Impact of Kiri dam on the lower reaches of river Gongola, Nigeria

Changes in Geomorphic characteristics in the lower reaches of the Gongola River channel following construction of Kiri dam have been investigated. The study focused on changes in the channel bankfull width and of riverbed width after the control of the river flow, variation in discharge characteristics between pre- and post- dam periods and the impact of discharge variation on post- dam river channel. Results of the analysis revealed that the main effect of the impoundment of the Gongola channel is a drastic decrease in flood peaks below the reservoir by 11.5% (from 1,420 m³/sec to 1,256 m³/sec). The low flows have on the other hand increased by 268% (from 5.7 m³/sec to 21 m³/sec). The resultant effect of decrease in the discharge was reduction in the channel bankfull and riverbed widths by 38.3% and 72.2% respectively. Also, the post- dam channel became less sinuous and braided in some of the reaches downstream. Discharges of high peaks were found during the period of maximum precipitation (June to September) whereas low discharges were recorded during the period of minimum or no precipitation (December to May). Some of the observed implications of the flow control on the geometric variables were reduction in the overall channel width, concave bank erosion and emergence of vegetation in some of the reaches.     

An improved earthquake catalogue (<Emphasis Type="Italic">M</Emphasis> ≥ 4.0) for Turkey and its near vicinity (1900–2012)

Many catalogues, agency reports and research articles have been published on seismicity of Turkey and its surrounding since 1950s. Given existing magnitude heterogeneity, erroneous information on epicentral location, event date and time, this past published data however is far from fulfilling the required standards. Paucity of a standardized format in the available catalogues have reinforced the need for a refined and updated catalogue for earthquake related hazard and risk studies. During this study, ~37,000 earthquakes and related parametric data were evaluated by utilizing more than 41 published studies and, an integrated database was prepared in order to analyse all parameters acquired from the catalogues and references for each event. Within the scope of this study, the epicentral locations of M ≥ 5.0 events were firstly reappraised based on the updated Active Fault Map of Turkey. An improved catalogue of 12.674 events for the period 1900–2012 was as a result recompiled for the region between 32–45N° and 23–48E° by analyzing in detail accuracy of all seismological parameters available for each event. The events consist of M ≥ 4.0 are reported in several magnitude scales (e.g. moment magnitude, M_w; surface wave magnitude, M_S; body-wave magnitude m_b; local magnitude M_L and duration magnitude M_d) whereas the maximum focal depth reaches up to 225-km. In order to provide homogenous data, the improved catalogue is unified in terms of M_w. Fore-and aftershocks were also removed from the catalogue and completeness analyses were performed both separately for various tectonic sources and as a whole for the study region of interest. Thus, the prepared homogenous and declustered catalogue consisting of 6573 events provides the basis for a reliable input to the seismic hazard assessment studies for Turkey and its surrounding areas.     

Active fault database of Turkey

We have updated the active fault map of Turkey and built its database within GIS environment. In the study, four distinct active fault types, classified according to geochronological criteria and character, were delineated on the 1:25,000 base map of Turkey. 176 fault segments not included in the former active fault map of Turkey, have been identified and documented. We infer that there are 485 single fault segments which are substantially potential seismic sources. In total 1964 active-fault base-maps were transferred into the GIS environment. Each fault was attributed with key parameters such as class, activity, type, length, trend, and attitude of fault plane. The fault parameters are also supported by slip-rate and seismogenic depth inferred from available GPS, seismological and paleoseismological data. Additionally, expected maximum magnitude for each fault segment was estimated by empirical equations. We present the database in a parametric catalogue of fault segments to be of interest in earthquake engineering and seismotectonics. The study provides essential geological and seismological inputs for regional seismic hazard analysis of all over Turkey and its vicinity.     

Evolution of seismic hazard maps in Turkey

A review on the historical evolution of seismic hazard maps in Turkey is followed by summarizing the important aspects of the updated national probabilistic seismic hazard maps. Comparisons with the predecessor probabilistic seismic hazard maps as well as the implications on the national design codes conclude the paper.     

Late Quaternary chronology of the southern Black Sea basin

During New Euxinian time when sea level dropped below the sill connecting the Black and Marmara seas, the Black Sea became isolated and freshwater sediments were deposited. Now it is a semieuxinic basin with the oxic/anoxic boundary at 100–150 m. The seasonal changes in sedimentation are preserved in the form of laminated sequences. The counting of varves in southeastern Black Sea cores show the chronology of the O₂/H₂S interface. The age of the Holocene sapropel along the eastern margin ranges from 4000 to 1000 yr BP in deep water and 2500—1000 yr BP in shallower water. Sapropel formation started at 3650 yr BP at a water depth of 2200 m.     

High-Rate Communication for Underwater Acoustic Channels Using Multiple Transmitters and Space–Time Coding: Receiver Structures and Experimental Results

In this paper, we consider the use of multiple antennas and space-time coding for high data rate underwater acoustic (UWA) communications. Recent advances in information theory have shown that significant capacity gains can be achieved by using multiple-input-multiple-output (MIMO) systems and space-time coding techniques for rich scattering environments. This is especially significant for the UWA channel where the usable bandwidth is severely limited due to frequency-dependent attenuation. In this paper, we propose to use space-time coding and iterative decoding techniques to obtain high data rates and reliability over shallow-water, medium-range UWA channels. In particular, we propose to use space-time trellis codes (STTCs), layered space-time codes (LSTCs) and their combinations along with three low-complexity adaptive equalizer structures at the receiver. We consider multiband transmissions where the available bandwidth is divided into several subbands with guard bands in between them. We describe the theoretical basis of the proposed receivers along with a comprehensive set of experimental results obtained by processing data collected from real UWA communications experiments carried out in the Pacific Ocean. We demonstrate that by using space-time coding at the transmitter and sophisticated iterative processing at the receiver, we can obtain data rates and spectral efficiencies that are not possible with single transmitter systems at similar ranges and depths. In particular, we have demonstrated reliable transmission at a data rate of 48 kb/s in 23 kHz of bandwidth, and 12 kb/s in 3 kHz of bandwidth (a spectral efficiency of 4 bs^-1Hz^-1) at a 2-km range.     

Application of logistic regression for landslide susceptibility zoning of Cekmece Area, Istanbul, Turkey

As a result of industrialization, throughout the world, cities have been growing rapidly for the last century. One typical example of these growing cities is Istanbul, the population of which is over 10 million. Due to rapid urbanization, new areas suitable for settlement and engineering structures are necessary. The Cekmece area located west of the Istanbul metropolitan area is studied, because the landslide activity is extensive in this area. The purpose of this study is to develop a model that can be used to characterize landslide susceptibility in map form using logistic regression analysis of an extensive landslide database. A database of landslide activity was constructed using both aerial-photography and field studies. About 19.2% of the selected study area is covered by deep-seated landslides. The landslides that occur in the area are primarily located in sandstones with interbedded permeable and impermeable layers such as claystone, siltstone and mudstone. About 31.95% of the total landslide area is located at this unit. To apply logistic regression analyses, a data matrix including 37 variables was constructed. The variables used in the forwards stepwise analyses are different measures of slope, aspect, elevation, stream power index (SPI), plan curvature, profile curvature, geology, geomorphology and relative permeability of lithological units. A total of 25 variables were identified as exerting strong influence on landslide occurrence, and included by the logistic regression equation. Wald statistics values indicate that lithology, SPI and slope are more important than the other parameters in the equation. Beta coefficients of the 25 variables included the logistic regression equation provide a model for landslide susceptibility in the Cekmece area. This model is used to generate a landslide susceptibility map that correctly classified 83.8% of the landslide-prone areas.     

A probabilistic seismic hazard assessment for the Turkish territory—part I: the area source model

The seismic zoning map of Turkey that is used in connection with the national seismic design code (versions issued both in 1997 and 2007) is based on a probabilistic seismic hazard assessment study conducted more than 20 years ago (Gülkan et al. in En son verilere göre haz?rlanan Türkiye deprem bölgeleri haritas?, Report No: METU/EERC 93-1, 1993). In line with the efforts for the update of the seismic design code, the need aroused for an updated seismic hazard map, incorporating recent data and state-of-the-art methodologies and providing ground motion parameters required for the construction of the design spectra stipulated by the new Turkish Earthquake Design Code. Supported by AFAD (Disaster and Emergency Management Authority of Turkey), a project has been conducted for the country scale assessment of the seismic hazard by probabilistic methods. The present paper describes the probabilistic seismic hazard assessment study conducted in connection with this project, incorporating in an area source model, all recently compiled data on seismicity and active faulting, and using a set of recently developed ground motion prediction equations, for both active shallow crustal and subduction regimes, evaluated as adequately representing the ground motion characteristics in the region. The area sources delineated in the model are fully parameterized in terms of maximum magnitude, depth distribution, predominant strike and dip angles and mechanism of possible ruptures. Resulting ground motion distributions are quantified and presented for PGA and 5 % damped spectral accelerations at T = 0.2 and 1.0 s, associated with return periods of 475 and 2475 years. The full set of seismic hazard curves was also made available for the hazard computation sites. The second part of the study, which is based on a fault source and smoothed seismicity model is covered in Demircioglu et al. in Bull Earthq Eng, (2016).     

Surface wave dynamics off Mumbai coast,north-eastern Arabian Sea

Ocean Dynamics - Directional wave data collected in the coastal area at 10-m water depth for a period of 1&nbsp;year is used to describe the surface wave dynamics off Mumbai coast. Partitioning...