Some breakage characteristics of ultra-fine wet grinding with a centrifugal mill

A centrifugal mill is a high-power intensity media mill that can be used for ultra-fine grinding, employing centrifugal forces generated by gyration of the axis of the mill tube in a circle. The mill charge motion is quite different depending on the ratio of the gyration diameter to the mill diameter (G / D ratio), varying from a motion similar to that of a conventional tumbling media mill to that of a vibration mill. In this study, a centrifugal mill was constructed with an arrangement where the gyration diameter could be readily adjusted. The batch grinding characteristics of three different minerals (limestone, talc and illite) in water with dispersing agent were investigated at various G / D ratios. It was found that the optimum G / D ratio in terms of the specific energy consumption to give a desired fineness of product was different for the three minerals. This was due to their different reactions to the breakage mechanisms provided by the mill charge motion at varying G / D ratios. The size distributions became progressively narrower at increased grinding times, and particles finer than about 0.1 μm were not detected even for prolonged grinding times. Measurement of specific surface areas indicated that this was not due to an artifact of the size measurements by laser diffractometry. This implies that there is a limitation in which particles finer than 0.1 μm are not produced under the conditions tested in this type of mill, but further investigation is needed for experimental verification of this limit of comminution.     

Estimation of non-CO2 GHGs emissions by analyzing burn severity in the Samcheok fire, South Korea

This study was performed to estimate the emission of non-CO 2 greenhouse gases(GHGs) from biomass burning at a large fire area.The extended methodology adopted the IPCC Guidelines(2003) equation for use on data from the Samcheok forest fire gathered using 30 m resolution Landsat TM satellite imagery,digital forest type maps,and growing stock information per hectare by forest type in 1999.Normalized burn ratio(NBR) technique was employed to analyze the area and severity of the Samcheok forest fire that occurred in 2000.The differences between NBR from pre-and post-fire datasets are examined to determine the extent and degree of change detected from burning.The results of burn severity analysis by dNBR of the Samcheok forest fire area revealed that a total of 16,200 ha of forest were burned.The proportion of the area characterized by a ’Low’ burn severity(dNBR below 152) was 35%,with ’Moderate’(dNBR 153-190) and ’High’(dNBR 191-255) areas were at 33% and 32%,respectively.The combustion efficiency for burn severity was calculated as 0.43 for crown fire where burn severity was ’High’,as 0.40 for ’Moderate’ severity,and 0.15 for ’Low’ severity surface fire.The emission factors for estimating non-CO 2 GHGs were separately applied to CO 130,CH 4 9,NO x 0.7 and N 2 O 0.11.Non-CO 2 GHGs emissions from biomass burning in the Samcheok forest fire area were estimated to be CO 44.100,CH 4 3.053,NO x 0.238 and N 2 O 0.038 Gg.     

Velocities and Temperatures of an Ellerman Bomb and Its Associated Features

We investigated the velocity and temperature characteristics of an Ellerman bomb (EB) and its associated features based on observations made with the Fast Imaging Solar Spectrograph (FISS) and a broadband TiO filter of the 1.6 meter New Solar Telescope at Big Bear Solar Observatory. In the TiO images of the photospheric level, we found a granular cell expanding in two opposite directions near the site of the EB. When one end of this granule reached the EB site, the transverse speed of the tip of the expanding granule rapidly decreased and the EB brightened. The wings of the Hα profile of the EB indicated that the EB was blueshifted up to 7 km?s^?1. About 260 s after the EB brightening, a surge was seen in absorption and varied from a blueshift of 20 km?s^?1 to a redshift of 40 km?s^?1 seen in the Hα and Ca ii 8542 Å lines. From the Doppler absorption width of the two lines determined by applying the cloud model, we estimated the mean temperature of the surge material to be about 29000 K and the mean speed of nonthermal motion to be about 11 km?s^?1. We discuss the physical implications of our results in terms of magnetic reconnection and processes related to it.     

Numerical and experimental study on hydrodynamic interaction of side-by-side moored multiple vessels

This paper aims to investigate the basic interaction characteristics of side-by-side moored vessels both numerically and experimentally. A higher-order boundary element method (HOBEM) combined with generalized mode approach is applied to analysis of motion and drift force of side-by-side moored multiple vessels (LNG FPSO, LNGC and shuttle tankers). Model tests were carried out for the same floating bodies investigated in the numerical study in regular and irregular waves. Global and local motion responses and drift forces of three vessels are compared with those of calculations. Discussions is highlighted on applicability of numerical method to prediction of sophisticated multi-body interaction problem of which motion behavior is very important to analysis of mooring dynamics of deep sea floating bodies.     

Analysis of resistivity data obtained from cone penetrometer in contaminated soil layers

In horizontally layered soils of different electrical properties, electrical potential distribution becomes complex and the obtained resistivity data may be limited in reflecting the actual soil profile. Thus the objective of this study was to identify the factors that affect resistivity measurement on the cone penetrometer and further investigate the sensitivity of measured resistivity to different types and concentrations of contaminants at the subsurface level. First, a theoretical resistivity equation was derived to provide a means of computing the geometric factor. The effective volume of measurement on the cone penetrometer was investigated and laboratory soil box tests verified the dominance of partially high resistivity regions within the effective volume of measurement over the apparent resistivity. Such effect was found to lead to possible discrepancies between the recorded resistivity data and the actual depth of measurement. Measurements on contaminated soil layers indicated that resistivity cones are efffective in delineating inorganic contaminants in soils of high water contents, and detecting NAPLs floating above the groundwater table provided that soils adjacent to the plume are not dry of water. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Large temporal changes in contributions of groundwater-borne nutrients to coastal waters off a volcanic island

We examined the contribution of submarine groundwater discharge (SGD) to nutrient budgets in Hwasun Bay, Jeju Island, Korea in August 2009, October 2014, and May 2015. The concentrations of dissolved inorganic nitrogen (DIN) and dissolved inorganic phosphorus (DIP) in fresh groundwater were in the range of 285?716 μM and 2.3?3.2 μM, respectively, which were each 1?2 orders of magnitude higher than those in the bay seawater. The outer-bay seawater flowing into the bay was oligotrophic (2.9 ± 1.9 μM for DIN and 0.2 ± 0.3 μM for DIP). Nutrient budget calculations were performed for each season by accounting for submarine fresh groundwater discharge (SFGD) and water residence times. In August 2009 (DIN = 1.8 μM and DIN:DIP ratio = 4.6 for the outerbay water), DIN inputs from SFGD accounted for approximately 40% of the DIN inventory in the bay seawater. In October 2014 (DIN = 1.1 μM and DIP < 0.05 μM for the outer-bay water), DIP from SFGD accounted for approximately 100% of the DIP inventory in the bay seawater. In May 2015, mean concentrations of DIN and DIP in the bay seawater were 8.6 ± 12 μM and 0.11 ± 0.04 μM, respectively, with conservative behaviors in the bay seawater in association with excessive groundwater inputs. These results imply that SGD plays a critical but different role in nutrient budgets and stoichiometry in coastal waters off a volcanic island depending on open-ocean nutrient conditions.     

Evaluation of bending moments and shear forces at unit connections of very large floating structures using hydroelastic and rigid body analyses

This paper investigates the characteristics of bending moments, shear forces and stresses at unit connections of very large floating structures (VLFS) under wave loads. The responses of VLFS are calculated by solving multi-body motion equation considering hydroelasticity and connection stiffness. Hydroelastic responses are calculated by the direct method. Higher-order boundary element method (HOBEM) is used for fluid analysis and finite element method (FEM) is introduced for structural analysis. The equation of motion is modified to describe the unit connections by employing spring elements. Bending moments and shear forces at the connections are obtained from the dynamic equilibrium condition for pressures and inertia forces. Two types of VLFS units such as tandem arranged units and side-by-side arranged units are considered in the numerical examples. The influences of connection stiffness, wave frequency and heading angle on responses of VLFS are investigated through the numerical examples. Rigid body analysis along with hydroelastic analysis is also carried out in the numerical analysis and comparison of those two approaches is discussed.     

Population structure of the Korean gizzard shad, <Emphasis Type="Italic">Konosirus punctatus</Emphasis> (Clupeiformes,Clupeidae) using multivariate morphometric analysis

The gizzard shad, Konosirus punctatus, is one of the most important fish species in Korea, China, Japan and Taiwan, and therefore the implementation of an appropriate population structure analysis is both necessary and fitting. In order to clarify the current distribution range for the two lineages of the Korean gizzard shad (Myoung and Kim 2014), we conducted a multivariate morphometric analysis by locality and lineage. We analyzed 17 morphometric and 5 meristic characters of 173 individuals, which were sampled from eight localities in the East Sea, the Yellow Sea and the Korean Strait. Unlike population genetics studies, the canonical discriminant analysis (CDA) results showed that the two morphotypes were clearly segregated by the center value “0” of CAN1, of which morphotype A occurred from the Yellow Sea to the western Korean Strait with negative values, and morphotype B occurred from the East Sea to the eastern Korean Strait with positive values even though there exists an admixture zone in the eastern Korean Strait. Further studies using more sensitive markers such as microsatellite DNA are required in order to define the true relationship between the two lineages.     

Rare earth element fingerprints in Korean coastal bay sediments: Association with provenance discrimination

Rare earth elements (REEs: La-Lu) in surface sediments collected from the mouth and middle tidal flats of Gomso Bay, South Korea, in August 2011 and May 2012 were analyzed to investigate the fine-grained sediment provenance. The upper continental crust (UCC)-normalized light REEs (LREEs: La to Nd) were more enriched than the middle REEs (MREEs: Sm to Dy) and heavy REEs (HREEs: Ho to Lu), resulting in large (La/Yb)_UCC (1.9 ± 0.4) to (Gd/Yb)_UCC (1.4 ± 0.2) ratios. The monthly (La/Yb)_UCC values differed between the mouth and middle tidal flats due to deposition of fine-grained sediments that originated from distant rivers (the Geum and Yeongsan) and the Jujin Stream, located on the southern shore of the inner bay. We observed relative reductions in the (La/Yb)_UCC value and REE content in the sediments from the mouth of the bay compared with those from Jujin Stream sediments. Confined to the middle tidal flat around the KH Line of Jujin Stream, the sediments, most enriched in LREEs but depleted in Eu, were distributed in August as strong Jujin Stream runs. Here, we suggest that an increase in LREE/HREE and decrease in MREE/LREE ratios can be used as a proxy to identify the Jujin Stream provenance in mixed riverine sediments and to trace Jujin Stream sediments within the Gomso Bay tidal flat, especially in the summer rainy season.