“BASS 300 PARACOM”: a “model” underwaterparametric communication system

Parametric transduction offers valuable advantages for underwater acoustic communications. Perhaps the most significant benefit is the fact that high directivity is achieved by means of a physically small transmit transducer. This feature may, ultimately, be employed to permit long-range, low-frequency communication using a compact source. The high directivity is desirable to combat multipath propagation and to achieve data communications in water which is shallow by comparison with range. A real-time, high data-rate “model” differential phase shift keying (DPSK) communication system has been constructed and demonstrated. This system uses parametric transduction, with a 300-kHz primary frequency and a 50-kHz secondary frequency. Experimental results show that the system can be employed to combat multipath propagation in shallow water and can achieve high data-rate text and color image transmission at 10 and 20 kb s^-1 for 2-DPSK and 4-DPSK, respectively, through a transmission bandwidth of 10 kHz. The “model” system was developed to confirm performance predictions for a future, operational long-range link employing a 50-kHz primary frequency and a 5-kHz secondary frequency     

A reanalysis of the light curve of RT Persei with the W-D code

The UBV photometric observations of RT Per, from Sanwal and Chaubey (1981), were analyzed by the Wilson and Devinney code (1971). The light curves include reflection effects that for the first time has been suggested by Dugan (1911). RT Per has a semi-detached configuration where the lower-mass component is in contact with its respective Roche surface. The higher-mass component very nearly fills its Roche lobe. It has the characteristic of an Algol type system. The absolute dimensions for the primary and secondary of this system were calculated from its spectral types and by combining the photometric solution with inferred component radial velocities (Lu, 1990).     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Finite-element analysis of time-dependent large-deformation problems

An updated Lagrangian finite-element formulation has been developed for time-dependent problems of soil consolidation involving finite deformations. Large plastic strains as well as rotations occur in such problems and nominal stress measures are introduced in the formulation to redefine stresses. This leads to corrective terms for equilibrium and yield violations in addition to geometric stiffening terms in the governing integral equations. The soil is considered to be either a linear elastic or an elastoplastic, critical-state material. Some simple numerical examples are studied to validate the formulation, followed by a detailed analysis of the problem of penetration of a pile into soil. The results of this problem are viewed with emphasis on the physical interpretation and practical significance.     

Simulation of adaptive optics for the Vacuum Tower Telescope

A simulation model of the adaptive optics of the German Vacuum Tower Telescope (VTT), Observatorio del Teide, Tenerife, is presented. The model uses modules from the integrated model of the Euro50 extremely large telescope, and includes submodels of a Shack-Hartmann wavefront sensor, a de-formable mirror, a tip-tilt mirror, high-voltage amplifier low-pass filters, a reconstructor and a controller. We investigate the impact on the closed loop bandwidth of changes in controller configuration and certain system parameters, such as low pass filter bandwidth and camera integration and readout time. Control strategies were tested on simple models before implementation on the full VTT model. Using the models, different control strategies are compared.     

Environmental effects on galaxy luminosity functions: the cluster Abell 496

We have derived the galaxy luminosity function in various regions of the cluster of galaxies Abell 496 from a wide field image in the I band. A Schechter function fit in the 17≤ I_AB ≤22(–19.5≤ M_IAB ≤ –14.5) magnitude interval gives a steep power law index, which is somewhat steeper in the outer regions than in the inner zones. This result agrees with previous findings obtained by several teams on the Coma cluster and can be interpreted as due to the fact that faint galaxies are accreted by large ones in the central regions. This revised version was published online in July 2006 with corrections to the Cover Date.