Geostatistical estimation of chemical contamination in stream sediments: The case study of Vale das Gatas mine (northern Portugal)

Based on an environmental geochemistry case study carried out in the neighbourhood of a W–Sn abandoned mine, the pollution in stream sediments was modelled through a Global Contamination Index. Such an index permits one to summarize the combination of deleterious elements in a single variable, obtained by the projection of samples onto the first axis of a PCASD (Principal Components Analysis of Standardized Data) applied to the entire n × p matrix containing the available concentrations of p = 16 elements in the set of n = 220 collected samples.In order to provide a sound basis for a coherent planning of the remediation process which will be put in operation in the affected area, it is necessary to balance the costs of reclaiming with the probabilities of exceeding the upper limits accepted for concentrations of environmentally harmful elements in sediments. Given these limits, they are back-transformed in the index values, providing a practical threshold between ‘clean’ and ‘contaminated’ samples. On the other hand, the minimum dimension of the cell to be reclaimed is restrained by the selected remediation process to be applied in the affected area. Hence, to meet the constraints of such a remediation process, it is required to estimate the probabilities of exceeding the index threshold in technologically meaningful sub-areas. For this end, the Indicator Block Kriging technique was applied, producing a series of maps where sub-areas to be reclaimed can be spotted for different probability levels. These maps, on which the decision making remediation agency can rely for its cost-benefit analysis, take into account both the spatial structure of ‘clean’ vs. ‘contaminated’ samples and the constraints of the reclaiming process.     

Sequence hierarchy in a Mesoproterozoic interior sag basin: from basin fill to reservoir scale,the Tombador Formation,Chapada Diamantina Basin,Brazil

The Tombador Formation exhibits depositional sequence boundaries placed at the base of extensive amalgamated fluvial sand sheets or at the base of alluvial fan conglomeratic successions that indicate basinward shifts of facies. The hierarchy system that applies to the Tombador Formation includes sequences of different orders, which are defined as follows: sequences associated with a particular tectonic setting are designated as ‘first order’ and are separated by first‐order sequence boundaries where changes in the tectonic setting are recorded; second‐order sequences represent the major subdivisions of a first‐order sequence and reflect cycles of change in stratal stacking pattern observed at 10² m scales (i.e., 200–300 m); changes in stratal stacking pattern at 10¹ m scales indicate third‐order sequences (i.e., 40–70 m); and changes in stratal stacking pattern at 10⁰ m scales are assigned to the fourth order (i.e., 8–12 m). Changes in palaeogeography due to relative sea level changes are recorded at all hierarchical levels, with a magnitude that increases with the hierarchical rank. Thus, the Tombador Formation corresponds to one‐first‐order sequence, representing a distinct intracratonic sag basin fill in the polycyclic history of the Espinhaço Supergroup in Chapada Diamantina Basin. An angular unconformity separates fluvial‐estuarine to alluvial fan deposits and marks the second‐order boundary. Below the angular unconformity the third‐order sequences record fluvial to estuarine deposition. In contrast, above the angular unconformity these sequences exhibit continental alluvial successions composed conglomerates overlain by fluvial and eolian strata. Fourth‐order sequences are recognized within third‐order transgressive systems tract, and they exhibit distinct facies associations depending on their occurrence at estuarine or fluvial domains. At the estuarine domain, they are composed of tidal channel, tidal bar and overlying shoreface heterolithic strata. At the fluvial domain the sequences are formed of fluvial deposits bounded by fine‐grained or tidal influenced intervals. Fine grained intervals are the most reliable to map in fourth‐order sequences because of their broad laterally extensive sheet‐like external geometry. Therefore, they constitute fourth‐order sequence boundaries that, at the reservoir approach, constitute the most important horizontal heterogeneity and, hence, the preferable boundaries of production zones. The criteria applied to assign sequence hierarchies in the Tombador Formation are based on rock attributes, are easy to apply, and can be used as a baseline for the study of sequence stratigraphy in Precambrian and Phanerozoic basins placed in similar tectonic settings.     

Enhanced data and methods for improving open and free global population grids: putting ‘leaving no one behind’ into practice

ABSTRACT

Data on global population distribution are a strategic resource currently in high demand in an age of new Development Agendas that call for universal inclusiveness of people. However, quality, detail, and age of census data varies significantly by country and suffers from shortcomings that propagate to derived population grids and their applications. In this work, the improved capabilities of recent remote sensing-derived global settlement data to detect and mitigate major discrepancies with census data is explored. Open layers mapping built-up presence were used to revise census units deemed as ‘unpopulated’ and to harmonize population distribution along coastlines. Automated procedures to detect and mitigate these anomalies, while minimizing changes to census geometry, preserving the regional distribution of population, and the overall counts were developed, tested, and applied. The two procedures employed for the detection of deficiencies in global census data obtained high rates of true positives, after verification and validation. Results also show that the targeted anomalies were significantly mitigated and are encouraging for further uses of free and open geospatial data derived from remote sensing in complementing and improving conventional sources of fundamental population statistics.     

A new technique for timing the double pulsar system

In 2004, McLaughlin et al. discovered a phenomenon in the radio emission of PSR J0737−3039B (B) that resembles drifting subpulses. The repeat rate of the subpulses is equal to the spin frequency of PSR J0737−3039A (A); this led to the suggestion that they are caused by incidence upon B's magnetosphere of electromagnetic radiation from A. Here, we describe a geometrical model which predicts the delay of B's subpulses relative to A's radio pulses. We show that measuring these delays is equivalent to tracking A's rotation from the point of view of a hypothetical observer located near B. This has three main astrophysical applications: (i) to determine the sense of rotation of A relative to its orbital plane, (ii) to estimate where in B's magnetosphere the radio subpulses are modulated and (iii) to provide an independent estimate of the mass ratio of A and B. The latter might improve existing tests of gravitational theories using this system.     

Metals in eggs and hatchlings of Dermochelys coriacea (testudines) in Espírito Santo,Brazil and their relation to hatching and emergence success

Certain concentration of metal may influence survival in embryonic stages, reducing the birthrate and hatching emergence. This study aimed to evaluate concentration of metal in eggs and hatchlings of Dermochelys coriacea and correlate metal concentrations in eggs with hatching and emergence success. The samples were collected at Biological Reserve Station, ES, Brazil. At the nests' opening, unhatched eggs and stillborn hatchlings were collected to survey the successful hatching and emergence of D. coriacea. The eggs shell, egg content, and dead hatchlings metal concentrations were compared to hatching and emergence success. A positive correlation was found between the concentration of copper (Cu) in the hatchlings and the success of the emergence (r² = .28, p < .05), and a moderate positive correlation between the concentrations of iron (Fe) and barium (Ba; r² = .44, p < .05) and success hatching. The concentrations of metals in eggs and hatchlings of D. coriacea in the Espírito Santo are below the levels that could be considered harmful to the species. In summary, there is a positive correlation between metals levels and hatching and emergence success.     

Structural-stratigraphic control on the Umitaka Spur gas hydrates of Joetsu Basin in the eastern margin of Japan Sea

Integrated geological, geochemical, and geophysical exploration since 2004 has identified massive accumulation of gas hydrate associated with active methane seeps on the Umitaka Spur, located in the Joetsu Basin on the eastern margin of Japan Sea. Umitaka Spur is an asymmetric anticline formed along an incipient subduction zone that extends throughout the western side of the Japanese island-arc system. Seismic surveys recognized chimney structures that seem strongly controlled by a complex anticlinal axial fault system, and exhibit high seismic amplitudes with apparent pull-up structures, probably due to massive and dense accumulation of gas hydrate. Bottom simulating reflectors are widely developed, in particular within gas chimneys and in the gently dipping eastern flank of the anticline, where debris can store gas hydrates that may represent a potential natural gas resource. The axial fault system, the shape of the anticline, and the carrier beds induce thermogenic gas migration to the top of the structure, and supply gas to the gas hydrate stability zone. Gas reaching the seafloor produces strong seepages and giant plumes in the sea water column.     

Mapping benthic macroalgal communities in the coastal zone using CHRIS-PROBA mode 2 images

The ecological importance of benthic macroalgal communities in coastal ecosystems has been recognised worldwide and the application of remote sensing to study these communities presents certain advantages respect to in situ methods. The present study used three CHRIS-PROBA images to analyse macroalgal communities distribution in the Seno de Corcubión (NW Spain). The use of this sensor represent a challenge given that its design, build and deployment programme is intended to follow the principles of the “faster, better, cheaper”. To assess the application of this sensor to macroalgal mapping, two types of classifications were carried out: Maximum Likelihood and Spectral Angle Mapper (SAM). Maximum Likelihood classifier showed positive results, reaching overall accuracy percentages higher than 90% and kappa coefficients higher than 0.80 for the bottom classes shallow submerged sand, deep submerged sand, macroalgae less than 5 m and macroalgae between 5 and 10 m depth. The differentiation among macroalgal groups using SAM classifications showed positive results for green seaweeds although the differentiation between brown and red algae was not clear in the study area.