CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

Periodic Intrusion of Cold Water from the Pacific Ocean into the Bottom Layer of the Bungo Channel in Japan

A cold-water intrusion, called a “bottom intrusion”, occurs in the lower layer of the Bungo Channel in Japan. It is an intrusion from the shelf slope region of the Pacific Ocean margin in the south of the channel. In order to reveal the fundamental characteristics of the bottom intrusion, we conducted long-term observations of water temperature at the surface and bottom layers of the channel and 15-day current observations at the bottom of the shelf-break region. The long-term water temperature data indicated that the bottom intrusion occurs repeatedly between early summer and late autumn, and its reiteration between early and mid-summer causes a local minimum of water temperature in the lower layer in mid-summer. Moreover, the data revealed that most of the bottom intrusions occurred in neap tidal periods. The current meter recorded a bottom intrusion with a speed of approximately 15 cm⋅s⁻¹. The current meter also revealed that the intruded cold water slowly retreated back to the shelf slope region after the intrusion. This revised version was published online in July 2006 with corrections to the Cover Date.     

Gold Mineralization and Occurrence of Sinter in the Hoshino Area, Fukuoka Prefecture, Japan

Abstract. Several epithermal gold deposits occur in the Hoshino area, which is located in the western end of the late Cenozoic Hohi volcanic zone, north‐central Kyushu, Japan. The area is characterized by intermediate to felsic extrusive rocks of Pliocene age. In the Hoshino area, the shallow manifestation of the hydrothermal activity is exposed on the surface. Several outcrops of sinter are still preserved on the top of hydro thermally altered volcanic rocks, and high‐grade gold‐bearing quartz veins occur on the surface at lower levels. The hydrothermal alteration resulted into well‐developed alteration zones. The zonal alteration pattern, primarily of near‐neutral pH type, is characterized by the outer smectite zone of a lower temperature, and the inner mixed layer minerals zone of a higher temperature. Quartz vein‐related or fracture‐controlled alteration, is represented by the occurrence of interstratified illite/smectite and K‐feldspar, suggesting a potassium‐enriched alteration. The mineralization in the Hoshino area is recognized on the surface by the occurrence of gold‐bearing quartz veins distributed mainly in the mixed layer minerals zone. The fracture system related to the gold mineralization is mainly characterized by NW‐SE trend. The alteration pattern and the mineralogical composition of the veins suggest that the mineralizing fluids had near‐neutral pH and the mineralization is of low‐sulfidation‐type. Fluid inclusion data and textures observed in quartz veins indicate that gold precipitated during boiling. The chemical composition of quartz veins shows that high‐grade gold‐bearing quartz veins are characterized by higher content of Al₂O₃, K₂O and Rb. Several outcrops of silica‐sinters are distributed on the top of the mixed layer minerals zone. Although their structures are not very well preserved, because of later silicification, the Hoshino sinters still show characteristic textures identical to those observed in modern sinters, such as the presence of plant fossil incorporated into the sinters, the strongly developed depositional laminations and the columnar structures perpendicular to the depositional surfaces. Quartz is the only silica mineral constituting the Hoshino sinters presently. The conversion of amorphous silica into quartz was probably governed by higher temperatures resulting from later hydrothermal activity. This later hydrothermal activity is reflected by the intense silicification affecting mainly the lower parts of the sinters and also by the presence of quartz veins cutting the sinters. The distribution of sinters in the Hoshino area is very significant. The presence beneath the sinters of concealed high‐grade gold‐bearing quartz veins should be highly considered and exploration work is strongly suggested.     

Potential of mosques to serve as evacuation shelters for foreign Muslims during disasters: a case study in Gunma,Japan

Natural Hazards - Foreigners tend to be vulnerable to disasters due to religious and cultural differences. In Japan, Muslim foreign residents, who are minorities, likely face difficulties in terms...     

LEADAT: a MATLAB-based program for lead-210 data analysis of sediment cores

1Introduction Tracking the history of man s impact on the en-vironment, it is clear that in many places the periodof greatest impact and most dramatic transformationlies within the last 150 a (Oldfield and Appleby,1984). Many aspects of this impact can be…     

Origin of EL3 chondrites: Evidence for variable C/O ratios during their course of formation—A state of the art scrutiny

Mineral inventories of enstatite chondrites; (EH and EL) are strictly dictated by combined parameters mainly very low dual oxygen (fO₂) and sulfur (fS₂) fugacities. They are best preserved in the Almahata Sitta MS‐17, MS‐177 fragments, and the ALHA 77295 and MAC 88136 Antarctic meteorites. These conditions induce a stark change of the geochemical behavior of nominally lithophile elements to chalcophile or even siderophile and changes in the elemental partitioning thus leading to formation of unusual mineral assemblages with high abundance of exotic sulfide species and enrichment in the metallic alloys, for example, silicides and phosphides. Origin and mode of formation of these exotic chondrites, and their parental source regions could be best scrutinized by multitask research experiments of the most primitive members covering mineralogical, petrological, cosmochemical, and indispensably short‐lived isotopic chronology. The magnitude of temperature and pressure prevailed during their formation in their source regions could eventually be reasonably estimated: pre‐ and postaccretionary could eventually be deduced. The dual low fugacities are regulated by the carbon to oxygen ratios estimated to be >0.83 and <1.03. These parameters not only induce unusual geochemical behavior of the elements inverting many nominally lithophile elements to chalcophile or even siderophile or anthracophile. Structure and mineral inventories in EL3 and EH3 chondrites are fundamentally different. Yet EH3 and EL3 members store crucial information relevant to eventual source regions and importantly possible variation in C/O ratio in the course of their evolution. EL3 and EH3 chondrites contain trichotomous lithologies (1) chondrules and their fragments, (2) polygonal enstatite‐dominated objects, and (3) multiphase metal‐rich nodules. Mineralogical and cosmochemical inventories of lithologies in the same EL3 indicate not only similarities (REE inventory and anomalies in oldhamite) but also distinct differences (sinoite‐enstatite‐graphite relationship). Oldhamite in chondrules and polygonal fragments in EL3 depict negative Eu anomaly attesting a common cosmochemical source. Metal‐dominated nodules in both EL3 and EH3 are conglomerates of metal clasts and sulfide fragments in EH3 and concentrically zoned C‐bearing metal micropebbles (≥25 μm ≤50 μm) in EL3 thus manifesting a frozen in unique primordial accretionary metal texture and composition. Sinoite‐enstatite‐diopside‐graphite textures reveal a nucleation and growth strongly suggestive of fluctuating C/O ratio during their nucleation and growth in the source regions. Mineral inventories, sulfide phase relations, sinoite‐enstatite‐graphite intergrowth, carbon and nitrogen isotopic compositions of graphite, spatial nitrogen abundance in graphite in metal nodules, and last but not least ¹²⁹I/¹²⁹Xe and ⁵³Mn/⁵³Cr systematics negate any previously suggested melting episode, pre‐accretionary or dynamic, in parental asteroids.     

Composition of the core,I. Solubility of oxygen in molten iron at high temperatures

Experiments on the solubility of FeO in molten iron have been carried out at temperatures between 2100 and 2550°C. The results show that liquid FeO is extensively soluble in molten iron at 2500°C and indicate that they probably become completely miscible above 2800°C. Liquid iron in equilibrium with crystalline magnesiowüstite (Mg_0.8Fe_0.2)O which is believed to be an important mineral in the lower mantle, would dissolve about 14 mol.% of FeO at 2500°C and 40 mol.% of FeO at 2800°C. The geochemical implications of these results are discussed. It is concluded that the outer core probably contains a large amount of dissolved FeO and that oxygen is probably the principal light element in the outer core.     

Application of an infrared carbon dioxide and humidity instrument to studies of turbulent transport

A calibration equation and some results of the field performance of an infrared instrument, which is designed to measure simultaneous fluctuations of atmospheric carbon dioxide and water vapor, are described. Field observations show that the instrument is suitable for simultaneous measurement of turbulent fluxes of carbon dioxide and water vapor in conjunction with a sonic anemometer. Measured values of carbon dioxide and water vapor fluxes show diurnal variations characterized by crop activity with respect to assimilation, respiration and evapotranspiration. Carbon dioxide is transferred downward during the daytime and upward at night, while latent heat and sensible heat are transferred in the opposite sense. The non-dimensional gradient of carbon dioxide is expressed in the following form under weak unstable conditions: _c = (1 – 16 _v )^-1/2. Here, _v is the Monin-Obukhov stability parameter including the humidity effect. This relation was originally proposed for temperature and humidity. Thus, the results indicate that the turbulent mechanisms of carbon dioxide fluctuations are similar to those of other scalar entities. This is strongly supported by the high correlation coefficient found between fluctuations of carbon dioxide and temperature or humidity in the air layer over crop fields.     

Transition enthalpies and entropies of high pressure zinc metasilicates and zinc metagermanates

The enthalpies of transition at T= 298 K between zinc metasilicate assemblages, measured by molten oxide solution calorimetry, are:

Predicting the displacement of triple pendulum™ bearings in a full‐scale shaking experiment using a three‐dimensional element

The accuracy of a series spring model to predict the peak displacement and displacement history of Triple Pendulum? (TP) bearings in a strongly shaken, full‐scale building is evaluated in this paper. The series spring model was implemented as a self‐contained three‐dimensional TP bearing element in OpenSees and is now available for general use. The TP bearing element contains the option for constant friction or a generalized friction model that accounts for the effect of instantaneous velocity and compression load on the friction coefficient. Comparison between numerical simulation and experimental data of a five‐story steel moment frame building shows that the peak displacement of isolation system can generally be predicted with confidence using a constant friction coefficient model. The friction coefficient model accounting for the effect of axial load and velocity leads to minor improvement over the constant friction coefficient models in some cases. Copyright © 2013 John Wiley & Sons, Ltd.