Diel Patterns in Chlorophyll <Emphasis Type="Italic">a</Emphasis> Specific Absorption Coefficient and Absorption Efficiency Factor of Picoplankton

Diel patterns in the chlorophyll a specific absorption coefficient of surface picoplankton, a*_pico (γ) (m²·[mg chlorophyll a]⁻¹), were studied at 7 stations under daily cycle of in situ light condition in the western subarctic Pacific and Japan Sea. All the data were normalized by dividing the anomaly with daily averaged a*_pico (γ). Opposite diel patterns were observed for the normalized a*_pico (443) and a*_pico (675) with maximum toward dawn or dusk and minimum toward midday at 4 stations under low-irradiance (LI) conditions and vice versa at 3 stations under high-irradiance (HI) conditions. The absorption efficiency factors at red absorption peak, Q _a (675), were determined by reconstruction with intracellular chlorophyll a concentration and cell diameter. The normalized Q _a (675) also showed diel pattern with maximum toward midday and minimum toward dawn or dusk under LI. The diel pattern in a*_pico (675) and Q _a (675) were primarily caused by changes in intracellular chlorophyll a concentration due to photoadaptation under LI. The diel pattern in a*_pico (443) was influenced by pigmentation, as recognized by blue to red ratio [a*_pico (443)/a*_pico (675)] under HI. This study proposed that the opposite diel pattern in a*_pico (γ) might occur for a wide range of algal species. The results presented here have important consequences for the interpretation of diel variations in optical properties observed in the open ocean.     

CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

Seasonal and Spatial Variations of Total Mass Flux around Coral Reefs in the Southern Ryukyus,Japan

Total mass flux, size distribution of sediment particles and some chemical components such as total carbon (TC), total nitrogen (TN) and calcium carbonate (CaCO₃) were monitored monthly using a multi-cup sediment traps at seven coral reef sites (6 reef flat and 1 reef slope) of the Marine Protected Areas around Ishigaki, Kohama, Kuroshima and Iriomote Islands in the southern Ryukyus, Japan from September 2000 to September 2001. The size distribution of trapped sediments revealed mostly uni-modal fine sand to mud in the reef flat and gravelly to coarse sand in the reef slope. The total mass flux ranged between 0.54 to 872 gm⁻²d⁻¹, and showed a pronounced seasonality (high in summer-autumn and low in spring) at each site, which was consistent with the rainfall and typhoon regime. Exceptionally high values were observed on the reef slope (Iriomote) in February–March 2001 (1533 gm⁻²d⁻¹) owing to a large amount of bottom sediment re-suspension. On the reef flat (Todoroki South and North; Ishigaki), values obtained in July–August 2001 (872 gm⁻²d⁻¹) and August–September 2001 (800 gm^{− 2}d⁻¹) indicate the high terrestrial discharge from Todoroki River. Trapped sediment particles consist of CaCO₃ (1.2–27.1%) and a non-carbonate fraction (98.8–72.9%), which contains total carbon (4.9–26%), carbonate carbon (CO₂-C) (0.2–3.1%) and non-carbonate carbon (NC-C) (7.9–25.6%). Total nitrogen content was in the range 0.02–0.48%. TN is contained mainly in the carbonate fraction and NC-C may be contained in the non-carbonate fraction. The low TN/OC ratio of the trapped sediments suggests that they were mostly of terrestrial origin and that both fractions migrated. The high total mass flux derived from Todoroki River exceeded the threshold at which a lethal effect on coral community is caused. The results stress the importance of conducting seasonal studies of sedimentation over more than one year and at more than one location in south Japan coral reef ecosystems to gain an understanding of the processes controlling the total mass fluxes and their nutrients content, also to develop an awareness of how to prevent the damage of coral reef ecosystems and, if it does occur, to allow mitigation measures to be undertaken.     

Seismic structure and tectonics of the Shackleton Fracture Zone (Drake Passage,Scotia Sea)

The structural framework of the southern part of the Shackleton Fracture Zone has been investigated through the analysis of a 130-km-long multichannel seismic reflection profile acquired orthogonally to the fracture zone near 60° S. The Shackleton Fracture Zone is a 800-km-long, mostly rectilinear and pronounced bathymetric lineation joining the westernmost South Scotia Ridge to southern South America south of Cape Horn, separating the western Scotia Sea plate from the Antarctic plate. Conventional processing applied to the seismic data outlines the main structures of the Shackleton Fracture Zone, but only the use of enhanced techniques, such as accurate velocity analyses and pre-stack depth migration, provides a good definition of the acoustic basement and the architecture of the sedimentary sequences. In particular, a strong and mostly continuous reflector found at about 8.0 s two-way traveltime is very clear across the entire section and is interpreted as the Moho discontinuity. Data show a complex system of troughs developed along the eastern flank of the crustal ridge, containing tilted and rotated blocks, and the presence of a prominent listric normal fault developed within the oceanic crust. Positive flower structures developed within the oceanic basement indicate strike-slip tectonism and partial reactivation of pre-existing faults. Present-day tectonic activity is found mostly in correspondence to the relief, whereas fault-induced deformation is negligible across the entire trough system. This indicates that the E–W-directed stress regime present in the Drake Passage region is mainly dissipated along a narrow zone within the Shackleton Ridge axis. A reappraisal of all available magnetic anomaly identifications in the western Scotia Sea and in the former Phoenix plate, in conjunction with new magnetic profiles acquired to the east of the Shackleton Fracture Zone off the Tierra del Fuego continental margin, has allowed us to propose a simple reconstruction of Shackleton Fracture Zone development in the general context of the Drake Passage opening.     

Scaling analysis of deposition from turbidity currents

Many oil-bearing sedimentary deposits are formed by the settling of particles from turbidity currents. Modeling sedimentary processes that form these turbidites enables the calculation of properties such as extent, depth, porosity and permeability of hydrocarbon-bearing reservoirs. This paper estimates the extent and thickness of turbidites from the initial conditions of the turbidity flow. This is achieved by the application of scaling analysis of the partial differential equations that govern the dynamics of and deposition from turbidity currents. We apply the results of scaling analysis to five modern submarine fans. The predicted and actual values of the dimensions of the fan deposits match well. We then compare the derived results against tabulated sizes of ancient turbidites. The comparisons are good as long as we correctly identify the flow regimes in which the deposition took place. The good agreements observed in the two cases show that the estimates obtained using scaling analysis can provide useful first-guess values for the dimensions of the deposits.     

Simple determination of dimethylsulfide (DMS) and dimethylsulfoniopropionate (DMSP) using solid-phase microextraction and gas chromatography-mass spectrometry

Solid-phase microextraction (SPME) is a simple, sensitive and less destructive method for the determination of dimethylsulfide (DMS) in seawater. Combined with detection by gas chromatography-mass spectrometry (GC-MS), the method had sufficient sensitivity (minimum detectable concentration of DMS was 0.05 nM), and practical levels of reproducibility (relative standard deviation ≤7%) and linearity (r ² > 0.995) over a wide concentration range (0.5 to 910 nM). The protocol developed was applied to a Sagami Bay water sample to determine concentrations of DMS and DMSP, and in situ DMSP-lyase activity.     

Magnetic properties,self-reversal remanence and thermal alteration products of smythite

Summary This study is a follow up of the investigation of some magnetic properties and metastability of greigite in samples obtained from Miocene claystones in the Kruné hory (Erzgebirge) Piedmont basins (Bohemia). Three different methods of upgrading the smythite were applied; the magnetic properties of the concentrates are compared. The thermal conversion of smythite sets in at 200°C while greigite converts at 250°C. The first intermediate products to be formed are iron sulphides, marcasite clearly dominating over pyrite and pyrrhotite. Apart from a Fe³⁺ sulphate with a composition of Fe₂(SO₄)₃, oxidation of these sulphides gives rise to -Fe₂O₃. The result of the subsequent decomposition of the mentioned sulphate is the formation of -Fe₂O₃, which retains the sulphate structure. The final product of the thermal decomposition at 800°C is -Fe₂O₃. In the smythite concentrate the conversion to Fe³⁺ sulphate and -Fe₂O₃ is about twice as intensive as in greigite. No direct conversion to -Fe₂O₃ was found. During the thermal process self-reversals of remanence were observed, in various samples as many as four reversals in the temperature interval from 340 to 590°C. The occurrences of self-reversals of remanence were only observed at high degrees of thermal demagnetization, of the order of 10^–2 down to 10^–3 in the temperature interval of sulphide origin (below 400°C), and of the order of 10^–4 down to 10^–6 in the temperature interval of Fe-oxides origin (above 400°C).Presented at the 3rd Conference on New Trends in Geomagnetism, Castle of Smolenice, Czechoslovakia, June 22–29, 1992     

Oil-generation kinetics for organic facies with Type-II and -IIS kerogen in the Menilite Shales of the Polish Carpathians

The Menilite Shales (Oligocene) of the Polish Carpathians are the source of low-sulfur oils in the thrust belt and some high-sulfur oils in the Carpathian Foredeep. These oil occurrences indicate that the high-sulfur oils in the Foredeep were generated and expelled before major thrusting and the low-sulfur oils in the thrust belt were generated and expelled during or after major thrusting. Two distinct organic facies have been observed in the Menilite Shales. One organic facies has a high clastic sediment input and contains Type-II kerogen. The other organic facies has a lower clastic sediment input and contains Type-IIS kerogen. Representative samples of both organic facies were used to determine kinetic parameters for immiscible oil generation by isothermal hydrous pyrolysis and S₂ generation by non-isothermal open-system pyrolysis. The derived kinetic parameters showed that timing of S₂ generation was not as different between the Type-IIS and -II kerogen based on open-system pyrolysis as compared with immiscible oil generation based on hydrous pyrolysis. Applying these kinetic parameters to a burial history in the Skole unit showed that some expelled oil would have been generated from the organic facies with Type-IIS kerogen before major thrusting with the hydrous-pyrolysis kinetic parameters but not with the open-system pyrolysis kinetic parameters. The inability of open-system pyrolysis to determine earlier petroleum generation from Type-IIS kerogen is attributed to the large polar-rich bitumen component in S₂ generation, rapid loss of sulfur free-radical initiators in the open system, and diminished radical selectivity and rate constant differences at higher temperatures. Hydrous-pyrolysis kinetic parameters are determined in the presence of water at lower temperatures in a closed system, which allows differentiation of bitumen and oil generation, interaction of free-radical initiators, greater radical selectivity, and more distinguishable rate constants as would occur during natural maturation. Kinetic parameters derived from hydrous pyrolysis show good correlations with one another (compensation effect) and kerogen organic-sulfur contents. These correlations allow for indirect determination of hydrous-pyrolysis kinetic parameters on the basis of the organic-sulfur mole fraction of an immature Type-II or -IIS kerogen.