CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

Application of AVO Analysis to Seismic Data for Detection of Gas below Methane Hydrate Stability Zone in Nankai Trough Area

Abstract. For the purpose of development of methane hydrate, occurring in the deep marine subsurface, as a resource, the most important issue is to understand the methane hydrate system (generation, migration and accumulation) as well as to delineate the methane hydrate reservoir properties. We have applied the Amplitude Versus Offset (AVO) analysis to the seismic data acquired in the Nankai Trough, offshore Japan, in order to confirm the occurrence of gas just below the methane hydrate-bearing zone, assuming that gas will show a so-called Class-3 AVO response. Knowledge of the amount and occurrence of gas in the sediment below methane hydrate-bearing zone is one of the keys to understand the methane hydrate system.
We have utilized the qualitative analysis of AVO methodology to delineate how gas is located below the BSR, which is thought to be the reflection event from the interface between the methane hydrate-bearing zone and the underlying gas-bearing zone. In the region of MITI Nankai Trough Well PSW-3, we observe two BSRs separated by 25 ms. After AVO modeling using well data, we applied AVO attribute analysis and attribute crossplot analysis to the seismic data. Finally we applied an offset-amplitude analysis to CMP gather data at specific locations to confirm the results of AVO attribute analysis. The AVO analysis shows that there is very little gas located in the underlying sediment below methane hydrate-bearing zone. This result supports the fact that we could not obtain any clear evidence of gas occurrence just below the methane hydrate-bearing zone in the Nankai Trough well drilling.     

Detection of Methane Hydrate-Bearing Zones from Seismic Data

Abstract. The MITI Nankai Trough wells were drilled offshore Japan in the Tokai area in 1999 and 2000. The occurrence of methane hydrate was confirmed by various indicators in the borehole logs and from core data. These findings have a large impact on potential future Japanese energy resources and other related-scientific interests.
We first tried to find the methane hydrate-bearing zones using interval velocities derived from NMO velocity analysis. However, this analysis produced poor resolution. To achieve a more detailed delineation of the gas hydrate- and gas-bearing zones, we executed a seismic impedance inversion calibrated by the logs from two of the MITI Nankai Trough wells. Although these two wells are only about 90 m apart, we were able to produce an impedance section with fine detail by adopting a simple initial model and incorporating physical properties of the methane hydrate-bearing zones. The locations of the methane hydrate-bearing zones are readily apparent in the final section.     

A diatom‐inferred record of lake variability during the last 900 years in Lützow–Holm Bay,East Antarctica

Decadal–centennial‐scale climate variability in coastal Antarctica remains poorly understood due to the limited number of highly resolved, well‐dated records. We present a 900‐year, decadal‐scale reconstruction based on sedimentary diatoms from Lake Abi in Lützow–Holm Bay, East Antarctica. Hydrological change is inferred from diatom ecological preferences in conjunction with an existing regional training set and implies that lake water specific conductivity, depth and nitrogen availability are the key drivers of diatom assemblage change. Lake Abi underwent a series of subtle environmental changes related to these environmental variables, possibly driven by changes in catchment snow melt and the duration of seasonal ice cover. Ordination is used to trace the major patterns of change in the diatom community, with notable shifts identified between 470 and 400 and at ～350 cal a BP (where present = CE 1950). The frequency of environmental variability at Lake Abi is broadly consistent with a record of the Interdecadal Pacific Oscillation during the last millennium, but contrasts with the apparent climate stability elsewhere in eastern Antarctica. Further research is required to constrain the limnological and ecological responses of lakes in coastal Antarctica to obtain more rigorous palaeoclimate reconstructions from these sites of immense potential.     

Molecular and isotopic characteristics of gas hydrate-bound hydrocarbons in southern and central Lake Baikal

We investigated the molecular composition (methane, ethane, and propane) and stable isotope composition (methane and ethane) of hydrate-bound gas in sediments of Lake Baikal. Hydrate-bearing sediment cores were retrieved from eight gas seep sites, located in the southern and central Baikal basins. Empirical classification of the methane stable isotopes (δ¹³C and δD) for all the seep sites indicated the dominant microbial origin of methane via methyl-type fermentation; however, a mixture of thermogenic and microbial gases resulted in relatively high methane δ¹³C signatures at two sites where ethane δ¹³C indicated a typical thermogenic origin. At one of the sites in the southern Baikal basin, we found gas hydrates of enclathrated microbial ethane in which ¹³C and deuterium were both highly depleted (mean δ¹³C and δD of –61.6‰ V-PDB and –285.4‰ V-SMOW, respectively). To the best of our knowledge, this is the first report of C₂ δ¹³C–δD classification for hydrate-bound gas in either freshwater or marine environments.