Induced Microearthquake Patterns in Hydrocarbon and Geothermal Reservoirs: Six Case Studies

—?The injection or production of fluids can induce microseismic events in hydrocarbon and geothermal reservoirs. By deploying sensors downhole, data sets have been collected that consist of a few hundred to well over 10,000 induced events. We find that most induced events cluster into well-defined geometrical patterns. In many cases, we must apply high-precision, relative location techniques to observe these patterns. At three sedimentary sites, thin horizontal strands of activity are commonly found within the location patterns. We believe this reflects fracture containment between stratigraphic layers of differing mechanical properties or states of stress. At a massive carbonate and two crystalline sites, combinations of linear and planar features indicate networks of intersecting fractures and allow us to infer positions of aseismic fractures through their influence on the location patterns. In addition, the fine-scale seismicity patterns often evolve systematically with time. At sedimentary sites, migration of seismicity toward the injection point has been observed and may result from slip-induced stress along fractures that initially have little resolved shear. In such cases, triggering events may be critical to generate high levels of seismic activity. At one crystalline site, the early occurrence of linear features that traverse planes of activity indicate permeable zones and possible flow paths within fractures. We hope the continued development of microseismic techniques and refinement of conceptual models will further increase our understanding of fluid behavior and lead to improved resource management in fractured reservoirs.     

Evaluating the effects of catch-and-release angling on Cape stumpnose Rhabdosargus holubi in a South African estuary

Fisheries managers are increasingly promoting catch-and-release (C&R) to manage recreationally angled fish stocks. Despite this, there is a scarcity of information on the effects of C&R on estuarine-dependent species. Cape stumpnose Rhabdosargus holubi dominates the recreational fisheries catch and provides an important source of food for subsistence fishers in some temperate South African estuaries. The health and survival of R. holubi exposed to a C&R event was investigated by examining their physiological stress response (blood glucose and lactate), reflex impairment (reflex action mortality predictors [RAMP]) and short-term (12-hour) survival. Fish were captured and exposed to one of three air-exposure treatments: 0 s, 30 s or 90 s. Stress and health were measured either immediately (immediate) or one hour after (delayed) the C&R event. There was no significant difference in blood glucose between air-exposure treatments, but there was a significant difference between the mean immediate and delayed glucose levels within each treatment (F_(2,143) = 81.8, p < 0.01). In contrast, blood lactate level was significantly higher in the 90-s treatment (p < 0.05). Immediate blood lactate levels were significantly lower than the delayed samples for each treatment (F = 4.29, p = 0.02; n = 169). Although all fish exhibited at least one reflex impairment, the RAMP score was significantly higher in the 90-s air-exposure treatment (H_(2,86) = 9.73, p = 0.007). Also, RAMP scores were significantly lower in the delayed samples (p < 0.01). Although short-term mortality was relatively low (2.3%) for this species, it was highest in the 90-s treatment (7%). These results suggest that physiological stress is higher when R. holubi are exposed to longer periods of air exposure and that the physiological stress of fish subject to a C&R event is best measured after a delay.     

Source mechanism of volcanic tremor: fluid-driven crack models and their application to the 1963 kilauea eruption

We propose a model for the mechanism of magma transport based on a fluid-filled tensile crack driven by the excess pressure of fluid. Such a transport mechanism can generate seismic waves by a succession of jerky crack extensions, if the fracture strength of rock varies in space, or if there is a difference between the dynamic and static values of the critical stress intensity factor. We also find that the opening and closing of a narrow channel connecting two fluid-filled cracks may be a source of seismic waves. Using the finite-difference method, we calculated the vibration of dry and fluid-filled cracks generated by: (1) a jerky extension at one end or at both ends and (2) a jerky opening of a narrow channel connecting two cracks. We then calculated the far-field and near-field radiation from these vibrating cracks. The spectra show peaked structures, but interestingly, most high-frequency peaks are only present in the near-field and cannot be transmitted to the far-field. The spectral features described above are often observed for volcanic tremors and in some cases for seismic signals associated with hydraulic fracturing experiments.We first consider as a model of volcanic tremor randomly occurring jerky crack extensions, and derive a formula relating the tremor amplitude to the excess pressure in the magma, the incremental area in each extension, and the frequency of extensions. These parameters are also constrained by other observations, such as the rate of magma flow.Our model was tested quantitatively against observations made in one of the best-described case histories of volcanic tremor: the October 5–6, 1963 Kilauea flank eruption. We found that a single, long crack extending from the summit to the eruptive site cannot explain the observations. The model of a steadily expanding crack ran into difficulties when quantitative comparisons were made with observations. The extension of crack area needed to explain the amplitude of volcanic tremor should accompany a large increase in tremor period which was not observed.Our second model is a chain of cracks connected by narrow channels which open and close. The length of each crack is around 1 km, the channel area connecting neighboring cracks is about 10³m², and the channel opens jerkily with the magmatic excess pressure of about 20 bars. The frequency of jerky opening of each channel is about once in 15 seconds. The channel is closed after each jerky opening, as soon as magma is moved through the channel.     

Using Automated, High-precision Repicking to Improve Delineation of Microseismic Structures at the Soultz Geothermal Reservoir

—?An automatic, adaptive, correlation-based algorithm for adjusting phase picks in large digital seismic data sets provides significant improvement in resolution of microseismic structures using only a small fraction of the time and manpower which would be required to re-analyze waveforms manually or semi-automatically. We apply this technique to induced seismicity at the Soultz-sous-Forêts geothermal site, France. The method is first applied to a small, previously manually repicked subset of the catalogue so that we may compare our results to those obtained from painstaking, visual, cross-correlation-based techniques. Relative centroid-adjusted hypocenters show a decrease in median mislocation from 31 to 7?m for preliminary and automatically adjusted picks, respectively, compared to the manual results. Narrow, intersecting joint features not observed in the preliminary hypocenter cloud, but revealed through manual repicking, are also recovered using the automatic method. We then address a larger catalogue of ～7000 microearthquakes. After relocating the events using automatic repicks, the percentage of events clustering within 5?m of their nearest neighbor increases form 5 to 26% of the catalogue. Hypocenter relocations delineate narrow, linear features previously obscured within the seismic cloud, interpreted as faults or fractures which may correspond to fluid propagation paths, or to changes in stress as a result of elevated pore pressures. RMS travel-time residuals for the larger data set are reduced by only 0.2%; however, phase-pick biases in the preliminary catalogue have influenced both the velocity model and station correction calculations, which will affect location residuals. These pick biases are apparent on the adjusted, stacked waveforms and correcting them will be important prior to future velocity model refinements.     

中国西部铂矿床类型与找矿方向探讨

中国铂矿资源严重不足,主要分布在中国西部,根据原生矿床特征可划分为4类：①硫化物型;②铬铁矿型;③辉石岩型;④层控型。寻找铂矿新类型和富铂(岩石)资源,应成为解决中国铂矿资源紧缺的重要任务。铂矿找矿方向：地台与地槽接合部位,特别是围绕着基性、超基性岩内外接触带,铂的预富集岩带与层控型铂矿带,另外还有砂铂型铂矿发育区有望扩大找铂前景。     

Possibilities of soil spectroscopy for the classification of contaminated areas in river floodplains

During the past decades, large amounts of diffuse contaminated soil material have been deposited in the floodplains of the river Rhine in the Netherlands. The dynamic character of this river causes a large spatial variability in the contamination level of its floodplain soils. Characterisation of the spatial variability exclusively based on soil sampling and analysis is often insufficient and expensive. Hyperspectral images can provide additional spatial information for a proper characterisation of the contamination situation of river floodplains. This paper describes the possible application of soil spectroscopy to estimate metal concentration levels in river floodplains. Soil reflectance spectra in the visible-near infrared region (VNIR) were measured in the laboratory for soil samples taken from two river floodplains along the river Waal, the main tributary of the river Rhine in the Netherlands. A multivariate calibration procedure using partial least squares (PLS) regression was applied to establish a relationship between reflectance spectra in the visible-near infrared (VNIR) region and spectrally active soil characteristics (organic matter and clay content) that are intercorrelated with concentration levels of Cd and Zn. Results of the analysis of two river floodplains are summarised and the influence of scale-level and sub soil material on the prediction capability is discussed.     

A New Octahedrite from South Africa

Abstract Examination of an iron meteorite found in South Africa discloses it to be a coarse octahedrite containing 6.90 weight-percent nickel. The meteorite body contains several inclusions of troilite, or troilite plus graphite, and at least one of pure graphite veined with kamacite. Kamacite, cohenite, and phosphides are the other major constituents of the structure.     

Monitoring viscosity changes from time‐lapse seismic attenuation: case study from a heavy oil reservoir

Heating heavy oil reservoirs is a common method for reducing the high viscosity of heavy oil and thus increasing the recovery factor. Monitoring of these viscosity changes in the reservoir is essential for delineating the heated region and controlling production. In this study, we present an approach for estimating viscosity changes in a heavy oil reservoir. The approach consists of three steps: measuring seismic wave attenuation between reflections from above and below the reservoir, constructing time‐lapse Q and Q^?1 factor maps, and interpreting these maps using Kelvin–Voigt and Maxwell viscoelastic models. We use a 4D relative spectrum method to measure changes in attenuation. The method is tested with synthetic seismic data that are noise free and data with additive Gaussian noise to show the robustness and the accuracy of the estimates of the Q‐factor. The results of the application of the method to a field data set exhibit alignment of high attenuation zones along the steam‐injection wells, and indicate that temperature dependent viscosity changes in the heavy oil reservoir can be explained by the Kelvin–Voigt model.     

Coda

— Observations and analysis of seismic scattering in the heterogeneous earth have grown from the initial observations of Aki in the 1960s into a well-developed subfield of seismology. The area presents many challenging and interesting problems for seismologists today and there are many areas of fruitful research. We focus on a small subset of areas of research within the general area of, “coda study,” that can be most directly tied to Kei's early work in this field: scattering coefficient, coda Q, coda normalization method, and the radiative transfer approach. These are the most useful tools in the interpretation of high-frequency seismograms. In each of these areas, Kei provided initial inspiration through insightful observation and well-thought out models for his observations. The results of ongoing work in these areas have provided insight into the complexity of wave propagation in the earth and have yielded new insights into the character of the earth's lithosphere. They have also provided reliable means to obtain practical information like relative site amplification factors and relative source radiation as a function of frequency.