CO<Subscript>2</Subscript> Flux Measurements over the Sea Surface by Eddy Correlation and Aerodynamic Techniques

The measurements of the vertical transport of CO₂ were carried out over the Sea of Japan using the specially designed pier of Kyoto University on September 20 to 22, 2000. CO₂ fluxes were measured by the eddy correlation and aerodynamic techniques. Both techniques showed comparable CO₂ fluxes during sea breeze conditions: −0.001 to −0.08 mg m⁻²s⁻¹ with the mean of −0.05 mg m⁻²s⁻¹. This means that the measuring site satisfies the fetch requirement for meteorological observations under sea breeze conditions. Moreover, the eddy diffusivity coefficient used in the aerodynamic technique is found to be consistent with the coefficient used in the eddy correlation technique. The present result leads us to conclude that the aerodynamic technique may be applicable to underway CO₂ flux measurements over the ocean and may be used in place of the bulk technique. The important point is the need to maintain a measuring accuracy of CO₂ concentration difference of the order of 0.1 ppmv on the research vessels or the buoys.     

The role of Nuta (large amorphous particles) as a nutrient regenerator in Osaka Bay

Large amorphous particles (Nuta) observed in coastal areas after phytoplankton blooms and red tide outbreaks were collected by Nuta traps. These particles are always thickly attached to mooring ropes and/or fishing nets. From the decomposition experiments of Nuta and the sinking particles, dissolved inorganic nitrogen (DIN) and dissolved inorganic phosphorus (DIP) regenerations were active in Nuta, but were not active in sinking particles. In Nuta, regeneration abundances during 10 days were 567 g-N/mg of initial particulate organic nitrogen (PON), and 583 -P/mg of initial particulate phosphorus (PP), respectively. Thus DIP was more regenerated from Nuta than DIN. Ten days integral regeneration abundances of DIN and DIP from Nuta were estimated to be 36% and 79% of in situ DIN and DIP standing stocks, respectively. Nuta contributes an important role of nutrient regeneration particularly DIN, in coastal water. Carbon and nitrogen stable isotope ratios of suspended particles, sinking particles and Nuta indicated that these three different type of particles were almost the same origin, and thus Nuta in the coastal water should be made from phytoplankton debris.     

Seasonal and Spatial Variations of Iceberg Drift off Dronning Maud Land, Antarctica, Detected by Satellite Scatterometers

Seasonal and spatial variations of iceberg drift were studied using continuous satellite scatterometer images off Dronning Maud Land, East Antarctica. Generally, iceberg drift speed showed a westward increase to the Greenwich Meridian. Seasonal variations of the drift speed were high in autumn—early winter and low in spring, and their magnitudes also increased westward. Seasonal variations of the drift speed were significantly correlated with variations of sea levels at Syowa and Mawson Stations, and hence qualitatively consistent with geostrophic current variations. Thus, the scatterometer data are demonstrated to be useful in monitoring iceberg trajectory and oceanic current variations. This revised version was published online in July 2006 with corrections to the Cover Date.     

Detecting fluctuations of the Kuroshio axis south of Japan using TOPEX/POSEIDON altimeter data

Sea surface dynamic topography (SSDT) can be divided into temporal mean SSDT and fluctuation SSDT. The former is approximated with a climatological mean SSDT and the latter is derived from satellite altimetry data, to give an approximated total SSDT (called a composite SSDT). The method is applied to detecting fluctuations of the Kuroshio axis south of Japan using TOPEX/POSEIDON altimeter data from the first year mission in 1992–1993. The fluctuation SSDT averaged over a wide area south of Japan clearly shows an annual cycle with an amplitude of about 15 cm. Temporal changes of SSDT along a subsatellite track crossing the Kuroshio compare moderately well with those estimated from repeated hydrographic observations, although there is a discrepancy of unknown origin. The composite SSDT also compares well with SSDT estimated from the same hydrographic data. Horizontal distribution of the surface geostrophic velocity component normal to subsatellite tracks is derived every ten days from the composite SSDT. Most locations of estimated strong eastward geostrophic velocities coincide well with locations of the Kuroshio axis determined every 15 days fromin situ surface velocity measurements on various vessels; for example, a fairly large meander of the Kuroshio south of Honshu is clearly detected. It is concluded that the composite SSDT can be used reliably to detect fluctuations of the Kuroshio axis south of Japan.     

Semidiurnal Dynamics of Salinity, Nutrients and Suspended Particulate Matter in an Estuary in the Seto Inland Sea, Japan, during a Spring Tide Cycle

The physical and chemical variability of the water column at subtidal station of an estuary in the Seto Inland Sea, Japan, was studied over a 24-hour period during a spring tide (tidal range ca. 2 m) in May 1995. Surface water and several depths through the water column were monitored every one and two hours, respectively. At each occasion, water temperature, salinity and dissolved oxygen concentration were measured and water samples were collected for the determination of nutrients and suspended particulate matter (SPM). Disruptive changes in the physical and chemical characteristics of the water was produced by the tidal cycle and the mixing of water masses of different origin. These changes were highly significant both spatially and temporally, yet with varying effects on physical parameters, nutrients and the different components of SPM. Significant differences in nutrient concentrations were also observed when the data-set was divided into ebb and flood components, irrespective of the depth. Nitrate and nitrite rose to 1.8 times higher during the flood. Spatial differences of SPM were less marked than those of nutrients, only particulate organic carbon (POC) being significantly higher at the surface than in the intermediate and the lower layer. Both POC and pheopigment concentrations increased markedly through the water column, being highest shortly before the lower low tide. In contrast, suspended solid (SS) content increased sharply after the lower low tide (>40 mg l⁻¹) and this coincided with a marked decrease of the C/SS content (<20 mg g⁻¹). The lagtime between POC and SS tidal transport was caused by particle resuspension from the exposed intertidal sediments as the tidal level rose, and particle transport selection in relation to the tidal state. This revised version was published online in August 2006 with corrections to the Cover Date.     

A laboratory experiment to monitor the contact state of a fault by transmission waves

We performed a series of laboratory experiments in which elastic waves were transmitted across a simulated fault. Two types of experiments were carried out: (1) Normal Stress Holding Test (NSHT): normal stress was kept constant for about 3 h without shear stress and transmission waves were observed. (2) Shear Stress Increasing Test (SSIT): shear stress was gradually increased until a stick-slip event occurred. Transmission waves were continuously observed throughout the process of stress accumulation. We focused on the change in transmission waves during the application of shear stress and especially during precursory slips.It was found in NSHT that the amplitude of transmission waves linearly increased with the logarithm of stationary contact time. The increase amounted to a few percent after about 3 h. Creep at asperity contacts is responsible for this phenomenon. From a theoretical consideration, it was concluded that the real contact area increased with the logarithm of stationary contact time.We observed in SSIT a significant increase in wave amplitude with shear stress application. This phenomenon cannot be attributed to the time effect observed in NSHT. Instead, it can be explained by the mechanism of “junction growth” proposed by Tabor. Junction growth yields an increase in real contact area. It is required for junction growth to occur that the material in contact is already plastic under a purely normal loading condition. A computer simulation confirmed that this requirement was satisfied in our experiments. We also found that the rate at which the amplitude increased was slightly reduced prior to a stick-slip event. The onset time of the reduction well coincides with the onset of precursory slip. The cause of the reduction is attributed to the reset of stationary contact time due to displacement. This interpretation is supported by the result of NSHT. Taking the time of stationary contact in SSIT into account, we may expect the change in wave amplitude to be, at most, only a few percent. The observed slight reduction in increasing rate is, in this sense, reasonable. The static stiffness of the fault also decreases with precursory slip. It was also found that low frequency waves are a better indicator of precursory slip than high frequency waves. This might suggest that low frequency waves with longer wavelength are a better indicator of average behavior of faults. The problem, however, merits a further investigation. The shifts in phase were also found to be a good indicator of the change in contact state of the fault. The changes in both amplitude and phase of transmission waves are unifyingly understood through the theory of transmission coefficient presented by Pyrak-Nolte et al. Rough surfaces have a tendency to give larger stick-slips than smooth surfaces. The amount of precursory slip is larger for rough surfaces than for smooth surfaces. Although it was confirmed by a computer simulation that rough surfaces have larger contact diameters than smooth surfaces, the rigorous relationship between the surface roughness (contact diameter) and the amount of precursory slips was not established.     

Preparation of a New Geological Survey of Japan Geochemical Reference Material: Coral JCp-1

A new geochemical reference material, coral Porites sp. JCp-1 has been prepared by the Geological Survey of Japan (GSJ). Provisional values for twenty one major, minor and trace elements are presented. The homogeneity tests showed that all elements studied are considered to be homogeneously distributed.     

Carbon isotopes and petrography of kerogens in ∼3.5-Ga hydrothermal silica dikes in the North Pole area, Western Australia

More than 600 specimens of ∼3.5 Ga-old hydrothermal silica dikes from the North Pole area, Pilbara craton, Western Australia, have been studied petrographically. The kerogens in 44 samples have been analyzed isotopically (C and N) and chemically (C, N, and H). The silica dikes are composed mainly of fine-grained silica (modal abundance: >97%) and are classified into two types by minor mineral assemblages: B(black)-type and G(gray)-type. The B-type silica dikes contain kerogen (0.37 to 6.72 mgC/g; average 2.44 mgC/g, n = 21) and disseminated sulfides, dominantly pyrite and Fe-poor sphalerite. In some cases, carbonate and apatite are also present. Their silica-dominated and sulfide-poor mineral assemblages suggest precipitation from low-temperature reducing hydrothermal fluid (likely 100-200°C). On the other hand, the G-type silica dikes are sulfide-free and concentrations of kerogen are relatively low (0.05 to 0.41 mgC/g; average 0.17 mgC/g, n = 13). They typically contain Fe-oxide (mainly hematite) which commonly replaces cubic pyrite and rhombic carbonate. Some G-types occur along secondary quartz veins. These textures indicate that the G-type silica dikes were formed by postdepositional metasomatism (oxidation) of the B-types, and that the B-types probably possess premetasomatic signatures. The δ¹³C values of kerogen in the B-types are −38.1 to −33.1‰ (average −35.9‰, n = 21), which are ∼4‰ lower than those of the G-types (−34.5 to −30.0‰; average −32.2‰, n = 19), and ∼6‰ lower than bedded chert (−31.2 to −29.4‰; average −30.5‰, n = 4). This indicates the preferential loss of ¹²C during the metasomatism (estimated fractionation factor: 0.9985). Considering the metasomatic effect on carbon isotopes with probably minor diagenetic and metamorphic overprints, we conclude that the original δ¹³C values of the kerogen in the silica dikes would have been heterogeneous (∼5‰) and at least some material had initial δ¹³C values of ≤ −38‰. The inferred ¹³C-depletions of organic carbon could have been produced by anaerobic chemoautotrophs such as methanogen, but not by aerobic photoautotrophs. This is consistent with the estimated physical and chemical condition of the hydrothermal fluid, which was probably habitable for anaerobic and thermophilic/hyperthermophilic chemoautotrophs. Alternatively, the organic matter may have been possibly produced by abiological reaction such as Fischer-Tropsch Type (FTT) synthesis under the hydrothermal condition. However, the estimated condition is inconsistent with the presence of the effective catalysts for the FTT reaction (i.e., Fe-Ni alloy, magnetite, and hematite). These lines of evidence suggest the possible existence of biosphere in the ∼3.5 Ga sub-seafloor hydrothermal system.     

Diatoms grow faster using ammonium in rapidly flushed eutrophic Dokai Bay,Japan

The importance of the nitrogen source for phytoplankton growth in a highly eutrophic embayment, Dokai Bay, was investigated. The DIN concentration often exceeded 100 μM of which 40–70% was NH₄ ⁺. During two incubation experiments, the natural assemblage of mainly diatoms took up NH₄ ⁺ instead of NO₃ ⁻. The growth of two Skeletonema species isolated in Dokai Bay were significantly faster on NH₄ ⁺ (1.86 and 1.27 div. d⁻¹ respectively) than on NO₃ ⁻ (1.55 and 1.04 div. d⁻¹ respectively). Our results indicated that these diatoms could grow faster by using NH₄ ⁺ compared to NO₃ ⁻ in this eutrophic bay.     

Preliminary results of a study on the responses of sedimentary rocks to shaft excavation

A shaft with a diameter of 6 m and a depth of 150 m was excavated in sedimentary rocks. Anin situ study was carried out to identify the size and rock properties of the zone disturbed by the excavation and to estimate the applicability of existing methods for measuring and modelling such a zone. The study detected displacements and changes in the properties of the rock within about 1 m of the shaft wall. Numerical analysis using a model of continuous rock mass can simulate some features of disturbance due to excavation, although slight discrepancies exist between the measured and analysed results. The excavation disturbance detected in this study is probably due to fracturing, the redistribution of stress and undersaturation. However, the relationships between the disturbance due to excavation and these processes have not been quantified. The existing methods for measurements and numerical analysis can provide important information on the disturbance due to excavation but need to be improved to understand disturbance due to excavation further.