Simulation of adaptive optics for the Vacuum Tower Telescope

A simulation model of the adaptive optics of the German Vacuum Tower Telescope (VTT), Observatorio del Teide, Tenerife, is presented. The model uses modules from the integrated model of the Euro50 extremely large telescope, and includes submodels of a Shack-Hartmann wavefront sensor, a de-formable mirror, a tip-tilt mirror, high-voltage amplifier low-pass filters, a reconstructor and a controller. We investigate the impact on the closed loop bandwidth of changes in controller configuration and certain system parameters, such as low pass filter bandwidth and camera integration and readout time. Control strategies were tested on simple models before implementation on the full VTT model. Using the models, different control strategies are compared.     

Coronal Holes and Flare Index: A correlation study

The correlation between the presence of coronal holes and flare indices has been investigated for the period from 1976 to 1995. The analysis shows that in the cases of 227 Carrington rotations (CRs) backward time lags yield the highest correlation between the coronal holes and flare indices. The maximum correlations were found at time lags of 222 and 142 CRs for polar and equatorial coronal holes, respectively. The period of study covers the past two solar cycles (21 and 22). Correlation analysis of both solar cycles has also been studied individually. The correlation analysis reveals that there is in general a forward shift in the maximum correlation for polar coronal holes, but it cannot be recommended to use polar coronal hole numbers for forecasting the next solar cycle.     

Spatially resolved spectrophotometry of comet P/Stephan-Oterma

Observations of Comet P/Stephan-Oterma were made with an Intensified Dissector Scanner spectrograph on the McDonald Observatory 2.7-m telescope during the period from July 1980 to February 1981. These spectra cover a range of heliocentric distances from 2.3 AU preperihelion to 1.8 AU postperihelion. A small aperture was used to map the spatial distributions of the gases in the coma. Column densities of the observed cometary emissions (CN, C₃, CH, and C₂) were calculated and it is shown that Stephan-Oterma appeared nearly spherically symmetric. These date are used by Cochran (1985, Icarus62, 82–92) to constrain chemical models of Stephan-Oterma.     

A warped m= 2 water maser disc in V778 Cyg?

The silicate carbon star V778 Cyg is a source of 22-GHz water maser emission which was recently resolved by MERLIN. Observations revealed an elongated     -like structure along which the velocities of the maser features show a linear dependence on the impact parameter. This is consistent with a doubly warped   m = 2  disc observed edge-on. Water masers and silicate dust emission (detected by the Infrared Astronomical Satellite and Infrared Space Observatory ) have a common origin in O-rich material and are likely to be co-located in the disc. We propose a detailed self-consistent model of a masing gas–dust disc around a companion to the carbon star in a binary system, which allows us to estimate the companion mass of  1.7 ± 0.1 M_⊙  , the disc radius of  40 ± 3  au and the distance between companions of ∼80 au. Using a dust–gas coupling model for water masing, we calculate the maser power self-consistently, accounting for both the gas and the dust energy balances. Comparing the simulation results with the observational data, we deduce the main physical parameters of the masing disc, such as the gas and dust temperatures and their densities. We also present an analysis of the stability of the disc.     

Forest cover mapping of East district,Sikkim using IRS-1A LISS II satellite data

Remote sensing techniques have been applied to classify tour density classes within each of the forest type along with other major landuse/landcover classes in the East district, Sikkim using IRS-1A LISS II satellite data pertaining to the period of November, 1988. The shadow problem in rugged terrain and difficulty in acquiring cloud free data for different seasons pose problems to achieve considerable mapping accuracy. In the present study, the forests of the district were delineated through supervised classification techniques using maximum likelihood algorithm into five forest types as sal forests, subtropical broad-leaved forests, Himalayan wet temperate forests, Rhododendron forests and alpine forests. The alpine forests were further stratified into two categories as moist alpine scrub and dry alpine scrub. The statistical data obtained from the present study shows that 55.47 percent of the total geographical area of the East district was under forest cover. An overall accuracy of more than 85 percent in correctly delineating forest classes was achieved.     

Flocculation improves uptake of Sr and Cs from radioactive effluents

This paper presents the results of investigation on uptake of radioactive species ⁹⁰Sr and ¹³⁷Cs present in the liquid effluents from nuclear processing plants. Chemical precipitation process is adopted to remove radioactivity from the effluents with low and intermediate level of activity. In this process, radioactive ⁹⁰Sr and ¹³⁷Cs are co-precipitated along with copper ferrocyanide, ferric hydroxide and either calcium phosphate or barium sulphate. These precipitates being fine in size require flocculation for enhanced settling rate in clarifier/thickener. The flocculation by some selected high molecular weight polyacrylamide based polymers has improved the uptake of radioactive metal ions. The adsorption of these radioactive species has been found to increase in the presence of these flocculants thereby improving the decontamination factor (DF). While flocculating the precipitates, there may be some complex formation with Sr²⁺/Cs⁺, flocculant and the substrate. This has enhanced the uptake of the radioactive metal ions from the liquid component. The plant trials have indicated the improvement of DF value due to flocculation by cationic flocculant.     

A comparison of mud- and sand-dominated meanders in a downstream coarsening reach of the mixed bedrock-alluvial Klip River, eastern Free State, South Africa

Along a 28 km reach of the Klip River, eastern Free State, South Africa, mud- and sand-dominated meanders have developed in close proximity within a floodplain wetland up to 1.5 km wide, providing an unusual opportunity to compare their characteristics under similar hydrological conditions. Throughout the reach, the channel bed is grounded on sandstone/shale bedrock although the banks are alluvial, and most river activity occurs during summer high flows. The reach can be divided into three geomorphological zones: Zone 1 (0–11 km), a muddy proximal part with a single meandering channel (w/d < 10) and near-permanent standing water in oxbows and backswamps; Zone 2 (11–17.5 km), a transitional mud-to-sand part with one main channel (w/d  20–30), a number of sinuous palaeochannels and oxbows, and only limited standing water; and Zone 3 (17.5–28 km), a sandy distal part with a single meandering channel (w/d  15–30), scroll bars and oxbows, and little standing water. Each zone also has a distinctive sedimentology: Zone 1 is characterised by an  3–4 m thick succession of basal sand and minor granules overlain by dominantly muddy sediment deposited primarily by oblique accretion in meander bends; Zone 2 is characterised by < 4 m of interbedded sand and mud deposited primarily by lateral point-bar accretion, although a history of avulsions also attests to the importance of abandoned-channel accretion; and Zone 3 is characterised by < 3 m of dominantly sand deposited primarily by lateral point-bar accretion. This unusual downstream sediment coarsening trend, and the associated changes in channel and floodplain character, are independent of sediment inputs from tributaries, and result from a downstream increase in bankfull unit stream power from < 3.5 W m^− 2 (Zone 1) to  4–10 W m^− 2 (Zone 3). Mud is deposited primarily in low-energy Zone 1 but is conveyed in suspension more effectively through higher energy Zones 2 and 3, only forming drapes over sandy lateral accretion deposits during waning flood stages. The downstream increase in unit stream power is controlled in part by a slight downstream increase in floodplain gradient that may be related to a subtle variation in the erosional resistance of the bedrock underlying the channel bed. These findings add to previous work on meandering rivers by demonstrating that mud-dominated meanders can occur in long-term erosional settings where the channel bed is grounded on bedrock, and that downstream fining trends may be reversed locally.     

Primary volcanic structures from a type section of Deccan Trap flows around Narsingpur-Harrai-Amarwara, central India: Implications for cooling history

Field investigations of the Deccan Trap lava sequence along a 70 km traverse in the Narsingpur-Harrai-Amarwara area of central India indicate twenty lava flows comprising a total thickness of around 480 m. Primary volcanic structures like vesicles and cooling joints are conspicuous in this volcanic succession and are used to divide individual flows into three well-defined zones namely the lower colonnade zone, entablature zone, and the upper colonnade zone. The variable nature of these structural zones is used for identification and correlation of lava flows in the field. For twenty lava flows, the thicknesses of upper colonnade zones of eight flows are ∼5 m while those of eight other flows are ∼8 m each. The thicknesses of upper colonnade zones of remaining four flows could not be measured in the field. Using the thicknesses of these upper colonnade zones and standard temperature-flow thickness-cooling time profiles for lava pile, the total cooling time of these sixteen Deccan Trap lava flows has been estimated at 12 to 15 years.     

Spectral factorization technique for estimation of an ARMA operator for multichannel deconvolution of seismic data

A new spectral factorization method is presented for the estimation of a causal as well as a causally invertible ARMA operator from the correlation sequence of seismic traces. The method has been implemented for multichannel deconvolution of seismic traces with the aim of exploiting the trace-to-trace correlation that exists within seismograms. A layered earth model with a small reflectivity sequence has been considered, and the seismic traces have been considered as the output of a linear system driven by white noise reflection coefficient sequences. The present method is the concatenation of three algorithms, namely Kung's method for state variable ( F , G , H ) realization using a singular value decomposition (SVD) algorithm, Faurre's technique for computation of the strong spectral factor and Leverrier's algorithm for ARMA representation of the spectral factor. The inverted ARMA operator is used as a recursive filter for deconvolution of seismic traces. In the example shown, two traces with a covariance sequence of 160 ms length have been considered for multichannel deconvolution of stacked seismic traces. The results presented, when compared with those obtained from a conventional deconvolution algorithm, have shown encouraging prospects.