India's growing role in the global climate debate makes it imperative to analyse emission reduction policies and strategies across a range of GHGs, especially for under-researched non-CO2 gases. Hydrofluorocarbons' (HFCs) usage in cooling equipment and subsequent emissions are expected to increase dramatically in India with the phase-out of hydrochlorofluorocarbons (HCFCs) as coolants in air-conditioning equipment. We focus on the residential air-conditioning sector in India and analyse a suite of HFC and alternative coolant gas scenarios for understanding the implications for GHG emissions from this sector within an integrated assessment modelling framework. We find that, if unabated, HFC410A emissions will contribute to 36% of the total global warming impact from the residential air-conditioner sector in India in 2050, irrespective of the future economic growth trajectory, and the remaining 64% is from energy to power residential air-conditioners. A move towards more efficient, low global warming potential (GWP) alternative refrigerants will significantly reduce the cumulative global warming footprint of this sector by 37% during the period 2010–2050, due to gains both from energy efficiency as well as low GWP alternatives. Best practices for reducing direct emissions are important, but only of limited utility, and if a sustainable lifestyle is adopted by consumers with lower floorspace, low GWP refrigerants, and higher building envelope efficiencies, cumulative emissions during 2010–2050 can be reduced by 46% compared to the Reference scenario.
Policy relevance
Our analysis has important implications for Indian climate policy. We highlight that the Indian government's amendment proposal to the Montreal Protocol is a strong signal to the Indian market that the transition away from high GWP refrigerants towards low/zero GWP alternatives will happen sooner or later. The Bureau of Energy Efficiency should extend building energy conservation code policy to residential buildings immediately, and the government should mandate it. Government authorities should set guidelines and mandate reporting of data related to air-conditioner coolant recharge frequency and recovery of scrapped air-conditioner units. For contentious issues like flammability where there is no consensus within the industry, the government needs to undertake an independent technical assessment that can provide unbiased and reliable information to the market. 相似文献
A massive disaster occurred in June 2013 in Kedarnath, India, due to cloudburst and extremely heavy rain along the Chorabari glacier. The resulting flash floods further aggravated the instability of natural and hill cut slopes at different places on the downstream side. The village Rambara that existed in close proximity of Kedarnath was swept away under flow of debris and water. The immediate surrounding area, which housed over a hundred and fifty shops and hotels, was completely washed away leaving no trace of civilization. This calamity in Uttarakhand is considered as India’s worst natural disasters after the tsunami in December 2004. On the downstream of the affected areas lie other pilgrim destinations that witness innumerable footfalls every year. Investigation of the health of the slopes on the routes to these destinations is therefore very important to ensure minimal damage to humans and machinery. The Himalayan terrain is a tectonically active mountain belt, having a large number of unstable natural and road cut slopes. Such slopes with rugged topography lie in the high seismic vulnerability zone. Further, the instability is aggravated by natural and anthropogenic activities increasing at a rapid and uncontrollable rate. In the light of the Kedarnath tragedy, more advanced research is being conducted along the National Highways to monitor and prevent slope/structure failures. This study was conducted to evaluate the hazard potential along National Highway-58, near Saknidhar village of Devprayag district by analysing rockfall using hazard rating systems and numerical simulation. Rockfall hazard rating systems were applied to evaluate the conditions of the slopes and to identify the associated risks. Based on the field and laboratory analyses, the parameters required for numerical models were determined. The bounce height, roll-out distance, kinetic energy and speed of the detached blocks were determined by using a competent rockfall simulator. The results obtained were used to identify rockfall risk in the region. Optimization strategies were applied during investigation by modifying the slope angle, ditch width and ditch angle to assess the possibility of a hazard to occur in different scenarios. The simulation studies revealed that an increasing slope angle could significantly increase the kinetic energy of the rock blocks. However, an increase in the ditch angle and the ditch width reduces the energy of moving blocks. The maximum bounce height above the slope varied from 0.003 m to 0.8 m for 10-kg blocks, whereas the maximum velocity and the maximum kinetic energy under such circumstances were 7.882 m/s and 379.89 J, respectively. The barrier capacity was found to be 233.18 J for 10-kg falling blocks at a height of 10.02 m. From the optimization studies, it was found that the risk can be reduced by up to 13 % if the slope of 70° has a ditch angle of 15° while on a flat ditch, the maximum risk will be at an angle of 65°. If the ditch angle is increased, the vertical component of the falling blocks is more effective than that in case of a flat ditch. These optimization studies lay foundation for advanced research for mitigation of rockfall hazards in similar potential areas.
Knowledge of Martian igneous and mantle compositions is crucial for understanding Mars' mantle evolution, including early differentiation, mantle convection, and the chemical alteration at the surface. Primitive magmas provide the most direct information about their mantle source regions, but most Martian meteorites either contain cumulate olivine or crystallized from fractionated melts. The new Martian meteorite Northwest Africa (NWA) 6234 is an olivine‐phyric shergottite. Its most magnesian olivine cores (Fo78) are in Mg‐Fe equilibrium with a magma of the bulk rock composition, suggesting that it represents a melt composition. Thermochemical calculations show that NWA 6234 not only represents a melt composition but is a primitive melt derived from an approximately Fo80 mantle. Thus, NWA 6234 is similar to NWA 5789 and Y 980459 in the sense that all three are olivine‐phyric shergottites and represent primitive magma compositions. However, NWA 6234 is of special significance because it represents the first olivine‐phyric shergottite from a primitive ferroan magma. On the basis of Al/Ti ratio of pyroxenes in NWA 6234, the minor components in olivine and merrillite, and phosphorus zoning of olivine, we infer that the rock crystallized completely at pressures consistent with conditions in Mars' upper crust. The textural intergrowths of the two phosphates (merrillite and apatite) indicate that at a very last stage of crystallization, merrillite reacted with an OH‐Cl‐F‐rich melt to form apatite. As this meteorite crystallized completely at depth and never erupted, it is likely that its apatite compositions represent snapshots of the volatile ratios of the source region without being affected by degassing processes, which contain high OH‐F content. 相似文献
Natural Hazards - The Nirsa block, a coal mining area, and an industrial town lies in the southern part of Dhanbad district, at the border between the Indian states of Jharkhand and West Bengal.... 相似文献
Climatic extremes including precipitation are bound to intensify in the global warming environment. The present study intends to understand the response of the Tons sub-watershed in Lesser Himalaya, in 3 years with entirely different hydrological conditions (July 2008–June 2011) in terms of discharge, sediment flux and denudation rates. Within an uncertainty limit of ±20%, the mean interannual discharge (5.74 ± 1.44 m 3s?1) (±SE), was found highly variable (CV: 151%; 0.8–38 m 3s?1). In a normal rainfall year (2008–2009; ~1550 mm), the discharge was 5.12 ± 1.75 m 3s?1, whereas in a drought year (2009–2010), it reduced by 30% with the reduction in ~23% rainfall (CV: 85%). In an excessive rainfall year (once-in-a-century event) (2010–2011; ~3050 mm), discharge as well as total solid load was ~200% higher. Monsoon months (July–September) accounted for more than 90% of the annual solid load transport. The ratio of dissolved to suspended solid (C/P ratio) was consistently low (<1) during monsoon months and higher (1–7) during the rest of the dry period. C/P ratio was inversely (R2=0.49), but significantly (P <0.001) related to the rainfall. The average mechanical erosion rate in the three different rainfall years was 0.24, 0.19 and 1.03 mmyr ?1, whereas the chemical erosion was estimated at 0.12, 0.11 and 0.46 mmyr ?1, respectively. Thus, the average denudation rate of the Tons sub-watershed has been estimated at 0.33 mmyr ?1 (excluding extreme rainfall year: 1.5 mmyr ?1). Our results have implications to understand the hydrological behaviour of the Lesser Himalayan watersheds and will be valuable for the proposed and several upcoming small hydropower plants in the region in the context of regional ecology and natural resource management. 相似文献
Ambient concentrations of organic carbon (OC), elemental carbon (EC) and water soluble inorganic ionic components (WSIC) of PM10 were studied at Giridih, Jharkhand, a sub-urban site near the Indo Gangatic Plain (IGP) of India during two consecutive winter seasons (November 2011–February 2012 and November 2012–February 2013). The abundance of carbonaceous and water soluble inorganic species of PM10 was recorded at the study site of Giridih. During winter 2011–12, the average concentrations of PM10, OC, EC and WSIC were 180.2?±?46.4; 37.2?±?6.2; 15.2?±?5.4 and 18.0?±?5.1 μg m?3, respectively. Similar concentrations of PM10, OC, EC and WSIC were also recorded during winter 2012–13. In the present case, a positive linear trend is observed between OC and EC at sampling site of Giridih indicates the coal burning, as well as dispersed coal powder and vehicular emissions may be the source of carbonaceous aerosols. The principal components analysis (PCA) also identifies the contribution of coal burning? +?soil dust, vehicular emissions?+?biomass burning and seconday aerosol to PM10 mass concentration at the study site. Backward trajectoy and potential source contributing function (PSCF) analysis indicated that the aerosols being transported to Giridih from upwind IGP (Punjab, Haryana, Uttar Pradesh and Bihar) and surrounding region. 相似文献
This work includes a study of some properties such as speed, apparent width, acceleration and latitudes, etc. of all types of Prominence Eruptions (PEs) and the associated Coronal Mass Ejections (CMEs) observed during the period of 1997–2006 by Nobeyama Radioheliograph (NORH) and SOHO/LASCO covering the solar cycle 23. The average speed of prominences and associated CMEs are 51 km/sec and 559 km/sec, respectively. The average angular width is 32° and 74°, respectively. As expected the associated CMEs are relatively faster and wider than the prominences. 相似文献
Because wind is one of the main forcings in storm surge, we present an idealised process-based model to study the influence of topographic variations on the frequency response of large-scale coastal basins subject to time-periodic wind forcing. Coastal basins are represented by a semi-enclosed rectangular inner region forced by wind. It is connected to an outer region (represented as an infinitely long channel) without wind forcing, which allows waves to freely propagate outward. The model solves the three-dimensional linearised shallow water equations on the f plane, forced by a spatially uniform wind field that has an arbitrary angle with respect to the along-basin direction. Turbulence is represented using a spatially uniform vertical eddy viscosity, combined with a partial slip condition at the bed. The surface elevation amplitudes, and hence the vertical profiles of the velocity, are obtained using the finite element method (FEM), extended to account for the connection to the outer region. The results are then evaluated in terms of the elevation amplitude averaged over the basin’s landward end, as a function of the wind forcing frequency. In general, the results point out that adding topographic elements in the inner region (such as a topographic step, a linearly sloping bed or a parabolic cross-basin profile), causes the resonance peaks to shift in the frequency domain, through their effect on local wave speed. The Coriolis effect causes the resonance peaks associated with cross-basin modes (which without rotation only appear in the response to cross-basin wind) to emerge also in the response to along-basin wind and vice versa. 相似文献
Remote sensing measurements in coral reef environments commonly confront the problem of overlying atmosphere and modification of spectral signal due to water column over the bottom substrates. In order to correct these problems, hyperspectral observations offer an advantage over multispectral observations. Airborne hyperspectral remote sensing data from Airborne Visible Infrared Imaging Spectrometer- Next Generation (AVIRIS-NG) sensor was acquired during low tidal condition on 14 February 2016 at Pirotan reef, Gulf of Kachchh region, India. The objective of this study is to map benthic coverage and bottom topography over Pirotan reef. The methodology involved atmospheric correction, simultaneous retrieval of water parameters, bathymetry, water column correction and mapping. Atmospheric correction was performed by removing path radiance and aerosol contribution and dividing by atmospheric transmittance and incoming solar irradiance to obtain remote sensing reflectance. Model derived error minimization technique was used for simultaneous retrieval of water parameters and bathymetry. Derived water parameters were used to account for water column attenuation and retrieve concomitant true bottom signature. 相似文献
In this paper, a three-dimensional semi-idealized model for tidal motion in a tidal estuary of arbitrary shape and bathymetry is presented. This model aims at bridging the gap between idealized and complex models. The vertical profiles of the velocities are obtained analytically in terms of the first-order and the second-order partial derivatives of surface elevation, which itself follows from an elliptic partial differential equation. The surface elevation is computed numerically using the finite element method and its partial derivatives are obtained using various methods. The newly developed semi-idealized model allows for a systematic investigation of the influence of geometry and bathymetry on the tidal motion which was not possible in previously developed idealized models. The new model also retains the flexibility and computational efficiency of previous idealized models, essential for sensitivity analysis. As a first step, the accuracy of the semi-idealized model is investigated. To this end, an extensive comparison is made between the model results of the semi-idealized model and two other idealized models: a width-averaged model and a three-dimensional idealized model. Finally, the semi-idealized model is used to understand the influence of local geometrical effects on the tidal motion in the Ems estuary. The model shows that local convergence and meandering effects can have a significant influence on the tidal motion. Finally, the model is applied to the Ems estuary. The model results agree well with observations and results from a complex numerical model. 相似文献