Distribution of lunar impacts by objects in parabolic low inclination orbits

This paper presents a computer investigation extending to the case of parabolic orbits, an earlier investigation conducted by Barricelli and Metcalfe (1969) on lunar impacts by external low eccentricity satellites as a means to interpret the asymmetric distribution of lunar maria. Parabolic orbits can be approximated by two kinds of objects:

1. High eccentricity external satellites may, near periapsis, approach the Moon with orbital velocity and other characteristics closely resembling those of a parabolic orbit.
2. Asteroids and meteoroids approaching the Earth-Moon system with a low velocity may have moved in a nearly parabolic orbit when they reached the lunar distance from the Earth at the time when the impacts which carved the lunar maria took place.

The investigation gives, therefore, not only additional information relevant to the interpretation of the distribution of lunar maria by the satellite impacts hypothesis (in this case high eccentricity ones), but also information about the alternative hypothesis (Wood, 1973) that asteroid impacts rather than satellite impacts were involved.     

Molybdenum in icelandic geothermal waters

Molybdenum concentrations in Icelandic geothermal waters lie in the range 1–70 ppb. Warm waters and dilute high-temperature waters which contain high concentrations of sulphide are lowest in molybdenum. No correlation is otherwise observed between molybdenum concentrations and temperature. Surface waters and cold ground waters do not contain detectable molybdenum (<1 ppb). It seems likely that leaching rate is the prime factor in limiting molybdenum levels in these waters. Within individual geothermal fields molybdenum concentrations are either approximately constant or they vary regularly across the field. This regular variation may often be correlated with variations in other solute concentrations and subsurface temperatures and is taken to indicate a control of molybdenum mobility by a temperature dependent equilibrium. The evidence suggests that the solubility of molybdenite is responsible. Molybdenite has not been found in active geothermal systems in Iceland but is known to occur in some New Zealand geothermal systems and it has been identified in hydrothermally altered Tertiary basalt formations at Reydarártindur in southeast Iceland. Boiling and mixing with cold water leads to molybdenite undersaturation and thus these processes favour leaching of molybdenum from the rock. On the other hand, conductive cooling leads to supersaturation which favours removal of molybdenum from solution.     

Germanium in Icelandic geothermal systems

Germanium concentrations in geothermal waters in Iceland lie mostly in the range 2–30 ppb. There is an overall positive relation between the germanium content of the water and its temperature. Most of the germanium occurs as Ge(OH)^?₅in solution but Ge(OH)₄ may also be present in significant amounts in saline waters when above 200°C. Evidence indicates that aqueous germanium concentrations are controlled by exchange reactions where it substitutes for silica in silicates and iron in sulphides. It is the rate of dissolution and the relative abundance of the alteration minerals which take up germanium to a variable extent that ultimately fix Ge(OH)₄ concentrations in the water. This, together with water pH, fixes total dissolved germanium. It is mostly the primary rock composition that dictates the relative abundance of the alteration minerals. Conductive cooling in upflow zones favours removal of germanium from solution. During the initial stages of boiling of rising hot water dissolution is enhanced but precipitation at later stages.Thermodynamic data of various aqueous germanium species and several minerals are summarized and dissociation constants and solubilities estimated at elevated temperatures using available predictive methods.     

Description and interpretation of the composition of fluid and alteration mineralogy in the geothermal system,at Svartsengi,Iceland

The bulk composition and mineralogy of hydrothermally altered tholeiite, along with the composition and speciation of fluid, have been determined for a well-defined alteration zone at 240°C and 110 bars at Svartsengi, Iceland. Mass balances between the geothermal fluid and altered tholeiite, relative to a seawater/fresh water mixture and unaltered tholeiite, indicate the overall reaction per 1000 cm³ is: 1325 gm plagioclase + 1228 gm pyroxene + 215 gm oxide-minerals break down to form 685 gm chlorite + 636 gm albite + 441 gm quartz + 249 gm epidote + 266 gm calcite + 201 gm oxide-minerals + 15 gm pyrite, requiring an influx of 123 gm CO₂, 10 gm H₂S and 4 gm Na₂O and a release of 57 gm SiO₂, 35 gm FeO, 21 gm CaO, 8 gm MgO and 4 gm K₂O.Principal reactions, deduced from textural evidence, include Na-Ca exchange in plagioclase, precipitation of quartz, calcite and anhydrite, and formation of chlorite and epidote by reactions between groundmass minerals and fluid.Thermodynamic analyses of authigenic minerals and downhole fluid indicate that the fluid maintains a state close to equilibrium with the secondary mineral phases chlorite, epidote, albite, quartz, calcite, prehnite, anhydrite, pyrite and magnetite, whereas remnant primary labradorite and augite are out of equilibrium with the fluid.Water/rock ratios for the system are determined under a variety of assumptions. However, the open nature of the system makes comparisons with experimental and theoretical closed system studies ambiguous.     

The chemistry of geothermal waters in Iceland. III. Chemical geothermometry in geothermal investigations

New data from geothermal wells in Iceland have permitted empirical calibration of the chalcedony and $\text{Na}\text{K}$ geothermometers in the range of 25–180°C and 25–250°C respectively. The temperature functions are:

$\text{t°C=}\text{1112}\text{4.91?}\text{log SiO}{}_2\text{?273.15}$

$\text{t°C=}\text{933}\text{0.993+}\text{log Na/K}\text{?273.15}$

Concentrations are expressed in ppm. These temperature functions correspond well with the chalcedony solubility data of Fournier (1973) and the thermodynamic data for low-albite/microcline/solution equilibria of Heloeson (1969).A new CO₂ geothermometer is proposed which is considered to be useful in estimating underground temperatures in fumarolic geothermal fields. Its application involves analysis of CO₂ concentrations in the fumarole steam. The temperature function which applies in the range 180?300°C is: logCO₂ = 37.43 + 73192/T- 11829· 10₃/T² + 0.18923T- 86.187·logT where T is in °K and CO₂ in moles per kg of steam.     

1983–2003 decaying rate of deflation at Askja caldera: Pressure decrease in an extensive magma plumbing system at a spreading plate boundary

New deformation data from the Askja volcano, Iceland, show that the volcano's caldera has been deflating continuously for over 20 years, and confirm that the rate of subsidence is slowing down. The decay in subsidence rate can be fitted with a function of the form e ^{− t / τ} , where τ is 39 years. Reanalysis of GPS data from 1993–1998 show that these data can be fitted with a model calling for two Mogi point sources, one shallow, and another one much deeper (16.2 km depth). Pressure decrease occurs in both sources. The deeper source is responsible for observed horizontal contraction towards Askja at distances that cannot be explained by the shallower source. Plate spreading of 19 mm/year distributed evenly over about 100-km-wide zone is also favoured by the data.     

Seismic hazard assessment for Iceland in terms of macroseismic intensity using a site approach

We present the results of probabilistic seismic hazard assessment for Iceland in the framework of the EU project UPStrat-MAFA using the so-called site approach implemented in the SASHA computational code. This approach estimates seismic hazard in terms of macroseismic intensity by basically relying on local information about documented effects of past seismic events in the framework of a formally coherent and complete treatment of intensity data. In the case of Iceland, due to the lack of observed intensities for past earthquakes, local seismic histories were built using indirect macroseismic estimates deduced from epicentral information through an empirical attenuation relationship in probabilistic form. Seismic hazard was computed for four exceedance probabilities for an exposure time of 50 years, equivalent to average return periods of 50, 200, 475 and 975 years. For some localities, further return periods were examined and deaggregation analysis was performed. Results appear significantly different from previous seismic hazard maps, though just a semi-qualitative comparison is possible because of the different shaking measure considered (peak ground acceleration versus intensity), and the different computational methodology and input data used in these studies.