Identification of the interstellar cyanomethyl radical (CH2CN) in the molecular clouds TMC-1 and Sagittarius B2

We report the astronomical identification of the cyanomethyl radical, CH2CN, the heaviest nonlinear molecular radical to be identified in interstellar clouds. The complex fine and hyperfine structures of the lowest rotational transitions at about 20.12 and 40.24 GHz are resolved in TMC-1, where the abundance appears to be about 5 x 10(-9) relative to that of H2. This is significantly greater than the observed abundance of CH3CN (methyl cyanide) in TMC-1. In Sgr B2 the hyperfine structure is blended in the higher frequency transitions at 40, 80, and 100 GHz, although the spin-rotation doubling is clearly evident. Preliminary searches in other sources indicate that the distribution of CH2CN is similar to that for such carbon chain species as HC3N or C4H.     

The first absolute gravity measurements in Indonesia

For the purposes of the calibration of the superconducting gravimeter (SG) in Bandung and the establishment of the absolute gravity (AG) points, we carried out AG measurements for the first time in Indonesia in November 2002. The measurements in Bandung were conducted between November 15th and 20th by means of a FG5 (#210), and 14,520 effective drops were obtained. The gravity value newly determined at the AG point in Bandung is 977976701.2 μgal (1 μgal = 10⁻⁸ ms⁻²) and the scale factor for the SG is −52.22 μgal/V. We also established another AG point in Yogyakarta near Merapi volcano and carried out AG measurements in Yogyakarta between November 22nd and 26th. The gravity value determined for this station is 978203093.5 μgal.     

Nitrogen isotopic discrimination by water column nitrification in a shallow coastal environment

Temporal changes in nitrogen isotopic composition (δ¹⁵N) of the NO₃ ⁻ pool in the water column below the pycnocline in Ise Bay, Japan were investigated to evaluate the effect of nitrification on the change in the δ¹⁵N in the water column. The δ¹⁵N of NO₃ ⁻ in the lower layers varied from −8.5‰ in May to +8.4‰ in July in response to the development of seasonal hypoxia and conversion from NH₄ ⁺ to NO₃ ⁻. The significantly ¹⁵N-depleted NO₃ ⁻ in May most likely arose from nitrification in the water column. The calculated apparent isotopic discrimination for water column nitrification (ɛ_nit = δ¹⁵N_substrate − δ¹⁵N_product) was 24.5‰, which lies within the range of previous laboratory-based estimates. Though prominent deficits of NO₃ ⁻ from hypoxic bottom waters due to denitrification were revealed in July, the isotopic discrimination of denitrification in the sediments was low (ɛ_denit = ∼1‰). δ¹⁵N_NO3 in the hypoxic lower layer mainly reflects the isotopic effect of water column nitrification, given that water column nitrification is not directly linked with sedimentary denitrification and the effect of sedimentary denitrification on the change in δ¹⁵N_NO3 is relatively small.     

Anhydrous and water-saturated melting experiments of an olivine andesite from Mt Yakushi-Yama, northeastern Shikoku, Japan

Abstract Melting experiments have been carried out on an olivine andesite of Mt Yakushi-Yama from the Miocene Setouchi volcanic belt in northeastern Shikoku, Japan. This andesite has been characterized by a low ratio of FeO*/Mg° (= 0.78). Phase relations have been determined within the pressure range of 2.8 to 19.3 kbar at 1000-1300°C under anhydrous and water-saturated conditions. At pressures less than 8.8 kbar, olivine is a liquidus phase. Orthopyroxene appears on the liquidus at 9.3 kbar under the anhydrous conditions. The multiple saturation point rises up to 17.5 kbar for water-saturated experiments. The andesite melt coexists with olivine and orthopyroxene just below the liquidus at 8.8–9.3 kbar and 1230°C for dry conditions, and at 17.5 kbar and 1060°C under water-saturated conditions. These experimental results indicate that the Yakushi-Yama olivine andesite magma could coexist with a harzburgitic mantle at depths between about 30 and 60 km, and at temperatures between 1060 and 1230°C. Experimental data also suggest a possibility that a high magnesian andesite magma would be generated by a direct partial melting of the uppermost harzburgitic mantle under anhydrous conditions.     

Assessment of the Uncertainties in the NO2 and O3 Measurements by Visible Spectrometers

The column amounts of nitrogen dioxide (NO2) and ozone (O3) were measured using a visible spectrometer based on the twilight zenith-sky technique at two observatories located at similar latitudes in the northern part of Japan separated by a distance of 150 km. The measurements began in April 1991 at the Moshiri Observatory (44.4°N, 142.3°E) and in April 1994 at the Rikubetsu Observatory (43.5°N, 143.8°E). Since weather conditions and the possible influence from tropospheric pollution were not always identical at these two observatories, the overall accuracy of the measurements was studied comparing these data sets. The first year data obtained at a solar zenith angle of 90 degrees indicated that the NO2 slant column values at sunrise and sunset agreed within 0.36 and 0.54 × 1016 cm-2, respectively, corresponding to 5 % (June) and to 12 % (December) of the columns. The O3 values agreed within 0.76 × 1019 cm-2, corresponding to 4 % (March) 6 % (August) of the columns, although a part of the difference was systematic. The O3 column amounts were also compared to those obtained by the Dobson spectrometer at Sapporo (43.5°N, 143.8°E), whose latitude is similar to these observatories. When an air mass factor of 17.5 was used, the two-year Moshiri vertical column values agreed with the Dobson direct sun values to within 15 Dobson Units, or 3 6 % of the column. The difference between the two values was found to be due partly to the change in the air mass factor caused by seasonal and day-to-day changes in the shape of the O3 vertical profiles. These results confirm the reliability of the NO2 and O3 measurements by visible spectrometers at these sites for the Network for the Detection of Stratospheric Change (NDSC).     

A small-scale energy release observed on the limb

The D3 emission lines observed on the emerging flux loops and mound prominences above the limb were locally found to consist of two components, i.e., the main and the broadened components. A number of Doppler shifted emission lines, separated distinctly from the main body of the emission lines were also detected, which we call the separated components. On the sequential spectrograms, the lifetimes of these broadened and separated components were obtained and their histograms were made.We present the results of fitting the observed emission lines with the sum of two gaussian profiles in two simple cases under two different assumptions. In each assumption, it is found that the line-of-sight velocities of the broadened components with lifetimes shorter than 10 min monotonously increase with time and we attribute this behaviour to a single ejection of mass from the parent structures. In the broadened components with lifetimes longer than 10 min, the acceleration turns on and off alternately, each with a duration of several minutes. We attribute this behaviour to multiple ejections of mass.Finally, it is shown that the corona over the active region is supplied with enough mass for the formation of a coronal condensation if the ejected mass diffuses out high into the corona and some heating mechanisms for the mass switch on.Contributions from the Kwasan and Hida Observatories, University of Kyoto, No. 269.     

Micro-X-ray fluorescence-based comparison of skeletal structure and P, Mg, Sr, O and Fe in a fossil of the cold-water coral Desmophyllum sp., NW Pacific

Micro-scale distributions of trace and minor elements in, for example, coral skeletons are crucial as geochemical tracers of past environmental conditions, because they have the inherent advantage of accounting for confounding diagenetic and physiological effects. To extract reproducible paleoceanographic records from coral skeletons, a selective measurement of specific ultrastructures at high spatial resolution is required. Compared to warm-water reef-building corals, such data are limited in cold-water corals and, to the best of the authors’ knowledge, the latter have to date not been examined by means of micro-X-ray fluorescence. This technique was used for micrometer-scale imaging of P, Mg, Sr, O, and Fe intensities (counts per unit time) in a fossil specimen (as yet unknown age) of the cold-water coral Desmophyllum sp. from surface sediments of the NW Pacific. Cross plots confirmed that the micro-XRF signals were associated with corresponding trends in elemental concentration (ppm). Two major structural components of the septum—centers of calcification (COCs) and the surrounding fibrous aragonite portion—differed in composition. The COCs were characterized by higher intensities of P and Mg (650 and 220 counts per 5 s, respectively), and lower intensities of Sr (2,800) and O (580; corresponding values for the fibrous aragonite are 370, 180, 3,300 and 620 counts per 5 s, respectively). Oxygen intensity values were mostly homogeneous, but slightly lower in COCs and substantially higher in a well-defined patch in the fibrous aragonite. The mostly homogeneous P signals in the fibrous aragonite confirm the utility of this structural component and of coral septa in general for tracer studies of oceanic P. Nevertheless, spot occurrences of elevated P (>950 counts per 5 s) spanning tens of micrometers in specific parts of the fibrous region of the septum would cause overestimates of oceanic P, and should evidently not be overlooked in future research. The distribution of Fe showed no correlation with P, indicating no significant contamination in the form of P-bearing diagenetic ferromanganese precipitates. Such hotspots plausibly reflect the presence of other mineral phases, such as crystalline hydroxylapatite inclusions or contamination with organic material. The P signal intensity was positively correlated with Mg (r=0.553, p<0.001), and negatively with Sr (r=–0.489, p<0.001) and O (r=–0.311, p<0.001). There was no discernible evidence of control by water temperature in the Sr distribution pattern. These findings establish micro-X-ray fluorescence as a highly suitable pre-screening tool in cold-water coral sclerochronology, which can serve to refine sampling strategies without sample damage, and complement other micrometer-scale spatial distribution analyses of elements (notably, Ca) based on well-known approaches involving micro-milling, electron microprobes, secondary ion mass spectrometry, and laser ablation.     

Current-to-Current Converter for Scientific Underwater Cable Networks

A new current-to-current converter, which is a key device to branch a constant direct current (DC) into two constant DCs, was proposed [K. Asakawa , Proc. OCEANS, pp. 1868-1873, 2003]. It has been verified, through computer simulations and experiments using prototypes, to have good conversion efficiency and stable operation. Because the basic circuit is simple, high reliability is expected. The current-to-current converter is a key device to realize a constant current (CC) power-feeding system for scientific underwater cable networks having mesh topology, which is necessary to enhance robustness against cable breakdowns and to deploy sensors in 2-D and efficiently over a vast research area.     

Families of periodic orbits in Hill’s problem with solar radiation pressure: application to Hayabusa 2

This work studies periodic solutions applicable, as an extended phase, to the JAXA asteroid rendezvous mission Hayabusa 2 when it is close to target asteroid 1999 JU3. The motion of a spacecraft close to a small asteroid can be approximated with the equations of Hill’s problem modified to account for the strong solar radiation pressure. The identification of families of periodic solutions in such systems is just starting and the field is largely unexplored. We find several periodic orbits using a grid search, then apply numerical continuation and bifurcation theory to a subset of these to explore the changes in the orbit families when the orbital energy is varied. This analysis gives information on their stability and bifurcations. We then compare the various families on the basis of the restrictions and requirements of the specific mission considered, such as the pointing of the solar panels and instruments. We also use information about their resilience against parameter errors and their ground tracks to identify one particularly promising type of solution.