Bioremediation perspective of historically contaminated sediment with polycyclic aromatic hydrocarbons

The purpose of the current study is to compare the influence of different aerobic conditions(biostimulation(BS),bioaugmentation(BA),and a combination of biostimulation and bioaugmentation(BB))on polycyclic aromatic hydrocarbons(PAH)degradation and compare the degraded amount with single step XAD-4 extraction as a new tool for bioavailability assessment for chronically contaminated sediment samples obtained from territory of Autonomous Province Vojvodina of Serbia(S1,S2,and S3).A great number of papers dealing with biodegradation of PAHs in spiked sediment or soil have been published,but to the authors’knowledge,a limited number of papers studied aged,historically polluted sediment and a sum of chosen U.S.Environmental Protection Agency(USEPA)PAHs.A significant reduction(up to67%)in PAH concentration was observed,while the percentage of reduction varied depending on the sediment sample and treatment used.BS treatment successfully stimulated growth of indigenous bacteria.Further,PAH-degrading strain Sphingomonas paucimobilis F8 inoculated in BA and BB treatment survived for up to 7 weeks after it was suppressed by unfavorable conditions or native microbes.Degraded amounts generally showed good correlation with results obtained from XAD-4 extraction.Results obtained in the current study represent a good start for standardizing a XAD-4 extraction technique as a simplified,easier,and lower cost method for bioavailability assessment.     

Biomarker distributions in asphaltenes and kerogens analysed by flash pyrolysis-gas chromatography-mass spectrometry

Biomarker distributions in a suite of asphaltenes and kerogens have been analysed by flash pyrolysis directly coupled to a GCMS system. Attention has been focussed on biomarkers of the sterane and triterpane types. The sample suite under investigation consists of sediments with different kerogen types and some crude oils. Biomarker distributions in the pyrolysates have been compared with the “free” biomarkers in the corresponding saturated hydrocarbon fractions.The analyses show significant differences between the distributions of the free biomarkers and those in the pyrolysates. The latter have lower amounts of steranes while diasteranes are absent or present at low concentrations only. In the triterpane traces a shift of maximum intensity from C₃₀ (free compounds) to C₂₇/C₂₉ is observed. Furthermore, the pyrolysates contain a set of triterpenes (not present among the free compounds), and there is a selective loss of “non-regular” triterpanes that are present in the saturated hydrocarbon fractions. The observed differences between pyrolysates and free hydrocarbons can be explained partly by the processes occurring during pyrolysis such as bond rupture and subsequent stabilisation of primary pyrolysis products. To a certain extent these differences also show that maturation processes occurring in sediments have effects on free biomarker molecules different from those on molecules that are enclosed in a macromolecular matrix (kerogen or asphaltenes).Differences between biomarker distributions of asphaltene and kerogen pyrolysates are relatively small. A comparison with the pyrolysates from extracted whole sediments suggests that these differences are mainly caused by interactions between the organic material and the mineral matrix during pyrolysis.Oil asphaltenes behave differently from sediment asphaltenes as their pyrolysates are more similar to the corresponding saturated hydrocarbon fractions, i.e. the differences described above are observed to a much smaller extent. This different behaviour appears to be the result of coprecipitation of a part of the maltene fraction with the oil asphaltenes.     

Groundwater quality on the territory of Kikinda municipality (Vojvodina,Serbia)

This paper provides insight into the quality of groundwater used for public water supply on the territory of Kikinda municipality (Vojvodina, Serbia) and main processes which control it. The following parameters were measured: color, turbidity, pH, KMnO₄ consumption, TDS, EC, NH₄ ⁺, Cl^?, NO₂ ^?, NO₃ ^?, Fe, Mn, total hardness, Ca²⁺, Mg²⁺, SO₄ ²⁺, HCO₃ ^?, K⁺, Na⁺, As. The correlations and ratios among parameters that define the chemical composition were determined aiming to identify main processes that control the formation of the chemical composition of the analyzed waters. Groundwater from 11 analyzed sources is Na–HCO₃ type. Intense color and elevated organic matter content of these waters originate from humic substances. The importance of organic matter decay is assumed by positive correlation between organic matter content and TDS, HCO₃ content. There is no evidence that groundwater chemistry is determined by the depth of captured aquifer interval. The main processes that control the chemistry of all analyzed water are cation exchange and feldspar weathering.     

Vulnerability to natural disasters in Serbia: spatial and temporal comparison

The frequency of natural disasters and the extent of their consequences at a global level are constantly increasing. This trend is partially caused by increased population vulnerability, which implies the degree of population vulnerability due to high-magnitude natural processes. This paper presents an analysis of vulnerability to natural disaster in Serbia in the second half of the twentieth and the early twenty-first century. Vulnerability changes were traced on the basis of demographic–economic indicators derived from statistical data for local government units (municipalities) provided by the Statistical Office of the Republic of Serbia. Calculations were performed in the geographical information system environment. The results of the study show that spatial and temporal vulnerability variations are causally correlated with changes in the selected components. Significant rise of vulnerability is related to urban areas, while lower values are characteristic for other areas of Serbia; this is primarily a consequence of different population density.     

A new design of the LAPS land surface scheme for use over and through heterogeneous and non-heterogeneous surfaces: Numerical simulations and tests

Numerical simulations and tests with the recently redesigned land–air parameterization scheme (LAPS) are presented. In all experiments, supported either by one-point micrometeorological, 1D or 3D simulations, the attention has been directed to: (1) comparison of simulation outputs, expressing the energy transfer over and through heterogeneous and non-heterogeneous surfaces, versus observations and (2) analysis of uncertainties occurring in the solution of the energy balance equation at the land–air interface. To check the proposed method for aggregation of albedo, “propagating hole” sensitivity tests with LAPS over a sandstone rock grid cell have been performed with the forcing meteorological data for July 17, 1999 in Baxter site, Philadelphia (USA). Micrometeorological and biophysical measurements from the surface experiments conducted over crops and apple orchard in Serbia, Poland, Austria and France were used to test the operation of LAPS in calculating surface fluxes and canopy environment temperatures within and above plant covers of different densities. In addition, sensitivity tests with single canopy covers over the Central Europe region and comparison against the observations taken from SYNOP data using 3D simulations were made. Validation of LAPS performances over a solid surface has been done by comparison of 2 m air temperature observations against 5-day simulations over the Sahara Desert rocky ground using 3D model. To examine how realistically the LAPS simulates surface processes over a heterogeneous surface, we compared the air temperature measured at 2 m and that predicted by the 1D model with the LAPS as the surface scheme. Finally, the scheme behaviour over urban surface was tested by runs over different parts of a hypothetical urban area. The corresponding 1D simulations were carried out with an imposed meteorological dataset collected during HAPEX-MOBILHY experiment at Caumont (France). The quantities predicted by the LAPS compare well with the observations and the various subcomponents of the scheme appear to operate realistically.     

Northern Adriatic phytoplankton response to short Po River discharge pulses during summer stratified conditions

A 275‐km‐long transversel Northern Adriatic profile from the mouth of the Po River (Italian Adriatic coast) to the Kvarner region (Croatian coastal island area) was investigated in three successive case studies in August 2008, 2009 and 2010. The short Po River pulses in August result in the surface advection of riverine water, nutrients and phytoplankton from the western to the eastern side of the Adriatic. This surface spreading exhibits inter‐annual variability depending on the riverine discharge in the preceding period. The Po River discharge pulse in August 2010 in particular resulted in an extraordinary tongue‐like advection of riverine water, nutrients, and phytoplankton towards the Eastern Adriatic coast. The phenomenon was detected using both satellite imagery and classical oceanographic measurements. In the advective water, toxic dinoflagellates were most abundant in August 2010, when the influence of the Po was greatest.     

Statistical methods as indicator of offset printing wastewater quality

This study presents the application of different chemometric approaches on the dataset obtained during the monitoring of offset printing wastewater quality in Pozarevac, Serbia. Collecting of wastewaters was performed during a working week, five working days, in five offset printing facilities. Twenty five physico-chemical parameters were analyzed in wastewaters using the standard analytical and instrumental methods. The obtained dataset were subjected to cluster analysis and principal component analysis. Cluster analysis showed four groups of similarity between the printing facilities reflecting the different physico-chemical characteristics and pollution levels of studied wastewaters. Principal component analysis identified two principal components responsible for the data structure explaining 86 % of total variance of offset printing wastewaters. The obtained principal components indicate the parameters that are the most responsible for variation of offset printing wastewaters. This study clearly demonstrates the usefulness of chemometric methods in analysis of printing wastewater quality, identification of the main sources and understanding of spatial variations in wastewater quality. Also, it could be useful for the selection of an appropriate wastewater treatment plant.     

Seismic vulnerability assessment of a mixed masonry–RC building aggregate by linear and nonlinear analyses

From the beginning of the twentieth century, and due to the rapid increase of reinforced concrete (RC) usage, mixed masonry–RC buildings have emerged. In Lisbon, Portugal, old mixed masonry–RC buildings appeared between 1920 and 1960, representing the transition period between masonry and proper RC. These buildings are often integrated in blocks, and frequently share the side-walls, implying, thus, the need to assess the seismic vulnerability of building aggregates. The present paper approaches the seismic vulnerability assessment of a specific type of old mixed masonry–RC buildings in Lisbon. The study comprises the analysis of a building, both as an isolated structure and inserted in its aggregate, using two approaches: (1) linear dynamic analysis with SAP2000 and (2) nonlinear static analysis by means of 3Muri/Tremuri software. A comparison of both approaches derives a good matching between the obtained results. However, a nonlinear analysis is required to identify, in an adequate manner, the critical areas of the structure requiring strengthening.