See Tephra (MLST‐C2) indicating a more northeasterly distribution of this fan than reported previously. Copyright © 2006 John Wiley & Sons, Ltd.     

Evaluation of ferrous and ferric Mössbauer fractions

The Mössbauer fractions f for various ferrous- and/or ferric-containing oxides and oxyhydroxides, silicates and carbonates were evaluated from the experimental temperature dependence of their center shifts, using the Debye approximation for the second-order Doppler shift. It is concluded that ferrous ions exhibit a lower fraction as compared to ferric ions. Using standard mixtures of -Fe₂O₃ with selected Fe²⁺ or Fe³⁺ compounds, it is found that the calculated Fe³⁺ f values are somewhat overestimated with respect to those of Fe²⁺. Possible explanations for this shortcoming are discussed and it is suggested that a different temperature dependence of the intrinsic isomer shift is the most likely reason. This suggestion is corroborated by analyses of hematite and hedenbergite data which are available for temperatures up to 900 K and 800 K respectively.     

Sunspot nests

For the period August 1959–December 1964 the Greenwich Photoheliographic Results were searched for sunspot nests. Such a nest is a sequence of sunspot groups that appear within a small area on the solar surface and that last for several months. The search procedure is described and data for 41 probable sunspot nests are given. At least three quarters of these nests appear to be real, and not chance clusters.The nests are the same type of activity sequences as the Fleckenherde discovered by Becker (1955) and the complexes of activity pointed out by Gaizauskas et al. (1983). The complexes of activity as defined by Bumba and Howard (1965) are different patterns, however; the relation between complexes and the nests is shown.Some properties of the nests are: (i) many nests appear as double structures; (ii) single nests and components of double nests are quite compact: the effective areas are comparable to those of medium-large sunspot groups; (iii) each nest rotates at its own steady rate about the Sun; (iv) the intrinsic scatter in the rotation rates is much larger than the trend in the differential rotation; (v) displacements in latitude are less than a few meters per second; (vi) many nests live for 6 to 15 Carrington rotation periods, the minimum lifetime is not yet determined; (vii) the fraction of the sunspot groups that are members of nests is large (at least 30%).     

Accuracy of close binary mass determinations from parallaxes

Absolute masses for W Ursae Majoris and Algol-type close binaries can be determined from their parallax, if observed, and the relative sizes of the stars and their mass ratio, obtained from a light curve solution. An error propagation study compares the typical order of magnitude of the various terms involved, and shows how accurate parallaxes have to be in order to make the procedure work, i.e., making the parallax term not larger than the combined non-parallax terms, and producing reasonably low mass errors. Some comments are made on the possibilities with respect to the HIPPARCOS program.Communication presented at the International Conference on Astrometric Binaries, held on 13–15 June, 1984, at the Remeis-Sternwarte Bamberg, Germany, to commemorate the 200th anniversary of the birth of Friedrich Wilhelm Bessel (1784–1846).     

Numerical simulations of comet nuclei: II. The effect of the dust mantle

The insulating effect of an evolving dust mantle is examined. The role of this mantle in determining the surface temperature of the ice core is studied as a function of the mass fraction of the dust in the ice-dust mixture and the thermal conductivity of the nucleus. Using the so-called “looselattice” model of D.A. Mendis and G.D. Brin (1977, Moon17, 359–372) (which was also extended to include cracks and pores in the mantle), it was found that both high dust to ice ratios and high core conductivities inhibit mantle blowoff. Indeed, it is often possible to build an essentially permanent dust mantle around an ice nucleus, so that the nucleus will take on an asteroidal appearance.     

Emission features in the solar corona after the perihelion passage of Comet 1979 XI

On the coronograph spectrophotographic records taken on 31.372 UT, August 1979, some faint emission features were found which can be ascribed to Siii and Niii. These emissions were obviously a transient phenomena which were detected only 10 hr after the supposed fall of Comet 1979 XI in the Sun's photosphere. It cannot be excluded that the appearance of Si and Ni lines was triggered by the evaporation of dust particles with a high abundance of heavier elements in the solar corona. This assumption is also supported by intensity distribution of the Fex coronal line around the Sun's limb. The maximum coincide with the position angle of the projected path of the comet.