Effects of onshore and offshore topography on sea breeze circulation: An observational study at eastern Attica,Greece

Field measurements of wind, air temperature and humidity were taken at the eastern part of the Attika district in June 1991, to examine the topographic influences exerted on the local sea breezes. These influences are due either to the elongated Evia island, faced by the northern half of Attica coastline some tens of kilometers offshore, or to the coast-parallel range of Hymettos mountain, rising steeply 12 km onshore. The instrumentation consisted mainly of three tethered meteorological balloons released at characteristic sires (i.e., the coast, a location between shoreline and mountain foot and the mountain top) and three autographic ground-based anemometers operating at selected locations. Data from the ground-based and upper air stations of the Hellenic National Meteorological Service, as well as the diurnal weather maps were also obtained and analyzed. Observations were made under different synoptic wind and the latter was found to determine remarkably the significance of the topographic effects. A preliminary two-dimensional numerical approach was also made concerning the sea breeze capability to reach the Hymettos mountain top in the case of a weak opposing geostrophic flow.     

A critical state interpretation for the cyclic liquefaction resistance of silty sands

Contrary to many laboratory investigations, common empirical correlations from in situ tests consider that the increase in the percentage of fines leads to an increase of the cyclic liquefaction resistance of sands. This paper draws upon the integrated Critical State Soil Mechanics framework in order to study this seemingly not univocal effect. Firstly the effect of fines on the Critical State Line (CSL) is studied through a statistical analysis of a large data set of published monotonic triaxial tests. The results show that increasing the content of non-plastic fines practically leads to a clockwise rotation of the CSL in (e–ln p) space. The implication of this effect on cyclic liquefaction resistance is subsequently evaluated with the aid of a properly calibrated critical state elasto-plastic constitutive model, as well as a large number of published experimental results and in situ empirical correlations. Both sets of data show clearly that a fines content, less than about 30% by weight, may prove beneficial at relatively small effective stresses (p₀<50–70 kPa), such as the in situ stresses prevailing in most liquefaction case studies, and detrimental at larger confining stresses, i.e. the stresses usually considered in laboratory tests. To the extent of these findings, a correction factor is proposed for the practical evaluation of liquefaction resistance in terms of the fines content and the mean effective confining stress.     

Hydrology, circulation and distribution of particulate matter in Thermaikos Gulf (NW Aegean Sea), during September 2001–October 2001 and February 2002

The hydrography, circulation and distribution of particulate matter in Thermaikos Gulf (NW Aegean Sea) are described, for September 2001 and October 2001 and February 2002. The observations were obtained to assess the impact of anthropogenic and natural resuspension processes on the coastal ecosystem. The first two periods represent highly stratified conditions and mild weather conditions; in September trawling is prohibited, whilst the October cruise took place following the commencement of the activity. The sampling in February was undertaken to record the contribution of natural resuspension to the system, in a stormy period.The water circulation was mainly baroclinic during autumn and barotropic in winter; this was due to vertical homogenisation of the water column, during the latter period. The distribution of the bottom nepheloid layer (BNL) was very different in the winter than in the autumn.Microstructure measurements were undertaken, which allowed the vertical eddy diffusivity to be estimated, together with the near-bed shear stresses. Computation of the diffusive flux of particulate matter (PM), from the BNL into the intermediate water column in response to turbulent motions, reveals that the PM flux was much higher in October than in September; this is despite the fact that the friction velocities were similar. This observation could explain partly the observed higher PM concentrations (PMC) in the intermediate layer, in October. Likewise suggest that the higher PMC in October could be attributed to trawling. The limited shear stress and friction velocity values obtained during the September and October cruises were always low; these were possibly capable of resuspending only recently deposited, “fluffy” material. Thus, the observed nepheloid layers are likely to be maintained by advection from the shallow water regions and trawled areas.     

Planar trajectory planning and tracking control design for underactuated AUVs

This paper addresses the combined problem of trajectory planning and tracking control for underactuated autonomous underwater vehicles (AUVs) on the horizontal plane. Given a smooth, inertial, 2D reference trajectory, the planning algorithm uses vehicle dynamics to compute the reference orientation and body-fixed velocities. Using these, the error dynamics are obtained. These are stabilized using backstepping techniques, forcing the tracking error to an arbitrarily small neighborhood of zero. Simulation results for a constant velocity trajectory, i.e. a circle, and a time-varying velocity one, i.e. a sinusoidal path, are presented. The parametric robustness is considered and it is shown that tracking remains satisfactory.     

Explicit integration of bounding surface model for the analysis of earthquake soil liquefaction

This paper presents a new plasticity model developed for the simulation of monotonic and cyclic loading of non‐cohesive soils and its implementation to the commercial finite‐difference code FLAC, using its User‐Defined‐Model (UDM) capability. The new model incorporates the framework of Critical State Soil Mechanics, while it relies upon bounding surface plasticity with a vanished elastic region to simulate the non‐linear soil response. Stress integration of constitutive relations is performed using a recently proposed explicit scheme with automatic error control and substepping, which so far has been employed in the literature only for constitutive models aiming at monotonic loading. The overall accuracy of this scheme is evaluated at element level by simulating cyclic loading along complex stress paths and by using iso‐error maps for paths involving change of the Lode angle. The performance of the new constitutive model and its stress integration scheme in complex boundary value problems involving earthquake‐induced liquefaction is evaluated, in terms of accuracy and computational cost, via a number of parametric analyses inspired by the successful simulation of the VELACS centrifuge Model Test No. 2 studying the lateral spreading response of a liquefied sand layer. Copyright © 2009 John Wiley & Sons, Ltd.     

Application of integrated methods in mapping waste disposal areas

An integrated suite of environmental methods was used to characterize the hydrogeological, geological and tectonic regime of the largest waste disposal landfill of Crete Island, the Fodele municipal solid waste site (MSW), to determine the geometry of the landfill (depth and spatial extent of electrically conductive anomalies), to define the anisotropy caused by bedrock fabric fractures and to locate potential zones of electrically conductive contamination. A combination of geophysical methods and chemical analysis was implemented for the characterization and management of the landfill. Five different types of geophysical surveys were performed: (1) 2D electrical resistance tomography (ERT), (2) electromagnetic measurements using very low frequencies (VLF), (3) electromagnetic conductivity (EM31), (4) seismic refraction measurements (SR), and (5) ambient noise measurements (HVSR). The above geophysical methods were used with the aim of studying the subsurface properties of the landfill and to define the exact geometrical characteristics of the site under investigation.