Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

Design of a 3D Chirp Sub-bottom Imaging System

Chirp sub-bottom profilers are marine acoustic devices that use a known and repeatable source signature (1–24 kHz) to produce decimetre vertical resolution cross-sections of the sub-seabed. Here the design and development of the first true 3D Chirp system is described. When developing the design, critical factors that had to be considered included spatial aliasing, and precise positioning of sources and receivers. Full 3D numerical modelling of the combined source and receiver directivity was completed to determine optimal source and receiver geometries. The design incorporates four source transducers (1.5–13 kHz) that can be arranged into different configurations, including Maltese Cross, a square and two separated pairs. The receive array comprises 240 hydrophones in 60 groups whose group-centres are separated by 25 cm in both horizontal directions, with each hydrophone group containing four individual elements and a pre-amplifier. After careful consideration, it was concluded that the only way to determine with sufficient accuracy the source–receiver geometry, was to fix the sources and receivers within a rigid array. Positional information for the array is given by a Real Time Kinematic GPS and attitude system incorporating four antennas to give position, heading, pitch and roll. It is shown that this system offers vertical positioning accuracy with a root-mean-square (rms) error less than 2.6 cm, while the horizontal positioning rms error was less than 2.0 cm. The system is configured so that the Chirp source signature can be chosen by software aboard the acquisition vessel. The complete system is described and initial navigational and seismic data results are presented. These data demonstrate that the approach of using fixed source-receiver geometry combined with RTK navigation can provide complete 3D imaging of the sub-surface.     

Accelerating ground warming in the Canadian Prairie provinces: Is it a result of global warming?

The results of precision temperature logs made to depths of several hundred meters in some 80 wells in Western Canada, most of which are located in the Prairie Provinces, show evidence of warming at the ground surface in the 0.5 K to 3.5 K range (average=2.2±0.7 K, for 80 unevenly distributed sites). Modeling shows that this warming mostly pertains to this century and it has been most substantal in the last four decades if the ramp function of the linear increase of surface temperature is assumed. Using the step function model's increase of surface temperature (land clearing, forest fires, etc.) the calculated onset of warming would pertain mostly to the last two decades. Contour maps of ground temperatures currently and previously and a contour map of the ground warming magnitude dilineate a large regional character of the ground temperature change at the southern marigin of permafrost for the large area of the Prairie Provinces. In many cases however, the magnitude of ground warming is much larger than the magnitude of air warming. This is especially evident for the northern areas of Alberta in the boreal forest ecoprovince. The magnitude of ground warming is equal to the magnitude of surface air warming in southern Alberta in the grassland and aspen parkland ecoprovinces. The analysis of the temperature depth response to the surface warming from well data shows the integrated effect of surface air warming together with the increases in ground temperature due to natural terrain effects and other anthropogenical changes to the surface of the earth.     

Aquatic hydrocarbon distributions in the Seine estuary: Biogenic polyaromatics and n-alkanes

Dissolved and particulate hydrocarbons of biogenic origin were investigated for the first time in surface waters along the Seine River and its estuary. They comprise n-alkanes (n-ALKs) and diagenetic polycyclic aromatic hydrocarbons (PAHs). Samples were collected in three different sections of the estuary: the riverine zone, the mixing zone, and the marine zone. At the river mouth, two mooring stations were used for the collection of samples over tidal cycles. Total particulate n-ALK concentrations ranged from 31 ng 1^?1 to 2,918 ng 1^?1, or 5 μg g^?1 dry ng 1^?1, or 2 μg g^?1 of SM. Concentrations varied with the SM load and could be related to sedimentation and estuarine mixing. The sources of the n-ALKs were different in each zone of the estuary. The dissolved n-ALKs displayed lower concentrations than the particulate phase, varying from 136 ng 1^?1 to 344 ng 1^?1, while biogenic dissolved PAHs were almost absent.     

A reconstruction of the palaeohydrological conditions of a flood‐plain: a multi‐proxy study from the Grabia River valley mire,central Poland

This study investigated the Grabia River valley mire in central Poland to reconstruct its palaeoenvironmental conditions from the Younger Dryas to the present. We analysed sedimentological, biological and geochemical data from the palaeo‐oxbow lake and valley mire to identify the principal hydrological trends, especially episodes of high water level. During the Lateglacial and Holocene, the Grabia River had a meandering channel, and its hydraulic parameters and the channel dimensions changed in response to climatic oscillations and vegetation development. We identified phases of high flood intensity and high groundwater level that correlate with regional and supraregional climatic events. The frequency and timing of palaeohydroclimatic oscillations show strong similarities to records from other sites in Poland and the rest of Europe. We show that various analytical methods, namely, pollen, plant macrofossils, Cladocera, Chironomidae, sedimentological, geochemical and radiocarbon data, can be effective tools for reconstructing past hydroclimatic changes in palaeo‐oxbow lakes and investigating the effects of past climate changes on river environments. The high sensitivity of the biota, especially Cladocera, to changes in water level permits the reconstruction of palaeoecological changes, especially flood episodes that occurred in the river valley. In particular, the increase in the proportion of sediment‐associated Cladocera and pelagic taxa was closely correlated with floods. Through comparisons with the palaeobiological data, geochemical data allowed the identification of humid phases within the fen associated with a rising groundwater table, direct fluvial activity (floods) and alluvial deposition. We also discuss the limitations of palaeohydrological reconstructions based on these proxies, especially on fossil aquatic invertebrates.     

Lithospheric mantle beneath NE part of Bohemian Massif and its relation to overlying crust: new insights from Pilchowice xenolith suite,Sudetes, SW Poland

International Journal of Earth Sciences - The Oligocene/Miocene basanite from Pilchowice (Sudetes Mts., SW Poland) carries numerous small xenoliths of mantle peridotite, mostly harzburgite. The...     

The first Surijokocixiidae (Insecta: Hemiptera: Fulgoromorpha) from the Triassic of China

A planthopper originally assigned to the genus Boreocixius in Surijokocixiidae (Surijokocixioidea, Fulgoromorpha) from the Ladinian (Middle Triassic) of Tongchuan in Shaanxi, northwestern China is described as Boreocixius tongchuanensis Zhang et al. sp. nov. As the third species ascribed to the genus, it differs from its congeners in having the much larger tegmen with postnodal veinlets and pigmented bands, providing new morphological information for Boreocixius. The establishment of the new species further increases the diversity of Boreocixius and Surijokocixiidae as well.     

A GIS-based WFD oriented typology of shallow micro-tidal soft bottom using wave exposure and turbidity mapping

Our GIS based project aims at producing a classification scheme to develop a typology of the bottom of the Bay of Gdansk in the southern Baltic. The typology was based on the abiotic factors which are used to define water body types by the European Water Framework Directive (WFD). Significance analysis of particular factors has shown that within the discussed area wave exposure seems to play the most important role. All other factors are to a greater or lesser degree correlated with these two. Taking into consideration the shallows and the varied coastline of the investigated area it was decided to make use of the SWAN numerical wave model to determine the influence of wave impact upon the bottom. The model was used to produce raster maps of orbital velocity near the bottom for each wind scenario. With the help of the GIS analysis the maps were turned into layers: the mean velocity and the maximum velocity at the bottom. To produce the layer of yearly amount of solar radiation a GIS model was built which main parameters were the layer of depth and three layers of turbidity for three seasons. The layers of the maximum orbital velocity and of the solar radiation at the bottom were then used in a classificatory procedure consisted in an iterative sequence of the three following steps: cluster formation, dendrogram analysis and classification using the maximum likelihood method. Ecological importance of the classification has been obtained by means of the aggregation of a part of classes based upon the statistics calculated for them within the GIS system with the help of the zonal function out of the following parameters: salinity, depth, mean and maximum orbital velocity at the bottom, temperature differences between warm and cold seasons, solar radiation, and type of sediments. The method proposed here makes it possible to produce high resolution thematic maps of the bottom even with incomplete data cover of the investigated area.