A novel time-series station in the Wadden Sea (NW Germany): First results on continuous nutrient and methane measurements

In autumn 2002 a time-series station was installed in the tidal inlet between the Islands of Langeoog and Spiekeroog (Southern North Sea, NW Germany) to continuously measure physical, chemical, and meteorological parameters, even during extreme weather conditions (gale-force storms, drifting ice). Inside the pole of the station sensor tubes are installed in direction of the prevailing tidal currents. The tubes are equipped with hydrographic sensors (pressure, temperature, conductivity) and allow retrieval of water for nutrient analysis by automated instruments located inside the pole. Dissolved methane and the nutrients ammonia, nitrite, nitrate, phosphate, and silicate are measured at the station.     

In-plane and anti-plane strong shaking of soil systems and structures

The concept of in-plane and anti-plane shaking is introduced with a rigid block on a plane surface with Coulomb friction. Using a hypoplastic constitutive relation to model the mechanical behaviour of the soil, numerical solutions for a rigid block on a thin dry or saturated soil layer are obtained. The coupled nature of dynamic problems involving granular materials is shown, i.e. the motion of the block changes the soil state—skeleton stresses and density—which in turn affects the block motion. Motions of the block as well as soil response can be more realistically calculated by the new model. The same constitutive equation is applied to the numerical simulation of the propagation of plane waves in homogeneous and layered level soil deposits induced by a wave coming from below. Experiments with a novel laminar shake box as well as real seismic records from well-documented sites during strong earthquakes are used to verify the adequacy of the hypoplasticity-based numerical model for the prediction of soil response during strong earthquakes. The response of a homogeneous earth dam subjected to in-plane and anti-plane shaking is investigated numerically. In-plane and anti-plane shaking is shown to cause nearly the same spreading of a sand dam under drained conditions, whereas under undrained conditions anti-plane shaking causes stronger spreading of the dam. The dynamic behaviour of a breakwater founded on rockfill and soft clay during the 1995 Kobe earthquake is back-calculated to show the good performance of the proposed numerical model also with a structure. Section 9 deals with buildings on mattresses of densified cohesionless soils or fine-grained soils with granular columns, slopes with ‘hidden’ dams and structures on piles traversing clayey slopes to show the suitability of hypoplasticity-based models for the earthquake-resistant design and safety assessment of geotechnical systems.     

Thermal evolution of an extensional detachment as constrained by organic metamorphic data and thermal modeling: Graz Paleozoic Nappe Complex (Eastern Alps)

Following Early Cretaceous nappe stacking, the Eastern Alps were affected by late-orogenic extension during the Late Cretaceous. In the eastern segment of this range, a Late Cretaceous detachment separates a very low- to low-grade metamorphic cover (Graz Paleozoic Nappe Complex, GPNC) above a low- to high-grade metamorphic basement. Synchronously, the Kainach Gosau Basin (KGB) collapsed and subsided on top of the section.Metamorphism of organic material within this section has been investigated using vitrinite reflectance data and Raman spectra of extracted carbonaceous material. In the southern part of the GPNC, vitrinite reflectance indicates a decrease in organic maturity towards the stratigraphic youngest unit. The remaining part of the GPNC is characterized by an aureole of elevated vitrinite reflectance values and Raman R2 ratios that parallels the margins of the GPNC. Vitrinite reflectance in the KGB shows a steep coalification gradient and increases significantly towards the western basin margin. The observed stratigraphic trend in the southern GPNC is a result of deep Paleozoic to Early Cretaceous burial. This maturity pattern was overprinted along the margins by advective heat and convective fluids during Late Cretaceous to Paleogene exhumation of basement rocks.During shearing, the fault zone was heated up to ca. 500 °C. This overprint is explained by a two-dimensional thermal model with a ramp-flat fault geometry and a slip rate of 1 to 1.5 cm/year during 5 Ma fault movement. The collapse basin above the detachment subsided in a thermal regime which was characterized by relaxing isotherms.     

Mechanisms of partly flooded loose sand deposits

Partly flooded loose sand deposits are left back from lignite mining, particularly in east Germany. After flooding, gas inclusions in macropores enhance the pore pressure increase by total stress cycles without drainage, and this can cause the transition into a kind of suspension. Thus, natural and technical changes of surface loads triggered flow slides in chain reactions of sometimes catastrophic extent. Such collapsible deposits were and are stabilized by blast-induced liquefaction and densification. Successive collapse fronts in flooded grain skeletons are seismogeneous, and this appears as wavering in the near-field and leads to power-law spectra in the far-field. Apart from this evidence of mild fractality, the wild fractality of chain reactions eludes mathematical treatment. Therefore, uncommon methods of geotechnical design, operations and monitoring are required.     

Why chromatic imaging matters

During the last two decades, the first generation of beam combiners at the Very Large Telescope Interferometer has proved the importance of optical interferometry for high-angular resolution astrophysical studies in the near- and mid-infrared. With the advent of 4-beam combiners at the VLTI, the u ? v coverage per pointing increases significantly, providing an opportunity to use reconstructed images as powerful scientific tools. Therefore, interferometric imaging is already a key feature of the new generation of VLTI instruments, as well as for other interferometric facilities like CHARA and JWST. It is thus imperative to account for the current image reconstruction capabilities and their expected evolutions in the coming years. Here, we present a general overview of the current situation of optical interferometric image reconstruction with a focus on new wavelength-dependent information, highlighting its main advantages and limitations. As an Appendix we include several cookbooks describing the usage and installation of several state-of-the art image reconstruction packages. To illustrate the current capabilities of the software available to the community, we recovered chromatic images, from simulated MATISSE data, using the MCMC software SQUEEZE. With these images, we aim at showing the importance of selecting good regularization functions and their impact on the reconstruction.     

Application of a spectral correction method for measurements of covariances with fast-response sensors in the atmospheric boundary layer up to a height of 130 m and testing of the corrections

Measurement of meteorological quantities with fast-response sensors by means of the eddycorrelation technique allows calculation of turbulent transport without too severe demands with regard to stationarity and homogeneity. However, the measurement system causes frequency-dependent errors due to measuring height, averaging interval, sampling rate and mean wind speed. A correction method (Moore, 1986) was applied to measurements taken on a 130 m tower located at the German North Sea coast. The errors for 10-min averages, obtained at a height of 10 m were between 20 and 30%, mainly caused by the inertia of the sensors, increasing to between 30 and 60% at 130 m height due to a loss of low-frequency parts of the spectra because of the averaging interval. The corrections to the obtained data were validated by comparing the cospectra calculated from the data with the spectra used for the computation of the correction factors.