Dynamical implications of Jupiter's tropospheric ammonia abundance

Groundbased radio observations indicate that Jupiter's ammonia is globally depleted from 0.6 bars to at least 4-6 bars relative to the deep abundance of ∼3 times solar, a fact that has so far defied explanation. The observations also indicate that (i) the depletion is greater in belts than zones, and (ii) the greatest depletion occurs within Jupiter's local 5-μm hot spots, which have recently been detected at radio wavelengths. Here, we first show that both the global depletion and its belt-zone variation can be explained by a simple model for the interaction of moist convection with Jupiter's cloud-layer circulation. If the global depletion is dynamical in origin, then important endmember models for the belt-zone circulation can be ruled out. Next, we show that the radio observations of Jupiter's 5-μm hot spots imply that the equatorial wave inferred to cause hot spots induces vertical parcel oscillation of a factor of ∼2 in pressure near the 2-bar level, which places important constraints on hot-spot dynamics. Finally, using spatially resolved radio maps, we demonstrate that low-latitude features exceeding ∼4000 km diameter, such as the equatorial plumes and large vortices, are also depleted in ammonia from 0.6 bars to at least 2 bars relative to the deep abundance of 3 times solar. If any low-latitude features exist that contain 3-times-solar ammonia up to the 0.6-bar ammonia condensation level, they must have diameters less than ∼4000 km.     

Geochemistry, petrology and ages of the lunar meteorites Kalahari 008 and 009: New constraints on early lunar evolution

Kalahari 008 and 009 are two lunar meteorites that were found close to each other in Botswana. Kalahari 008 is a typical lunar anorthositic breccia; Kalahari 009 a monomict breccia with basaltic composition and mineralogy. Based on minor and trace elements Kalahari 009 is classified as VLT (very-low-Ti) mare basalt with extremely low contents of incompatible elements, including the REE. The Lu-Hf data define an age of 4286 ± 95 Ma indicating that Kalahari 009 is one of the oldest known basalt samples from the Moon. It provides evidence for lunar basalt volcanism prior to 4.1 Ga (pre-Nectarian) and may represent the first sample from a cryptomare. The very radiogenic initial ¹⁷⁶Hf/¹⁷⁷Hf (εHf = +12.9 ± 4.6), the low REE, Th and Ti concentrations indicate that Kalahari 009 formed from re-melting of mantle material that had undergone strong incompatible trace element depletion early in lunar history. This unusually depleted composition points toward a hitherto unsampled basalt source region for the lunar interior that may represent a new depleted endmember source for low-Ti mare basalt volcanism. Apparently, the Moon became chemically very heterogeneous at an early stage in its history and different cumulate sources are responsible for the diverse mare basalt types.Evidence that Kalahari 008 and 009 may be paired includes the similar fayalite content of their olivine, the identical initial Hf isotope composition, the exceptionally low exposure ages of both rocks and the fact that they were found close to each other. Since cryptomaria are covered by highland ejecta, it is possible that these rocks are from the boundary area, where basalt deposits are covered by highland ejecta. The concentrations of cosmogenic radionuclides and trapped noble gases are unusually low in both rocks, although Kalahari 008 contains slightly higher concentrations. A likely reason for this difference is that Kalahari 008 is a polymict breccia containing a briefly exposed regolith, while Kalahari 009 is a monomict brecciated rock that may never have been at the surface of the Moon.Altogether, the compositions of Kalahari 008 and 009 permit new insight into early lunar evolution, as both meteorites sample lunar reservoirs hitherto unsampled by spacecraft missions. The very low Th and REE content of Kalahari 009 as well as the depletion in Sm and the lack of a KREEP-like signature in Kalahari 008 point to a possible source far from the influence of the Procellarum-KREEP Terrane, possibly the lunar farside.     

Plesiosaurs

Plesiosaurs are an unusual and intriguing group of extinct aquatic reptiles ( Fig. 1 ). They are sauropterygians, a group known from an array of semi‐aquatic forms during the Triassic period: placodonts, pachypleurosaurs and nothosaurs. The first plesiosaurs are known from the very latest Triassic, but by the Early Jurassic plesiosaurs were cosmopolitan in distribution and lasted successfully to the latest Cretaceous, when they became victims of the K‐T extinction event. Plesiosaurs were predominantly marine organisms, although their fossils are not uncommon in brackish or even fresh water deposits. We know that all plesiosaurs were carnivorous; many of them were top predators in their respective ecosystems. But with no living descendants (or analogues) plesiosaurs are mysterious fossil organisms—as we will see, many questions regarding their biology remain unanswered or contentious. However, plesiosaurs are currently undergoing renewed scientific attention.

Figure 1 Open in figure viewer PowerPoint The beautifully preserved skeleton of the plesiosaur Rhomaleosaurus victor seen in ventral view, from the Lower Jurassic (Toarcian) of Holzmaden, Germany (total length 3.44 m). Redrawn from Fraas (1910).     

Inventory of nonvolatile fatty acids and hydrocarbons in the oceans

A survey of the distribution of nonvolatile fatty acids and hydrocarbons in the oceans is given. The results represent more a “feel” from the literature rather than a mathematical analysis and are given in Table III. Fatty acid concentration appears to show a greater variation, presumably because they are more prone to biological influences than the hydrocarbons.     

Bringing GPS into harsh environments for fully automated deformation monitoring

Engineering projects that require deformation monitoring frequently utilize geodetic sensors to measure displacements of target points located in the deformation zone. In situations where control stations and targets are separated by a kilometer or more, GPS can offer higher precision position updates at more frequent intervals than can normally be achieved using total station technology. For large-scale deformation projects requiring the highest precision, it is therefore advisable to use a combination of the two sensors. In response to the need for high precision, continuous GPS position updates in harsh deformation monitoring environments, a software has been developed that employs triple-differenced carrier-phase measurements in a delayed-state Kalman filter. Two data sets were analyzed to test the capabilities of the software. In the first test, a GPS antenna was displaced using a translation stage to mimic slow deformation. In the second test, data collected at a large open pit mine were processed. It was shown that the delayed-state Kalman filter developed could detect millimeter-level displacements of a GPS antenna. The actual precision attained depends upon the amount of process noise infused at each epoch to accommodate the antenna displacements. Higher process noise values result in quicker detection times, but at the same time increase the noise in the solutions. A slow, 25 mm displacement was detected within 30 min of the full displacement with sigma values in E, N and U of ±10 mm or better. The same displacement could also be detected in less than 5 h with sigma values in E, N and U of ±5 mm or better. The software works best for detecting long period deformations (e.g., 20 mm per day or less) for which sigma values of 1–2 mm are attained in all three solution components. It was also shown that the triple-differenced carrier-phase observation can be used to significantly reduce the effects of residual tropospheric delay that would normally plague double-differenced observations in harsh GPS environments.

Micromechanical approach to unsaturated water flow in structured geomaterials by two-scale computations

This article presents a micromechanical approach to the problem of unsaturated water flow in heterogeneous porous media in transient conditions. The numerical formulation is based on the two-scale model obtained previously by periodic homogenization. It allows for a coupled solution of the non-linear flow equations at macroscopic and microscopic scales and takes into account the macroscopic anisotropy of the medium and the local non-equilibrium of the capillary pressure. The model was applied to simulate two-dimensional water infiltration at constant flux into an initially dry medium containing inclusions of square and rectangular shapes. The numerical results showed the influence of the inclusion–matrix conductivity ratio and the local geometry on the macroscopic behavior. The influence of the conductivity ratio manifested itself by the acceleration or retardation of the onset of the macroscopic water flux at the outlet, while the local geometry (anisotropy) significantly affected the macroscopic spatial distribution of the water flux. Such type of approach can be extended to simulate coupled phenomena (for example hydro-mechanical problems) with evolving local geometry.     

Non-radial stellar oscillations: a perspective from potential scattering (I)

This article is the first in a series designed to gain insight into the stellar oscillation problem from a somewhat novel point of view: that of potential scattering, well-known in the quantum mechanical literature. In this paper the known theoretical foundations are developed and applied in the context of the astrophysical problem, wherein the star itself (rather than any portion of it) is the potential which scatters waves and traps them. The basis for the identification of a precisely defined scattering problem is the existence of a linear Schrödinger equation associated both globally (Section 2) and locally (Section 8) with the nonlinear eigenvalue equation for nonradial stellar pulsations. The paper is also designed to be a fairly complete account of the relevant mathematical topics that are germane to a study of this kind. This paper is dedicated to the memory of Professor Zdenèk Kopal, who was a great source of professional encouragement to me during the last fifteen years of his life.     

Rates of Deglaciation during the Last Glaciation and Holocene in the Cordillera Vilcanota-Quelccaya Ice Cap Region, Southeastern Perú

Moraine chronology is combined with digital topography to model deglacial rates of paleoglacier volumes in both the Huancané Valley on the west side of the Quelccaya Ice Cap and the Upismayo Valley on the northwest side of the Cordillera Vilcanota. The fastest rates of deglaciation (39×10⁻⁵ to 114×10⁻⁵ km³ yr⁻¹ and 112×10⁻⁵ to 247×10⁻⁵ km³ yr⁻¹ for each valley, respectively) were calculated for the most recent paleoglaciers, corresponding to the last few centuries. These results are consistent with observations in the Venezuelan Andes showing high rates of deglaciation since the Little Ice Age. These rates also fall within the range of 20th century rates of deglaciation measured on the Quelccaya Ice Cap (29×10⁻⁵ to 220×10⁻⁵ km³ yr⁻¹, Brecher and Thompson, 1993; Thompson, 2000). These results imply that rates of deglaciation may fluctuate significantly over time and that high rates of deglaciation may not be exclusive to the late 20th century. Equilibrium line altitude (ELA) depressions for the ice volumes of the last glaciation modeled here were computed as 230 m for the Quelccaya Ice Cap and 170 m for the Cordillera Vilcanota. Maximum ELA depressions are lower than previously published: <500 m for the Cordillera Vilcanota and <400 m for the Quelccaya Ice Cap. These lower values could imply a topographic control over paleoglacier extent.