Study of the flood control scheduling scheme for the Three Gorges Reservoir in a catastrophic flood

The Three Gorges Project is the world's largest water conservancy project. According to the design standards for the 1,000‐year flood, flood diversion areas in the Jingjiang reach of the Yangtze River must be utilized to ensure the safety of the Jingjiang area and the city of Wuhan. However, once these areas are used, the economic and life loss in these areas may be very great. Therefore, it is vital to reduce this loss by developing a scheme that reduces the use of the flood diversion areas through flood regulation by the Three Gorges Reservoir (TGR), under the premise of ensuring the safety of the Three Gorges Dam. For a 1,000‐year flood on the basis of a highly destructive flood in 1954, this paper evaluates scheduling schemes in which flood diversion areas are or are not used. The schemes are simulated based on 2.5‐m resolution reservoir topography and an optimized model of dynamic capacity flood regulation. The simulation results show the following. (a) In accord with the normal flood‐control regulation discharge, the maximum water level above the dam should be not more than 175 m, which ensures the safety of the dam and reservoir area. However, it is necessary to utilize the flood diversion areas within the Jingjiang area, and flood discharge can reach 2.81 billion m³. (b) In the case of relying on the TGR to impound floodwaters independently rather than using the flood diversion areas, the maximum water level above the dam reaches 177.35 m, which is less than the flood check level of 180.4 m to ensure the safety of the Three Gorges Dam. The average increase of the TGR water level in the Chongqing area is not more than 0.11 m, which indicates no significant effect on the upstream reservoir area. Comparing the various scheduling schemes, when the flood diversion areas are not used, it is believed that the TGR can execute safe flood control for a 1,000‐year flood, thereby greatly reducing flood damage.     

Cytoplasmic regionalization in starfish oocyte occurrence and localization of cytoplasmic determinants responsible for the formation of archenteron and primary mesenchyme in starfish (asterias amurensis) oocytes

Starfish oocytes with intact germinal vesicles (GVs) were cut along desired planes with glass needles or ligated using silk thread loops into two parts and allowed to mature in vitro, and inseminated. The experimental results showed that (1) only the parts with GVs or partial GV contents (PGVCs) cleaved, those without any GV materials did not; but nucleated and non-nucleated fragments cut from mature eggs were able to divide; (2) the development of animal parts of oocytes containing GVs or PGVCs was like that of animal fragments of matured oocytes with female pronuclei; most of them gave rise to permanent blastulae, and just a few formed ectodermal vesicles with a little primary mesenchyme; (3) a large part of vegetal fragments with GVs or PGVCs, and the vegetal parts of mature eggs without female pronuclei developed into small but normal embryos; (4) the fragments containing GVs or PGVCs obtained from the oocytes along a plane parallel to the animal-vegetal (A-V) axis developed as normally as the halves (with or without female pronuclei) severed from mature eggs along the same axis. Based on the data above, it was concluded that (1) the non-chromatin materials in the oocyte GVs are indispensable for successful fertilization and cleavage of starfish eggs; (2) some factor (s) located asymmetrically in the vegetal hemispheres of starfish oocytes is (are) responsible for formation of the archenteron and primary mesenchyme. It is evident from the above findings that the oocyte cytoplasm of the starfish had already regionalized before the GV break-down. Contribution No. 1722 from the Institute of Oceanology, Academia Sinica     

邻菲啰啉在测定亚铁中的保护效果

样品在分解过程中 ,亚铁易被空气部分氧化 ,致使测试结果偏低 ,采用在HF H2 SO4溶矿过程中加入邻菲卟罗啉 ,与亚铁形成络合物 ,对保护亚铁具有较好的效果。拟定了在塑料坩埚中加邻菲卟罗啉、H2 SO4及HF ,中高温电热板溶矿 ,容量法测定样品中的亚铁 ,方法精密度为 0 .2 3% ,样品加标准回收率 98.8%～ 10 1.9%。此方法具有较好的应用效果     

Finite element formulation and algorithms for unsaturated soils. Part II: Verification and application

The finite‐element formulation and integration algorithms developed in Part I are used to analyse a number of practical problems involving unsaturated and saturated soils. The formulation and algorithms perform well for all the cases analysed, with the robustness of the latter being largely insensitive to user‐defined parameters such as the number of coarse time steps and error control tolerances. The efficiency of the algorithms, as measured by the CPU time consumed, does not depend on the number of coarse time steps, but may be influenced by the error control tolerances. Based on the analyses presented here, typical values for the error control tolerances are suggested. It is also shown that the constitutive modelling framework presented in Part I can, by adjusting one constitutive equation and one or two material parameters, be used to simulate soils that expand or collapse upon wetting. Treating the suction as a strain variable instead of a stress variable proves to be an efficient and robust way of solving suction‐dependent plastic yielding. Moreover, the concept of the constitutive stress is a particularly convenient way of handling the transition between saturation and unsaturation. Copyright © 2003 John Wiley & Sons, Ltd.     

Study of a model for correcting the effects of horizontal advection on surface fluxes measurement based on remote sensing

As well known, the methods of remote sensing and Bowen Ratio for retrieving surface flux are based on energy balance closure; however, in most cases, surface energy observed in experiment is lack of closure. There are two main causes for this: one is from the errors of the observation devices and the differences of their observational scale; the other lies in the effect of horizontal advection on the surface flux measurement. Therefore, it is very important to estimate the effects of horizontal advection quantitatively. Based on the local advection theory and the surface experiment, a model has been proposed for correcting the effect of horizontal advection on surface flux measurement, in which the relationship between the fetch of the measurement and pixel size for remote sensed data was considered. By means of numerical simulations, the sensitivities of the main parameters in the model and the scaling problems of horizontal advection were analyzed. At last, by using the observational data acquired in agricultural field with relatively homogeneous surface, the model was validated.

     

我国个人所得税制度完善的法律思考

个人所得税是与每个人联系都很紧密的税种,它的完善与否,直接体现了我国法制建设的完善程度及居民素质的高低。但现行税制由于内外原因,存在各种缺陷。因此有必要在理论中找到对策,并在实践中寻求答案逐步完善个人所得税制度。     

Effect of spatial variation characteristics on contouring of design storm depth

The ordinary kriging method, a geostatistical interpolation technique, was applied for developing contour maps of design storm depth in northern Taiwan using intensity–duration–frequency (IDF) data. Results of variogram modelling on design storm depths indicate that the design storms can be categorized into two distinct storm types: (i) storms of short duration and high spatial variation and (ii) storms of long duration and less spatial variation. For storms of the first category, the influence range of rainfall depth decreases when the recurrence interval increases, owing to the increasing degree of their spatial independence. However, for storms of the second category, the influence range of rainfall depth does not change significantly and has an average of approximately 72 km. For very extreme events, such as events of short duration and long recurrence interval, we do not recommend usage of the established design storm contours, because most of the interstation distances exceed the influence ranges. Our study concludes that the influence range of the design storm depth is dependent on the design duration and recurrence interval and is a key factor in developing design storm contours. Copyright © 2003 John Wiley & Sons, Ltd.     

在BPL信道上增加数据广播内容的探讨

分析了现有罗兰C（包括BPL）在授时方面存在的不足，提出了在BPL信道上实现数据广播的主要目的。详细讨论了各种可能的数据信息的结构，并给出了有关参数和数据的计算方式和公式。认为发播内容的选择是由期望的系统功能决定的，广播内容的编排则与具体实现技术相关。最后给出了在不同调制方法下的传输速率，这是合理编排广播内容的基础。     

Silicon limitation on primary production and its destiny in Jiaozhou Bay, China——Ⅳ：Study on cross-bay transect from estuary to ocean

The authors analyzed the data collected in the Ecological Station Jiaozhou Bay from May 1991 to November 1994, including 12 seasonal investigations, to determine the characteristics, dynamic cycles and variation trends of the silicate in the bay. The results indicated that the rivers around Jiaozhou Bay provided abundant supply of silicate to the bay. The silicate concentration there depended on river flow variation. The horizontal variation of silicate concentration on the transect showed that the silicate concentration decreased with distance from shorelines. The vertical variation of it showed that silicate sank and deposited on the sea bottom by phytoplankton uptake and death, and zooplankton excretion. In this way, silicon would endlessly be transferred from terrestrial sources to the sea bottom. The silicon took up by phytoplankton and by other biogeochemical processes led to insufficient silicon supply for phytoplankton growth. In this paper, a 2D dynamic model of river flow versus silicate concentration was established by which silicate concentrations of 0.028–0.062 μmol/L in seawater was yielded by inputting certain seasonal unit river flows (m³/s), or in other words, the silicate supply rate; and when the unit river flow was set to zero, meaning no river input, the silicate concentrations were between 0.05–0.69 μmol/L in the bay. In terms of the silicate supply rate, Jiaozhou Bay was divided into three parts. The division shows a given river flow could generate several different silicon levels in corresponding regions, so as to the silicon-limitation levels to the phytoplankton in these regions. Another dynamic model of river flow versus primary production was set up by which the phytoplankton primary production of 5.21–15.55 (mgC/m²·d)/(m³/s) were obtained in our case at unit river flow values via silicate concentration or primary production conversion rate. Similarly, the values of primary production of 121.98–195.33 (mgC/m²·d) were achieved at zero unit river flow condition. A primary production conversion rate reflects the sensitivity to silicon depletion so as to different phytoplankton primary production and silicon requirements by different phytoplankton assemblages in different marine areas. In addition, the authors differentiated two equations (Eqs. 1 and 2) in the models to obtain the river flow variation that determines the silicate concentration variation, and in turn, the variation of primary production. These results proved further that nutrient silicon is a limiting factor for phytoplankton growth. This study was funded by NSFC (No. 40036010), and the Director's Fund of the Beihai Sea Monitoring Center, the State Oceanic Administration.