Nutrient (P, N) dynamics in the southwestern Kattegat, Scandinavia: sedimentation and resuspension effects

 The yearly nutrient supply from land and atmosphere to the study area in SW Kattegat is 10 900 tons of N and 365 tons of P. This is only few percent of the supply from adjacent marine areas, as the yearly transport through the study area is 218 000 tons of N and 18 250 tons of P. Yearly net deposition makes up 1340 tons of N (on average 2.5 g m^–2 yr^–1) and 477 ton of P (on average 0.9 g m^–2 yr^–1). Shallow-water parts of the study area have no net deposition because of frequent (>35% of the year) resuspension. Resuspension frequency in deep water is <1% of the year. Resuspension rates, as averages for the study area, are 10–17 times higher than net deposition rates. Because of resuspension, shallow-water sediments are coarse lag deposits with small amounts of organic matter (1.1%) and nutrients (0.04% N and 0.02% P). Deep-water sediments, in contrast, are fine grained with high levels of organic matter (11.7%) and nutrients (0.43% N and 0.15% P). Laboratory studies showed that resuspension changes the diffusive sediment water fluxes of nutrients, oxygen consumption, and penetration into the sediment. Fluxes of dissolved reactive phosphate from sediment to water after resuspension were negative in organic-rich sediments (13.2% organic matter) with low porosity (56) and close to zero in coarse sediments with a low organic matter content (2.3%) and high porosity (73). Fluxes of inorganic N after resuspension were reduced to 70% and 0–20% in relation to the rates before resuspension, respectively. Received: 10 July 1995 · Accepted: 19 January 1996     

Physiological and behavioral responses of Bathynerita naticoidea (Gastropoda: Neritidae) and Methanoaricia dendrobranchiata (Polychaeta: Orbiniidae) to hypersaline conditions at a brine pool cold seep

Bathynerita naticoidea (Gastropoda: Neritidae) and Methanoaricia dendrobranchiata (Polychaeta: Orbiniidae) are two of the most abundant invertebrates associated with cold‐seep mussel beds in the Gulf of Mexico. At the methane seep known as Brine Pool NR‐1 (27 °43.415 N, 91 °16.756 W; 650 m depth), which is surrounded by a broad band of mussels (Bathymodiolus childressi), these species have distinctly different patterns of abundance, with the gastropod being found mostly at the outer edge of the mussel bed (average density in November 2003: 817 individuals·m⁻² in outer zone, 20·m⁻² in inner zone) and the polychaete being found almost exclusively near the inner edge (average density in November 2003: 3155 individuals·m⁻² in inner zone, 0·m⁻² in outer zone), adjacent to the brine pool itself. The salinity of the brine pool exceeds 120, so we hypothesized that M. dendrobranchiata should be more tolerant of high salinities than B. naticoidea. The opposite proved to be true. The gastropods were capable of withstanding salinities at least as high as 85, whereas the polychaetes died at salinities higher than 75. Both species were osmoconformers over the range of salinities (35–75) tested. Behavioral responses of B. naticoidea to salinities of 50, 60, and 70 were investigated in inverted vertical haloclines. Gastropods generally did not enter water of salinity greater than 60, but tolerated short periods at 60. Behavioral avoidance of brine should limit the vertical distribution of B. naticoidea in the inner zone to the top 2.5–5 cm of the mussel bed. Behavior is also a likely (though unproven) mechanism for controlling horizontal distribution of this species across the mussel bed. Methanoaricia dendrobranchiata can tolerate short excursions into the brine, but probably avoids hypersaline conditions by aggregating on the tops of the mussels.     

Optimizing a layered and laterally constrained 2D inversion of resistivity data using Broyden's update and 1D derivatives

Dense profile-oriented resistivity data allows for 2D and 3D inversions. However, huge amounts of data make it practically impossible to do full 2D or 3D inversions on a routine basis. Therefore, a number of approximations have been suggested over the years to speed up computations. We suggest using a combination of Broyden's update on the Jacobian matrix with derivatives calculated using a 1D formulation on a parameterized 2D model of locally 1D layered models. The approximations bring down the effective number of 2D forward responses to a minimum, which again gives us the ability to invert very large sections. Broyden's update is not as useful with a parameterized problem as is the case with a smooth minimum structure problem that has been the usual application. 1D derivatives, however, seem to be very effective when initiating a full 2D solution with Broyden's update. We compare the different methods using two different kinds of data on two synthetic models and on two field examples. The most effective and reliable optimization combines 1D derivatives with a full 2D solution and Broyden's update. When using Broyden's update the Jacobian matrix needs to be reset every once in a while. We do this whenever the difference in data residual from the previous iteration is less than 5%. This combined inversion method reduces the computation time approximately a factor of 3 without losing model resolution.     

Using a Thermal Proxy to Examine Sediment–Water Exchange in Mid-Continental Shelf Sandy Sediments

Fluid exchange across the sediment–water interface in a sandy open continental shelf setting was studied using heat as a tracer. Summertime tidal oscillation of cross-shelf thermal fronts on the South Atlantic Bight provided a sufficient signal at the sediment–water interface to trace the advective and conductive transport of heat into and out of the seabed, indicating rapid flushing of ocean water through the upper 10–40 cm of the sandy seafloor. A newly developed transport model was applied to the in situ temperature data set to estimate the extent to which heat was transported by advection rather than conduction. Heat transported by shallow 3-D porewater flow processes was accounted for in the model by using a dispersion term, the depth and intensity of which reflected the depth and intensity of shallow flushing. Similar to the results of past studies in shallower and more energetic nearshore settings, transport of heat was greater when higher near-bed velocities and shear stresses occurred over a rippled bed. However, boundary layer processes by themselves were insufficient to promote non-conductive heat transport. Advective heat transport only occurred when both larger boundary layer stresses and thermal instabilities within the porespace were present. The latter process is dependent on shelf-scale heating and cooling of bottom water associated with upwelling events that are not coupled to local-scale boundary layer processes.     

Tidal Habitats Support Large Numbers of Invasive Blue Catfish in a Chesapeake Bay Subestuary

The introduction of a non-native freshwater fish, blue catfish Ictalurus furcatus, in tributaries of Chesapeake Bay resulted in the establishment of fisheries and in the expansion of the population into brackish habitats. Blue catfish are an invasive species in the Chesapeake Bay region, and efforts are underway to limit their impacts on native communities. Key characteristics of the population (population size, survival rates) are unknown, but such knowledge is useful in understanding the impact of blue catfish in estuarine systems. We estimated population size and survival rates of blue catfish in tidal habitats of the James River subestuary. We tagged 34,252 blue catfish during July–August 2012 and 2013; information from live recaptures (n = 1177) and dead recoveries (n = 279) were used to estimate annual survival rates and population size using Barker’s Model in a Robust Design and allowing for heterogeneity in detection probabilities. The blue catfish population in the 12-km study area was estimated to be 1.6 million fish in 2013 (95% confidence interval [CI] adjusted for overdispersion: 926,307–2,914,208 fish). Annual apparent survival rate estimates were low: 0.16 (95% CI 0.10–0.24) in 2012–2013 and 0.44 (95% CI 0.31–0.58) in 2013–2014 and represent losses from the population through mortality, permanent emigration, or both. The tagged fish included individuals that were large enough to exhibit piscivory and represented size classes that are likely to colonize estuarine habitats. The large population size that we estimated was unexpected for a freshwater fish in tidal habitats and highlights the need to effectively manage such species.     

Origins and evolution of rhyolitic magmas in the central Snake River Plain: insights from coupled high-precision geochronology,oxygen isotope,and hafnium isotope analyses of zircon

We present new high-precision CA-ID-TIMS and in situ U–Pb ages together with Hf and O isotopic analyses (analyses performed all on the same grains) from four tuffs from the 15?10 Ma Bruneau–Jarbidge center of the Snake River Plain and from three rhyolitic units from the Kimberly borehole in the neighboring 10?6 Ma Twin Falls volcanic center. We find significant intrasample diversity in zircon ages (ranges of up to 3 Myr) and in δ¹⁸O (ranges of up to 6‰) and ε_Hf (ranges of up to 24 ε units) values. Zircon rims are also more homogeneous than the associated cores, and we show that zircon rim growth occurs faster than the resolution of in situ dating techniques. CA-ID-TIMS dating of a subset of zircon grains from the Twin Falls samples reveals complex crystallization histories spanning 10⁴–10⁶ years prior to some eruptions, suggesting that magma genesis was characterized by the cyclic remelting of buried volcanic rocks and intrusions associated with previous magmatic episodes. Age-dependent trends in zircon isotopic compositions show that rhyolite production in the Yellowstone hotspot track is driven by the mixing of mantle-derived melts (normal δ¹⁸O and ε_Hf) and a combination of Precambrian basement rock (normal δ¹⁸O and ε_Hf down to ??60) and shallow Mesozoic and Cenozoic age rocks, some of which are hydrothermally altered (to low δ¹⁸O values) by earlier stages of Snake River Plain magmatism. These crustal melts hybridize with juvenile basalts and rhyolites to produce the erupted rhyolites. We also observe that the Precambrian basement rock is only an important component in the erupted magmas in the first eruption at each caldera center, suggesting that the accumulation of new intrusions quickly builds an upper crustal intrusive body which is isolated from the Precambrian basement and evolves towards more isotopically juvenile and lower-δ¹⁸O compositions over time.