Noble gases in ureilites released by crushing

Abstract— Noble gases in two ureilites, Kenna and Allan Hills (ALH) 78019, were measured with two extraction methods: mechanical crushing in a vacuum and heating. Large amounts of noble gases were released by crushing, up to 26.5% of ¹³²Xe from ALH 78019 relative to the bulk concentration. Isotopic ratios of the crush‐released Ne of ALH 78019 resemble those of the trapped Ne components determined for some ureilites or terrestrial atmosphere, while the crush‐released He and Ne from Kenna are mostly cosmogenic. The crush‐released Xe of ALH 78019 and Kenna is similar in isotopic composition to Q gas, which indicates that the crush‐released noble gases are indigenous and not caused by contamination from terrestrial atmosphere. In contrast to the similarities in isotopic composition with the bulk samples, light elements in the crush‐released noble gases are depleted relative to Xe and distinct from those of each bulk sample. This depletion is prominent especially in the ²⁰Ne/¹³²Xe ratio of ALH 78019 and the ³⁶Ar/¹³²Xe ratio of Kenna. The values of measured ³He/²¹Ne for the gases released by crushing are significantly higher than those for heating‐released gases. This suggests that host phases of the crush‐released gases might be carbonaceous because cosmogenic Ne is produced mainly from elements with a mass number larger than Ne. Based on our optical microscopic observation, tabular‐foliated graphite is the major carbon mineral in ALH 78019, while Kenna contains abundant polycrystalline graphite aggregates and diamonds along with minor foliated graphite. There are many inclusions at the edge and within the interior of olivine grains that are reduced by carbonaceous material. Gaps can be seen at the boundary between carbonaceous material and silicates. Considering these petrologic and noble gas features, we infer that possible host phases of crush‐released noble gases are graphite, inclusions in reduction rims, and gaps between carbonaceous materials and silicates. The elemental ratios of noble gases released by crushing can be explained by fractionation, assuming that the starting noble gas composition is the same as that of amorphous carbon in ALH 78019. The crush‐released noble gases are the minor part of trapped noble gases in ureilites but could be an important clue to the thermal history of the ureilite parent body. Further investigation is needed to identify the host phases of the crush‐released noble gases.     

Effect of vertical viscosity and diffusivity on tropical ocean circulation

Response of the tropical ocean to a uniform zonal wind is studied numerically and analytically. In addition to the Equatorial Undercurrent and surface westward flows on both sides of the equator, an eastward flow at the pycnocline depth is formed at several degrees latitude in both hemispheres. This subsurface eastward flow first appears in the eastern part of the ocean and extends to the west. Then it gradually decreases in speed, and at a steady state the speed is of the order of 1cm sec^–1. The spatial distribution of this subsurface flow is similar to the Subsurface Countercurrent, but the speed is one order smaller than that observed. The obtained thermostad is obscure compared with that observed. Whole of the time evolution produced by a numerical model can be accounted for by linear wave dynamics in a multi-layer model including vertical diffusion and friction. Although diffusion and friction are essential to maintain this subsurface flow, changes in the values of coefficients for vertical viscosity and diffusivity and also in initial density stratification lead only to a minor change in the speed of the subsurface eastward flow. It is concluded that a subsurface eastward flow with speed exceeding 10 cm sec^–1 accompanied by a distinctive thermostad structure cannot be explained by linear wave dynamics including vertical dissipation.     

Annual variation of methane in seawater in Funka bay,Japan

The concentration of methane in seawater was determined approximately once a month for one year from August 1990 to July 1991 at a station close to the center of Funka bay (92 m depth) and some supplementary observations were also carried out. The concentration of methane was usually increased with increasing depth, suggesting that methane was emitted from the bottom of the bay. While highly variable both spatially and temporally, the emission was intense in March and April, a period immediately after the spring bloom of phytoplankton. The maximum of methane found in the intermediate water suggests its source from the slope of the bay. The concentration of methane in the surface water changed seasonally and also interannually. The annually averaged flux of methane transferred to the atmosphere in the bay was estimated to be 6×10^–3 gCH₄m²/day. The coastal zone in the world may be a significant source of the atmospheric methane, although its source strength has yet to be accurately estimated from more data in different coastal seas.     

Convection induced by cooling at one side wall in two-dimensional non-rotating fluid —applicability to the deep Pacific circulation—

In recognition that similarity in the density balance leads to resemblance in circulation between the two-dimensional non-rotating and three-dimensional rotating systems which have similar density stratification, we investigate convection induced by cooling at one side wall and heating at the sea surface by using a two-dimensional non-rotating model as idealized representation for the deep Pacific circulation. In the model, various vertical profiles are taken for the side wall cooling, which are assumed to correspond to the density structure of the Anatarctic Circumpolar Current. In a small diffusivity range, two important features are found to be robust against change in the vertical profile of the side wall cooling. One is that the density stratification is horizontally almost uniform. The other is that the balance in the density equation between the vertical advection and the vertical diffusion holds in the interior. Consequently, the vertical density balance, together with the equation of continuity, determines the circulation pattern for the prescribed vertical profile of the side wall cooling. The multi-layered meridional flow, which is expected to exist in the deep Pacific, is shown to form for certain vertical profiles of the side wall cooling.     

Effects of bottom topography and density stratification on the formation of western boundary currents

A wind-driven, general circulation for a two-layer ocean with continental shelf-slope along the western boundary is studied numerically. Special attention is focused on the formation process of the western boundary current in the subtropical gyre. The western boundary current develops in the upper layer along the western boundary on the shelf-slope with a bottom trapped poleward flow in the lower layer. The poleward undercurrent is concentrated approximately along the contour lines of the potential vorticity,f/D, wheref is the Coriolis parameter andD the depth of the ocean. The separation of upper- and lower-layer flows on the shelf-slope represents a typical transient response. As the response approaches a steady state, the poleward undercurrent decreases in amplitude, and the motion tends to be confined to the upper layer. The flow pattern becomes similar to that found in a flat bottom ocean. A steady-state response is expected to be isostatic (no motion in the lower layer), even on the shelf-slope, as conservation of potential vorticity would suggest.The remarkable increase in transport of the western boundary current produced by the formation of an anticyclonic vortex on the shelf-slope extending throughout the hemisphere (Holland, 1973) does not occur in the wind-driven general circulation.     

Evapotranspiration from citrus trees growing in sandy soilunder drip irrigation with saline water

An experiment on evapotranspiration from citrus trees under irrigation with saline waterwas carried out for 4 months. Two lysimeters planted with a citrus tree in the green house wereused. One lysimeter was irrigated with saline water (NaCl and CaCl2 of 2000 mg/L equivalence,EC = 3.8 dS/m, SAR = 5.9) and the other was irrigated with freshwater using drip irrigation. Theapplied irrigation water was 1.2 times that of the evapotranspiration on the previous day.Evapotranspiration was calculated as the change in lysimeter weight recorded every 30 minutes.The lysimeters were filled with soil with 95.8% sand. The results of the experiment were as follows.(i) The evapotranspiration from citrus tree was reduced after irrigation with saline water. Theevapotranspiration returns to normal after leaching. However it takes months to exhaust the saltfrom the tree. ( ii ) To estimate the impact of irrigation with saline water on the evapotranspirationfrom citrus trees, the reduction coefficient due to salt stress (Ks) was used in this experiment.Evapotranspiration under irrigation with saline water (ETs) can be calculated from evapotranspira-tion under irrigation with freshwater (ET) by the equation ETs = Ks× ET. Ks can be expressed as afunction of ECsw. (iii) The critical soil-water electrical conductivity (ECsw) is 9.5 dS/m, beyondwhich adverse effects on evapotranspiration begin to appear. If ECsw can be controlled at below9.5 dS/m, saline water can be safely used for irrigation.     

Interpretation of charging on fracture or frictional slip surface of rocks

Fracturing and frictional sliding of quartz and granite under dry condition generates fractoluminescence, charged particle emission and electromagnetic radiation. Various kinds of experiments indicate that surface charge density on fracture or frictional slip surface of quartz and granite is 10⁻⁴ to 10⁻² C/m² which is larger than bound charges induced by the disappearance of piezoelectricity due to the release of stress. Hole and electron trapping centers, which is found in semiconductor devices with the Si–SiO₂ system, are causes of surface charging on fracture or frictional slip surface of quartz crystal. The quantity of the surface charge is enough to cause corona discharge that can generate earthquake lights. The mechanism considering the hole and electron trapping centers has a probability to explain why non-piezoelectric minerals or rocks generate electromagnetic phenomena. It can be one of origins of seismo-electromagnetic phenomena (SEP).     

Magnetotelluric Investigation of the Hydrothermal System and Heat Source in the Muine-Toyoha Geothermal Area, Hokkaido, Japan

Abstract. Magnetotelluric (MT) surveys were carried out around the Muine volcano, Hokkaido, Japan, where it is expected that the heat and metal source forming the polymetallic Ag-Pb-Zn-Cu-In Toyoha deposit is present at depth. Measurements were performed at 20 sites, 18 of which were located along a WSW-ENE profile traversing the north ridge of Mt. Muine. A resistivity model obtained from 2D inversion of the MT data shows subsurface specific conductive and resistive features. Conductive layers are present at the surface of Mt. Muine. The low resistivity is probably due to the clay-rich rocks associated with the hydrothermal alteration. A high resistivity layer, which corresponds to the pre-Tertiary Usubetsu Formation, crops out east of Mt. Muine and dips westward. At the west foot of Mt. Muine, relatively high resistive layers are widely exposed. The resistivity increases with depth and exceeds 1000 ohm-m. This fact indicates that this region is not influenced by the recent hydrothermal activity. An extremely conductive zone about 3–6 km wide and 6–9 km thick exists at a depth of 2 km below Mt. Muine. This zone mostly corresponds to an elastic wave attenuation zone detected by a seismic survey. It is interpreted as a large hydrothermal reservoir or melted magma, which is a heat source of the hydrothermal system in this area.     

Temperature and pH Dependence of Some Metals Leaching from Fly Ash of Municipal Solid Waste

Abstract. Municipal solid waste combustion leads to concentration of various metals in the solid residue (fly ash) remaining after combustion. These metals pose serious environmental hazard and require proper handling and monitoring in order to control their harmful effects. Leachability of some metals from fly ash was examined in fly ash and Milli-Q water mixture (liquid-to-solid ratio, 100) under various temperature and pH conditions in the laboratory. The leaching experiments conducted for 24 hours showed that pH was generally more important than temperature in controlling the amount of metals leached out of the fly ash. However, at a given pH, rise in temperature led to different degree of (usually one to two fold) enhanced or reduced leaching of metals. Owing to amphoteric nature of oxides of Al, Cr, Pb and Zn, these metals often yielded typical pattern of increase and decrease in their concentrations with change in pH. The extent of leaching of Cr and Pb in our experiments suggests that decrease of pH to acidic range in the case of Pb and to neutral to acidic range for Cr over a long period of storage of fly ash at solid waste dumping site may facilitate leaching of these metals from fly ash, leading to contamination of groundwater to the level that exceeds beyond the level permitted by the environmental laws.