Tektite research 1936–1990*

Abstract— Fifty-odd years of tektite research are reviewed, proceeding from the discovery of the first North American tektites in 1936. This included the early recognition that tektites were terrestrial objects rather than meteorites and that the glassy particles in tektites were fused quartz (lechatelierite). Later, during National Science Foundation-supported research, it was found that some tektites appeared to have formed as puddles of melt, that the content and character of bubbles in lechatelierite can be used as a relative temperature scale, that rayed bubbles in tektites formed from hydrous minerals, that bubbles in tektites formed chiefly from water which was absorbed into the walls of the bubbles leaving vacuums, and that “fingers” in the surficial part of some tektites may have formed by differential volatilization. Some unpublished observations and adventures are briefly reported.     

Multistep matched-field inversion for broad-band data from ASIAEX2001

This paper discusses the results of geoacoustic inversion carried out using explosive charge data from the Asian Seas International Acoustic Experiment (ASIAEX) East China Sea (ECS) Experiment. A multifrequency incoherent matched-field inversion processor and a genetic algorithm (GA) are used for the inversion. A multistep matched field inversion approach is presented, which makes use of the varying sensitivities of wave fields at various frequencies to reduce the inversion problem into a sequence of smaller inversions with fewer unknowns to estimate at each stage. Different parameters are estimated using data at different frequencies according to their sensitivities. Inversion results for different areas in the ECS region are summarized and compared with core data.     

High spectral resolution ground-based observations of Venus in the 450- to 1250-cm−1 region

Ground-based observations of Venus were made with a 5-cm drive Michelson interferometer during December 1970 and December 1973. The thermal emission spectrum of the central portion of the apparent disk was recorded from 450–1250 cm^?1 with an apodized spectral resolution of 0.25 cm^?1. All statistically significant sharp line absorption features in the spectrum have been identified with gaseous CO₂. Comparison between the observed spectrum and a synthetic spectrum computed from a model atmosphere, assuming gaseous CO₂ and a sulfuric acid haze as opacity sources, indicates good agreement. A broad diffuse absorption feature associated with the sulfuric acid haze is evident in the 870- to 930 cm^?1 region. With the exception of the rotational lines of the 927-cm^?1 CO₂ band, the above feature appears as a continuum down to 0.25 cm^?1 resolution. In the 750- to 1250-cm^?1 range, the spectrum exhibits moderate thermal contrast with maximum brightness temperatures of 234–238°K occurring near 825 cm^?1. These temperatures are in general agreement with previous measurements.     

A hexagonal sampling grid for 3D recording and processing of 3D seismic data

3D seismic data are usually recorded and processed on rectangular grids, for which sampling requirements are generally derived from the usual 1D viewpoint. For a 3D data set, the band region (the region of the Fourier space in which the amplitude spectrum is not zero) can be approximated by a domain bounded by two cones. Considering the particular shape of this band region we can use the 3D sampling viewpoint, which leads to weaker sampling requirements than does the 1D viewpoint; i.e. fewer sample points are needed to represent data with the same degree of accuracy. The 3D sampling viewpoint considers regular nonrectangular sampling grids. The recording and processing of 3D seismic data on a hexagonal sampling grid is explored. The acquisition of 3D seismic data on a hexagonal sampling grid is an advantageous economic alternative because it requires 13.4% fewer sample points than a rectangular sampling grid. The hexagonal sampling offers savings in data storage and processing of 3D seismic data. A fast algorithm for 3D discrete spectrum evaluation and trace interpolation in the case of a 3D seismic data set sampled on a hexagonal grid is presented and illustrated by synthetic examples. It is shown that by using this algorithm the hexagonal sampling offers, approximately, the same advantage of saving 13.4% in data storage and computational time for 3D phase-shift migration.     

Analysis of Cassini/CIRS limb spectra of Titan acquired during the nominal mission II: Aerosol extinction profiles in the 600–1420 cm spectral range

We have analyzed the continuum emission of limb spectra acquired by the Cassini/CIRS infrared spectrometer in order to derive information on haze extinction in the 3–0.02 mbar range (∼150–350 km). We focused on the 600–1420 cm⁻¹ spectral range and studied nine different limb observations acquired during the Cassini nominal mission at 55°S, 20°S, 5°N, 30°N, 40°N, 45°N, 55°N, 70°N and 80°N. By means of an inversion algorithm solving the radiative transfer equation, we derived the vertical profiles of haze extinction coefficients from 17 spectral ranges of 20-cm⁻¹ wide at each of the nine latitudes. At a given latitude, all extinction vertical profiles retrieved from various spectral intervals between 600 and 1120 cm⁻¹ display similar vertical slopes implying similar spectral characteristics of the material at all altitudes. We calculated a mean vertical extinction profile for each latitude and derived the ratio of the haze scale height (H_haze) to the pressure scale height (H_gas) as a function of altitude. We inferred H_haze/H_gas values varying from 0.8 to 2.4. The aerosol scale height varies with altitude and also with latitude. Overall, the haze extinction does not show strong latitudinal variations but, at 1 mbar, an increase by a factor of 1.5 is observed at the north pole compared to high southern latitudes. The vertical optical depths at 0.5 and 1.7 mbar increase from 55°S to 5°N, remain constant between 5°N and 30°N and display little variation at higher latitudes, except the presence of a slight local maximum at 45°N. The spectral dependence of the haze vertical optical depth is uniform with latitude and displays three main spectral features centered at 630 cm⁻¹, 745 cm⁻¹ and 1390 cm⁻¹, the latter showing a wide tail extending down to ∼1000 cm⁻¹. From 600 to 750 cm⁻¹, the optical depth increases by a factor of 3 in contrast with the absorbance of laboratory tholins, which is generally constant. We derived the mass mixing ratio profiles of haze at the nine latitudes. Below the 0.4-mbar level all mass mixing ratio profiles increase with height. Above this pressure level, the profiles at 40°N, 45°N, 55°N, at the edge of the polar vortex, display a decrease-with-height whereas the other profiles increase. The global increase with height of the haze mass mixing ratio suggest a source at high altitudes and a sink at low altitudes. An enrichment of haze is observed at 0.1 mbar around the equator, which could be due to a more efficient photochemistry because of the strongest insolation there or an accumulation of haze due to a balance between sedimentation and upward vertical drag.     

Atmospheric variations and meteorite production on Mars

Through a combination of aerobraking (drag deceleration) and ablation, meteoroids which enter planetary atmospheres may be slowed sufficiently to soft-land as meteorites. Results of an earlier study suggest that the current 6 mbar atmosphere of Mars is sufficient to aerobrake significant numbers of small (<10 kg) asteroidal-type meteoroids into survivable, low-velocity (<500 m s⁻¹) impacts with the planet's surface. Since rates of meteorite production depend upon the density of Mars's atmosphere, they must also change as the martian climate changes. However, to date, martian meteorite production has received relatively little attention in the literature Here we expand upon our previous work to study martian meteorite production rates and how they depend upon variations of the martian atmosphere, and to estimate the ranges of mass, velocity and entry-angle that produce meteorites. We find that even the current atmosphere of Mars is sufficient to soft-land significant fractions of incident stony and iron objects, and that these fractions increase dramatically for denser martian atmospheres. Therefore, like impact cratering, meteorite populations may preserve evidence of past martian climates.     

An improved shadow measurement technique for constraining the morphometry of simple impact craters

Abstract— The lengths of the shadows cast within simple, bowl‐shaped impact craters have been used to constrain their depths on a variety of planetary bodies. This technique, however, only yields the “true” crater depth if the shadow transects the crater center where the floor is deepest. In the past, attempts have been made to circumvent this limitation by choosing only craters where the shadow tip lies very near the crater center; but this approach may introduce serious artifacts that adversely affect the slope of the regressed depth vs. diameter data and its variance. Here we introduce an improved method for deriving depth information from shadow measurements that considers three basic shape variations of simple craters: paraboloidal, conical, and flat‐floored. We show that the shape of the cast shadow can be used to constrain crater shape and we derive improved equations for finding the depths of these simple craters.     

The 12C/13C ratio in jupiter from the Voyager infrared investigation

The ¹²C/¹³C ratio in Jupiter has been derived from the analysis of the ν₄ band of CH₄ in the spectra recorded by the Voyager 1 IRIS experiment. It is found to be 160_?55⁺⁴⁰, i.e., 1.8_?0.6^+0.4 times the terrestrial value. Instrumental noise as well as systematic sources of error were taken into account for the estimate of the uncertainty. No plausible theory predicts such a difference between the values of the ¹²C/¹³C ratio in the inner solar system and in Jupiter. However, values of this ratio in the solar neighborhood 4.5 by ago inferred—through the use of models of chemical evolution of the Galaxy —from recent interstellar medium measurements are compatible with the present determination in Jupiter. The Jovian value, rather than the terrestrial one, could then be representative of the ratio in the primitive solar nebula.     

A study of the mixed layer of the South China Sea based on the multiple linear regression

Multiple linear regression(MLR) method was applied to quantify the effects of the net heat flux(NHF),the net freshwater flux(NFF) and the wind stress on the mixed layer depth(MLD) of the South China Sea(SCS) based on the simple ocean data assimilation(SODA) dataset.The spatio-temporal distributions of the MLD,the buoyancy flux(combining the NHF and the NFF) and the wind stress of the SCS were presented.Then using an oceanic vertical mixing model,the MLD after a certain time under the same initial conditions but various pairs of boundary conditions(the three factors) was simulated.Applying the MLR method to the results,regression equations which modeling the relationship between the simulated MLD and the three factors were calculated.The equations indicate that when the NHF was negative,it was the primary driver of the mixed layer deepening;and when the NHF was positive,the wind stress played a more important role than that of the NHF while the NFF had the least effect.When the NHF was positive,the relative quantitative effects of the wind stress,the NHF,and the NFF were about 10,6 and 2.The above conclusions were applied to explaining the spatio-temporal distributions of the MLD in the SCS and thus proved to be valid.