Equilibrium and disequilibrium degassing of a phonolitic melt (Vesuvius AD 79 “white pumice”) simulated by decompression experiments

Equilibrium and disequilibrium degassing of a volatile phase from a magma of K-phonolitic composition was investigated to assess its behavior upon ascent. Decompression experiments were conducted in Ar-pressurized externally heated pressure vessels at superliquidus temperature (1050 °C), in the pressure range 10–200 MPa using pure water as fluid phase. All experiments were equilibrated at 200 MPa and then decompressed to lower pressures with rates varying from 0.0028 to 4.8 MPa/s. Isobaric saturation experiments were performed at the same temperature and at 900–950 °C to determine the equilibrium water solubility in the pressure range 30–250 MPa. The glasses obtained from decompression experiments were analyzed for their dissolved water content, vesicularity and bubble size distribution. All decompressed samples presented a first event of bubble nucleation at the capsule–melt interface. Homogeneous bubble nucleation in the melt only occurred in fast-decompressed experiments (4.8 and 1.7 MPa/s), for ΔP ≅ 100 MPa. For these decompression rates high water over-saturations were maintained until a rapid exsolution was triggered at ΔP > 150 MPa. For slower rates (0.0028, 0.024, 0.17 MPa/s) the degassing of the melt took place by diffusive growth of the bubbles nucleating at the capsule–melt interface. This process sensibly reduced water over-saturation in the melt, preventing homogeneous nucleation to occur. For decompression rates of 0.024 and 0.17 MPa/s low water over-saturations were attained in the melt, gradually declining toward equilibrium concentrations at low pressures. A near-equilibrium degassing path was observed for a decompression rate of 0.0028 MPa/s. Experimental data combined with natural pumice textures suggest that both homogeneous and heterogeneous bubble nucleations occurred in the phonolitic magma during the AD 79 Vesuvius plinian event. Homogeneous bubble nucleation probably occurred at a depth of ∼ 3 km, in response to a fast decompression of the magma during the ascent.     

Shaking‐table tests of flat‐bottom circular silos containing grain‐like material

According to Eurocode 8, the seismic design of flat‐bottom circular silos containing grain‐like material is based on a rough estimate of the inertial force imposed on the structure by the ensiled content during an earthquake: 80% of the mass of the content multiplied by the peak ground acceleration. A recent analytical consideration of the horizontal shear force mobilised within the ensiled material during an earthquake proposed by some of the authors has resulted in a radically reduced estimate of this load suggesting that, in practice, the effective mass of the content is significantly less than that specified. This paper describes a series of laboratory tests that featured shaking table and a silo model, which were conducted in order to obtain some experimental data to verify the proposed theoretical formulations and to compare with the established code provisions. Several tests have been performed with different heights of ensiled material – about 0.5 mm diameter Ballotini glass – and different magnitudes of grain–wall friction. The results indicate that in all cases, the effective mass is indeed lower than the Eurocode specification, suggesting that the specification is overly conservative, and that the wall–grain friction coefficient strongly affects the overturning moment at the silo base. At peak ground accelerations up to around 0.35 g, the proposed analytical formulation provides an improved estimate of the inertial force imposed on such structures by their contents. Copyright © 2015 John Wiley & Sons, Ltd.     

Environmental conditions for gravelly and pebbly dunes and sorted bedforms on a moderate-energy inner shelf (Marettimo Island,Italy, western Mediterranean)

Side scan sonar records, sediment textural characteristics, and in-situ field observations were used to study gravelly and pebbly dunes and sorted bedforms on the inner shelf of Marettimo Island, along the northwestern Sicilian shelf. The dunes are composed of coarse sands, gravels and pebbles (D50: 2–16 mm), displaying a symmetrical shape with a wavelength in the range of 1–2.5 m and a height of 0.15–0.30 m. The bedforms are distributed in a patchy pattern in a depth range of 10–50 m, and are described for the first time on a Mediterranean inner shelf. Sorted bedforms are linear morphological features developed almost perpendicular to the coast in the eastern sector of the island between 15 and 50 m water depth. Bottom shear stresses required for sediment entrainment and the generation of the shallower dunes can be reached during strong storms (Hs=5–6 m; Tp=9–11 s), which are not common in the Mediterranean Sea. However, wave storm events recorded in the study area during the last 17 years are not able to generate the coarsest and deeper dunes, suggesting that the stirring mechanism for dune formation is associated with severe storms that have a recurrence interval of more than 17 years. The long-term stability of the coarse bedforms is supported by the permanence of sorted bedforms without significant morphological changes for long periods (>13 years). Therefore, it is shown that processes forming coarse bedforms can occur in tideless and moderate-energy settings like those of the Mediterranean continental shelves, although the morphological features are probably less dynamic and remain unaltered for longer periods than on higher-energy shelves.     

Time-course evaluation of ROS-mediated toxicity in mussels, Mytilus galloprovincialis, during a field translocation experiment

Harbours can be considered as model environments for developing and validating field monitoring procedures and to investigate mechanistic relationships between different biological responses. In this study several biomarkers were investigated in marine mussels caged for 4 weeks (June-July 2001) into an industrialized harbour of NW Italy. Organisms were collected at different time-intervals to better characterize the sensitivity, temporal variations and interactions of analysed responses. Besides single antioxidants the total oxyradical scavenging capacity (TOSC) assay was used to analyse the capability of the whole antioxidant system to neutralize specific forms of radicals: these data were further integrated by measurement of DNA integrity, oxidized bases and the impairment of lysosomal membrane stability in haemocytes. Results showed a biphasic trend for single antioxidants and TOSC, with an increase during the first 2 weeks of exposure to the polluted site followed by a progressive decrease up to a severe depletion in the final part of the experiment.     

Size matters more than method: Visual quadrats vs photography in measuring human impact on Mediterranean rocky reef communities

The performances of two commonly used non-destructive sampling procedures for rocky benthic assemblages (i.e. photography and visually assessed quadrats) were compared. A damaging human activity, date mussel (Lithophaga lithophaga) harvesting (DMH), was chosen. Directly impacted sites were compared with reference conditions (controls). Both visual quadrats and photography were equally able to detect differences between impacted situations and controls. However, visual quadrats showed high variability among replicates and estimated higher species richness for controls, while photography did so for impacts. Pooling photos in a ‘sum photo quadrat’ showed that differences between the two methods are due to sampling unit size rather than sampling procedure itself. As a small sampling unit is unavoidable with photography, visual quadrats should be preferred in investigating shallow rocky reefs for their larger size; however, longer working time underwater with quadrats does not allow for numerous replicates. Pooling many photos to reach sampling sizes comparable with those of quadrats may be a valid alternative to reconcile image resolution and areal coverage.     

Approximate analytic solutions to the isothermal Lane–Emden equation

We derive accurate analytic approximations to the solution of the isothermal Lane–Emden equation, a basic equation in Astrophysics that describes the Newtonian equilibrium structure of self-gravitating, isothermal fluid spheres. The solutions we obtain, using analytic arguments and rational approximations, have simple forms, and are accurate over a radial extent that is much larger than that covered by conventional series expansions around the origin. Our best approximation has a maximum error on density of 0.04 % at 10 core radii, and is still within 1 % from an accurate numerical solution at a radius three times larger.     

Time-course evaluation of ROS-mediated toxicity in mussels, Mytilus galloprovincialis, during a field translocation experiment

Harbours can be considered as model environments for developing and validating field monitoring procedures and to investigate mechanistic relationships between different biological responses. In this study several biomarkers were investigated in marine mussels caged for 4 weeks (June–July 2001) into an industrialized harbour of NW Italy. Organisms were collected at different time-intervals to better characterize the sensitivity, temporal variations and interactions of analysed responses. Besides single antioxidants the total oxyradical scavenging capacity (TOSC) assay was used to analyse the capability of the whole antioxidant system to neutralize specific forms of radicals: these data were further integrated by measurement of DNA integrity, oxidized bases and the impairment of lysosomal membrane stability in haemocytes. Results showed a biphasic trend for single antioxidants and TOSC, with an increase during the first 2 weeks of exposure to the polluted site followed by a progressive decrease up to a severe depletion in the final part of the experiment.     

Merging active and passive data sets in traveltime tomography: The case study of Campi Flegrei caldera (Southern Italy)

We propose a strategy for merging both active and passive data sets in linearized tomographic inversion. We illustrate this in the reconstruction of 3D images of a complex volcanic structure, the Campi Flegrei caldera, located in the vicinity of the city of Naples, southern Italy. The caldera is occasionally the site of significant unrests characterized by large ground uplifts and seismicity. The P and S velocity models of the caldera structure are obtained by a tomographic inversion based on travel times recorded during two distinct experiments. The first data set is composed of 606 earthquakes recorded in 1984 and the second set is composed of recordings for 1528 shots produced during the SERAPIS experiment in 2001. The tomographic inversion is performed using an improved method based on an accurate finite‐difference traveltime computation and a simultaneous inversion of both velocity models and earthquake locations. In order to determine the adequate inversion parameters and relative data weighting factors, we perform massive synthetic simulations allowing one to merge the two types of data optimally. The proper merging provides high resolution velocity models, which allow one to reliably retrieve velocity anomalies over a large part of the tomography area. The obtained images confirm the presence of a high P velocity ring in the southern part of the bay of Pozzuoli and extends its trace inland as compared to previous results. This annular anomaly represents the buried trace of the rim of the Campi Flegrei caldera. Its shape at 1.5 km depth is in good agreement with the location of hydrothermalized lava inferred by gravimetric data modelling. The Vp/Vs model confirms the presence of two characteristic features. At about 1 km depth a very high Vp/Vs anomaly is observed below the town of Pozzuoli and is interpreted as due to the presence of rocks that contain fluids in the liquid phase. A low Vp/Vs body extending at about 3–4 km depth below a large part of the caldera is interpreted as the top of formations that are enriched in gas under supercritical conditions.     

Short-term,linear, and non-linear local effects of the tides on the surface dynamics in a new,high-resolution model of the Mediterranean Sea circulation

Ocean Dynamics - The tides in the Mediterranean Sea are generally weaker than in other regions of the world ocean, but are locally intensified in passages with complex bathymetry, such as the...